SEARCH · Engineering Papers

Results for “Stress field”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28

All sources NASA NTRS DOE OSTI

NASA NTRS1981

Analysis of Jamaican lineaments visible in Seasat-SAR imagery

Three digitally correlated Seasat SAR frames of Jamaica are used to examine the fault-related topography of the island. The major fault-controlled lineaments visible in the imagery are described, and some generalizations are made with respect to the recent tectonics of Jamaica. It is suggested that: (1) the island of Jamaica may represent the original position of a bend or discontinuity in the northern Caribbean Plate boundary; (2) the present tectonic regime may indicate the complex modification of a regional stress field at a discontinuity in an otherwise linear shear zone; (3) the island represents a tectonically maintained mass excess; and (4) the observed rapid uplift along the island's north coast may be related to compression-induced reverse faulting.

Dixon, T. H.↗

NASA NTRS1983

Introduction - Processes of continental rifting

It is thought likely that thermal thinning and/or diapirism can cause the extensional stress required for rifting. The rifting, however, will not occur unless the regional tectonic regime permits the sides of the rift to diverge. Whereas passive plate extension could cause rifting in isolation, the extension and rifting are likely to be localized where the lithosphere is weakest over an existing thermal anomaly. In those cases where asthenospheric diapirism occurs, which is essentially a response to thinning of the lithosphere by thermal thinning or plate extension, the effects of diapirism may completely mask the initiating mechanism. It is believed that anomalous heat transfer into the lithosphere, diapirism, and magmatism must all figure in rifting, along with a deviatoric stress field that will permit extension in a developing rift. Even though the models are useful in permitting idealized processes to be quantified and tested, better knowledge of lithosphere properties is considered necessary, in particular knowledge of mantle viscosity and its temperature dependence.

Morgan, P.↗

NASA NTRS1985

Interferometer Detects Acoustic Emissions in Composites

Embedded single-mode optical fibers sample internal-stress fields directly. Statically loaded composite matrix emits pulsed ultrasonic waves which mechanically modulate embedded fiber and phase-modulate transmitted optical field. Modulation detected by optical interferometry and Fourier optical processing converted to electronic signal proportional to acoustic field amplitude integated along length of fiber embedded in specimen. Technique used for measurements of both high- and low-frequency CW acoustic fields as well as high-frequency transients.

Cantrell, J. H.↗

NASA NTRS1984

Test bed ion engine development

A test bed ion (TBI) engine was developed to serve as a tool in exploring the limits of electrostatic ion thruster performance. A description of three key ion engine components, the decoupled extraction and amplified current (DE-AC) accelerator system, field enhanced refractory metal (FERM) hollow cathode and divergent line cusp (DLC) discharge chamber, whose designs and operating philosophies differ markedly from conventional thruster technology is given. Significant program achievements were: (1) high current density DE-AC accelerator system operation at low electric field stress with indicated feasibility of a 60 mA/sq cm argon ion beam; (2) reliable FERM cathode start up times of 1 to 2 secs. and demonstrated 35 ampere emission levels; (3) DLC discharge chamber plasma potentials negative of anode potential; and (4) identification of an efficient high plasma density engine operating mode. Using the performance projections of this program and reasonable estimates of other parameter values, a 1.0 Newton thrust ion engine is identified as a realizable technology goal. Calculations show that such an engine, comparable in beam area to a J series 30 cm thruster, could, operating on Xe or Hg, have thruster efficiencies as high as 0.76 and 0.78 respectively, with a 100 eV/ion discharge loss.

Aston, G.↗

NASA NTRS1984

On stress analysis of a crack-layer

This work considers the problem of elastic interaction of a macrocrack with an array of microcracks in the vicinity of the macrocrack tip. Using the double layer potential techniques, the solution to the problem within the framework of the plane problem of elastostatics has been obtained. Three particular problems of interest to fracture mechanics have been analyzed. It follows from analysis that microcrack array can either amplify or reduce the resulting stress field of the macrocrack-microcrack array system depending on the array's configuration. Using the obtained elastic solution the energy release rate associated with the translational motion of the macrocrack-microcrack array system has been evaluated.

Chudnovsky, A.↗

NASA NTRS1985

Fundamentals of microcrack nucleation mechanics

A foundation for ultrasonic evaluation of microcrack nucleation mechanics is identified in order to establish a basis for correlations between plane strain fracture toughness and ultrasonic factors through the interaction of elastic waves with material microstructures. Since microcracking is the origin of (brittle) fracture, it is appropriate to consider the role of stress waves in the dynamics of microcracking. Therefore, the following topics are discussed: (1) microstress distributions with typical microstructural defects located in the stress field; (2) elastic wave scattering from various idealized defects; and (3) dynamic effective-properties of media with randomly distributed inhomogeneities.

Fu, L. S.↗

NASA NTRS1985

Elysium Region, Mars: Tests of Lithospheric Loading Models for the Formation of Tectonic Features

In an effort to constrain the tectonic history and mechanical properties of the lithosphere in the Elysium province, the stress fields predicted by different models are compared to the observed tectonic features of the region. The models are all products of volcanic loading of the Martian lithosphere, but at three different scales: global (Tharsis), regional (Elysium Planitia), and local (individual shields). Conclusions: The concentric graben surrounding Elysium Mons can be ascribed to the flexural response of an approximately 50-km-thick elastic lithosphere to loading by the volcano. No tectonic evidence for the support of larger-scale Elysium Planitia volcanic units by lithospheric flexure. The quasi-global loading of the Tharsis rise appears to have produced identifiable tectonic effects in the Elysium region.

Hall, J. L.↗

NASA NTRS1985

Altimetry data and the elastic stress tensor of subduction zones

The stress field in the lithosphere caused by the distribution of density anomalies associated to the geoidal undulations observed by the GEOS-3 and SEASAT Earth satellites in the Tonga region was studied. Different models of the lithosphere were generated with different assumptions on the density distribution and geometry, all generating a geoid profile almost identical to the observed one. The first model is the Airy isostatic hypothesis which consists of a crust of density 2.85 laying on a lithosphere of density 3.35. The models obtained with different compensation depths give residual shortwavelength anomalies of the order of several tens of mgal and several tens of meters geoidal undulations. It indicates that there is no isostasy of the Airy type in the Tonga region because the observed geoid has very smooth undulation of about 25 m over a distance of 2000 km. The Pratt isostatic hypothesis is used in a model consisting of a crust of variable density laying on a lithosphere of higher density. This model gives smaller residual anomalies but still shows that there is no isostasy of the Pratt type in the Tonga region because the observed geoidal undulation are much smaller and smoother than the residual undulations associated to the Pratt model of isostasy.

Caputo, M.↗

NASA NTRS1985

Mineralogy and chemistry of the Earth

The Earth is the prototype if not typical terrestrial planet. Ideas about the origin, evolution, structure and chemistry of the planets can be tested most thoroughly on the Earth. Similarly, the study of the other planets has generated new ideas which may be applicable to the Earth. For example the concepts of magma oceans, large polar wander, global stress fields, buoyant lithosphere, deep cumulate reservoirs, multiple tectonic styles and crust generation may also apply to the Earth, present or past. It is no longer valid to think of the mantle as an essentially homogeneous undifferentiated shell of olivine with pockes of basalt providing melts to midocean ridges and oceanic islands. It appears to be a well differentiated, outgassed body with both radial and lateral chemical variations. The lower mantle is close to chondritic in its major element chemistry. The transition region is garnet and clinopyroxene rich and may be a major basalt reservoir. This would explain the thin crust paradox. Chemical stratification of the Earth probably occurred during accretion.

Anderson, D. L.↗

NASA NTRS1983

Transient response of a turbulent boundary layer

A unique feature of the present ensemble-averaged measurements of a turbulent boundary layer's transient response to a spontaneous change in the free stream velocity distribution, is that the test boundary layer is a standard, steady, flat plate turbulent boundary layer at the entrance to the unsteady region, and is then subjected to sudden changes in free stream velocity distribution in the test section. These water tunnel tests were controlled by minicomputer. It is noted that the boundary layer development was relatively slow, with a characteristic time that was greater than the free stream time-of-flight by a factor of as much as 3. Response varied dramatically across the boundary layer, and the evolution of the turbulent stress field occurred on the same time scale as that of the ensemble-averaged velocity field.

Parikh, P. G.↗

NASA NTRS1983

Crack arrest in structural ceramics

The non-unique, dynamic stress intensity factor versus crack-velocity relation as well as the lack of a dynamic arrest stress intensity factor in reaction bonded silicon nitride are contrasted with the gamma-shaped, dynamic stress intensity factor versus crack velocity relation and the dynamic arrest stress intensity factor of structural steel. These differences in dynamic fracture responses resulted in fracture of a hypothetical reaction bonded silicon nitride disk during a simulated start up condition of a gas turbine engine. A larger initial crack in a similar steel disk was arrested after propagating into a decreasing stress field generated by a steady state thermal gradient.

Kobayashi, A. S.↗

NASA NTRS1984

Investigating compression failure mechanisms in composite laminates with a transient fiberglass-epoxy birefringent material

An experimental study is reported in which a nondestructive technique involving the use of a transparent fiberglass-epoxy composite birefringent material has been used to investigate compression failure mechanisms in graphite-epoxy laminates. It is shown that the birefringency and transparency of the fiberglass-epoxy material permits regions of high stress to be located and the mechanisms of local failure propagation to be identified within the laminate. The material may also be useful for studying stress fields and for identifying failure initiation and propagation mechanisms in a wide variety of composite-structure problems.

Shuart, M. J.↗

NASA NTRS1984

The DE-AC accelerator system for high beam current density

A radically different ion accelerator system design has been developed to increase the extracted beam current density of ion thrusters. By independently controlling plasma ion extraction and acceleration, the Decoupled Extraction and Amplified Current (DE-AC) accelerator system gives higher beam currents at lower electric field stress levels. Results are presented for DE-AC grid system operation with the Test Bed Ion Engine. Using argon propellant, feasibility of a 60 mA/sq cm beam current density is shown. A discussion of power supply requirements, specific impulse operation and grid system geometrical design is presented also.

Aston, G.↗

NASA NTRS1984

Composite interlaminar fracture - Effect of matrix fracture energy

A major result of the use of the double cantilever beam test to provide a measure of the interlaminar fracture energy in composites subjected to simple Mode I-type loading is the observation that increasing the toughness of the matrix resin by as much as a factor of 20 produced a major (approximately four-fold) increase in interlaminar fracture energy. The data presently analyzed show that, with brittle polymers, resin toughness is fully transferred to the composite, while in the case of tougher polymers the resin toughness is only partially transferred due to the fibers' restriction of the crack tip deformation zone in the polymer, together with their changing of local stress field details. Factors which tend to increase interlaminar toughness are fiber nesting and bridging, as well as fiber breakage and pull-out during crack growth.

Hunston, D. L.↗

NASA NTRS1985

Elastic properties of woven fabric reinforced composites

An analytical model for the realistic representation of a woven fabric reinforced composite is presented in this paper. The approach uses a variable cross-section geometric model in order to achieve geometric compatibility at the yarn cross-over regions. Admissible displacement and stress fields are used to determine bounds on the fabric elastic properties. The approach adopted enables the determination of the complete three-dimensional woven fabric composite properties. The in-plane fabric properties obtained through this approach have been compared with results obtained from other approaches existing in the literature. Also, comparisons made with available experimental data indicate good agreement.

Ramnath, V.↗

NASA NTRS1984

Fracture mechanics and surface chemistry investigations of environment-assisted crack growth

It is pointed out that environment-assisted subcritical crack growth in high-strength steels and other high-strength alloys (particularly in hydrogen and in hydrogenous environments) is an important technological problem of long standing. This problem is directly related to issues of structural integrity, durability, and reliability. The terms 'hydrogen embrittlement' and 'stress corrosion cracking' have been employed to describe the considered phenomenon. This paper provides a summary of contributions made during the past ten years toward the understanding of environmentally assisted crack growth. The processes involved in crack growth are examined, and details regarding crack growth and chemical reactions are discussed, taking into account crack growth in steels exposed to water/water vapor, the effect of hydrogen, reactions involving hydrogen sulfide, and aspects of fracture surface morphology and composition. Attention is also given to the modeling of crack growth response, crack growth in gas mixtures, and the interaction of solute atoms with the crack-tip stress field.

Wei, R. P.↗

NASA NTRS1985

Design, Fabrication and Testing of an Experimental Apparatus for Determining Particle Behavior Under Very Low Intergranular Stresses

Because the constitutive laws for soils are governed mainly by interparticle friction, all aspects of their mechanical behavior depend strongly on gravitational body forces. This fact poses serious limitations on the formulation of a materially objective soil constitutive theory, based on experimentation performed on Earth. In particular, the presence of the Earth's gravity prohibits the design of controlled experiments to properly simulate a variety of critical phenomena associated with the dynamic response of soils to seismic excitation in a very low effective confining stress field. For these reasons, laboratory-controlled experiments in the Space Shuttle, under essentially zero-gravity conditions, could offer invaluable opportunities for developing a quantitative understanding of fundamental aspects of soil behavior during or after an earthquake, which, in turn, could result in significant technological advances in geotechnical earthquake engineering.

Sture, S.↗

NASA NTRS1985

Shear fatigue crack growth - A literature survey

Recent studies of shear crack growth are reviewed, emphasizing test methods and data analyses. The combined mode I and mode II elastic crack tip stress fields are considered. The development and design of the compact shear specimen are described, and the results of fatigue crack growth tests using compact shear specimens are reviewed. The fatigue crack growth tests are discussed and the results of inclined cracks in tensile panels, center cracks in plates under biaxial loading, cracked beam specimens with combined bending and shear loading, center-cracked panels and double edge-cracked plates under cyclic shear loading are examined and analyzed in detail.

Liu, H. W.↗