Engineering topics

Waites, H. B.

Publications and source records attributed to Waites, H. B..

17 records

NASA NTRS1991

Initial performance improvements due to design modifications for the Pointing Control System on the Hubble Space Telescope

Shortly after Hubble Space Telescope was deployed on orbit it became apparent that the Pointing Control System was experiencing unexpectedly large disturbances during certain portions of the orbit. While these disturbances were most pronounced during transitions of the Earth's shadow, significant disruptions to the pointing occurred at other times in the orbit. Careful analysis of the flight data has lead to the conclusion that the disturbances are caused by a combination of rapid thermal deformations of the Solar Arrays together with striction-friction mechanisms within the array that randomly release stored thermal/mechanical energy. This paper describes the baseline pointing control system design and the flight data that characterized the effects of the extraneous disturbances. The paper goes on to describe the procedure for modifying the onboard controller to attenuate the disturbances to levels consistent with the science operations. Flight data demonstrating the improved performance are shown and are tabulated to compare performance prior to and after phase I of the redesign.

Nurre, G. S.↗

NASA NTRS1990

The NASA controls-structures interaction technology program

The interaction between a flexible spacecraft structure and its control system is commonly referred to as controls-structures interaction (CSI). The CSI technology program is developing the capability and confidence to integrate the structure and control system, so as to avoid interactions that cause problems and to exploit interactions to increase spacecraft capability. A NASA program has been initiated to advance CSI technology to a point where it can be used in spacecraft design for future missions. The CSI technology program is a multicenter program utilizing the resources of the NASA Langley Research Center (LaRC), the NASA Marshall Space Flight Center (MSFC), and the NASA Jet Propulsion Laboratory (JPL). The purpose is to describe the current activities, results to date, and future activities of the NASA CSI technology program.

Newsom, Jerry R.↗

NASA NTRS1990

The NASA controls-structures interaction technology program

The interaction between a flexible spacecraft structure and its control system is commonly referred to as controls-structures interaction (CSI). The CSI technology program is developing the capability and confidence to integrate the structure and control system, so as to avoid interactions that cause problems and to exploit interactions to increase spacecraft capability. A NASA program has been initiated to advance CSI technology to a point where it can be used in spacecraft design for future missions. The CSI technology program is a multicenter program utilizing the resources of the NASA Langley Research Center, the NASA Marshall Space Flight Center, and the NASA Jet Propulsion Laboratory. The purpose of this paper is to describe the current activities, results to date, and future activities of the NASA CSI technology program.

Newsom, Jerry R.↗

NASA NTRS1988

An application of high authority/low authority control and positivity

Control Dynamics Company (CDy), in conjunction with NASA Marshall Space Flight Center (MSFC), has supported the U.S. Air Force Wright Aeronautical Laboratory (AFWAL) in conducting an investigation of the implementation of several DOD controls techniques. These techniques are to provide vibration suppression and precise attitude control for flexible space structures. AFWAL issued a contract to Control Dynamics to perform this work under the Active Control Technique Evaluation for Spacecraft (ACES) Program. The High Authority Control/Low Authority Control (HAC/LAC) and Positivity controls techniques, which were cultivated under the DARPA Active Control of Space Structures (ACOSS) Program, were applied to a structural model of the NASA/MSFC Ground Test Facility ACES configuration. The control systems design were accomplished and linear post-analyses of the closed-loop systems are provided. The control system designs take into account effects of sampling and delay in the control computer. Nonlinear simulation runs were used to verify the control system designs and implementations in the facility control computers. Finally, test results are given to verify operations of the control systems in the test facility.

Seltzer, S. M.↗

NASA NTRS1988

Emulating a flexible space structure: Modeling

Control Dynamics, in conjunction with Marshall Space Flight Center, has participated in the modeling and testing of Flexible Space Structures. Through the series of configurations tested and the many techniques used for collecting, analyzing, and modeling the data, many valuable insights have been gained and important lessons learned. This paper discusses the background of the Large Space Structure program, Control Dynamics' involvement in testing and modeling of the configurations (especially the Active Control Technique Evaluation for Spacecraft (ACES) configuration), the results from these two processes, and insights gained from this work.

Waites, H. B.↗

NASA NTRS1988

Cost effective development of a national test bed

For several years, the Marshall Space Flight Center has pursued the coordinated development of a Large Space Structures (LSS) National Test Bed for the investigation of numerous technical issues involved in the use of LSS in space. The origins of this development, the current status of the various test facilities and the plans laid down for the next five years' activities are described. Particular emphasis on the control and structural interaction issues has been paid so far; however, immediately emerging are user applications (such as the proposed pinhole occulter facility). In the immediate future, such emerging technologies as smart robots and multibody interactions will be studied. These areas are covered.

Waites, H. B.↗

NASA NTRS1985

NASA-VCOSS dynamic test facility

The Large Space Structure Ground Test Facility under development at the NASA Marshall Space Flight Center in Huntsville, Alabama is described. The Ground Test Facility was established initially to test experimentally the control system to be used on the Solar Array flight Experiment. The structural dynamics of the selected test article were investigated, including the fidelity of the associated mathematical model. The facility must permit the investigation of structural dynamics phenomena and be able to evaluate candidate attitude control and vibration suppression techniques.

Waites, H. B.↗

NASA NTRS1985

Ground test experiment for large space structures

In recent years a new body of control theory has been developed for the design of control systems for Large Space Structures (LSS). The problems of testing this theory on LSS hardware are aggravated by the expense and risk of actual in orbit tests. Ground tests on large space structures can provide a proving ground for candidate control systems, but such tests require a unique facility for their execution. The current development of such a facility at the NASA Marshall Space Flight Center (MSFC) is the subject of this report.

Tollison, D. K.↗

NASA NTRS1985

Active control of large space structures: An introduction and overview

An overview of the large space structure (LSS) control system design problem is presented. The LSS is defined as a class of system, and LSS modeling techniques are discussed. Model truncation, control system objectives, current control law design techniques, and particular problem areas are discussed.

Doane, G. B., III↗

NASA NTRS1985

NASA/MSFC ground experiment for Large Space Structure control verification

NASA Marshall Space Flight Center has developed a facility in which closed loop control of Large Space Structures (LSS) can be demonstrated and verified. The main objective of the facility is to verify LSS control system techniques so that on-orbit performance can be ensured. The facility consists of an LSS test article which is connected to a payload mounting system that provides control torque commands. It is attached to a base excitation system which will simulate disturbances most likely to occur for Orbiter and DOD payloads. A control computer will contain the calibration software, the reference system, the alignment procedures, the telemetry software, and the control algorithms. The total system will be suspended in such a fashion that LSS test article has the characteristics common to all LSS.

Waites, H. B.↗

NASA NTRS1984

NASA/MSFC ground experiment for large space structure control verification

Marshall Space Flight Center has developed a facility in which closed loop control of Large Space Structures (LSS) can be demonstrated and verified. The main objective of the facility is to verify LSS control system techniques so that on orbit performance can be ensured. The facility consists of an LSS test article which is connected to a payload mounting system that provides control torque commands. It is attached to a base excitation system which will simulate disturbances most likely to occur for Orbiter and DOD payloads. A control computer will contain the calibration software, the reference system, the alignment procedures, the telemetry software, and the control algorithms. The total system will be suspended in such a fashion that LSS test article has the characteristics common to all LSS.

Waites, H. B.↗

NASA NTRS1984

Ground test experiment for large space structures, appendix I

Marshall Space Flight Center has developed a Large Space Structure (LSS) ground test verification experiment facility having adequate fidelity and flexibility to accommodate the demands of LSS control theory testing. The first experiment is in the subsystem verification and integration phase. This test employs the ASTROMAST, a lightweight S glass composite deployable beam structure, as the test article and is cited to prove out centralized and distributed sensor control strategies.

Tollison, D. K.↗

NASA NTRS1984

Definition of ground test for Large Space Structure (LSS) control verification

An overview for the definition of a ground test for the verification of Large Space Structure (LSS) control is given. The definition contains information on the description of the LSS ground verification experiment, the project management scheme, the design, development, fabrication and checkout of the subsystems, the systems engineering and integration, the hardware subsystems, the software, and a summary which includes future LSS ground test plans. Upon completion of these items, NASA/Marshall Space Flight Center will have an LSS ground test facility which will provide sufficient data on dynamics and control verification of LSS so that LSS flight system operations can be reasonably ensured.

Waites, H. B.↗

NASA NTRS1984

An on-orbit experiment for dynamics and control of large structures

Attention is given to the definition of the on-orbit dynamic testing that is currently being planned for the flight of a large solar array test article, the Solar Array Flight Experiment (SAFE 1), which consists of a coilable longeron mast that deploys a large solar array blanket. Also discussed is the design of an additional experiment employing this structure in conjunction with a two- or three-axis gimbal system, in order to demonstrate control techniques applicable to such large structures. SAFE 1 experiment objectives, hardware, software, and the experimental operations foreseen are discussed.

Buchanan, H. J.↗

NASA NTRS1982

A disturbance isolation controller for the solar electric propulsion system flight experiment

A disturbance isolation controller (DIC) is developed for a simplified model of the solar electric propulsion system (SEPS) flight experiment which consists of a rigid Sperry gimbal torquer (AGS) mounted to a rigid orbiter and the SEPS solar array (rigid) end mounted to the AGS. The main purpose of the DIC is to reduce the effects of orbiter disturbances which are transmitted to the flight experiment. The DIC uses an observer, which does not require the direct measurement of the plant inputs, to obtain estimates of the plant states and the rate of the plant states. The state and rate of state information is used to design a controller which isolates disturbances from specified segments of the plant, and for the flight experiment, the isolated segment is the SEPS solar array.

Waites, H. B.↗

NASA NTRS1981

An observer for a deployable antenna

An observer is derived for use on an Orbiter-Deployable Antenna configuration. The unique feature of this observer design for this flight experiment is that all the plant inputs are not required to be directly accessible for the observer to ferret out the system states. The observer uses state and rate of the state information to reconstruct the plant states. Results are presented which show how effectively this observer design works for this large space structure flight experiment.

Waites, H. B.↗

NASA NTRS1979

Application of Model Reference Adaptive Control System to Instrument Pointing System /IPS/

A Model Reference Adaptive Controller (MRAC) is derived for a Shuttle payload called the Instrument Pointing System (IPS). The unique features of this MRAC design are that total state feedback is not required, that the internal structure of the model is independent of the internal structure of the IPS, and that the model input is of bounded variation and not required a priori. An application of Liapunov's stability theorems is used to synthesize a control signal which assures MRAC asymptotic stability. Exponential observers are used to obtain the necessary state information to implement the control synthesis. Results are presented which show how effectively the MRAC can maneuver the IPS.

Waites, H. B.↗