Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “UV”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,081 records · Page 60

Kinetics of the Photocurrent of a UV Sensor Based on Indium–Zinc Oxide Nanowires

An analysis of the experiments on the kinetics of the rise and decay of the current under the influence of extreme ultraviolet radiation on the indium–zinc oxide filament layer obtained by the electrospinning method is given. It is shown that the rate of rise of photocurrent is controlled by the radiation intensity and its decay rate is controlled by the partial pressure of oxygen on the surface of the wires. Owing to a significantly larger area of the active surface, this UV sensor with a layer of nanoscale wires has a shorter response time in comparison with homogeneous film structures in which the oxygen adsorption sites are concentrated.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

TiO2 Nanotubes/MWCNTs Nanocomposite Photocatalysts: Synthesis, Characterization and Photocatalytic Hydrogen Evolution Under UV-Vis Light Illumination

Nanocomposite of TiO2 nanotubes (TiO2NTs) and multiwalled carbon nanotubes (MWCNTs) has been synthesized by a hydrothermal method and firstly used in photocatalytic hydrogen production. The obtained TiO2 NTs/MWCNTs composites were characterized by X-ray diffraction, transmission electron microscopy, Raman spectrum and ultraviolet-visible diffuse reflectance spectroscopy. The experimental results revealed that the MWCNTs were decorated with well dispersed anatase TiO2 nanotubes with a diameter of 8-15 nm. A slight blue shift and weak symmetry was observed for the strongest Raman peak which resulted from strain gradients originating from interface integration between TiO2 nanotubes and MWCNTs. The photocatalytic activity of the as-prepared samples was evaluated by hydrogen evolution from water splitting using Na2S and Na2SO3 as sacrificial reagents under UV-vis light irradiation. Enhanced photocatalytic activity compared with P25 has been observed for the resulted samples. The nanocomposite with optimized MWCNTs content of 1% displayed a hydrogen production rate of 161 u mol/h/g. Good photocatalytic stability of the as-synthesized samples was observed as well.

08 HYDROGEN↗

Power enhancement of burst-mode UV pulses using a doubly-resonant optical cavity

We report a doubly-resonant enhancement cavity (DREC) that can realize a simultaneous enhancement of two incoming laser beams at different wavelengths and different temporal structures. The double-resonance condition is theoretically analyzed and different DREC locking methods are experimentally investigated. Simultaneous locking of a Fabry-Perot cavity to both an infrared (IR, 1064 nm) and its frequency tripled ultraviolet (UV, 355 nm) pulses has been demonstrated by controlling the frequency difference between the two beams with a fiber optic frequency shifter. The DREC technique opens a new paradigm in the applications of optical cavities to power enhancement of burst-mode lasers with arbitrary macropulse width and repetition rate.

42 ENGINEERING↗

Photoluminescence and Raman spectroscopy of wide bandgap semiconductors damaged by deep-UV laser irradiation

The effects of a pulsed, focused, deep-UV (4.66 eV) laser on wide and ultra-wide bandgap semiconductors were investigated with photoluminescence (PL) and Raman spectroscopy. Three semiconductor single crystals were studied: silicon carbide (6H-SiC), gallium nitride (GaN), and gallium oxide (β-Ga 2 O 3 ). Atomic emission lines from neutral Ga or Si were observed during the laser-damage process. For all three semiconductors, PL mapping (3.49 eV laser excitation) of the damaged material revealed visible emission bands in the 2.6–2.8 eV range, attributed to point defects. Raman spectra (2.33 eV excitation) showed a reduction in the Raman peak intensities in the damaged region, along with weak PL bands around 1.9–2.1 eV.

36 MATERIALS SCIENCE↗

Dual-frequency-comb UV spectroscopy with one million resolved comb lines

We present high-resolution dual-comb spectroscopy across two broad UV spectral regions spanning 372–410 nm and 325–342 nm. This is achieved by generating sixth and seventh harmonics, respectively, from a low-noise 2.35 µm Cr:ZnS dual-comb laser system. The sixth harmonic band contains approximately 1,000,000 spectrally resolved comb lines, while the seventh harmonic band—around 550,000 comb lines. With the line spacing of 80 MHz, this corresponds to a resolving power of up to 10 million, offering remarkable spectral resolution.

Muraviev, Andrey↗

Science-based Solutions to Achieve High-performance Deep-UV Laser Diodes (Final LDRD Report)

We present the results of a three year LDRD project that has focused on overcoming major materials roadblocks to achieving AlGaN-based deep-UV laser diodes. We describe our growth approach to achieving AlGaN templates with greater than ten times reduction of threading dislocations which resulted in greater than seven times enhancement of AlGaN quantum well photoluminescence and 15 times increase in electroluminescence from LED test structures. We describe the application of deep-level optical spectroscopy to AlGaN epilayers to quantify deep level energies and densities and further correlate defect properties with AlGaN luminescence efficiency. We further review our development of p-type short period superlattice structures as an approach to mitigate the high acceptor activation energies in AlGaN alloys. Finally, we describe our laser diode fabrication process, highlighting the development of highly vertical and smooth etched laser facets, as well as characterization of resulting laser heterostructures.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Soret Effect Study on High-Pressure CO 2 -Water Solutions Using UV-Raman Spectroscopy and a Concentric-Tube Optical Cell

Spatially resolved deep-UV Raman spectroscopy was applied to solutions of CO 2 and H 2 O (or D 2 O), which were subject to a temperature gradient in a thermally regulated high-pressure concentric-tube Raman cell in an attempt to measure a Soret effect in the vicinity of the critical point of CO 2 . Although Raman spectra of solutions of CO 2 dissolved in D 2 O at 10 MPa and temperatures near the critical point of CO 2 had adequate signal-to-noise and spatial resolution to observe a Soret effect with a Soret coefficient with magnitude of |S T | > 0.03, no evidence for an effect of this size was obtained for applied temperature gradients up to 19⁰C. The presence of 1 M NaCl did not make a difference. In contrast, the concentration of CO 2 dissolved in H 2 O was shown to vary significantly across the temperature gradient when excess CO 2 was present, but the results could be explained simply by the variation in CO 2 solubility over the temperature range and not to kinetic factors. For mixtures of D 2 O dissolved in scCO 2 at 10 MPa and temperatures close to the critical point of CO 2 , the Raman peaks for H 2 O were too weak to measure with confidence even at the limit of D 2 O solubility.

99 GENERAL AND MISCELLANEOUS↗

Validation and Verification of the Correct Operation of the Spectro RS23 UV-VIS Spectrometer used in ANC122 and NF-ANC122

In September of 2011, the old qualified Bausch and Laum Spec 100 UV-Vis instrument used in the ANC122 and NF-ANC122 procedures failed its monthly calibration check. Attempts to get the system to pass by cleaning flow cells, replacing the light bulb and realigning the light path failed to get sustained reproducible results from the system. In October the decision to take it out of service was made as the system was 40+ years in age. To replace the system, a previously purchased Labomed Inc.’s spectrometer (model Spectro 23RS; Serial #: 23RS-004253) was retrieved from storage. This report shows that the Labomed Inc. system is performing as required and meeting all QC requirements listed in ANC122 and NF-ANC122. Upon submitting this report to records, the system will be considered qualified to report results to customers of C-AAC.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Phosphors for near UV-Emitting LED's for Efficacious Generation of White Light

1) We studied phosphors for near-UV (nUV) LED application as an alternative to blue LEDs currently being used in SSL systems. We have shown that nUV light sources could be very efficient at high current and will have significantly less binning at both the chip and phosphor levels. We identified phosphor blends that could yield 4100K lamps with a CRI of approximately 80 and LPWnUV,opt equal to 179 for the best performing phosphor blend. Considering the fact that the lamps were not optimized for light coupling, the results are quite impressive. The main bottleneck is an optimum blue phosphor with a peak near 440 nm with a full width half maximum of about 25 nm and a quantum efficiency of >95%. Unfortunately, that may be a very difficult task when we want to excite a phosphor at ~400 nm with a very small margin for Stokes shift. Another way is to have all the phosphors in the blend having the excitation peak at 400 nm or slightly shorter wavelength. This could lead to a white light source with no body color and optimum efficacy due to no self-absorption effects by phosphors in the blend. This is even harder than finding an ideal blue phosphor, but not necessarily impossible. 2) With the phosphor blends identified, light sources using nUV LEDs at high current could be designed with comparable efficacy to those using blue LEDs. It will allow us to design light sources with multiple wattages using the same chips and phosphor blends simply by varying the input current. In the case of blue LEDs, this is not currently possible because varying the current will lower the efficacy at high current and alter the color point. With improvement of phosphor blends, control over CRI could improve. Less binning at the chip level and also at the phosphor blend level could reduce the cost of SSL light sources. 3) This study provided a deeper understanding of phosphor characteristics needed for LEDs in general and nUV LEDs in particular. Two students received Ph.D. degrees and three undergraduates participated in this work. Two of the undergraduate students are now in graduate school. The results were widely disseminated – 20 archival journal publications (published, accepted or in preparation) and three conference proceedings resulted. The students presented their work at 11 different national/international conferences (32 oral or poster presentations) and the PI’s delivered 12 invited, keynote or plenary lectures.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Electrically Injected UV-Visible Nanowire Lasers

There is strong interest in minimizing the volume of lasers to enable ultracompact, low-power, coherent light sources. Nanowires represent an ideal candidate for such nanolasers as stand-alone optical cavities and gain media, and optically pumped nanowire lasing has been demonstrated in several semiconductor systems. Electrically injected nanowire lasers are needed to realize actual working devices but have been elusive due to limitations of current methods to address the requirement for nanowire device heterostructures with high material quality, controlled doping and geometry, low optical loss, and efficient carrier injection. In this project we proposed to demonstrate electrically injected single nanowire lasers emitting in the important UV to visible wavelengths. Our approach to simultaneously address these challenges is based on high quality III-nitride nanowire device heterostructures with precisely controlled geometries and strong gain and mode confinement to minimize lasing thresholds, enabled by a unique top-down nanowire fabrication technique.

42 ENGINEERING↗

Utilization of UV Curing Technology to Significantly Reduce the Manufacturing Cost of LIB Electrodes

Previously identified novel binders and associated UV curing technology have been shown to reduce the time required to apply and finish electrode coatings from tens of minutes to less than one second. This revolutionary approach can result in dramatic increases in process speeds, significantly reduced capital (a factor of 10 to 20) and operating costs, reduced energy requirements, and reduced environmental concerns and costs due to the virtual elimination of harmful volatile organic solvents and associated solvent dryers and recovery systems. The accumulated advantages of higher speed, lower capital and operating costs, reduced footprint, lack of VOC recovery, and reduced energy cost is a reduction of 90% in the manufacturing cost of cathodes. When commercialized, the resulting cost reduction in Lithium batteries will allow storage device manufacturers to expand their sales in the market and thereby accrue the energy savings of broader utilization of HEVs, PHEVs and EVs in the U.S., and a broad technology export market is also envisioned.

14 SOLAR ENERGY↗

Ultraviolet (UV) Oxidation Final Report CRADA No. TC-0350-92

This CRADA was a collaborative agreement between the above parties to develop a more efficient ultraviolet (UV) oxidation process than the existing commercial processes. The proposed new process would be capable of completely mineralizing the organic constiruents in aqueous mixedwastes (wastes that contain both radioactive and organic constiruents) and converting them into ordinary radioactive wastes, which would mean cheaper and easier disposal.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Large scale, Low Temperature, Microplasma UV Lighting Tiles for Water Purification and Sterilization

Eden Park Illumination, Inc. is pursuing the development and commercialization of microcavity plasma lamps capable of generating light in the vacuum ultraviolet and deep ultraviolet wavelength ranges (VUV and UVC respectively), but in a slim and flat form factor. Ultraviolet light is well known to be efficient in enabling a number of chemical processes,and is particularly effective for disinfection.The ability of deep UV and VUV radiation to neutralize pathogens, drugs (hormone regulators), and organic chemicals is of increasing concern in drinking water and water re-use and is well-documented.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Radiometric Testing of Germicidal UV Products, Round 2: Upper-Room Luminaires (CALiPER Report)

This report analyzes the independently tested performance of eight germicidal ultraviolet (GUV) upper-room luminaires marketed for use in occupied spaces and purchased between March and June 2023. Three of the luminaires used UV-emitting LEDs, and the remaining five luminaires used low-pressure mercury (LPM) lamps. Product testing covered radiometric and electrical performance for each luminaire. Initial performance was measured for all eight products, and four were additionally measured after 100 h and 500 h of operation. Measured performance was compared against manufacturer or vendor claims. Specifiers and buyers of GUV products need accurate performance claims and data to deploy GUV technology safely and effectively. As with the CALiPER GUV Round 1 report, this CALiPER GUV Round 2 report demonstrates that manufacturers and vendors need significant education and training to accurately test and report the performance of their GUV products. Further development of industry consensus standards and guidelines may address testing limitations and improve test methods, product performance, and the accuracy of performance claims.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗