Engineering Papers⌕ Search

Engineering topics

Schuller, F. T.

Publications and source records attributed to Schuller, F. T..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Stability of water-lubricated three-lobe journals mated with plain bearings at zero load

Tests were conducted with plain bearings running with three types of three-lobe journals. The bearings, with a nominal 3.8-centimeter (1.5-in.) diameter and L/D of 1, were tested at 300 K (80 F) under stable conditions to 5400 rpm. The lobed configurations tested, in order of diminishing stability, were a tilted-lobe journal with grooves, a tilted-lobe journal without grooves, and a centrally lobed journal without grooves. A previously tested three-tilted-lobe bearing with grooves, running with a plain journal, was somewhat more stable than the tilted-lobe or centrally lobed journals.

Schuller, F. T.↗
NASA NTRS1972

Experiments on the stability of various water-lubricated fixed geometry hydrodynamic journal bearings at zero load

Hydrodynamic journal bearing stability tests were conducted with 1.5 in. diameter, 1.5 in. long fixed geometry bearings in water at 80 F with zero load. Five fixed geometry bearings were rated in order of diminishing stability as follows: (1) three-tilted-lobe bearing (offset factor of 1.0), (2) herringbone-groove bearing, (3) one-segment, three-pod, shrouded Rayleigh-step bearing, (4) three-tilted-lobe journal with axial grooves (offset factor of 1.0) mated with a plain bearing, and (5) three-centrally-lobed bearing with axial grooves (offset factor of 0.5). The various parameters that affect the stability of each bearing configuration were investigated.

Schuller, F. T.↗
NASA NTRS1970

Low cost lobed bearing

Separate sectors for each lobed area of the bearing are assembled into the bearing housing individually and bolted tightly against the housing inside diameter. The center of a grinding wheel and the center of the housing are offset, resulting in the desired inner radius and tilt of the sector.

Schuller, F. T.↗
NASA NTRS1968

Low cost techniques for fabricating lobed bearings

New low cost technique utilizes shims to create the lobes in bearing. Conventional methods of manufacture require accurate off-center grinding of the inside diameter of a bearing in a housing at various arc lengths depending on the number of lobes required.

Schuller, F. T.↗