Engineering Papers⌕ Search

Engineering topics

Young, L. E.

Publications and source records attributed to Young, L. E..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Time and position accuracy using codeless GPS

The Global Positioning System has allowed scientists and engineers to make measurements having accuracy far beyond the original 15 meter goal of the system. Using global networks of P-Code capable receivers and extensive post-processing, geodesists have achieved baseline precision of a few parts per billion, and clock offsets have been measured at the nanosecond level over intercontinental distances. A cloud hangs over this picture, however. The Department of Defense plans to encrypt the P-Code (called Anti-Spoofing, or AS) in the fall of 1993. After this event, geodetic and time measurements will have to be made using codeless GPS receivers. However, there appears to be a silver lining to the cloud. In response to the anticipated encryption of the P-Code, the geodetic and GPS receiver community has developed some remarkably effective means of coping with AS without classified information. We will discuss various codeless techniques currently available and the data noise resulting from each. We will review some geodetic results obtained using only codeless data, and discuss the implications for time measurements. Finally, we will present the status of GPS research at JPL in relation to codeless clock measurements.

Dunn, C. E.↗
NASA NTRS1993

New approaches for tracking earth orbiters using modified GPS ground receivers

A Global Positioning System (GPS) flight receiver provides a means to precisely determine orbits for satellites in low to moderate altitude orbits. Above a 5000-km altitude, however, relatively few GPS satellites are visible. New approaches to orbit determination for satellites at higher altitudes could reduce DSN antenna time needed to provide navigation and orbit determination support to future missions. Modification of GPS ground receivers enables a beacon from the orbiter to be tracked simultaneously with GPS data. The orbit accuracy expected from this GPS-like tracking (GLT) technique is expected to be in the range of a few meters or better for altitudes up to 100,000 km with a global ground network. For geosynchronous satellites, however, there are unique challenges due to geometrical limitations and to the lack of strong dynamical signature in tracking data. We examine two approaches for tracking the Tracking and Data Relay Satellite System (TDRSS) geostationary orbiters. One uses GLT with a global network; the other relies on a small 'connected element' ground network with a distributed clock for short-baseline differential carrier phase (SB Delta Phi). We describe an experiment planned for late 1993, which will combine aspects of both GLT and SB Delta Phi, to demonstrate a new approach for tracking the Tracking and Data Relay Satellites (TDRSs) that offers a number of operationally convenient and attractive features. The TDRS demonstration will be in effect a proof-of-concept experiment for a new approach to tracking spacecraft which could be applied more generally to deep-space as well as near-Earth regimes.

Lichten, S. M.↗
NASA NTRS1992

GPS Measurement Of Attitude

Signals transmitted by satellites of Global Positioning System (GPS) measure orientation of baseline on ship, aircraft, or other vehicle with accuracy. Two GPS antennas and receivers placed at well separated points on platform. Receivers measure positions of ends of baseline as functions of time. Output processor computes vector difference between two positions and determines orientation of baseline. Combined with conventional GPS data, orientation data allows more precise navigation and mapping and enhances calculations related to performance and control of vehicle.

Dinardo, S. J.↗
NASA NTRS1991

Design and status of the RF-digitizer integrated circuit

An integrated circuit currently under development samples a bandpass-limited signal at a radio frequency in quadrature and then performs a simple sum-and-dump operation in order to filter and lower the rate of the samples. Downconversion to baseband is carried out by the sampling step itself through the aliasing effect of an appropriately selected subharmonic sampling frequency. Two complete RF digitizer circuits with these functions will be implemented with analog and digital elements on one GaAs substrate. An input signal, with a carrier frequency as high as 8 GHz, can be sampled at a rate as high as 600 Msamples/sec for each quadrature component. The initial version of the chip will sign-sample (1-bit) the input RF signal. The chip will contain a synthesizer to generate a sample frequency that is a selectable integer multiple of an input reference frequency. In addition to the usual advantages of compactness and reliability associated with integrated circuits, the single chip will replace several steps required by standard analog downconversion. Furthermore, when a very high initial sample rate is selected, the presampling analog filters can be given very large bandwidths, thereby greatly reducing phase and delay instabilities typically introduced by such filters, as well as phase and delay variation due to Doppler changes.

Rayhrer, B.↗
NASA NTRS1990

Sampling Downconverter For Radio-Frequency Signals

Phase and delay errors reduced greatly. Proposed GaAs integrated-circuit for receiver of radio signals at gigahertz frequencies samples incoming signal in phase and in quadrature, digitizes it, and down-converts it to baseband in single step. Incorporates both digital and analog components in design offering improved stability, versatility, and sampling bandwidth. Eliminates need for several components found in conventional analog designs, including mixers, postmixer filters, and 90 degree phase shifter.

Thomas, J. B.↗
NASA NTRS1990

Accurate GPS measurement of the location and orientation of a floating platform

This article describes the design and initial tests of the GPS portion of a system for making seafloor geodesy measurements. In the planned system, GPS antennas on a floating platform will be used to measure the location of an acoustic transducer, attached below the platform, which interrogates an array of transponders on the seafloor. Since the GPS antennas are necessarily some distance above the transducer, a short-baseline GPS interferometer consisting of three antennas is used to measure the platform's orientation. A preliminary test of several crucial elements of the system was performed. The test involved a fixed antenna on the pier and a second antenna floating on a buoy about 80 m away. GPS measurements of the vertical component of this baseline, analyzed independently by two groups using different software, agree with each other and with an independent measurement within a centimeter. The first test of an integrated GPS/acoustic system took place in the Santa Cruz Basin off the coast of southern California in May 1990. In this test a much larger buoy, designed and built at SIO, was equipped with three GPS antennas and an acoustic transducer that interrogated a transponder on the ocean floor. Preliminary analysis indicates that the horizontal position of the transponder can be determined with a precision of about a centimeter.

Purcell, G. H., Jr.↗
NASA NTRS1986

The March 1985 demonstration of the fiducial network concept for GPS geodesy: A preliminary report

The first field tests in preparation for the NASA Global Positioning System (GPS) Caribbean Initiative were conducted in late March and Early April of 1985. The GPS receivers were located at the POLARIS Very Long Base Interferometry (VLBI) stations at Westford, Massachusetts; Richmond, Florida; and Ft. Davis, Texas; and at the Mojave, Owens Valley, and Hat Creek VLBI stations in California. Other mobile receivers were placed near Mammoth Lakes, California; Pt. Mugu, California; Austin, Texas; and Dahlgren, Virginia. These sites were equipped with a combination of GPS receiver types, including SERIES-X, TI-4100 and AFGL dual frequency receivers. The principal objectives of these tests were the demonstration of the fiducial network concept for precise GPS geodesy, the performance assessment of the participating GPS receiver types, and to conduct the first in a series of experiments to monitor ground deformation in the Mammoth Lakes-Long Valley caldera region in California. Other objectives included the testing of the water vapor radiometers for the calibration of GPS data, the development of efficient procedures for planning and coordinating GPS field exercise, the establishment of institutional interfaces for future cooperating ventures, the testing of the GPS Data Analysis Software (GIPSY, for GPS Inferred Positioning SYstem), and the establishment of a set of calibration baselines in California. Preliminary reports of the success of the field tests, including receiver performance and data quality, and on the status of the data analysis software are given.

Davidson, J. M.↗
NASA NTRS1985

A comparison of four precise global positioning system geodetic receivers

Four precise global positioning system (GPS) geodetic receivers were operated simultaneously in January and February 1984 over ten baselines ranging in distance from 13 to 1304 km. Several of the baselines had been previously measured using very long baseline interferometry and, therefore, provide very good standards to which the satellite results can be compared. Results of these experiments are presented along with a brief description of each receiver and the associated analysis techniques.

Goad, C. C.↗
NASA NTRS1985

VLBI collimation-tower technique for time-delay studies of a large ground-station communications antenna

A need for an accurate but inexpensive method for measuring and evaluating time delays of large ground antennas for VLBI applications motivated the development of the collimation tower technique. Supporting analytical work which was performed primarily to verify time delay measurement results obtained for a large antenna when the transmitter was at a collimation distance of 1/25 of the usual far field criterion is discussed. Comparisons of theoretical and experimental results are also given.

Otoshi, T. Y.↗
NASA NTRS1985

Solar Array Experiment (SAE) Flight Experience

The space flight testing of a large, flat, flexible panel solar array is examined. The experiment objectives are: to demonstrate the functional operational of the wind deployment and packaging system; Electrical performance; Thermal performance; and dynamic performance. A complete description of the experiment and the flight results are given.

Hill, H. C.↗
NASA NTRS1984

Satellite Emission Range Inferred Earth Survey (SERIES) project

The Global Positioning System (GPS) was developed by the Department of Defense primarily for navigation use by the United States Armed Forces. The system will consist of a constellation of 18 operational Navigation Satellite Timing and Ranging (NAVSTAR) satellites by the late 1980's. During the last four years, the Satellite Emission Range Inferred Earth Surveying (SERIES) team at the Jet Propulsion Laboratory (JPL) has developed a novel receiver which is the heart of the SERIES geodetic system designed to use signals broadcast from the GPS. This receiver does not require knowledge of the exact code sequence being transmitted. In addition, when two SERIES receivers are used differentially to determine a baseline, few cm accuracies can be obtained. The initial engineering test phase has been completed for the SERIES Project. Baseline lengths, ranging from 150 meters to 171 kilometers, have been measured with 0.3 cm to 7 cm accuracies. This technology, which is sponsored by the NASA Geodynamics Program, has been developed at JPL to meet the challenge for high precision, cost-effective geodesy, and to complement the mobile Very Long Baseline Interferometry (VLBI) system for Earth surveying.

Buennagel, L. A.↗
NASA NTRS1984

Solar-array-materials passive LDEF experiment (A0171)

The objective of this experiment is to evaluate the synergistic effects of the space environment on various solar-array materials, including solar cells, cover slips with various antireflectance coatings, adhesive, encapsulants, reflector materials, substrate strength materials, mast and harness materials, structural composites, and thermal control treatments. The experiment is passive and consists of an arrangement of material specimens mounted in a 3-in.-deep peripheral tray. The effects of the space environment on the specimens will be determined by comparison of preflight and postflight measurements of mechanical, electrical, and optical properties.

Whitaker, A. F.↗
NASA NTRS1984

GPS-based certification for the microwave landing system

An MLS (microwave landing system) certification system based on the Global Positioning System (GPS) is described. To determine the position history of the flight inspection aircraft during runway approach, signals from the GPS satellites, together with on-board radar altimetry, are used. It is shown that the aircraft position relative to a fixed point on the runway at threshold can be determined to about 30 cm vertically and 1 m horizontally. A requirement of the system is that the GPS receivers be placed on each flight inspection aircraft and at selected ground sites. The effects of different error sources on the determination of aircraft instantaneous position and its dynamics are analyzed.

Thornton, C. L.↗
NASA NTRS1983

VLBI maps of 3C 273 and 3C 345 at 2.3 GHz

Maps of the quasars 3C 273 and 3C 345 made at 2.3 GHz with an eight station VLBI array are presented. Five compact components spanning 45 milli-arcsec are seen in 3C 273, and four are seen in 3C 345. Comparisons with maps at higher and lower frequencies show that in both sources the core, which dominates the high-frequency 'core-jet' structure, is strongly self-absorbed at 2.3 GHz and below. The jet components have flat spectra, peaking between 2 and 5 GHz. In both sources the VLBI jet curves toward the direction of the arcsecond-scale outer jet.

Cohen, M. H.↗
NASA NTRS1983

SAFE II: Large systems space plasma evaluation experiment

A shuttle flight experiment, the purpose of which is to obtain space data on the interaction of a high voltage solar array with the ambient space plasma is addressed. This flight experiment is a reflight of the solar array flight experiment, SAFE, except that three active solar array panels, electron release devices and plasma diagnostics are added. This experiment, SAFE 2, evaluates power loss due to parasitic current collected by the solar array, arcing on the solar array and perturbations to the plasma which may increase power loss and disturb plasma and charged particle science acquisition.

Carruth, M. R., Jr.↗
NASA NTRS1983

VLBI collimation tower technique for time-delay studies of a large ground station communications antenna

A need for an accurate but inexpensive method for measuring and evaluating time delays of large ground antennas for VLBI applications motivated the development of the collimation tower technique. Supporting analytical work which was performed primarily to verify time delay measurement results obtained for a large antenna when the transmitter was at a collimation distance of 1/25 of the usual far field criterion is discussed. Comparisons of theoretical and experimental results are also given.

Otoshi, T. Y.↗