Engineering topics

Kim, J.

Publications and source records attributed to Kim, J..

At least 55 records · Page 3

NASA NTRS1993

Escape of Mars atmospheric carbon through time by photochemical means

Luhmann et al. recently suggested that sputtering of the Martian atmosphere by re-entering O(+) pickup ions could have provided a significant route of escape for CO2 and its products throughout Mars' history. They estimated that the equivalent of C in an approximately 140-mbar CO2 atmosphere should have been lost this way if the Sun and solar wind evolved according to available models. Another source of escaping C (and O) that is potentially important is the dissociative recombination of ionospheric CO(+) near the exobase. We have evaluated the loss rates due to this process for 'ancient' solar EUV radiation fluxes of 1, 3, and 6 times the present flux in order to calculate the possible cumulative loss over the last 3.5 Gyr.

Luhmann, J. G.↗

NASA NTRS1992

Isotropy of small scale turbulence

The degree to which local isotropy is satisfied has been examined using direct numerical simulations for a fully developed channel flow. Attention is mainly given to the high wavenumber part of vorticity and temperature derivative spectra. The ratio of these spectra and their isotropic values depends on the particular quantity considered, the departure from isotropy being more pronounced for the temperature derivative than for the vorticity. When the Kolmogorov-normalized wavenumber is sufficiently large, isotropy is satisfied provided the (Kolmogorov-normalized) mean strain rate is sufficiently small. This result appears to be independent of the quantity considered and of the Reynolds number.

Antonia, R. A.↗

NASA NTRS1992

Calculated ionization rates, ion densities, and airglow emission rates due to precipitating electrons in the nightside ionosphere of Mars

The calculations presented in this paper clearly establish that the electron fluxes measured by the HARP instrument, carried on board Phobos 2, could cause significant electron impact ionization and excitation in the nightside atmosphere of Mars, if these electrons actually do precipitate. The calculated peak electron densities were found to be about a factor of 2 larger than the mean observed nightside densities, indicating that if a significant fraction of the measured electrons actually precipitate, they could be the dominant mechanism responsible for maintaining the nightside ionosphere. The calculated zenith column emission rates of the O I 5577-A and 6300-A and CO Cameron band emissions, due to electron impact and dissociative recombination mechanisms, were found to be significant.

Haider, S. A.↗

NASA NTRS1992

Rotative quadrature phase-shift keying

A rotative quadrature phase-shift keying (RQPSK) modulation scheme is proposed. By rotating the QPSK signal constellation by pi/2, either clockwise or anticlockwise, during a symbol duration, the conventional QPSK scheme can be modified to transmit 3 bits per symbol to achieve both power and bandwidth efficiency.

Liu, J.↗

NASA NTRS1992

Time-averaged heat transfer and pressure measurements and comparison with prediction for a two-stage turbine

Time-averaged Stanton number and surface-pressure distributions are reported for the first-stage vane row and the first-stage blade row of the Rocketdyne Space Shuttle Main Engine two-stage fuel-side turbine. These measurements were made at 10 percent, 50 percent, and 90 percent span on both the pressure and suction surfaces of the component. Stanton-number distributions are also reported for the second-stage vane at 50 percent span. A shock tube is used as a short-duration source of heated and pressurized air to which the turbine is subjected. Platinum thin-film gages are used to obtain the heat-flux measurements and miniature silicone-diaphragm pressure transducers are used to obtain the surface pressure measurements. The first-stage vane Stanton number distributions are compared with predictions obtained using a quasi-3D Navier-Stokes solution and a version of STAN5. This same N-S technique was also used to obtain predictions for the first blade and the second vane.

Dunn, M. G.↗

NASA NTRS1992

Heat transfer and pressure measurements and comparison with prediction for the SSME two-stage turbine

Time averaged Stanton number and surface pressure distributions are reported for the first stage vane row, the first stage blade row, and the second stage vane row of the Rocketdyne Space Shuttle Main Engine (SSME) two-stage fuel-side turbine. Unsteady pressure envelope measurements for the first blade are also reported. These measurements were made at 10 percent, 50 percent, and 90 percent span on both the pressure and suction surfaces of the first stage components. Additional Stanton number measurements were made on the first stage blade platform, blade tip, and shroud, and at 50 percent span on the second vane. A shock tube was used as a short duration source of heated and pressurized air to which the turbine was subjected. Platinum thin film heat flux gages were used to obtain the heat flux measurements, while miniature silicon diaphragm flush-mounted pressure transducers were used to obtain the pressure measurements. The first stage vane Stanton number distributions are compared with predictions obtained using a version of STAN5 and quasi-3D Navier-Stokes solution. This same quasi-3D N-S code was also used to obtain predictions for the first blade and the second vane.

Dunn, M. G.↗

NASA NTRS1992

Low-Reynolds-number effects in a fully developed turbulent channel flow

Low-Reynolds-number effects are observed in the inner region of a fully developed turbulent channel flow, using data obtained either from experiments or by direct numerical simulations. The Reynolds-number influence is observed on the turbulence intensities and to a lesser degree on the average production and dissipation of the turbulent energy. In the near-wall region, the data confirm Wei and Willmarth's (1989) conclusion that the Reynolds stresses do not scale on wall variables. One of the reasons proposed to account for this behavior, namely, the 'geometry' effect or direct interaction between inner regions on opposite walls, was investigated in some detail by introducing temperature at one of the walls, both in experiment and simulation. Although the extent of penetration of thermal excursions into the opposite side of the channel can be significant at low Reynolds numbers, the contribution these excursions make to the Reynolds shear stress and the spanwise vorticity in the opposite wall region is negligible. In the inner region, spectra and cospectra of the velocity fluctuations u and v change rapidly with the Reynolds number, the variations being mainly confined to low wavenumbers in the u spectrum.

Antonia, R. A.↗

NASA NTRS1991

An eddy viscosity calculation method for a turbulent duct flow

The mean velocity profile across a fully developed turbulent duct flow is obtained from an eddy viscosity relation combined with an empirical outer region wake function. Results are in good agreement with experiments and with direct numerical simulations in the same flow at two Reynolds numbers. In particular, the near-wall trend of the Reynolds shear stress and its variation with Reynolds number are similar to those of the simulations. The eddy viscosity method is more accurate than previous mixing length or implicit function methods.

Antonia, R. A.↗

NASA NTRS1991

Some characteristics of small-scale turbulence in a turbulent duct flow

The fine-scale structure of turbulence in a fully developed turbulent duct flow is examined by considering the 3D velocity derivative field obtained from direct numerical simulations at two relatively small Reynolds numbers. The magnitudes of all mean-square derivatives (normalized by wall variables) increase with the Reynolds number, the increase being largest at the wall. These magnitudes are not consistent with the assumption of local isotropy except perhaps near the duct center-line. When the assumption of local isotropy is relaxed to one of local axisymmetry, or invariance with respect to rotation about a coordinate axis (here chosen in the streamwise direction), satisfactory agreement is indicated by the data outside the wall region. Support for axisymmetry is demonstrated by anisotropy invariant maps of the dissipation and vorticity tensors.

Antonia, R. A.↗

NASA NTRS1991

Free-stream turbulence and concave curvature effects on heated, transitional boundary layers, volume 1

An experimental investigation of the transition process on flat-plate and concave curved-wall boundary layers for various free-streem turbulence levels was performed. Where possible, sampling according to the intermittency function was made. Such sampling allowed segregation of the signal into two types of behavior: laminar-like and turbulent-like. The results from the investigation are discussed. Documentation is presented in two volumes. Volume one contains the text of the report including figures and supporting appendices. Volume two contains data reduction program listings and tabulated data.

Kim, J.↗

NASA NTRS1991

Free-stream turbulence and concave curvature effects on heated, transitional boundary layers

An experimental investigation of the transition process on flat-plate and concave curved-wall boundary layers for various free-stream turbulence levels was performed. Results show that for transition of a flat-plate, the two forms of boundary layer behavior, identified as laminar-like and turbulent-like, cannot be thought of as separate Blasius and fully-turbulent profiles, respectively. Thus, simple transition models in which the desired quantity is assumed to be an average, weighted on intermittency, of the theoretical laminar and fully turbulent values is not expected to be successful. Deviation of the flow identified as laminar-like from theoretical laminar behavior is shown to be due to recovery after the passage of a turbulent spot, while deviation of the flow identified as turbulent-like from the full-turbulent values is thought to be due to incomplete establishment of the fully-turbulent power spectral distribution. Turbulent Prandtl numbers for the transitional flow, computed from measured shear stress, turbulent heat flux and mean velocity and temperature profiles, were less than unity. For the curved-wall case with low free-stream turbulence intensity, the existence of Gortler vortices on the concave wall within both laminar and turbulent flows was established using liquid crystal visualization and spanwise velocity and temperature traverses. Transition was found to occur via a vortex breakdown mode. The vortex wavelength was quite irregular in both the laminar and turbulent flows, but the vortices were stable in time and space. The upwash was found to be more unstable, with higher levels of u' and u'v', and lower skin friction coefficients and shape factors. Turbulent Prandtl numbers, measured using a triple-wire probe, were found to be near unity for all post-transitional profiles, indicating no gross violation of Reynolds analogy. No evidence of streamwise vortices was seen in the high turbulence intensity case.

Kim, J.↗

NASA NTRS1991

Reynolds shear stress and heat flux calculations in a fully developed turbulent duct flow

The use of a modified form of the Van Driest mixing length for a fully developed turbulent channel flow leads to mean velocity and Reynolds stress distributions that are in close agreement with data obtained either from experiments or direct numerical simulations. The calculations are then extended to a nonisothermal flow by assuming a constant turbulent Prandtl number, the value of which depends on the molecular Prandtl number. Calculated distributions of mean temperature and lateral heat flux are in reasonable agreement with the simulations. The extension of the calculations to higher Reynolds numbers provides some idea of the Reynolds number required for scaling on wall variables to apply in the inner region of the flow.

Antonia, R. A.↗

NASA NTRS1991

Turbulent Prandtl number in the near-wall region of a turbulent channel flow

Calculations are presented of the turbulent Prandtl number Pr(T) in the near-wall region of a turbulent channel flow. It is shown that only the first-order terms in the Taylor series expansions for the eddy diffusivity and the Pr(T) are independent of the molecular Prandtl number Pr, at least to a first approximation. Also presented are calculations of the near-wall behavior of the correlations between temperature fluctuations and velocity fluctuations, as well as for their dependence on Pr.

Antonia, R. A.↗

NASA NTRS1991

A comprehensive magnetohydrodynamic model of the Venus ionosphere

The MHD Venus ionospheric model of Shinegawa and Cravens (1988) is improved here by including the energy equations for ions and electrons in a self-consistent manner. This new model reproduces observed electron density and magnetic field profiles very well, while the basic MHD process of the Venus ionosphere remain virtually unchanged. The results indicate that including energetics does not significantly alter the density and magnetic field profiles. Under unmagnetized conditions, heat fluxes for both ions and electrons must be imposed to reproduce the observed plasma temperature profiles. A heat source for the ions is probably present at higher altitudes in the magnetized ionosphere. Heating processes do not play a significant role in the dynamics at low altitudes.

Shinagawa, H.↗

NASA NTRS1991

Similarity between turbulent kinetic energy and temperature spectra in the near-wall region

The similarity between turbulent kinetic energy and temperature spectra, previously confirmed using experimental data in various turbulent shear flows, is validated in the near-wall region using direct numerical simulation data in a fully developed turbulent channel flow. The dependence of this similarity on the molecular Prandtl number is also examined.

Antonia, R. A.↗

NASA NTRS1991

Modeling and Numerical Simulation of Microwave Pulse Propagation in Air Breakdown Environment

Numerical simulation is used to investigate the extent of the electron density at a distant altitude location which can be generated by a high-power ground-transmitted microwave pulse. This is done by varying the power, width, shape, and carrier frequency of the pulse. The results show that once the breakdown threshold field is exceeded in the region below the desired altitude location, electron density starts to build up in that region through cascading breakdown. The generated plasma attenuates the pulse energy (tail erosion) and thus deteriorates the energy transmission to the destined altitude. The electron density saturates at a level limited by the pulse width and the tail erosion process. As the pulse continues to travel upward, though the breakdown threshold field of the background air decreases, the pulse energy (width) is reduced more severely by the tail erosion process. Thus, the electron density grows more quickly at the higher altitude, but saturates at a lower level. Consequently, the maximum electron density produced by a single pulse at 50 km altitude, for instance, is limited to a value below 10(exp 6) cm(exp -3). Three different approaches are examined to determine if the ionization at the destined location can be improved: a repetitive pulse approach, a focused pulse approach, and two intersecting beams. Only the intersecting beam approach is found to be practical for generating the desired density level.

Kuo, S. P.↗

NASA NTRS1990

The structure of turbulent channel flow with passive scalar transport

The simulation of turbulent channel flow, with various passive markers, was examined to investigate the local mechanisms of passive scalar transport. We found significant differences between the local transport of heat and momentum, even when the molecular and turbulent Prandtl numbers are of order one. These discrepancies can be attributed to the role of the pressure. We also found that the heat is a poor marker of the vorticity field outside of the near wall region and that scalar transport over significant distances results from the aggregate effect of many turbulent eddies.

Guezennec, Y.↗

NASA NTRS1990

A post-Pioneer Venus reassessment of the Martian dayside ionosphere as observed by radio occultation methods

Global characteristics of the dayside ionosphere of Mars were investigated by reanalyzing the electron-density dayside altitude profiles obtained by Mariners 4, 6, 7, and 9 and the Viking 1 and 2. The properties of both the electron density peaks and the topside profiles with the behavior expected for a Chapman layer in the Mars ionosphere were compared with those observed at Venus with the Pioneer Venus. The results yield an improved picture of the solar zenith angle dependences of both the peaks and the scale heights of the ionosphere of Mars, and their comparison with Venus at solar minimum. It is shown that, under similar conditions where the incident solar wind dynamic pressure exceeds the peak ionospheric thermal pressure, the Martian dayside ionosphere peaks at higher altitudes in the flanks and has a greater scale height. Thus, Martian and Venusian ionospheres would present different obstacles to solar wind.

Zhang, M. H. G.↗