Salmassi, F. | Engineering Papers

DOE OSTI2025

Low blaze angle grating for fully dispersive x-ray spectroscopy

We demonstrate fabrication of an ultra-low blaze angle (LBA) grating designed for time-resolved spectroscopy in the x-ray region. A blaze angle of 0.12° was achieved by the groove depth reduction process providing a perfect saw-tooth shape of the grooves. The 200 lines/mm LBA grating exhibited high diffraction efficiency at a photon energy of 8 KeV. Use in a spectrometer would open up dispersive x-ray absorption spectroscopy across a wide energy range including the K edges of 3d transition metals, with much greater efficiency than traditional crystal spectrometers.

Voronov, D. L.↗

DOE OSTI2023

Nanometer flat blazed x-ray gratings using ion beam figure correction

With the development of nanometer accuracy stitching interferometry, ion beam figuring (IBF) of x-ray mirrors can now be achieved with unprecedented performance. However, the process of producing x-ray diffraction gratings on these surfaces may degrade the figure quality due to process errors introduced during the ruling of the grating grooves. To address this challenge, we have investigated the post-production correction of gratings using IBF, where stitching interferometry is used to provide in-process feedback. A concern with ion beam correction in this case is that ions will induce enough surface mobility of atoms to cause smoothing of the grating structure and degradation of diffraction efficiency. In this study we found however that it is possible to achieve a nanometer-level planarity of the global grating surface with IBF, while preserving the grating structure. The preservation was so good, that we could not detect a change in the diffraction efficiency after ion beam correction. This is of major importance in achieving ultra-high spectral resolution, and the preservation of brightness for coherent x-ray beams.

36 MATERIALS SCIENCE↗

DOE OSTI2023

Correlating Tomographic Chemical Inhomogeneity and Low Energy Electronic Structure in Layered Quantum Materials

Photoemission spectroscopy (PES) is a suite of experimental tools to learn about the electronic and chemical structure of materials and surfaces. Normally implemented in a surface-sensitive manner, the research performed under this grant focused on pushing PES into less explored regimes, to reveal bulk electronic structure, to reveal tomographic (layer-resolved) chemistry and electronic structure of layered materials and heterostructures, and to reveal interface phenomena at the junction of two different materials. Standing wave (SW) spectroscopies have also been applied to PdCoO2, a material of interest due to its high conductivity and electron-hydrodynamic tendencies. This material can be modeled as an alternating layered structure consisting of metallic Pd layers and insulating CoO2 layers. Using SW XPS, the total electronic structure has been decomposed into contributions from the two layers, and computations highlighted the different many-body interactions in the two layers (Comm. Phys. 4, 143 (2021)). We have also used hard-x-ray angle-resolved photoemission spectroscopy (ARPES), to investigate LaB6, a technologically important material with widespread application as a cathode material for electron microscopes. We measured the bulk electronic structure of this material and found that the one-step model of photoemission better captured the electronic structure and correlations. This model treats the three steps of the photoemission process—excitation, transport of the photoelectron to the crystal surface, and escape into the vacuum—as a single quantum mechanically coherent process (Phys. Rev. Mater. 5, 055002 (2021)). We also applied x-ray photoelectron spectroscopy, implemented in a near total reflection grazing incidence geometry to elucidate technologically relevant interfaces, such as those between a substrate and photoresist (J. Phys. D: Appl. Phys. 54 464002 (2021)).

36 MATERIALS SCIENCE↗