Engineering Papers⌕ Search

Engineering topics

Kim, J.

Publications and source records attributed to Kim, J..

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Active turbulence control in wallbounded flow using direct numerical simulations

An exploratory study of concepts for active control of turbulent boundary layers using the direct numerical simulation technique was performed. Significant drag reduction was achieved when the surface boundary condition was modified such that it could suppress the large-scale structures present in the wall region. This was achieved by prescribing the normal component of velocity at the wall to be 180 deg out of phase with the normal velocity slightly above the wall at each instant. The drag reduction was accompanied with significant reduction in the intensity of the wall-layer structures and reductions in the magnitude of Reynolds stresses throughout the flow. Suitability of wall-pressure and shear-stress fluctuations for detection of flow structures above the wall was examined. A preliminary result obtained by applying the present control strategy to a transitional flow is also briefly described, from which one can infer a possible linkage between the control strategy and flow stability.

Kim, J.↗
NASA NTRS1989

Solar cycle variations of the electron densities near the ionospheric peak of Venus

Photochemical equilibrium calculations of electron and ion densities, appropriate for altitudes below about 180 km, were carried out for the Venus dayside ionosphere corresponding to solar cycle maximum and minimum conditions. The results were compared with data from radio occultation measurements. The agreement between the calculations and measurements was, in general, quite good. These comparisons indicate that the most commonly used neutral atmosphere model of Venus (Hedin et al., 1983) predicts densities which are somewhat low near the electron density peak for solar cycle maximum, but provides surprisingly good predictions for solar cycle minimum conditions.

Kim, J.↗
NASA NTRS1989

On the active control of wall-bounded turbulent flows

The direct numerical simulation technique is used to explore concepts for manipulation of turbulent boundary layers. Significant drag reduction was achieved when at each instant the normal component of velocity at the wall was prescribed to be 180 deg out of phase with the normal velocity slightly above the wall. The drag reduction is accompanied with significant reduction in the intensity of the wall-layer structures and reductions in the magnitude of Reynolds stresses throughout the flow. Suitability of wall pressure and shear stress fluctuations for detection of flow structures above the wall are examined.

Moin, P.↗
NASA NTRS1988

Reynolds-stress and dissipation-rate budgets in a turbulent channel flow

The budgets for the Reynolds stresses and for the dissipation rate of the turbulence kinetic energy are computed using direct simulation data of a turbulent channel flow. The budget data reveal that all the terms in the budget become important close to the wall. For inhomogeneous pressure boundary conditions, the pressure-strain term is split into a return term, a rapid term, and a Stokes term. The Stokes term is important close to the wall. The rapid and return terms play different roles depending on the component of the term. A split of the velocity pressure-gradient term into a redistributive term and a diffusion term is proposed, which should be simpler to model. The budget data is used to test existing closure models for the pressure-strain term, the dissipation rate, and the transport rate. In general, further work is needed to improve the models.

Mansour, N. N.↗
NASA NTRS1987

Reynolds-stress and dissipation rate budgets in a turbulent channel flow

The budgets for the Reynolds stresses and for the dissipation rate of the turbulence kinetic energy are computed using direct simulation data of a turbulent channel flow. The budget data reveal that all the terms in the budget become important close to the wall. For inhomogeneous pressure boundary conditions, the pressure-strain term is split into a return term, a rapid term, and a Stokes term. The Stokes term is important close to the wall. The rapid and return terms play different roles depending on the component of the term. A split of the velocity pressure-gradient term into a redistributive term and a diffusion term is proposed, which should be simpler to model. The budget data is used to test existing closure models for the pressure-strain term, the dissipation rate, and the transport rate. In general, further work is needed to improve the models.

Mansour, N. N.↗
NASA NTRS1987

Shear-layer structures in near-wall turbulence

The structure of internal shear layer observed in the near-wall region of turbulent flows is investigated by analyzing flow fields obtained from numerical simulations of channel and boundary-layer flows. It is found that the shear layer is an important contributor to the turbulence production. The conditionally averaged production at the center of the structure was almost twice as large as the long-time mean value. The shear-layer structure is also found to retain its coherence over streamwise distances on the order of a thousand viscous length units, and propagates with a constant velocity of about 10.6 u sub rho throughout the near wall region.

Johansson, A. V.↗
NASA NTRS1987

Structure of turbulent shear flows

Activities are summarized for each of the three topics discussed: eduction of coherent structures; measurement of propagation velocities of perturbation in turbulent flows; and direct evaluation of the Taylor hypothesis.

Hussain, A. K. M. F.↗
NASA NTRS1987

Active layer model for wall-bounded turbulence

The active-layer model for wall-bounded turbulence hypothesizes that the nonlinear terms are large only in a thin layer near the wall, and hence the turbulence in the region outside the active inner layer can be modeled as a linear fluctuating flow driven by the active layer. This hypothesis is tested using data obtained from a direct simulation of turbulent channel flow. It is found that the nonlinear effects are the strongest near the wall with a maximum at around y sup + = 20 and, outside the near-wall region, these involve primarily the cascading mechanism leading to dissipation.

Landahl, M. T.↗
NASA NTRS1987

Wave-growth associated with turbulent spot in plane Poiseuille flow

A kinematic wave theory is used to investigate the cause of the rapid growth of waves observed at the wingtip of turbulent spot in plane Poiseuille flow. It is found that the qualitative behavior of the wave motions is well described by Landahl's breakdown criterion as the wave selection procedure. The predicted wave number, wave angle, and phase velocity are in agreement with those values obtained in a direct simulation.

Henningson, D. S.↗
NASA NTRS1987

Near-wall k-epsilon turbulence modeling

The flow fields from a turbulent channel simulation are used to compute the budgets for the turbulent kinetic energy (k) and its dissipation rate (epsilon). Data from boundary layer simulations are used to analyze the dependence of the eddy-viscosity damping-function on the Reynolds number and the distance from the wall. The computed budgets are used to test existing near-wall turbulence models of the k-epsilon type. It was found that the turbulent transport models should be modified in the vicinity of the wall. It was also found that existing models for the different terms in the epsilon-budget are adequate in the region from the wall, but need modification near the wall. The channel flow is computed using a k-epsilon model with an eddy-viscosity damping function from the data and no damping functions in the epsilon-equation. These computations show that the k-profile can be adequately predicted, but to correctly predict the epsilon-profile, damping functions in the epsilon-equation are needed.

Mansour, N. N.↗
NASA NTRS1987

Measurements of the turbulent transport of heat and momentum in convexly curved boundary layers - Effects of curvature, recovery and free-stream turbulence

The effects of streamwise convex curvature, recovery, and freestream turbulence intensity on the turbulent transport of heat and momentum in a mature boundary layer are studied using a specially designed three-wire hot-wire probe. Increased freestream turbulence is found to increase the profiles throughout the boundary layer on the flat developing wall. Curvature effects were found to dominate turbulence intensity effects for the present cases considered. For the higher TI (turbulence intensity) case, negative values of the turbulent Prandtl number are found in the outer half of the boundary layer, indicating a breakdown in Reynolds analogy.

Kim, J.↗
NASA NTRS1987

Investigation of turbulent shear flows by numerical simulation

A data base (Kim et al., 1986) generated by direct numerical integration of the Navier-Stokes equations for unsteady three-dimensional turbulent channel flow at low Reynolds numbers is applied to investigate the physical processes acting in wall-bounded shear flows. The techniques used to construct the data base are outlined; the modeling of turbulence, streaks and streamwise vortices, horseshoe and inverted-horseshoe vortices, and vortex rings is described; the conditional sampling techniques employed are discussed; and typical results are presented graphically. An organized vorticity-field structure is revealed and found to be associated with the bursting process and a local peak in the wall pressure, indicating a possible approach to reducing viscous drag.

Kim, J.↗
NASA NTRS1987

Stochastic estimation of organized structures in turbulent channel flow

Linear stochastic estimation is used to approximate the conditional vector fields associated with high Reynolds stress producing events in numerically simulated turbulent channel flow. Joint probability density distributions of u-v are presented for y(+) between 1.35 and 180, and at each position the u-v values that make the greatest contributions to the average uv3 are used to define conditional ejection- and sweep-type events. In the y-z plane the conditional fields appear to be pairs of counter-rotating vortices. When the conditional event defined by the weighted probability density function is specified at a point close to the wall, the spacing and size of these eddies are consistent with the accepted wall streak spacing. As this point moves outwards, the eddy size increases significantly. An abrupt change in the flow angle occurs in the buffer layer and may indicate transition from streamwise oriented wall layer structures to hairpin vortices characterizing the outer layer.

Moin, P.↗
NASA NTRS1987

Near-wall k-epsilon turbulence modeling

The flow fields from a turbulent channel simulation are used to compute the budgets for the turbulent kinetic energy (k) and its dissipation rate (epsilon). Data from boundary layer simulations are used to analyze the dependence of the eddy-viscosity damping-function on the Reynolds number and the distance from the wall. The computed budgets are used to test existing near-wall turbulence models of the k-epsilon type. It was found that the turbulent transport models should be modified in the vicinity of the wall. It was also found that existing models for the different terms in the epsilon-budget are adequate in the region from the wall, but need modification near the wall. The channel flow is computed using a k-epsilon model with an eddy-viscosity damping function from the data and no damping functions in the epsilon-equation. These computations show that the k-profile can be adequately predicted, but to correctly predict the epsilon-profile, damping functions in the epsilon-equation are needed.

Mansour, N. N.↗
NASA NTRS1986

Evolution of a curved vortex filament into a vortex ring

The deformation of a hairpin-shaped vortex filament under self-induction and in the presence of shear is studied numerically using the Biot-Savart law. It is shown that the tip region of an elongated hairpin vortex evolves into a vortex ring and that the presence of mean shear impedes the process. Evolution of a finite-thickness vortex sheet under self-induction is also investigated using the Navier-Stokes equations. The layer evolves into a hairpin vortex which in turn produces a vortex ring of high Reynolds stress content. These results indicate a mechanism for the generation of ring vortices in turbulent shear flows, and a link between the experimental and numerical observation of hairpin vortices and the observation of ring vortices in the outer regions of turbulent boundary layers.

Moin, P.↗
NASA NTRS1986

The structure of the vorticity field in turbulent channel flow. II - Study of ensemble-averaged fields

Several conditional sampling techniques are applied to a data base generated by large-eddy simulation of turbulent channel flow. It is shown that the bursting process is associated with well-organized horseshoe vortices inclined at about 45 deg to the wall. These vortical structures are identified by examining the vortex lines of three-dimensional, ensemble averaged vorticity fields. Two distinct horseshoe-shaped vortices corresponding to the sweep and ejection events are detected. These vortices are associated with high Reynolds shear stress and hence make a significant contribution to turbulent energy production. The dependency of the ensemble averaged vortical structures on the detection criteria, and the question of whether this ensemble-averaged structure is an artifact of the ensemble averaging process are examined. The ensemble-averaged pattern of these vortical structures that emerge from the analysis could provide the basis for a hypothetical model of the organized structures of wall-bounded shear flows.

Kim, J.↗
NASA NTRS1985

Evolution of a curved vortex filament into a vortex ring

The deformation of a hairpin-shaped vortex filament under self-induction and in the presence of shear is studied numerically using the Biot-Savart law. It is shown that the tip region of an elongated hairpin vortex evolves into a vortex ring and that the presence of mean shear impedes the process. Evolution of a finite-thickness vortex sheet under self-induction is also investigated using the Navier-Stokes equations. The layer evolves into a hairpin vortex which in turn produces a vortex ring of high Reynolds stress content. These results indicate a mechanism for the generation of ring vortices in turbulent shear flows, and a link between the experimental and numerical observation of hairpin vortices and the observation of ring vortices in the outer regions of turbulent boundary layers.

Moin, P.↗