Engineering Papers⌕ Search

Engineering topics

Schiff, Lewis B.

Publications and source records attributed to Schiff, Lewis B..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Flow Over A Simplified-Rocket-Shaped Body

Report describes observations of supersonic flow of air over cylindrical body capped by hemisphere at its head and flared to cone at its tail end. Study prompted by need for greater aircraft control at high angles of attack.

Schiff, Lewis B.↗
NASA NTRS1992

Computational investigation of slot blowing for fuselage forebody flow control

This paper presents a computational investigation of a tangential slot blowing concept for generating lateral control forces on an aircraft fuselage forebody. The effects of varying both the jet width and jet exit velocity for a fixed location slot are analyzed. This work is aimed at aiding researchers in designing future experimental and computational models of tangential slot blowing. The primary influence on the resulting side force of the forebody is seen to be the jet mass flow rate. This influence is sensitive to different combinations of slot widths and jet velocities over the range of variables considered. Both an actuator plane and an overset grid technique are used to model the tangential slot. The overset method successfully resolves the details of the actual slot geometry, extending the generality of the numerical method. The actuator plane concept predicts side forces similar to those produced by resolving the actual slot geometry.

Murman, Scott M.↗
NASA NTRS1992

Coupled numerical simulation of the external and engine inlet flows for the F-18 at large incidence

This paper presents a numerical simulation of the external and engine inlet flows for the F-18 aircraft at typical high-angle-of-attack flight conditions. Two engine inlet mass flow rates, corresponding to flight idle and maximum power, were computed. This was accomplished using a structured, overset grid technique to couple the external and internal grid systems. Reynolds-averaged Navier-Stokes solutions were obtained using an implicit, finite-differencing scheme. Results show a strong coupling of the external and engine inlet flows, especially at the maximum power setting. Increasing the mass flow rate through the inlet caused the primary vortex breakdown location to move downstream. This trend is also observed in flight tests performed on the F-18. A reversed flow region upstream of the inlet duct is visible in the faired-inlet and flight-idle computations. This flow reversal is not present in the maximum power setting computation. These large-scale changes in flow structure highlight the importance of simulating inlet conditions in high-angle-of-attack aircraft computations.

Murman, Scott M.↗
NASA NTRS1992

Analysis of a pneumatic forebody flow control concept about a full aircraft geometry

A full aircraft geometry is used to computationally analyze the effectiveness of a pneumatic forebody flow control concept. An overset grid technique is employed to model the aircraft and slot geometry. Steady-state solutions for both isolated forebody and full aircraft configurations are carried out using a thin-layer Navier-Stokes flow solver. A solution obtained using the full aircraft geometry and a flight sideslip condition investigates the effect of sideslip on the leading edge extention vortex burst point. A no-sideslip blowing solution using the isolated forebody at full-scale wind tunnel test conditions is compared with experimental data to determine the accuracy of the numerical method. A solution employing the full geometry and slot blowing at flight conditions is obtained.

Gee, Ken↗
NASA NTRS1991

Navier-Stokes solutions for an oscillating double-delta wing

An upwind-biased implicit scheme is used to investigate steady-state and unsteady Navier-Stokes solutions of the vortical flow over a double-delta wing configuration. The governing equations are solved numerically with a fully upwind, implicit, iterative, and factorized numerical scheme. Steady-state solutions for fixed angles of attack and unsteady solutions for a sinusoidal oscillatory motion are obtained. The steady-state solutions on the baseline grid are in agreement with the experiment, and grid refinements show some improvements of the predictions. The higher-order accuracy of the present scheme yields equivalent solutions on smaller grid densities compared to solutions obtained with a second-order accurate method on larger grids. As the angle of attack increases, the grid resolution requirements for adequate resolution of the leeward-side vortical flowfield become very severe. The unsteady solutions are in general agreement with the measurements and show a qualitative correlation with the experiment.

Ekaterinaris, John A.↗
NASA NTRS1991

Numerical investigation of the flow over a double delta wing at high incidence

The vortical flowfield over a double-delta wing configuration, consisting of a sharp leading edge 76 deg sweep strake and a 40 deg sweep wing section is investigated. The governing equations are solved numerically with a partially upwind, finite-difference, factorized algorithm. The leeward side vortex system resulting from the strake and wing vortices is investigated for subsonic, high-Reynolds-number flow at various angles of incidence. At low angles of attack the strake and wing vortices remain separate over the wing section, while for flows at higher angles of attack the two vortices merge and vortex breakdown develops. Vortex breakdown appears initially at the trailing edge region of the wing section. As the angle of attack increases bursting occurs further upstream closer to the strake section. The effect of numerical grid density is investigated, and the solutions are compared with available experimental data.

Ekaterinaris, John A.↗
NASA NTRS1991

Navier-Stokes predictions of pitch damping for axisymmetric shell using steady coning motion

Previous theoretical investigations have proposed that the side force and moment acting on a body of revolution in steady coning motion could be related to the pitch-damping force and moment. In the current research effort, this approach is applied to produce predictions of the pitch damping for axisymmetric shell. The flow fields about these projectiles undergoing steady coning motion are successfully computed using a parabolized Navier-Stokes computational approach which makes use of a rotating coordinate frame. The governing equations are modified to include the centrifugal and Coriolis force terms due to the rotating coordinate frame. From the computed flow field, the side moments due to coning motion, spinning motion, and combined spinning and coning motion are used to determine the pitch-damping coefficients. Computations are performed for two generic shell configurations, a secant-ogive-cylinder and a secant-ogive-cylinder-boattail.

Weinacht, Paul↗
NASA NTRS1991

Computational optimization of a pneumatic forebody flow control concept

The effectiveness of a tangential slot blowing concept for generating lateral control forces on an aircraft forebody is analyzed using computational fluid dynamics. The flow about a fighter forebody is computed using a multiple-zone, thin-layer Navier-Stokes code. Tangential slot blowing is modeled by the use of an actuator plane. The effects of slot location and slot length on the efficiency of the system are analyzed. Results of the study indicate that placement of the slot near the nose of the aircraft greatly enhances the efficiency of the system, while the length and circumferential location of the slot are of secondary importance. Efficiency is defined by the amount of side force or yawing moment obtained per unit blowing coefficient. The effect of sideslip on the system is also analyzed. The system is able to generate incremental changes in forces and moments in flows with sideslip angles up to 10 deg comparable to those obtained at zero sideslip. These results are used to determine a baseline configuration for an experimental study of the tangential slot blowing concept.

Gee, Ken↗
NASA NTRS1990

Physical considerations governing computation of turbulent flows over bodies at large incidence

The physical aspects governing accurate numerical simulation of turbulent flows having large regions of crossflow separation are re-examined. Time-accurate, three-dimensional fine-grid Navier-Stokes solutions were obtained for turbulent subsonic and supersonic flows over a slender ogive-cylinder body of revolution at large angles of attack. These flowfields are complex and contain regions of crossflow separation and an organized leeward-side vortex structure. An algebraic eddy-viscosity turbulence model has been modified to correctly account for the effects of the vortices on the underlying viscous layers. The numerical results show that the vortical flow structure of both subsonic and supersonic high incidence flows are similar, and can be accurately treated by the turbulence model. As the angle of attack is increased, the effectiveness of the model increases since the influence of the vortices on the underlying boundary layer decreases.

Degani, David↗
NASA NTRS1990

Pneumatic vortical flow control at high angles of attack

The injection of thin, high-momentum jets of air into the fuselage forebody boundary layers of the F-18 aircraft is explored numerically as a means of controlling the onset of fuselage vortices and of generating yaw control forces. The study was carried out for an angle of attack of 30 deg with symmetrical and asymmetrical blowing configurations. One-sided blowing results in a strongly asymmetrical flow pattern in the fore portion of the fuselage, leading to a net lateral force.

Tavella, Domingo A.↗
NASA NTRS1990

Navier-Stokes predictions of the flowfield around the F-18 (HARV) wing and fuselage at large incidence

In support of the NASA High Alpha Technology Program, Navier-Stokes solutions have been obtained using the Chimera overset grid scheme for flow over the wing, fuselage, and wing leading-edge extension (LEX) of the F/A-18 High Alpha Research Vehicle (HARV) at high incidence. Solutions are also presented for flow over the fuselage forebody at high angles of attack. The solutions are for turbulent flows at high-Reynolds-number flight-test conditions, and are compared with available qualitative and quantitative experimental data. Comparisons of predicted surface flow patterns, off-surface flow visualization, and surface-pressure distributions are in good agreement with flight-test data. The ability of the numerical method to predict the bursting of the LEX vortex as it encounters the adverse pressure gradient field of the wing is demonstrated, and the capability of predicting high-angle-of-attack aerodynamics around realistic aircraft configurations is established.

Cummings, Russell M.↗
NASA NTRS1990

Vortical flows over delta wings and numerical prediction of vortex breakdown

Navier-Stokes solutions of subsonic vortical flow over a 75 deg sweep delta wing with a sharp leading edge are presented. The sensitivity of the solution to the numerical scheme is examined using both a partially upwind scheme and a scheme with central differencing in all directions. At moderate angles of attack, no vortex breakdown is observed, whereas the higher angle-of-attack cases exhibit breakdown. The effect of numerical grid density is investigated, and solutions that are obtained with various grid densities are compared with experimental data. An embedded grid approach is implemented to enable higher resolution in selected isolated flow regions, such as the leeward-side surface, the leading-edge vortical flow, and the vortex breakdown region.

Ekaterinaris, J. A.↗
NASA NTRS1990

Numerical simulation of the viscous flow around a simplified F/A-18 at high angles of attack

A numerical method developed for solving the viscous flow around three-dimensional complex configurations is presently used to simulate the flow around a simplified F/A-18 configuration encompassing forebody, wing, leading-edge extension, faired-over inlet, and deflected wing leading-edge flaps, at Mach 0.243 and 30.3 deg angle of attack. The computational results show the details of the flowfield structure, including primary, secondary, and tertiary separation lines, the development of forebody and leading-edge extension vortex, and the burst of this vortex. A grid-refinement study is conducted to assess the effect of grid characteristics on solution accuracy. Substantial agreement is obtained between these results and flight data.

Rizk, Yehia M.↗