Engineering Papers⌕ Search

Engineering topics

Schiff, Lewis B.

Publications and source records attributed to Schiff, Lewis B..

49 records · Page 3

Numerical simulation of the effects of variation of angle of attack and sweep angle on vortex breakdown over delta wings

In the present investigation of the vortical flowfield structure over delta wings at high angles of attack, three-dimensional Navier-Stokes numerical simulations were conducted to predict the complex leeward flowfield characteristics; these encompass leading-edge separation, secondary separation, and vortex breakdown. Attention is given to the effect on solution accuracy of circumferential grid-resolution variations in the vicinity of the wing leading edge, and well as to the effect of turbulence modeling on the solutions. When a critical angle-of-attack was reached, bubble-type vortex breakdown was found. With further angle-of-attack increase, a change from bubble-type to spiral-type vortex breakdown was predicted by the numerical solution.

Ekaterinaris, J. A.↗

The effect of turbulence models on the numerical prediction of the flowfield about a prolate spheroid at high angle of attack

The F3D thin-layer Navier-Stokes code presently used to numerically investigate the three-dimensional separated flow about a prolate spheroid at high incidence analyzes the effect of different turbulence models on the flowfield solution and the characteristics of the predicted flow. The Johnson-King (1984) model is applied in order to evaluate the importance of modeling nonequilibrium effects in predicting flow about a slender body at high incidence; the computations in question are for steady-state, fully turbulent flow. Insight is gained into the effects of turbulence models on flow characteristics, and model effects on the accurate prediction of highly separated and vortical flows about a slender body are demonstrated.

Gee, Ken↗

Numerical simulation of high-incidence flow over the F-18 aircraft

Navier-Stokes solutions have been obtained using the Chimera overset grid scheme for flow over the wing, fuselage, and wing leading-edge extension (LEX) of the F-18 aircraft at high incidence. Solutions are also presented for flow over the fuselage forebody at high angles of attack. The solutions are for turbulent flows at high-Reynolds number flight-test conditions, and are compared with available qualitative and quantitative experimental data. Comparisons of predicted surface flow patterns, off-surface flow visualizations, and surface-pressure distributions are in good agreement with flight-test data. The ability of the numerical method to predict the bursting of the LEX vortex as it encounters the adverse pressure gradient field of the wing is demonstrated.

Cummings, Russell M.↗

Numerical simulation of F-18 fuselage forebody flows at high angles of attack

Fine-grid Navier-Stokes solutions were obtained for flow over the fuselage forebody and wing leading edge extension of the F/A-18 High Alpha Research Vehicle at large incidence. The resulting flows are complex, and exhibit cross flow separation from the sides of the forebody and from the leading edge extension. A well-defined vortex pattern is observed in the leeward-side flow. Results obtained for laminar flow show good agreement with flow visualizations obtained in ground-based experiments. Further, turbulent flows computed at high Reynolds-number flight-test conditions show good agreement with surface and off-surface visualizations obtained in flight.

Schiff, Lewis B.↗

Numerical simulation of vortex unsteadiness on slender bodies of revolution at large incidence

Time-accurate, fine-grid Navier-Stokes solutions were obtained for flow over a slender ogive-cylinder body of revolution at angles of attack ranging from 10 deg to 40 deg. The results indicate the progressive growth of crossflow separation and the development of the leeward side vortex pattern with increasing incidence. The computed flows show good agreement with experimental measurements. As the angle of attack was increased, the flows become less damped, and at 40 deg a nonsteady flow exhibiting self-sustained fluctuations was observed. The nonsteadiness was linked to the presence of small-scale three-dimensional vortices moving along the primary surfaces of crossflow separation. The behavior of the fluctuations with incidence parallels the trend observed in experiments.

Schiff, Lewis B.↗

Numerical simulation of high-incidence flow over the F-18 fuselage forebody

As part of the NASA High Alpha Technology Program, fine-grid Navier-Stokes solutions have been obtained for flow over the fuselage forebody and wing leading-edge extension of the F/A-18 High Alpha Research Vehicle at large incidence. The resulting flows are complex and exhibit cross-flow separation from the sides of the forebody and from the leading-edge extension. A well-defined vortex pattern is observed in the leeward-side flow. Results obtained for laminar flow show good agreement with flow visualizations obtained in ground-based experiments. Further, turbulent flows computed at high-Reynolds-number flight-test conditions show good agreement with surface and off-surface visualizations obtained in flight.

Schiff, Lewis B.↗

Numerical simulation of the effect of spatial disturbances on vortex asymmetry

The steady asymmetric vortex pattern observed on slender bodies of revolution at large angle of attack was investigated using fine-grid Navier-Stokes computations. The computed results demonstrate the marked asymmetry which has been observed in experiments. To obtain asymmetry, it was found essential to introduce a space-fixed time-invariant perturbation into the computation. The computational results suggest that vortex asymmetry is forced by amplification of small disturbances, such as those due to surface roughness, occurring within the body viscous boundary layer.

Degani, David↗

Numerical simulation of separated and vortical flows on bodies at large angles of attack

Navier-Stokes computations were carried out for high-angle-of-attack flow about bodies of revolution in supersonic and subsonic flow. Numerical and physical factors affecting flow predictions are discussed. Accurate prediction of the complex three-dimensional separated flow is found to depend on using grids sufficiently fine to resolve the details of both the viscous boundary layer and the off-surface separated flow structures, and, for turbulent flow cases, use of an eddy-viscosity turbulence model which accounts for the leeward vortical flow structures. An example of high-incidence flow computed about a more complex geometry, the F-18 fighter fuselage forebody and leading edge extension, is also presented.

Schiff, Lewis B.↗

Experimental study of three-dimensional separated flow surrounding a hemisphere-cylinder at incidence

Detailed experimental surface pressure coefficient measurements, obtained for a hemisphere-cylinder-flare model in a low supersonic flow (freestream M = 1.2) at various angles of attack (0 deg to 27.5 deg), have been analyzed. The pressure values for each angle of attack were smoothed and checked against their respective oil-flow photographs. The smoothed results were then used to validate a theory which relates the number and type of singular points observed in the oil-flow patterns with local surface-pressure extrema.

Meade, Andrew J., Jr.↗

A numerical study of three-dimensional separated flow past a hemisphere cylinder

Separated and vortical flow about a hemisphere-cylinder body has been investigated. An algorithm featuring two implicit factors, and partial flux splitting has been used to solve the thin-layer Navier-Stokes equations. In analyzing the complex flow patterns, experimental data and topological concepts are used to complement the numerical results in interpreting the surface-flow patterns as well as the flowfield structures. Basic issues concerning the three-dimensional separation characteristics and the leeward vortical structures are examined.

Ying, Susan X.↗

Numerical simulation of vortical flows over a strake-delta wing

The vortical flow fields over a double-delta wing with sweep angles 80 and 60 deg are investigated by means of numerical simulations based on the LU-ADI code of Fujii and Obayashi (1986) for the three-dimensional thin-layer Navier-Stokes equations. The results obtained using an 850,000-point grid at angle of attack alpha = 6-40 deg are presented graphically, compared with experimental data, and characterized in detail. Qualitatively accurate simulations are obtained for transition phenomena such as strake/wing-vortex interaction at alpha = 12 deg, bubble-type vortex breakdown near the trailing edge at alpha = 30 deg, and spiral-type breakdown at alpha = 35 deg. It is suggested that quantitative simulations can be achieved at higher grid resolution.

Fujii, Kozo↗

Nonlinear Aerodynamics of Bodies in Coning Motion

A numerical method for computing the nonlinear inviscid flowfield surrounding a body performing coning motion is described. The method permits accurate computation of the aerodynamic moment due to one of the four motions characterizing an arbitrary nonplanar motion. Results of computations for a slender circular cone in coning motion are presented, and show good agreement with experiment for angles of attack up to twice the cone half-angle. The computational results display significant departure of the side moment from the linear theory value with increasing angle of attack, but agree well with experimental measurements. This indicates that the initial nonlinear behavior of the aerodynamic moment is determined primarily by the inviscid flow.

Schiff, Lewis B.↗