Engineering Papers⌕ Search

Engineering topics

Liu, Yang

Publications and source records attributed to Liu, Yang.

At least 235 records · Page 13

Measuring Activation and Luminescence Time Scales of Upconverting NaYF 4 :Yb,Er Nanocrystals

Accurate determination of upconversion and luminescence lifetimes requires kinetic modeling of the complete time-resolved response for upconversion luminescence of NaYF4:Yb,Er nanocrystals. Prior investigations typically perform exponential fitting of the tail in the time profile or employ complex systems of differential equations to extract lifetimes. To simplify analysis while fitting the entire time-resolved response, this work introduces a set of simplified models that model the response as a convolution of upconversion and fluorescence processes. Models for two- and three-photon upconversion processes are developed and tested for NaYF4:Yb,Er nanocrystals excited by a 980 nm laser. The results are presented for the transitions 2 H 11/2 , 4 S 3/2 → 4 I 15/2 (530 nm, green emission), 4 F 9/2 → 4 I 15/2 (650 nm, red emission), and 2 H 9/2 → 4 I 15/2 (400 nm, blue emission). Even with the same number of fitting parameters, the two- and three-photon models resulted in better fitting than the simpler models of single and two convolved exponentials for 30 nm, 400 nm, and silica-coated 30 nm nanoparticles. We provide evidence that the longest time scales (0.5–4 ms) are due to the luminescence of the final state, that the energy transfer waiting times leading to upconversion are shorter (<0.1 ms), and that more than two waiting times are required to explain the entire time response. The long-time response deviates from single-exponential behavior more strongly in uncoated and silica-coated 30 nm particles than for 400 nm particles. This deviation may result from heterogeneity of the local environment of ions within the 30 nm particles.

36 MATERIALS SCIENCE↗

Effect of Heating Rate on Latent Heat of Fusion of Waxy Crystals in Crude Oil

Crude-oil transportation requires a study of the latent heat of phase transitions and the melting parameters of solid paraffin in the oil. The latent heat of fusion and the effect of the heating rate on melting were measured for Daqing oilfield waxy oil using differential scanning calorimetry. The peak melting ranges of the waxes were determined. The results showed that the total latent heats at heating rate 5°C/min from —20°C to the end of melting were 3035 and 39.26 J/g for two crude-oil samples. The latent heat maximum temperatures were 24.5 and 25.5°C The maximum latent heat for both samples was attained at heating rate 1°C/min. The relative deviation for the other heating rates was less than 3%. It was shown that the heating rate affected the position of the latent heat peak. The peak temperature shifted from 24 to 28°C for one sample and from 25.5 to 28.0°C for the other as the heating rate increased from I to 15°C/min. The results of the present work could be useful for further research on the paraffin precipitation mechanism during transportation of crude oil.

02 PETROLEUM↗

Crank–Nicolson WSGI difference scheme with finite element method for multi-dimensional time-fractional wave problem

In this article, a second-order Crank–Nicolson weighted and shifted Grünwald integral (WSGI) time-discrete scheme combined with finite element method is studied for finding the numerical solution of the multi-dimensional time-fractional wave equation. The time-fractional wave equation with Caputo-fractional derivative is transformed into the time-fractional integral equation by integral technique, then the second-order Crank–Nicolson finite element scheme with a time second-order WSGI discrete approximation for fractional integral is formulated. The analysis of stability is made, then a priori error estimate is given by making use of the conversion technique between the WSGI formula and fractional integral. At the end of the article, some numerical examples covering two two-dimensional cases with rectangular element and triangular element and a three-dimensional case with tetrahedral element are shown to test and verify our theoretical results.

97 MATHEMATICS AND COMPUTING↗

Auriculasin from Flemingia philippinensis roots shows good therapeutic indexes on hyperactive behavior in zebrafish

Highlights: • Auriculasin regulates dopamine secretion through per1b. • Auriculasin shows good therapeutic indexes on hyperactive behavior in zebrafish. • Auriculasin have potential therapeutic indexes on ADHD. Previously, period1b−/− zebrafish mutants were used to establish an attention deficit hyperactivity disorder (ADHD) model, in which hyperactive behavior was found to be a typical characteristic of ADHD due to down-regulated dopamine levels. Here, we used five prenylated isoflavones from Flemingia philippinensis roots to study their therapeutic effects on hyperactivity behavior in period1b−/− zebrafish. Results of locomotor activity assay showed that auriculasin, one of the prenylated isoflavones, significantly reduced the hyperactivity behavior in period1b−/− zebrafish. Hormone measurement results showed that auriculasin increased melatonin and dopamine content. Results of quantitative real-time polymerase chain reaction showed that auriculasin down-regulated the expression of mao but up-regulated the expression of th and per1b. Thus, auriculasin demonstrated a potential biological effect on dopamine activity to inhibit hyperactivity behavior in the ADHD zebrafish model by regulating circadian clock gene per1b.

60 APPLIED LIFE SCIENCES↗

Integration of conductivity probe with optical and x-ray imaging systems for local air–water two-phase flow measurement

Various techniques have been developed in the past to measure different parameters in two-phase flow. Among them, the multi-sensor conductivity probe is one of the most commonly used techniques because of its good overall performance. Recently, more advanced techniques such as high speed optical imaging and fast X-ray densitometry become mature and easily accessible. The main objective of this work is to compare and integrate these different techniques, to achieve a more accurate and complete measurement of two-phase flow. In this study, a double-sensor conductivity probe is used to measure the local time-averaged parameters along the radial direction of a 2.54 cm ID round pipe. An X-ray densitometry system is used to measure the chordal averaged void fraction and gas velocity. A high speed camera system is employed to provide the visualization of the two-phase flow structure and obtain the line-averaged gas velocity. The unique advantages and main uncertainties of these three techniques are analyzed by considering their measuring principles and possible issues in practical measurements. From this, a method is developed to integrate the data obtained by the optical and X-ray systems into the probe signal processing. Finally, a better accuracy could be achieved using this method for various local two-phase flow parameters including void fraction, bubble velocity and superficial gas velocity, compared to the original probe measurements.

42 ENGINEERING↗

Evolution of Micro-structure and Magnetic Properties in L1{sub 0} CoPt Nanoparticles by Au Addition

L1{sub 0} CoPt-Au nanoparticles with face-centered tetragonal (FCT) structure were synthesized by sol-gel technique at 700°C. The micro-structure and magnetism of L1{sub 0} CoPt-Au were measured by different measuring technologies. The influences of Au on the micro-structure and magnetism of L1{sub 0} CoPt nanoparticles were investigated. The Au addition promoted the formation of ordered L1{sub 0} phase CoPt nanoparticles and improved the grain size of L1{sub 0} CoPt nanoparticles When the Au content increased to 10 at.%, coercivity increased and saturation magnetization decreased, which may be originated from the increased order degree and ferrimagnetic nature of L1{sub 0} CoPt nanoparticles. Interestingly, when the Au addition was more than 10 at.%, the coercivity decreased due to the decrease of the order degree.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Relationship Between Dissolved Calcium and Total Calcium in Al-Killed Steels After Calcium Treatment

The variation of dissolved calcium content after calcium treatment in 37Mn5 pipeline steels was investigated. The content of [Ca] was calculated based on measured results of T.Ca and the composition of inclusions, which decreased from 16 to 0.07 ppm due to calcium vaporization. A comparison between the calculated and predicted [Ca] contents using Factsage indicated a good agreement. The effect of T.Ca, T.O., T.S, [Al]{sub s}, and temperature on [Ca] was also discussed.

36 MATERIALS SCIENCE↗

Transient Evolution of Nonmetallic Inclusions During Calcium Treatment of Molten Steel

The transient evolution of nonmetallic inclusions after calcium addition in pipeline steels was investigated with a vacuum induction furnace. Samples were taken at 1, 5, 10, 15, and 20 minutes after calcium treatment in both MgO and Al{sub 2}O{sub 3} crucibles. It was found that the total oxygen and the number density of inclusions were increased during calcium modification, while they were dropped to a low level in the last tapped sample. Due to the evaporation of calcium, inclusions were transferred from CaO-CaS to Al{sub 2}O{sub 3}-CaO-CaS, and then to Al{sub 2}O{sub 3}-CaO. The decomposition of CaS was highly dependent on the decrease of the total calcium and the increase of the total oxygen in the steel. Thermodynamic calculation was performed to predict the composition of inclusions considering the effect of the total oxygen and the total calcium and was validated by measurement. The relationship between the content of Al{sub 2}O{sub 3} in inclusions and the ratio of the total calcium and the total oxygen in steels was measured and compared with the calculated one using thermodynamic software Factsage 7.0. The mass-transfer coefficient of the dissolved calcium in the steel was estimated in the range of 2.35 × 10{sup −4} to 3.53 × 10{sup −4} m/s.

36 MATERIALS SCIENCE↗

The Effect of Pretilt and Twisted Angle on Twisted Nematic Liquid Crystal Filter

The effect of pretilt and twisted angle on twisted nematic liquid crystal filter (TNLCF) is studied theoretically and experimentally in this paper, based on the birefringence and distortion characteristic of twisted nematic liquid crystal, the output performance of TNLCF has been analyzed through numerical simulation firstly, then the corresponding experiment results verify the correctness of the simulation results, which show that the output performance of TNLCF is indeed related to pretilt angle and twisted angle of liquid crystal–with the increasing of the twisted angle the central wavelength of TNLCF will shift to the long wavelength, with the increasing of pretilt angle for the top glass substrate and the decreasing of pretilt angle for the bottom glass substrate the central wavelength of TNLCF will shift to the short wavelength, and if the pretilt angle of the bottom glass substrate is increased and the pretilt angle of the top glass substrate is reduced at the same time in some certain value or otherwise the shift trend of the central wavelength will be not evident. These results will offer an important reference value for the design and application of TNLCF as we believe.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

A Study of Clustering Techniques and Hierarchical Matrix Formats for Kernel Ridge Regression

We present memory-efficient and scalable algorithms for kernel methods used in machine learning. Using hierarchical matrix approximations for the kernel matrix the memory requirements, the number of floating point operations, and the execution time are drastically reduced compared to standard dense linear algebra routines. We consider both the general H matrix hierarchical format as well as Hierarchically Semi-Separable (HSS) matrices. Furthermore, we investigate the impact of several preprocessing and clustering techniques on the hierarchical matrix compression. Effective clustering of the input leads to a ten-fold increase in efficiency of the compression. The algorithms are implemented using the STRUMPACK solver library. These results confirm that - with correct tuning of the hyperparameters - classification using kernel ridge regression with the compressed matrix does not lose prediction accuracy compared to the exact - not compressed - kernel matrix and that our approach can be extended to O(1M) datasets, for which computation with the full kernel matrix becomes prohibitively expensive. We present numerical experiments in a distributed memory environment up to 1,024 processors of the NERSC's Cori supercomputer using well-known datasets to the machine learning community that range from dimension 8 up to 784.

97 MATHEMATICS AND COMPUTING↗

Chloride Flux Growth of Idiomorphic AWO 4 (A = Sr, Ba) Single Microcrystals

Scheelite-type divalent metal tungstate materials (AWO 4 ) have been studied for various applications due to their attractive mechanical and chemical properties. Preparation of the shape-controlled AWO 4 crystals with high crystallinity is one of the most effective approaches for further exploring and improving their properties. In this study, highly crystalline SrWO 4 and BaWO 4 microcrystals with different morphologies were grown by using a chloride flux growth technique. To investigate the effect of growth conditions on SrWO 4 and BaWO 4 crystals, NaCl and KCl were used as a flux, and the solute concentration was adjusted in the range of 5-50 mol %. The difference in the flux cation species (Na + and K + ) mainly affected the crystal size. In accordance with increasing the solute concentration, the dominant crystal shape of SrWO 4 and BaWO 4 varied as follows: whisker (a rod- or wire-like morphology with a large aspect ratio) → platelet → well/less-faceted polyhedron. Additionally, according to scanning electron microscopy and transmission electron microscopy results, a dendritic morphological transformation from AWO4 whisker to platelet during crystal growth has been proposed.

36 MATERIALS SCIENCE↗

The TORC1 signaling pathway regulates respiration-induced mitophagy in yeast

Mitophagy is an evolutionarily conserved autophagy process that selectively degrades mitochondria. This catabolic event is considered to be a mitochondrial quality control system crucial for cell homeostasis, however, mechanisms regulating mitophagy remain largely unknown. Here we show that the TORC1 (target of rapamycin complex 1) signaling pathway regulates mitophagy in budding yeast via SEACIT (Seh1-associated complex inhibiting TORC1) consisting of Iml1, Npr2, and Npr3. Cells lacking SEACIT displayed significant reductions in mitophagy during prolonged respiratory growth, while the other selective autophagy processes are less affected. Under the same conditions, mitophagy defects were strikingly rescued in the SEACIT mutants (1) treated with rapamycin, a specific TOR kinase inhibitor, (2) lacking Gtr1, a TORC1-stimulating Rag family GTPase downstream of SEACIT, and (3) devoid of Pib2, a phosphatidylinositol 3-phosphate-binding TORC1 activator. Notably, loss of Npr2 exacerbated mitophagy defects in cells lacking Atg13, a TORC1 effector crucial for activation of autophagy-related processes, suggesting additional mitophagy-specific regulator(s) downstream of TORC1. Finally, we found that npr2-null cells failed to stabilize the interaction of Atg32 with Atg11, a scaffold protein essential for mitophagy. Collectively, our data implicate SEACIT-mediated inactivation of TORC1 signaling as a critical step to promote respiration-induced mitophagy.

60 APPLIED LIFE SCIENCES↗