SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Movable probe and tuning wall adjusted to obtain resonance at microwave frequency used to generate plasma in cell at one end of microwave cavity. Electroless discharge without disadvantages of dc-cathode-discharge and RF-induction methods. To achieve precise positioning, coaxial probe extends into microwave cavity through tube.
Microwave background radiation by intense sources studied by homogeneous and isotropic Friedmann and steady state models
It has been shown that the long-term frequency stability of a cesium (Cs) frequency standard is affected by variations in the standard's internal microwave power source. Studies were performed on a commercial Cs frequency standard for a period of 20 days, to determine the stability of its microwave power source. The results were then analyzed statistically, and the effects of microwave power drift on the standard's frequency stability were calculated.
Detection of metal objects on or near the Earth's surface was investigated using existing, passive, microwave sensors operating from Earth orbit. The range equations are derived from basic microwave principles and theories and the expressions are given explicitly to estimate the signal to noise ratio for detecting metal targets operating as bistatic scatterers. Actual measurements are made on a range of metal objects observed from orbit using existing passive microwave receiving systems. The details of the measurements and the results are tabulated and discussed. The advantages of a passive microwave sensor as it is applied to surveillance of metal objects as viewed from aerial platforms or from orbit, are examined.
Water vapor microwave emission measurement from galactic hydroxyl sources
Based on the rate of increse of the microwave flux relative to the hard X-ray flux at various energies from the onset to the peak of a flare, the mean energy of microwave-emitting electrons is estimated for 22 flares observed simultaneously in hard X-rays and microwaves. The energy of electrons varying in proportion to the 17 GHz emission is found to concentrate below 100 keV, and the mean energy or eletrons emitting 70 keV x-rays is less than about 130 keV for thin-target and less than about 180 keV for thick-target emission models, suggesting that the 17 GHz emission derives from electrons with energy of less than a few hundred keV. The magnetic field strength in the microwave source is found to be 500-1000 G for the thick-target and 1000-2000 G for the thin-target case, and 16 of the 22 events examined can be successfully explained by the thick-target model. Of the six events which cannot be explained by the thick-target model, two events give L of less than about 300 km.
Recent advances in the growth of aluminum scandium nitride films on silicon suggest that this material platform could be applied for quantum electromechanical applications. Here, we model, fabricate, and characterize microwave frequency silicon phononic delay lines with transducers formed in an adjacent aluminum scandium nitride layer to evaluate aluminum scandium nitride films, at 32% scandium, on silicon interdigital transducers for piezoelectric transduction into suspended silicon membranes. We achieve an electromechanical coupling coefficient of 2.7% for the extensional symmetric-like Lamb mode supported in the suspended material stack and show how this coupling coefficient could be increased to at least 8.5%, which would further boost transduction efficiency and reduce the device footprint. The one-sided transduction efficiency, which quantifies the efficiency at which the source of microwave photons is converted to microwave phonons in the silicon membrane, is 10% at 5 GHz at room temperature and, as we discuss, there is a path to increase this toward near-unity efficiency based on a combination of modified device design and operation at cryogenic temperatures.
Cosmic Microwave Background (CMB) experiments measure remnant radiation from the early universe and use that data to determine fundamental properties of the universe. We can constrain key parameters, such as \textit{r}, the cosmic tensor-to-scalar ratio, and $N_\text{eff}$, the effective number of relativistic species, by analyzing the CMB power spectra. Improving our measurements of the CMB requires improving our instrument systematics, one of the most important of which is detector bandpass. Current experiments use a Fourier Transform Spectrometer (FTS) to measure bandpass. However, the FTS is systematics limited, and cannot achieve the accuracy needed to make improved CMB measurements. For this reason, we are developing a new instrument, the Frequency-Selectable Laser Source (FLS) to decrease the uncertainty in bandpass by an order of magnitude. In this paper, we describe work completed to support the version 2 upgrade to the FLS. Using ray-tracing software, we modeled the FLS optics to set physical tolerances for the new design. We also discuss the laser calibration, and future work to be completed in further development of the FLS upgrade.
Report discusses integration of sources of microwave power for microwave-arcjet propulsive systems and such microwave instruments as synthetic-aperture radar and radiometers in spacecraft. Integration essential feature of Combined Microwave Science and Propulsion (COMAPP) concept, which incorporates new approach to design of spacecraft for exploration of planets. One of principal objectives in COMAPP to reduce overall weight of spacecraft and to maximize portion of weight devoted to scientific instrumentation.
Noise spectrum properties of low noise microwave tube and solid state signal sources
We present the list of point sources found in the WMAP 5-year maps. The technique used in the first-year and three-year analysis now finds 390 point sources, and the five-year source catalog is complete for regions of the sky away from the galactic plane to a 2 Jy limit, with SNR greater than 4.7 in all bands in the least covered parts of the sky. The noise at high frequencies is still mainly radiometer noise, but at low frequencies the CMB anisotropy is the largest uncertainty. A separate search of CMB-free V-W maps finds 99 sources of which all but one can be identified with known radio sources. The sources seen by WMAP are not strongly polarized. Many of the WMAP sources show significant variability from year to year, with more than a 2:l range between the minimum and maximum fluxes.
VLA and SMM hard X ray data on the solar flares of November 5, 1980 are analyzed and compared with data from other sources. The VLA provided measurements at 15 GHz at 10 sec intervals, using left and right circular polarizations with a 0.6 arcsec resolution. The hard X ray imaging spectrometer on the SMM obtained data in six bands from 3.5-30 keV, with 8 x 8 arcsec resolution and 1.5 sec separation. The data were examined for a possible nonthermal source for the microwave component of the emissions detected, the origin of 16-30 keV excess fluxes, the relation between the X ray and microwave sources, the magnetic connection between observed loops, and the physical characteristics of the radiating loop. The data were consistent with a model that assumes fast electrons are accelerated to a single power-law energy distribution and freely stream along the magnetic field. The data also agreed with a thick-target model for solar flare X ray emission.
The conceptual development of a method for the high angular resolution and accurate angular position estimates for the surveillance and traffic control of aircraft is considered. A target volume several hundred kilometers in diameter is illuminated by a CW microwave source located on a satellite in geosynchronous orbit. Signals are received by a large array of random, conformally located receiving elements. Each element receives the direct signal from the satellite plus signals reflected from aircraft in the illuminated volume. Coherent combination of the signals received from the individual elements permits the equivalent of holographic imaging or multiple beam formation from which the useful target data can be obtained.
Quantitative description of measured short term stability of microwave signal sources
A pair of parallel, spaced-apart circular ground planes define a microwave cavity with multi-port microwave power distributing switching circuitry formed on opposite sides of a thin circular dielectric substrate disposed between the ground planes. The power distributing circuitry includes a conductive disk located at the center of the substrate and connected to a source of microwave energy. A high speed, low insertion loss switching diode and a dc blocking capacitor are connected in series between the outer end of a transmission line and an output port. A high impedance, microwave blocking dc bias choke is connected between each switching diode and a source of switching current. The switching source forward biases the diodes to couple microwave energy from the conductive disk to selected output ports and, to associated antenna elements connected to the output ports to form a synthesized antenna pattern.
Radiometric technique for absolute temperature measurement of microwave noise sources under field conditions
Intense extratropical winter cyclones often impact the West Coast of North America with strong winds and heavy precipitation. Several times during a winter season, short-term forecasts (24 - 48 hours) of these storms are seriously deficient with central pressure errors in the 10's of hPa and surface low position errors in the 100's of km. For example, 48-hr sea level pressure errors (forecast - observation) at buoy 46005 off the Oregon coast for the 2001 - 2002 winter season is plotted. In addition, two times the standard deviation (determined from pressure errors from the last four winter seasons) are also shown. It is evident from this figure that large forecast errors (i.e. greater than 10 hPa) occurred about 10 times this past winter at buoy 46005 with three events where the errors were 20 hPa. Beside large forecast errors of sea level pressure, numerical forecasts of precipitation for land falling cyclones can also be flawed. This is due in large part to the lack of accurate precipitation information over the ocean. Therefore, remote sensing techniques are the only viable option for obtaining accurate information on the distribution and intensity of precipitation over the North Pacific. Due to the radiative characteristics of precipitation sized hydrometeors at microwave frequencies, microwave sensors are able to detect precipitation over oceanic regions. Past studies have demonstrated the utility of passive microwave rainrate data for locating intense rainfall in rapidly deepening cyclones, in detecting developing polar mesocyclones and in determining frontal bands. There are currently many sources of microwave rainrate data: the Special Sensor Microwave Imager (SSM/I) (currently flying on three platforms), the Advanced Microwave Sounding Unit (AMSU-B) (currently flying on NOAA-15, NOAA-16, and NOAA-17), and the Tropical Rainfall Measuring Mission Microwave Imager (TMI). Data will soon be available from the Advanced Microwave Radiometer-EOS (AMSR-E) on the Aqua platform. In this paper, we present a new technique for mapping rainrate distributions over the North Pacific utilizing rainrate estimates from several microwave sensors and upper-tropospheric winds derived from geosynchronous satellite IR data. The goal of this work is to develop a way to obtain high temporal and spatial rainfall information over the North Pacific. This information will be used to support the verification of model derived precipitation distributions and to support the analysis of in situ measurements of rainfall during the Improvement of Microphysical Parameterization through Observational Verification Experiment (IMPROVE) field campaigns.
It is well recognized that advection from the North Atlantic has a profound effect on the climatic conditions in central Europe. A new dataset of the ocean-surface winds, derived from the Special Sensor Microwave Imager, SSM/1, is now available. This satellite instrument measures the wind speed, but not the direction. However, variational analysis developed at the Data Assimilation Office, NASA Goddard Space Flight Center, by combining the SSM/I measurements with wind vectors measured from ships, etc., produced global maps of the ocean surface winds suitable for climate analysis. From this SSM/I dataset, a specific index I(sub na) of the North Atlantic surface winds has been developed, which pertinently quantifies the low-level advection into central Europe. For a selected time-period, the index I(sub na) reports the average of the amplitude of the wind, averaging only the speed when the direction is from the southwest (when the wind is from another direction, the contribution counts to the average as zero speed). Strong correlations were found between February I(sub na) and the surface air temperatures in Europe 50-60 deg N. In the present study, we present the correlations between I(sub na) and temperature I(sub s), and also the sensitivity of T(sub s), to an increase in I(sub na), in various seasons and various regions. We specifically analyze the flow of maritime-air from the North Atlantic that produced two extraordinary warm periods: February 1990, and early-winter 2000/2001. The very cold December 2001 was clearly due to a northerly flow. Our conclusion is that the SSM/I dataset is very useful for providing insight to the forcing of climatic fluctuations in Europe.