Engineering Papers⌕ Search

Engineering topics

Zhang, Z.

Publications and source records attributed to Zhang, Z..

At least 127 records · Page 7

Bright x-ray sources from laser irradiation of foams with high concentration of Ti

Low-density foams irradiated by a 20 kJ laser at the Omega laser facility (Laboratory for Laser Energetics, Rochester, NY, USA) are shown to convert more than 5% of the laser energy into 4.6 to 6.0 keV x rays. This record efficiency with foam targets is due to novel fabrication techniques based on atomic-layer-deposition of Ti atoms on an aerogel scaffold. A Ti concentration of 33 at. % was obtained in a foam with a total density of 5 mg/cm{sup 3}. The dynamics of the ionization front through these foams were investigated at the 1 kJ laser of the Gekko XII facility (Institute for Laser Engineering, Osaka, Japan). Hydrodynamic simulations can reproduce the average electron temperature but fail to predict accurately the heat front velocity in the foam. This discrepancy is shown to be unrelated to the possible water adsorbed in the foam but could be attributed to effects of the foam micro-structure.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Evaluating the Dominant Components of Warming in Pliocene Climate Simulations

The Pliocene Model Intercomparison Project (PlioMIP) is the first coordinated climate model comparison for a warmer palaeoclimate with atmospheric CO2 significantly higher than pre-industrial concentrations. The simulations of the mid-Pliocene warm period show global warming of between 1.8 and 3.6 C above pre-industrial surface air temperatures, with significant polar amplification. Here we perform energy balance calculations on all eight of the coupled ocean-atmosphere simulations within PlioMIP Experiment 2 to evaluate the causes of the increased temperatures and differences between the models. In the tropics simulated warming is dominated by greenhouse gas increases, with the cloud component of planetary albedo enhancing the warming in most of the models, but by widely varying amounts. The responses to mid-Pliocene climate forcing in the Northern Hemisphere midlatitudes are substantially different between the climate models, with the only consistent response being a warming due to increased greenhouse gases. In the high latitudes all the energy balance components become important, but the dominant warming influence comes from the clear sky albedo, only partially offset by the increases in the cooling impact of cloud albedo. This demonstrates the importance of specified ice sheet and high latitude vegetation boundary conditions and simulated sea ice and snow albedo feedbacks. The largest components in the overall uncertainty are associated with clouds in the tropics and polar clear sky albedo, particularly in sea ice regions. These simulations show that albedo feedbacks, particularly those of sea ice and ice sheets, provide the most significant enhancements to high latitude warming in the Pliocene.

climate models↗

A Novel Method for Estimating Shortwave Direct Radiative Effect of Above-cloud Aerosols over Ocean Using CALIOP and MODIS Data

This paper describes an efficient and unique method for computing the shortwave direct radiative effect (DRE) of aerosol residing above low-level liquid-phase clouds using CALIOP and MODIS data. It accounts for the overlapping of aerosol and cloud rigorously by utilizing the joint histogram of cloud optical depth and cloud top pressure. Effects of sub-grid scale cloud and aerosol variations on DRE are accounted for. It is computationally efficient through using grid-level cloud and aerosol statistics, instead of pixel-level products, and a pre-computed look-up table in radiative transfer calculations. We verified that for smoke over the southeast Atlantic Ocean the method yields a seasonal mean instantaneous shortwave DRE that generally agrees with more rigorous pixel-level computation within 4%. We have also computed the annual mean instantaneous shortwave DRE of light-absorbing aerosols (i.e., smoke and polluted dust) over global ocean based on 4 yr of CALIOP and MODIS data. We found that the variability of the annual mean shortwave DRE of above-cloud light-absorbing aerosol is mainly driven by the optical depth of the underlying clouds.

CALIOP and MODIS↗

Growth of single crystalline TaON on yttria-stabilized zirconia (YSZ)

Owing to its high stability in aqueous solution and high quantum efficiency, tantalum based oxyntride (TaON) has attracted increasing attentions for application as visible light photocatalyst. However, despite the recent progress in photocatalytic studies, its bulk charge transport mechanisms are yet to be discovered because of the lack of single crystal sample. In this paper, high quality single crystalline TaON(100) thin film was prepared on cubic YSZ(100) surface by reactive RF magnetron sputtering to avail the understandings of charge transport mechanism so as to improve the device efficiency. The stoichiometry, crystal phase and structure were examined in situ by x-ray photoelectron spectroscopy (XPS) and ex situ by x-ray diffraction (XRD) and transmission electron microscopy (TEM). The TaON film crystallizes in monoclinic β-phase with its [010]/[001] directions aligned to those of the substrate. The small band gap of 2.5 eV as well as the high structure perfection suggests better performance for visible light water splitting. The method can be used to prepare other surface orientations to elucidate fundamental surface structure dependent photoactivities. - Graphical abstract: Structure of single crystalline β-TaON and its diffraction pole figure. Highlights: • High quality single crystal TaON(100) thin film were grown on YSZ(100) surface. • β-phase monoclinic TaON film is formed. • Its [010]/[001] directions are aligned to those of the substrate. • The small band gap and structure perfection suggest visible light photo-activity.

36 MATERIALS SCIENCE↗

Impact of proton irradiation on deep level states in n-GaN

Deep levels in 1.8 MeV proton irradiated n-type GaN were systematically characterized using deep level transient spectroscopies and deep level optical spectroscopies. The impacts of proton irradiation on the introduction and evolution of those deep states were revealed as a function of proton fluences up to 1.1 × 10{sup 13} cm{sup −2}. The proton irradiation introduced two traps with activation energies of E{sub C} - 0.13 eV and 0.16 eV, and a monotonic increase in the concentration for most of the pre-existing traps, though the increase rates were different for each trap, suggesting different physical sources and/or configurations for these states. Through lighted capacitance voltage measurements, the deep levels at E{sub C} - 1.25 eV, 2.50 eV, and 3.25 eV were identified as being the source of systematic carrier removal in proton-damaged n-GaN as a function of proton fluence.

36 MATERIALS SCIENCE↗

Structure and function of Parkin E3 ubiquitin ligase reveals aspects of RING and HECT ligases

Parkin is a RING-between-RING E3 ligase that functions in the covalent attachment of ubiquitin to specific substrates, and mutations in Parkin are linked to Parkinson’s disease, cancer and mycobacterial infection. The RING-between-RING family of E3 ligases are suggested to function with a canonical RING domain and a catalytic cysteine residue usually restricted to HECT E3 ligases, thus termed ‘RING/HECT hybrid’ enzymes. Here we present the 1.58 Å structure of Parkin-R0RBR, revealing the fold architecture for the four RING domains, and several unpredicted interfaces. Examination of the Parkin active site suggests a catalytic network consisting of C431 and H433. In cells, mutation of C431 eliminates Parkin-catalysed degradation of mitochondria, and capture of an ubiquitin oxyester confirms C431 as Parkin’s cellular active site. Our data confirm that Parkin is a RING/HECT hybrid, and provide the first crystal structure of an RING-between-RING E3 ligase at atomic resolution, providing insight into this disease-related protein.

59 BASIC BIOLOGICAL SCIENCES↗

Thermal Reliability Study of Bypass Diodes in Photovoltaic Modules (Poster)

This paper presents the result of high-temperature durability and thermal cycling testing and analysis for the selected diodes to study the detail of the thermal design and relative long-term reliability of the bypass diodes used to limit the detrimental effects of module hot-spot susceptibility.

14 SOLAR ENERGY↗