Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Spring”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49

Variations in electron density in the middle latitude D-region above Urbana, Illinois

Electron density measurements made with the partial reflections technique above Urbana, Illinois (44 deg 10 min N, 88 deg 10 min W) were analyzed for day-to-day variations, seasonal variations, magnetic storm aftereffects, and stratosphere-ionosphere coupling effects. As well as showing a winter anomaly, the electron densities near 76 km were significantly lower in fall than in spring. Magnetic storm aftereffects of the type predicted by models of energetic electron precipitation at middle latitudes were observed. No strong correlations were found between stratospheric and D-region time series, or between the occurrence of stratospheric warmings and D-region changes. It is likely that most of the electron density variation was due to variations in the transport of minor neutral constituents. The spring-fall differences were also probably caused by differences in minor constituent concentrations rather than the effect of temperature changes on the recombination coefficient.

Wratt, D. S.↗

Rigid coupling is also flexible

Spring-loaded coupling is rigid under light loads and swivels under higher loads. Break-out point can be set at any desired value by selecting appropriate preload springs. Coupling requires no cushions or elastomeric joints that limit temperature range.

Appleberry, W. T.↗

Mechanical characteristics of stability-bleed valves for a supersonic inlet

Mechanical characteristics of a set of direct-operated relief valves used in a throat-bypass stability-bleed system designed for the YF-12 aircraft inlet are described. A comparison of data taken before and after the windtunnel tests (at room temperature) showed that both the effective spring rate and the piston friction had decreased during the wind tunnel tests. In neither the effective spring rate nor the piston friction was the magnitude of change great enough to cause significant impairment of overall system effectiveness. No major valve mechanical problems were encountered in any of the tests. During high temperature bench tests, piston frictional drag increased. The friction returned to its initial room temperature value when the stability-bleed valve was disassembled and reassembled. The problem might be solved by using a different material for the piston sleeve bearing and the piston rings.

Neiner, G. H.↗

Influence of wind turbine foundation

The 200 kW Mod-0A wind turbine was modeled using a 3 lumped mass-spring system for the superstructure and a rotational spring for the foundation and supporting soil. Natural frequencies were calculated using soil elastic moduli varying from 3000 to 22,400 p.s.i. The reduction in natural frequencies from the rigid foundation case ranged up to 20 percent.

Yee, S. T.↗

Crack-opening displacement transducer

Crack-opening displacement transducer consists of 30 deg cone, coil spring, and linear-displacement transducer. Conical probe is used to measure crack opening. Cone is pressed firmly into crack by spring. As applied load causes crack to open up, cone is pushed further into it. Movement of cone, and thus crack growth, is monitored by linear-displacement transducer. Method gives more accurate measurement of crack-opening displacement of very narrow slots.

Simonds, R. A.↗

Forest resource information system

The author has identified the following significant results. Satisfactory results were obtained separately from both winter and spring LANDSAT data for areal estimates. Bitemporal results were improved by combining winter and spring data. Per-point and per-field classifiers performed comparably, except regarding time, where the per-field classifiers were more efficient.

Mroczynski, R. P.↗

Variable area exhaust nozzle

An exhaust nozzle for a gas turbine engine comprises a number of arcuate flaps pivotally connected to the trailing edge of a cylindrical casing which houses the engine. Seals disposed within the flaps are spring biased and extensible beyond the side edges of the flaps. The seals of adjacent flaps are maintained in sealing engagement with each other when the flaps are adjusted between positions defining minimum nozzle flow area and the cruise position. Extensible, spring biased seals are also disposed within the flaps adjacent to a supporting pylon to thereby engage the pylon in a sealing arrangement. The flaps are hinged to the casing at the central portion of the flaps' leading edges and are connected to actuators at opposed outer portions of the leading edges to thereby maximize the mechanical advantage in the actuation of the flaps.

Johnston, E. A.↗

LACIE: An experiment in global crop forecasting

The author has identified the following significant results. Both the accuracy and efficiency with which LACIE crop survey estimates were made have shown significant improvement in three years. In the U.S. and U.S.S.R. winter wheat regions, the original accuracy goals were met or exceeded, with 90/90 estimates achieved in the United States 1.5 to 2 months before harvest. Additionally, all available accuracy parameters indicate 90/90 estimates for the U.S.S.R. total crop. Key technology problems were identified during phase 2 with spring wheat in the United States and Canada which prevented the attainment of 90/90 accuracies in these regions. Technology solutions developed and tested in phase 3 partly resolved these issues with a significant improvement realized in the accuracy of the spring wheat area estimates.

Macdonald, R. B.↗

Large Area Crop Inventory Experiment (LACIE). LACIE third interim phase 3 accuracy assessment report

The author has identified the following significant results. An accuracy of 90/85 was achieved with the October estimates which had a relative bias of -9.9 percent and a coefficient of variation of 5.2 percent for the total wheat production in the USGP. The probability was 0.9 that the LACIE estimate was within + or - 15 percent of true wheat production for the USGP. The LACIE spring wheat production underestimates in August, September, and October were the results of area underestimates for spring wheat in the USNGP region. The winter wheat blind study showed that the average proportion estimates were significantly different from the average dot-count, ground truth proportions at the USSGP and USGP-7 levels.

Source record↗

The influence of the Martian polar caps on the diurnal tide

The large horizontal heating gradients that exist near the edge of the Martian polar caps during spring are shown to be capable of exciting large oscillations in the diurnal tide. To a lesser extent, the daily mass cycling between cap and atmosphere can also contribute. The calculations which demonstrate this are based on classical tidal theory as applied to the cylindrical coordinate system. This is done to facilitate the representation of the heating function. Results are presented for the horizontal surface winds only. They indicate a circulation at the cap edge somewhat analogous to the smaller scale terrestrial sea breeze. The amplitude of the zonal component is largest and is increased from 1 to 10 m/sec by the modeled influence of the polar cap. When coupled with the basic flow these cap-edge tides can produce strong surface winds during spring. Such a mechanism may contribute to the ability of the south polar cap winds to generate the local dust storms observed near the cap edge at this season.

Haberle, R. M.↗

Sulfate and nitrate mixing ratios in the vicinity of the tropopause

Measurements of sulfate and nitrate in filter samples made during the Global Atmospheric Sampling Program (GASP) from aircraft flying near the tropopause over a period of 28 months beginning in early 1976 are presented. Sulfate and nitrate mixing ratios show a peak near or just above the tropopause during the winter-spring seasons. No peak is evident for sulfate during the summer-fall seasons. The sulfate mixing ratios show a constant average level in 1977-78 of 0.12 + or 0.04 ppbm above the tropopause and 0.05 + or - 0.04 ppbm below the tropopause with higher levels in the spring. Nitrate levels are similar but exhibit greater variability. Correlations between sulfate and nitrate (r = 0.78) and between sulfate and nitrate, on ozone (r = 0.80, 0.78) suggest a predominately stratospheric source for these species.

Lezberg, E. A.↗

Cleaving machine for hard crystals

Hard crystalline materials such as lithium fluoride (LiF) are cleaved in thin sections by semiautomatic machine. Yield of undistorted LiF crystals is almost 100 percent, even when cleaved section is only 1/32 inch thick. Machine contains spring-activated hammer that limits penetration of blade and controls shock that cleaves crystal. Fixture with spring-loaded clamps precisely locates and holds crystal, restraining it in ideal position for cleaving. Crystal then splays apart.

Benedicto, J. S. J.↗

The Relationship of Red and Photographic Infrared Spectral Data to Grain Yield Variation Within a Winter Wheat Field

Two band hand-held radiometer data from a winter wheat field, collected on 21 dates during the spring growing season, were correlated within field final grain yield. Significant linear relationships were found between various combinations of the red and photographic infrared radiance data collected and the grain yield. The spectral data explained approximately 64 percent of the within field grain yield variation. This variation in grain yield could not be explained using meteorological data as these were similar for all areas of the wheat field. Most importantly, data collected early in the spring were highly correlated with grain yield, a five week time window existed from stem elongation through antheses in which the spectral data were most highly correlated with grain yield, and manifestations of wheat canopy water stress were readily apparent in the spectral data.

Tucker, C. J.↗

Large Area Crop Inventory Experiment (LACIE). Evaluation of the LACIE transition year crop calendar model

The author has identified the following significant results. The estimates of developmental stage dates from the LACIE adjustable crop calendar (ACC) winter wheat model was somewhat more accurate than the historical crop calendar after jointing. The ACC winter wheat model was not so accurate for the Texas Panhandle as it was for the other areas of the USPG-7 because dry soil conditions delayed fall planting in the Panhandle. Since the LACIE ACC winter wheat model does not contain a moisture term and it was started with historical planting dates, lengthy delays in planting mean that the ACC model will probably be started early and will estimate the developmental growth stages to occur too early in the season. The LACIE ACC spring wheat model was also started early in most areas because of late planting due to fields wet from melting snow and rain. The starter model used to estimate spring planting dates was not accurate under these wet soil conditions and tended to predict the developmental stages to occur earlier than the dates observed in the fields.

Cheffin, R. E.↗

Large Area Crop Inventory Experiment (LACIE). Phase 3 direct wheat study of North Dakota

The author has identified the following significant results. The green number and brightness scatter plots, channel plots of radiance values, and visual study of the imagery indicate separability between barley and spring wheat/oats during the wheat mid-heading to mid-ripe stages. In the LACIE Phase 3 North Dakota data set, the separation time is more specifically the wheat soft dough stage. At this time, the barley is ripening, and is therefore, less green and brighter than the wheat. Only 4 of the 18 segments studied indicate separation of barley/other spring small grain, even though 11 of the segments have acquisitions covering the wheat soft dough stage. The remaining seven segments had less than 5 percent barley based on ground truth data.

Kinsler, M. C.↗

Sulfate and nitrate collected by filter sampling near the tropopause

Filter samples collected near the tropopause with an F-106 aircraft and two Boeing 747 aircraft were analyzed for sulfate and nitrate ion content. Within the range of routine commercial flight altitudes (at or below 12.5 km), stratospheric mass mixing ratios for the winter-spring group averaged 0.26 ppbm for sulfate and 0.35 ppbm for nitrate. For the summer-fall group, stratosphere mixing ratios averaged 0.13 ppbm and 0.25 ppbm for sulfate and nitrate, respectively. Winter-spring group tropospheric mass mixing ratios averaged 0.08 ppbm for sulfate and 0.10 ppbm for nitrate, while summer-fall group tropospheric mixing ratios averaged 0.05 ppbm for sulfate and 0.08 ppbm for nitrate. Correlations of the filter data with available ozone data suggest that the sulfate and nitrate are transported from the stratosphere to the troposphere.

Humenik, F. M.↗

Manned maneuvering unit latching mechanism

The astronaut/Manned Maneuvering Unit interface, which presented a challenging set of requirements for a latching mechanism, is described. A spring loaded cam segment with variable ratio pulley release actuator was developed to meet the requirements. To preclude jamming of the mechanism, special precautions were taken such as spring loaded bearing points and careful selection of materials to resist cold welding. The mechanism successfully passed a number of tests which partially simulated orbital conditions.

Allton, C. S.↗

Coordinated aircraft and ship surveys for determining impact of river inputs on great lakes waters. Remote sensing results

The remote sensing results of aircraft and ship surveys for determining the impact of river effluents on Great Lakes waters are presented. Aircraft multi-spectral scanner data were acquired throughout the spring and early summer of 1976 at five locations: the West Basin of Lake Erie, Genesee River - Lake Ontario, Menomonee River - Lake Michigan, Grand River - Lake Michigan, and Nemadji River - Lake Superior. Multispectral scanner data and ship surface sample data are correlated resulting in 40 contour plots showing large-scale distributions of parameters such as total suspended solids, turbidity, Secchi depth, nutrients, salts, and dissolved oxygen. The imagery and data analysis are used to determine the transport and dispersion of materials from the river discharges, especially during spring runoff events, and to evaluate the relative effects of river input, resuspension, and shore erosion. Twenty-five LANDSAT satellite images of the study sites are also included in the analysis. Examples of the use of remote sensing data in quantitatively estimating total particulate loading in determining water types, in assessing transport across international boundaries, and in supporting numerical current modeling are included. The importance of coordination of aircraft and ship lake surveys is discussed, including the use of telefacsimile for the transmission of imagery.

Raquet, C. A.↗