Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “GaAs solar cells”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Effects of low temperature periodic annealing on the deep-level defects in 200 keV proton irradiated AlGaAs-GaAs solar cells

The GaAs solar cell has shown good potential for space applications. However, degradation in performance occurred when the cells were irradiated by high energy electrons and protons in the space environment. The considered investigation is concerned with the effect of periodic thermal annealing on the deep-level defects induced by the 200 keV protons in the AlGaAs-GaAs solar cells. Protons at a fluence of 10 to the 11th P/sq cm were used in the irradiation cycle, while annealing temperatures of 200 C (for 24 hours), 300 C (six hours), and 400 C (six hours) were employed. The most likely candidate for the E(c) -0.71 eV electron trap observed in the 200 keV proton irradiated samples may be due to GaAs antisite, while the observed E(v) +0.18 eV hole trap has been attributed to the gallium vacancy related defect. The obtained results show that periodic annealing in the considered case does not offer any advantages over the one time annealing process.

Li, S. S.↗
NASA NTRS1979

High-efficiency thin-film GaAs solar cells

GaAs chemical vapor deposition (CVD) growth on single-crystal GaAs substrates was investigated over a temperature range of 600 to 750 C, As/GA mole-ratio range of 3 to 11, and gas molefraction range 5 x 10 to the minus 9th power to 7x 10 to the minus 7th power for H2S doping. GasAs CVD growth on recrystallized Ge films was investigated for a temperature range of 550 to 700 C, an As/GA mole ratio of 5, and for various H2S mole fraction. The highest efficiency cell observed on these films with 2 mm dots was 4.8% (8% when AR-coated). Improvements in fill factor and opencircuit voltage by about 40% each are required in order to obtain efficiencies of 15% or greater.

Stirn, R. J.↗
NASA NTRS1972

Development of GaAs solar cells

Calculations of GaAs solar cell output parameters were refined and a computer model was developed for parameter optimization. The results were analyzed to determine the material characteristics required for a high efficiency solar cell. Calculated efficiencies for a P/N cell polarity are higher than an N/P cell. Both cell polarities show efficiency to have a larger dependence on short circuit current than an open circuit voltage under nearly all conditions considered. The tolerances and requirements of a cell fabrication process are more critical for an N/P type than for a P/N type cell. Several solar cell fabrication considerations relative to junction formation using ion implantation are also discussed.

Mcnally, P. J.↗
NASA NTRS1980

Periodic annealing of radiation damage in GaAs solar cells

Continuous annealing of GaAs solar cells is compared with periodic annealing to determine their relative effectiveness in minimizing proton radiation damage. It is concluded that continuous annealing of the cells in space at 150 C can effectively reduce the proton radiation damage to the GaAs solar cells. Periodic annealing is most effective if it can be initiated at relatively low fluences (approximating continuous annealing), especially if low temperatures of less than 200 C are to be used. If annealing is started only after the fluence of the damaging protons has accumulated to a high value 10 to the 11th power sq/pcm), effective annealing is still possible at relatively high temperatures. Finally, since electron radiation damage anneals even more easily than proton radiation damage, substantial improvements in GaAs solar cell life can be achieved by incorporating the proper annealing capabilities in solar panels for practical space missions where both electron and proton radiation damage have to be minimized.

Loo, R. Y.↗
NASA NTRS1980

GaAs solar cells for space applications

GaAs solar cells offer substantial advantages for space photovoltaic power over Si solar cells in the areas of efficiency, elevated temperature operation, and radiation damage stability. A mission cost comparison is made for GaAs and Si solar cells. For Si cell arrays, the total mission cost is found to be a minimum for a solar concentration of 2.9. For GaAs, modes of operation and construction are investigated. Modes having lower mission costs than the minimum Si mission cost are defined. These include higher concentrations, lightweight cells, and simultaneous power generation and annealing. The technological progress necessary for GaAs to operate in these modes is identified.

Conway, E. J.↗
NASA NTRS1982

Medium energy proton radiation damage to (AlGa)As-GaAs solar cells

The performance of (AlGa)As-GaAs solar cells irradiated by medium energy 2, 5, and 10 MeV protons was evaluated. The Si cells without coverglass and a number of GaAs solar cells with 12 mil coverglass were irradiated simultaneously with bare GaAs cells. The cell degradation is directly related to the penetration of depth of protons with GaAs. The influence of periodic and continuous thermal annealing on the GaAs solar cells was investigated.

Loo, R. Y.↗
NASA NTRS1976

The optimization of Ga (1-x)Al (x)As-GaAs solar cells for air mass zero operation and a study of Ga (1-x)Al (x)As-GaAs solar cells at high temperatures, phase 1

The three types of solar cells investigated were: (1) one consisting of a nGaAs substrate, a Zn doped pGaAs region, and a Zn doped Ga(1-x)Al(x)As layer, (2) one consisting of an nGaAs substrate, a Ge doped pGaAs region, and a pGa(1-x)Al(x)As upper layer, and (3) one consisting of an n+GaAs substrate, an nGa(1-x)Al(X)As region, a pGa(1-x)Bl(X) As region, and a pGa(1-y)Al(y)As upper layer. In all three cases, the upper alloy layer is thin and of high Al composition in order to obtain high spectral response over the widest possible range of photon energies. Spectral response, capacitance-voltage, current-voltage, diffusion length, sunlight (or the equivalent)-efficiency, and efficiency-temperature measurements were made as a function of device parameters in order to analyze and optimize the solar cell behavior.

Hovel, H. J.↗
NASA NTRS1977

GaAs solar cell development

The motivation for developing GaAs solar cells is based on their superior efficiency when compared to silicon cells, their lower degradation with increasing temperature, and the expectation for better resistance to space radiation damage. The AMO efficiency of GaAs solar cells was calculated. A key consideration in the HRL technology is the production of GaAs cells of large area (greater than 4 sg cm) at a reasonable cost without sacrificing efficiency. An essential requirement for the successful fabrication of such cells is the ability to grow epitaxially a uniform layer of high quality GaAs (buffer layer) on state-of-the-art GaAs substrates, and to grow on this buffer layer the required than layer of (AlGa)As. A modified infinite melt liquid phase epitaxy (LPE) growth technique is detailed.

Knechtli, R. C.↗
NASA NTRS1980

Effects of low energy proton, electron, and simultaneously combined proton and electron environments in silicon and GaAs solar cells

Degradation of silicon and GaAs solar cells due to exposures to low energy proton and electron environments and annealing data for these cells are discussed. Degradation of silicon cells in simultaneously combined electron and low energy proton environments and previous experimental work is summarized and evaluated. The deficiencies in current solar array damage prediction techniques indicated by these data and the relevance of these deficiencies to specific missions such as intermediate altitude orbits and orbital transfer vehicles using solar electric propulsion systems are considered.

Horne, W. E.↗
NASA NTRS1982

Defects and annealing studies in 1-Me electron irradiated (AlGa)As-GaAs solar cells

The deep-level defects and recombination mechanisms in the one-MeV electron irradiated (AlGa)As-GaAs solar cells under various irradiation and annealing conditions are discussed. Deep-level transient spectroscopy (DLTS) and capacitance-voltage (CV) techniques were used to determine the defect and recombination parameters such as energy levels and defect density, carrier capture cross sections and lifetimes for both electron and hole traps as well as hole diffusion lengths in these electron irradiated GaAs solar cells. GaAs solar cells used in this study were prepared by the infinite solution melt liquid phase epitaxial (LPE) technique at Hughes Research Lab., with (Al0.9Ga0.1)-As window layer, Be-diffused p-GaAs layer on Sn-doped n-GaAs or undoped n-GaAs active layer grown on n(+)-GaAs substrate. Mesa structure with area of 5.86x1000 sq cm was fabricated. Three different irradiation and annealing experiments were performed on these solar cells.

Li, S. S.↗
NASA NTRS1979

Shallow-homojunction GaAs solar cells

Single-crystal GaAs shallow-homojunction solar cells on GaAs or Ge substrates, without Ga sub 1-x Al sub x As window layers, that have conversion efficiencies exceeding 20% at AM1 (17% at AMO). Using a simple theoretical model, good fits were obtained between computer calculations and experimental data for external quantum efficiency and conversion efficiency of cells with different values of n+ layer thickness. The calculations not only yield values for material properties of the GaAs layers composing the cells but will also permit the optimization of cell designs for space and terrestrial applications. Preliminary measurements indicate that the shallow-homojunction cells are resistant to electron irradiation. In the best test so far, bombardment with 1 x 10 to the 16th power/sq cm fluence of 1 MeV electrons reduced the short-circuit current by only about 6%.

Fan, J. C. C.↗
NASA NTRS1978

Long-term radiation effects on GaAs solar cell characteristics

This report investigates preliminary design considerations which should be considered for a space experiment involving Gallium Arsenide (GaAs) solar cells. The electron radiation effects on GaAs solar cells were conducted in a laboratory environment, and a statistical analysis of the data is presented. In order to augment the limited laboratory data, a theoretical investigation of the effect of radiation on GaAs solar cells is also developed. The results of this study are empirical prediction equations which can be used to estimate the actual damage of electrical characteristics in a space environment. The experimental and theoretical studies also indicate how GaAs solar cell parameters should be designed in order to withstand the effects of electron radiation damage.

Heinbockel, J. H.↗
NASA NTRS1979

Summary of GaAs Solar Cell Performance and Radiation Damage Workshop

The workshop considered the GaAs solar cell capability and promise in several steps: (1) maximum efficiency; (2) space application; (3) major technology problems (AR coating optimization, contacts); (4) radiation resistance; (5) cost and availability; and (6) alternatives. The workshop believes that GaAs solar cells are fast approaching the fulfillment of their potential as candidates for space cells. A maximum efficiency of 20 to 31 percent AMO can be reasonably expected from GaAs based cells, and this may go a little higher with concentration. The use of concentration in space needs to be more carefully evaluated.

Kamath, G. S.↗
NASA NTRS1980

"Pelled-film" solar cells

Cells are lighter and less expensive than conventional cells. GaAs cells are deposited on GaAs substrate coated with thin etchable layer that allows completed cell film to be peeled away from substrate. At estimated conversion of 18 percent, array of cells delivers about 1 kW of electricity per kilogram of cell material. Blanket of cells delivers energy at power-to-weight ratio about 4 times that of conventional 2-mil (0.5-mm) silicon solar cells. GaAs solar cells have better radiation resistance than silicon cells.

Stirn, R. J.↗
NASA NTRS1977

High efficiency GaAs solar cells

The present status of the GaAlAs/GaAs heteroface solar cell program is reported. Studies have been concentrated on GaAlAs/GaAs heteroface solar cells; however, some research has been conducted on thin junction, diffused GaAs solar cells. Emphasis has been on obtaining high efficiency (18% to 20%) GaAs solar cells. Two problems that have limited the efficiency of GaAs solar cells are the high recombination velocity of carriers near the surface and the low minority carrier diffusion length in n-GaAs.

Walker, G. H.↗
NASA NTRS1981

High-efficiency thin-film GaAs solar cells, phase2

Thin GaAs epi-layers with good crystallographic quality were grown using a (100) Si-substrate on which a thin Ge epi-interlayer was grown by CVD from germane. Both antireflection-coated metal oxide semiconductor (AMOS) and n(+)/p homojunction structures were studied. The AMOS cells were fabricated on undoped-GaAs epi-layers deposited on bulk poly-Ge substrates using organo-metallic CVD film-growth, with the best achieved AM1 conversion efficiency being 9.1%. Both p-type and n(+)-type GaAs growth were optimized using 50 ppm dimethyl zinc and 1% hydrogen sulfide, respectively. A direct GaAs deposition method in fabricating ultra-thin top layer, epitaxial n(+)/p shallow homojunction solar cells on (100) GaAs substrates (without anodic thinning) was developed to produce large area (1 sq/cm) cells, with 19.4% AM1 conversion efficiency achieved. Additionally, an AM1 conversion efficiency of 18.4% (17.5% with 5% grid coverage) was achieved for a single crystal GaAs n(+)/p cell grown by OM-CVD on a Ge wafer.

Yeh, Y. C. M.↗
NASA NTRS1979

GaAs solar cell development

The four (AlGa)As-GaAs solar cells were fabricated and will be delivered for radiation damage testing using 1 MeV electrons. These cells were LPE grown at 700 C for 4 minutes. The junction depth was measured to be 0.3 micron using a secondary electron microscope. The radiation model for the shallow junction cells was verified. Some mesa diodes were also fabricated and will be irradiated along with the cells for parallel evaluations of their electrical characteristics.

Source record↗