Preface: International Nuclear Science, Technology and Engineering Conference 2015 (iNuSTEC2015)
No abstract prepared.
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
No abstract prepared.
No abstract prepared.
No abstract prepared.
Two sets of high-quality epitaxial ruthenium oxide (RuO 2 ) thin films with different thicknesses were synthesized in situ on cost-competitive sapphire substrates by using a pulsed laser deposition technique. The first set of films, with a thickness of 40 nm and a sheet resistance of 15.7 Ω/□, was prepared using 2100 laser pulses, while the second set of films, with a thickness of 87 nm and a sheet resistance of 6.7 Ω/□, was prepared using 4800 laser pulses. All other deposition parameters were kept the same. The post-deposition structural and morphological measurements showed that both sets of films grew at the same growth rate, had the same crystallinity, similar grain boundary density, and slightly different surface roughness. The thicker RuO 2 films achieved an overpotential of 280 mV for the oxygen evolution reaction at a current density of 100 μA/cm 2 , comparable to or exceeding the performance of films grown on more expensive substrates. Comparatively, the thinner RuO 2 films, which have a significantly higher charge transfer resistance (250 Ω versus 100 Ω for thick films), display a higher overpotential of 320 mV. These results indicate that the lower electrical resistance of thicker films promotes charge transfer through the film body, leading to superior electrocatalytic properties.
The ScIDEP Collaboration is constructing muon telescopes based on scintillator technology to investigate the internal structure of the Egyptian Pyramid of Khafre at Giza near Cairo using cosmic-ray muons. The collaboration aims to scan the pyramid from multiple viewpoints, both inside the king’s burial chamber that is located centrally at the base of the pyramid, and outside of the pyramid, to potentially identify any new internal structures. An overview of the project is presented, including the development of the data-acquisition system, the simulation framework, and very first detector studies.
A concept of a large-scale nuclear power engineering system equipped with fusion and fission reactors is presented. The reactors have a joint fuel cycle, which imposes the lowest risk of the radiation impact on the environment. The formation of such a system is considered within the framework of the evolution of the current nuclear power industry with the dominance of thermal reactors, gradual transition to the thorium fuel cycle, and integration into the system of the hybrid fusion-fission reactors for breeding nuclear fuel for fission reactors. Such evolution of the nuclear power engineering system will allow preservation of the existing structure with the dominance of thermal reactors, enable the reprocessing of the spent nuclear fuel (SNF) with low burnup, and prevent the dangerous accumulation of minor actinides. The proposed structure of the nuclear power engineering system minimizes the risk of radioactive contamination of the environment and the SNF reprocessing facilities, decreasing it by more than one order of magnitude in comparison with the proposed scheme of closing the uranium–plutonium fuel cycle based on the reprocessing of SNF with high burnup from fast reactors.
Fluorophores covalently bound to azacrown ether ionophores can be assembled into sensitive turn-on chemosensors. The size specificity and electron-rich nature of the ionophore's binding domain contribute to both selectivity and strong turn-on fluorescence sensing by various mechanisms when properly constructed. Aza-18-crown-6 ethers are quite selective for binding to K + and Ba 2+ , yet the more electron-withdrawing dicationic nature of barium imposes a larger electronic effect on turn-on fluorescent sensors. Barium chemosensors can be important for measuring soluble Ba 2+ in drinking water and have gained recent attention for their potential to enhance the detection of rare events in xenon decay. Here we quantify the capability of three chemosensors, marketed for biologically useful K + sensing, as effective probes for Ba 2+ ions. Here, we present measurements from bulk spectrofluorometry to characterize the system in aqueous solutions and demonstrate the usefulness of these species for low-background single-ion fluorescence microscopy, revealing new candidates for Ba 2+ sensing.
Thermally activated annealing in semiconductors faces inherent limitations, such as dopant diffusion. Here, a nonthermal pathway is demonstrated for a complete structural restoration in predamaged germanium via ionization-induced recovery. By combining experiments and modeling, this study reveals that the energy transfer of only 2.4 keV nm −1 from incident ions to target electrons can effectively annihilate pre-existing defects and restore the original crystalline structure at room temperature. Moreover, it is revealed that the irradiation-induced crystalline-to-amorphous (c/a) transformation in Ge is reversible, a phenomenon previously considered unattainable without additional thermal energy imposed during irradiation. For partially damaged Ge, the overall damage fraction decreases exponentially with increasing fluence. Surprisingly, the recovery process in preamorphized Ge starts with defect recovery outside the amorphous layer and a shrinkage of the amorphous thickness. After this initial stage, the remaining damage decreases slowly with increasing fluence, but full restoration of the pristine state is not achieved. These differences in recovery are interpreted in the framework of structural differences in the initial defective layers that affect recovery kinetics. This study provides new insights on reversing the c/a transformation in Ge using highly-ionizing irradiation and has broad implications across materials science, radiation damage mitigation, and fabrication of Ge-based devices.
Recognizing that the zirconium (Zr) in used nuclear fuel (UNF) cladding is the second largest mass in UNF assemblies, process development studies for the recovery and purification of Zr were initiated and have been in progress at Oak Ridge National Laboratory (ORNL) for the last several years as a major element of waste minimization for advanced nuclear fuel recycle. Together with uranium recovery and recycle, Zr recovery would divert >90% (wt.) of the UNF assemblies from emplacement in a geologic repository by converting the Zr to low-level waste or reuse/recycle.
It was shown that the Fixed Point Method (also known as the Rayleigh Quotient Method) is several times faster than the Critical Search Method for solving neutron transport alpha eigenvalue problems. It was also shown that the Fixed Point Method is able to determine the alpha eigenvalues of sub-critical systems that are beyond the reach of the Critical Search Method. Despite these significant advances, the Fixed Point Method remains an unproven algorithm. Here, this report provides a proof.
U 3 Si 2 fuel with FeCrAl or SiC/SiC composite cladding is being considered as an advanced concept and accident tolerant fuel (ATF) system for light water reactors. Understanding their chemical compatibility under operational and accident conditions is fundamental to predicting behavior and fuel qualification. In the present work, experimental determination of interactions and thermodynamic and first principle calculation methods were employed to assess U 3 Si 2 compatibility with novel cladding of FeCrAl-alloys and SiC composites, and were contrasted with compatibility with Zircaloy-4. Diffusion-couple experiments were performed to simulate fuelcladding conditions and the samples were subjected to characterization by scanning electron microscopy and x-ray diffraction. Thermodynamic calculations, based in part on newly determined thermodynamic properties, were used to predict the equilibrium state of the studied systems and to interpret experimental results. First principles calculations using density functional theory were employed to obtain incorporation energies for carbon, iron and uranium in U 3 Si 2 , α- Fe, and SiC structures. Together, the experimental and modeling results have allowed evaluation of the nature of interactions in the fuel-cladding systems.
This Package Review Guide (PRG) provides guidance for Department of Energy (DOE) review and approval of packages to transport fissile and Type B quantities of radioactive material. It fulfills, in part, the requirements of DOE Order 460.1D for the Headquarters Certifying Official to establish standards and to provide guidance for the preparation of Safety Analysis Reports for Packages (SARP). This Package Review Guide is intended for use by the United States Department of Energy Headquarters Certifying Official and their staff, DOE Secretarial offices, operations/field offices, and applicants for Department of Energy package approval. This Package Review Guide is generally organized at the chapter-level in a format similar to that recommended in United States Nuclear Regulatory Commission Regulatory Guide 7.9. One notable exception is the addition of Chapter 9 Quality Assurance, which is not included as a separate chapter in Regulatory Guide 7.9. Within each chapter, this Package Review Guide addresses the technical and regulatory bases for the review, the manner in which the review is accomplished, and findings that are generally applicable for a package that meets the approval standards.
With the announcement of the Vision for Space Exploration on January 14, 2004, there has been a renewed interest in nuclear thermal propulsion. Nuclear thermal propulsion is a leading candidate for in-space propulsion for human Mars missions; however, the cost to develop a nuclear thermal rocket engine system is uncertain. Key to determining the engine development cost will be the engine requirements, the technology used in the development and the development approach. The engine requirements and technology selection have not been defined and are awaiting definition of the Mars architecture and vehicle definitions. The paper discusses an engine development approach in light of top-level strategic questions and considerations for nuclear thermal propulsion and provides a suggested approach based on work conducted at the NASA Marshall Space Flight Center to support planning and requirements for the Prometheus Power and Propulsion Office. This work is intended to help support the development of a comprehensive strategy for nuclear thermal propulsion, to help reduce the uncertainty in the development cost estimate, and to help assess the potential value of and need for nuclear thermal propulsion for a human Mars mission.
UK Engineering and Physical Sciences Research Council (EPSRC) and three industrial partners, the Nuclear Decommissioning Authority (NDA), the National Nuclear Laboratory (NNL) and Sellafield Ltd (SL) are supporting the DISTINCTIVE (Decommissioning, Immobilisation and Storage Solutions for Nuclear Waste Inventories) consortium of eleven universities to carry out research in four theme areas of importance to the UK nuclear industry: Advanced Gas-cooled Reactor (AGR), Magnox and exotic spent fuels; PuO{sub 2} and fuel residues; legacy ponds and silo wastes; and structural integrity. This paper describes the main industry challenges in each of these theme areas and some of industry led activities to address these challenges, and provides examples of where the DISTINCTIVE research output is assisting the nuclear industry in meeting these challenges. (authors)
The possibility to use a nuclear reactor for airplanes propulsion was investigated taking in to account 2 possible solutions: the direct cycle (where the fluid pass through the reactor's core) and the indirect cycle (where the fluid is passing through a heat exchanger). Taking in to account the radioprotection problems, the only realistic solution seems to be the indirect cycle, where the energy transfer should be performed by a heat exchanger that must work at very high speed of the fluid. The heat exchanger will replace the classical burning room. We had performed a more precise theoretical study for the nuclear jet engine regarding the performances of the nuclear reactor, of the heat exchanger and of the jet engine. It was taken in to account that in the moment when the burning room is replaced by a heat exchanger, a new model for gasodynamic process from the engine must be performed. Studies regarding the high flow speed heat transfer were performed.
A search for new neutron-rich isotopes beyond $Z=28$ and $N=50$ was performed using a 345 MeV/nucleon $^{238}$U beam at RI Beam Factory in RIKEN Nishina Center. The BigRIPS separator and state-of-the-art radiation detectors were used to efficiently separate and identify the produced nuclei. For the first time, we have observed and determined the production cross sections for eight neutron-rich isotopes $^{72}$Cr, $^{74,75}$Mn, $^{77}$Fe, $^{79,80}$Co, $^{85}$Cu, and $^{90}$Ga. This study broadens our understanding of nuclear existence and paves the way for investigating the properties of neutron-rich medium-mass nuclei.
Explore the source record for details and available documents.
This study demonstrates the life-cycle assessment of different energy sources-coal, natural gas, solar, wind, nuclear, and hydro-particularly focused on mining activities and waste per given electricity capacity and generation.