Engineering Papers⌕ Search

Engineering topics

Wang, Y

Publications and source records attributed to Wang, Y.

203 records · Page 12

Mapping Metal Elements of Shuangbai Dinosaur Fossil by Synchrotron X-ray Fluorescence Microprobe

The metal elements mapping of Shuangbai dinosaur fossil, was obtained by synchrotron x-ray fluorescence (SXRF). Eight elements, Ca, Mn, Fe, Cu, Zn, As, Y and Sr were determined. Elements As and Y were detected for the first time in the dinosaur fossil. The data indicated that metal elements are asymmetrical on fossil section. This is different from common minerals. Mapping metals showed that metal element As is few. The dinosaur most likely belongs to natural death. This is different from Zigong dinosaurs which were found dead from poisoning. This method has been used to find that metals Fe and Mn are accrete, and the same is true for Sr and Y. This study indicated that colloid granule Fe and Mn, as well as Sr and Y had opposite electric charges in lithification process of fossils. By this analysis, compound forms can be ascertained. Synchrotron light source x-ray fluorescence is a complementary method that shows mapping of metal elements at the dinosaur fossil, and is rapid, exact and intuitionist. This study shows that dinosaur fossil mineral imaging has a potential in reconstructing the paleoenvironment and ancient geology.

43 PARTICLE ACCELERATORS↗

Epitaxial orientation of Mg{sub 2}Si(110) thin film on Si(111) substrate

Epitaxial Mg{sub 2}Si(110) thin film has been obtained on Si(111) substrate by thermally enhanced solid-phase reaction of epitaxial Mg film with underlying Si substrate. An epitaxial orientation relationship of Si(111) parallel Mg{sub 2}Si(110) and Si<110> parallel Mg{sub 2}Si<110> has been revealed by transmission electron microscopy. The formation of the unusual epitaxial orientation relationship is attributed to the strain relaxation of Mg{sub 2}Si film in a MgO/Mg{sub 2}Si/Si double heterostructure.

36 MATERIALS SCIENCE↗

NO{sub x} emission trends for China, 1995-2004 : the view from the ground and the view from space.

A rapid increase of NO{sub 2} columns over China has been observed by satellite instruments in recent years. We present a 10-a regional trend of NO{sub x} emissions in China from 1995 to 2004 using a bottom-up methodology and compare the emission trends with the NO{sub 2} column trends observed from GOME and SCIAMACHY, the two spaceborne instruments. We use a dynamic methodology to reflect the dramatic change in China's NO{sub x} emissions caused by energy growth and technology renewal. We use a scenario analysis approach to identify the possible sources of uncertainties in the current bottom-up inventory, in comparison with the satellite observation data. Our best estimates for China's NO{sub x} emissions are 10.9 Tg in 1995 and 18.6 Tg in 2004, increasing by 70% during the period considered. NO{sub x} emissions and satellite-based NO{sub 2} columns show broad agreement in temporal evolution and spatial distribution. Both the emission inventory data and the satellite observations indicate a continuous and accelerating growth rate between 1996 and 2004 over east central China. However, the growth rate from the emission inventory is lower than that from the satellite observations. From 1996 to 2004, NO{sub x} emissions over the region increased by 61% according to the inventory, while a 95% increase in the NO{sub 2} columns measured by satellite was observed during the same period. We found good agreement during summertime but a large discrepancy during wintertime. The consistency between the summertime trends suggests that the bias cannot be due to systematic error of activity data or emission factors. The reasons for the discrepancy cannot yet be fully identified, but possible explanations include an underestimation in seasonal emission variations, variability of meteorology, NO{sub x} injection height, and the increasing trend of sulfate aerosols.

54 ENVIRONMENTAL SCIENCES↗

COMPASS, the COMmunity Petascale Project for Accelerator Science And Simulation, a Broad Computational Accelerator Physics Initiative

Accelerators are the largest and most costly scientific instruments of the Department of Energy, with uses across a broad range of science, including colliders for particle physics and nuclear science and light sources and neutron sources for materials studies. COMPASS, the Community Petascale Project for Accelerator Science and Simulation, is a broad, four-office (HEP, NP, BES, ASCR) effort to develop computational tools for the prediction and performance enhancement of accelerators. The tools being developed can be used to predict the dynamics of beams in the presence of optical elements and space charge forces, the calculation of electromagnetic modes and wake fields of cavities, the cooling induced by comoving beams, and the acceleration of beams by intense fields in plasmas generated by beams or lasers. In SciDAC-1, the computational tools had multiple successes in predicting the dynamics of beams and beam generation. In SciDAC-2 these tools will be petascale enabled to allow the inclusion of an unprecedented level of physics for detailed prediction.

43 PARTICLE ACCELERATORS↗

Neutron Diffraction Study on Plastic behavior of a Nickel-Based Alloy Under the Monotonic-Tension and the Low-Cyclic-Fatigue Experiments

The plastic behavior of an annealed HASTELLOY C-22HS alloy, a face-centered cubic (FCC), nickel-based superalloy, was examined by in-situ neutron-diffraction measurements at room temperature. Both monotonic-tension and low-cycle-fatigue experiments were conducted. Monotonic-tension straining and cyclic-loading deformation were studied as a function of stress. The plastic behavior during deformation is discussed in light of the relationship between the stress and dislocation-density evolution. The calculated dislocation-density evolution within the alloy reflects the strain hardening and cyclic hardening/softening. Experimentally determined lattice strains are compared to verify the hardening mechanism at selected stress levels for tension and cyclic loadings. Combined with calculations of the dislocation densities, the neutron-diffraction experiments provide direct information about the strain and cyclic hardening of the alloy.

36 MATERIALS SCIENCE↗