Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “raster”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 325 records · Page 18

The C I opacity and physical structure of cool, very dense plasma in the solar corona

The physical structure of the cool material in the volume of the solar corona is investigated. The observational evidence is summarized in a table giving the brightness contrast in optical and EUV radiations. The state of ionization and the opacity sources are discussed, and a physical model is described that is consistent with the EUV and optical data. It is noted that a comparison of the EUV raster pictures with H-alpha and Ca K photoheliograms indicates that the material is commonly injected from below into relatively low-lying magnetic loops (fibrils) seen near sunspots and plages.

Foukal, P.↗

Observations of the giant radio lobes region of Centaurus A with SAS 3

Observations of the X-ray flux from the extended radio lobes of the galaxy Centaurus A obtained with the SAS 3 observatory are reported. The 15 x 15 deg region that includes the lobes was mapped by superposing data from raster scans with the horizontal tubular collimator detectors, which have a 1.7 deg FWHM circular field of view. Data obtained is consistent with the presence of superposed emission from the point sources NGC 5128 and MX 1312-42, a previously unreported source detected by the Einstein Observatory IPC. Fluxes of 4.63 + or - 0.14 x 10 to the -10th and 4.6 + or - 0.6 x 10 to the -11th ergs/sq cm per sec were measured for NGC 5128 and MX 1312-42, respectively, with best fit power law spectra of indices 0.83 + or - 0.04 and 0.62 + or - 0.10 and hydrogen column densities of 1.23 + or - 0.10 x 10 to the 23rd and 9.7 + or - 15.0 x 10 to the 21st atoms/sq cm. Results imply an upper limit of 2.9 x 10 to the 11th for the X-ray emission from the extended radio lobes of Cen A between 2 and 10 keV, which indicates a lower limit to the magnetic field in the lobes of 1.6 x 10 to the -6th gauss.

Marshall, F. J.↗

Solar Maximum Mission Experiment - Ultraviolet Spectroscopy and Polarimetry on the Solar Maximum Mission

The Ultraviolet Spectrometer and Polarimeter on the Solar Maximum Mission spacecraft is described. It is pointed out that the instrument, which operates in the wavelength range 1150-3600 A, has a spatial resolution of 2-3 arcsec and a spectral resolution of 0.02 A FWHM in second order. A Gregorian telescope, with a focal length of 1.8 m, feeds a 1 m Ebert-Fastie spectrometer. A polarimeter comprising rotating Mg F2 waveplates can be inserted behind the spectrometer entrance slit; it permits all four Stokes parameters to be determined. Among the observing modes are rasters, spectral scans, velocity measurements, and polarimetry. Examples of initial observations made since launch are presented.

Tandberg-Hanssen, E.↗

Parallelism maps for optically contacted etalons

A measurement technique is described that is capable of producing accurate numerical maps of the parallelism defect of optically contacted Fabry-Perot etalons. A photoelectric raster scan of the etalon transmission intensity distribution is performed at each of three closely spaced etalon tunings, one at maximum on-axis and two at the half-maxima on-axis positions. Simple data manipulation gives numerical or contour maps of the parallelism defect. Results demonstrating the effect of mechanical constraints on etalon parallelism are presented

Killeen, T. L.↗

Interactive Digital Image Manipulation System (IDIMS)

The implementation of an interactive digital image manipulation system (IDIMS) is described. The system is run on an HP-3000 Series 3 minicomputer. The IDIMS system provides a complete image geoprocessing capability for raster formatted data in a self-contained system. It is easily installed, documentation is provided, and vendor support is available.

Fleming, M. D.↗

Computational aspects of remapping digital imagery

One of the advantages of automated cartography is that map data stored in the digital computer can be plotted or displayed at any scale or projection by recomputing the coordinates of the data. This is especially easy in the case of vector (graphics) data but in the case of digital image (raster) data, remapping is a more difficult operation. Examples of the remapping of digital imagery would include rectification of a LANDSAT MSS to an orthographic or Mercator projection, warping of one image to register with another, or rotation, scale, or aspect changes of a digital image. Use of general purpose computers and array processors for this task will be covered. Data processing error will be discussed for each modelling/warping approach.

Zobrist, A. L.↗

Attitude tracker

Line array sensors produce data which has no inherent geometrical continuity. Hence, any platform attitude variation will be evidenced as a distortion when the data lines are displayed in the normal Cartesian raster. Ancillary sensing is required to establish the platform attitude to allow geometric rectification. This is normally provided by inertial or star reference attitude sensors. However, in the absence of such sensors or if performance of them is degraded, the required attitude information is lost. A strawman sensor design is proposed which utilizes small image areas on the ground to provide a series of motion vectors with which the platform attitude can be tracked; this allows the distorted image received by the normal image line sensor to be rectified.

Billingsley, F. C.↗

An advanced programmable/reconfigurable color graphics display system for crew station technology research

The hardware configuration, software organization, and applications software for the NASA IKONAS color graphics display system are described. The systems were created at the Langley Research Center Display Device Laboratory to develop, evaluate, and demonstrate advanced generic concepts, technology, and systems integration techniques for electronic crew station systems of future civil aircraft. A minicomputer with 64K core memory acts as a host for a raster scan graphics display generator. The architectures of the hardware system and the graphics display system are provided. The applications software features a FORTRAN-based model of an aircraft, a display system, and the utility program for real-time communications. The model accepts inputs from a two-dimensional joystick and outputs a set of aircraft states. Ongoing and planned work for image segmentation/generation, specialized graphics procedures, and higher level language user interface are discussed.

Montoya, R. J.↗

Detection of a temperature deficit in magnetic faculae at the solar photosphere

A photometric technique is presented which allows the observation of faculae across the entire solar disk. A clean continuum was used and granular noise was reduced by subtracting simultaneous spectroheliograms taken at widely separated points of the photospheric radiation curve. Spectroheliographic observations taken from March 12-14, 1980, using two color-scans in the green at gamma 4980.96 and gamma 5256.31 in the fourth order resulted in observation of clean continua in the red at gamma 6641.85 and gamma 7008.8 in another slot of the magnetograph. Approximately 20 raster scans were obtained and indications were found that dark magnetic facular structures in the Delta signal were cooler than the photosphere at equal optical continuum depths

Foukal, P.↗

The thermal structure of solar coronal loops and implications for physical models of coronae

EUV spectra of three active region loops observed above the solar limb with the SO55 spectrometer on Skylab are analyzed. It is noted that the lengths, peak temperatures, and pressures of the loops are typical of the X-ray coronal loops to which static models have been applied. It is found that the physical parameters of the coronal loop plasma derived from EUV spectra and raster pictures are not well represented by the static models. Although the loops also contain a significant quantity of cool plasma, no physical reason is found to differentiate them from other active region loops of similar length, pressure, and temperature. Several line ratios in the loop spectrum suggest departures from ionization equilibrium caused by rapid cooling. The source of this cooling material is discussed with reference to several models of loop dynamics.

Raymond, J. C.↗

Optical Testing of Integrated Circuits

Optical spot-raster scanner produces weighted photoresponse image (PI) of operating CMOS IC. Digital analysis of PI's, which correlates differences in PI's with electrical behavior of IC, shows promise both as 100-percent screening method for use in IC manufacture and as diagnostic tool in IC development.

Erickson, J.↗

Lensless Image Scanner

Image scanner uses moving and stationary parallel slits to produce pictures of visible, infrared, X-ray microwave, or acoustic sources. No lenses or mirrors required. Single detector views all parts of image simultaneously rather than raster making relatively-short exposure times possible. Potential applications of system include medical x-ray imaging.

Schindler, R. A.↗

Prime agricultural land monitoring and assessment component of the California Integrated Remote Sensing System

The use of digital LANDSAT techniques for monitoring agricultural land use conversions was studied. Two study areas were investigated: one in Ventura County and the other in Fresno County (California). Ventura test site investigations included the use of three dates of LANDSAT data to improve classification performance beyond that previously obtained using single data techniques. The 9% improvement is considered highly significant. Also developed and demonstrated using Ventura County data is an automated cluster labeling procedure, considered a useful example of vertical data integration. Fresno County results for a single data LANDSAT classification paralleled those found in Ventura, demonstrating that the urban/rural fringe zone of most interest is a difficult environment to classify using LANDSAT data. A general raster to vector conversion program was developed to allow LANDSAT classification products to be transferred to an operational county level geographic information system in Fresno.

Estes, J. E.↗

Use of collateral information to improve LANDSAT classification accuracies

Methods to improve LANDSAT classification accuracies were investigated including: (1) the use of prior probabilities in maximum likelihood classification as a methodology to integrate discrete collateral data with continuously measured image density variables; (2) the use of the logit classifier as an alternative to multivariate normal classification that permits mixing both continuous and categorical variables in a single model and fits empirical distributions of observations more closely than the multivariate normal density function; and (3) the use of collateral data in a geographic information system as exercised to model a desired output information layer as a function of input layers of raster format collateral and image data base layers.

Strahler, A. H.↗

Development and implementation of a low cost micro computer system for LANDSAT analysis and geographic data base applications

Since the implementation of the GRID and IMGRID computer programs for multivariate spatial analysis in the early 1970's, geographic data analysis subsequently moved from large computers to minicomputers and now to microcomputers with radical reduction in the costs associated with planning analyses. Programs designed to process LANDSAT data to be used as one element in a geographic data base were used once NIMGRID (new IMGRID), a raster oriented geographic information system, was implemented on the microcomputer. Programs for training field selection, supervised and unsupervised classification, and image enhancement were added. Enhancements to the color graphics capabilities of the microsystem allow display of three channels of LANDSAT data in color infrared format. The basic microcomputer hardware needed to perform NIMGRID and most LANDSAT analyses is listed as well as the software available for LANDSAT processing.

Faust, N.↗

Bistatic radar meteorological satellite

A technique is discussed that employs a radar transmitter with a moderate size antenna placed in a geosynchronous orbit with either a 0 degree or a low inclination orbit. The reflected signals from the precipitation are then received either on a single beam from a satellite having a beamwidth of about 6 degrees or preferably with a beam that scans the U.S. in a raster pattern with about 0.9 degrees beamwidth. While it would seem that a bistatic system with the transmitter at synchronous altitude and the receivers near the surface would not be a very efficient way of designing a radar system, it is somewhat surprising that the required power and antenna sizes are not that great. Two factors make the meteorological application somewhat more attractive than the bistatic detection of point targets. First, the bistatic reflections of radar signals from precipitation are to a large extent omnidirectional, and while raindrops are spheriods rather than spheres, the relationship of the reflectivity of the rain to rainfall rate can be easily derived. The second reason is that the rain echo signal level is independent of range from a receive only radar, and if the bistatic system works at all, it will work at long ranges.

Nathanson, F. E.↗