Engineering Papers⌕ Search

Engineering topics

Rummler, D. R.

Publications and source records attributed to Rummler, D. R..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Prediction of elemental creep

Cyclic and steady-state creep tests were performed to provide data which were used to develop predictive equations. These equations, describing creep as a function of stress, temperature, and time, were developed through the use of a least squares regression analyses computer program for both the steady-state and cyclic data sets. Comparison of the data from the two types of tests, revealed that there was no significant difference between the cyclic and steady-state creep strains for the L-605 sheet under the experimental conditions investigated (for the same total time at load). Attempts to develop a single linear equation describing the combined steady-state and cyclic creep data resulted in standard errors of estimates higher than obtained for the individual data sets. A proposed approach to predict elemental creep in metals uses the cyclic creep equation and a computer program which applies strain and time hardening theories of creep accumulation.

Davis, J. W.↗
NASA NTRS1975

Creep analysis capability for stiffened panel structures

A method of analysis developed for predicting permanent cyclic creep deflections in stiffened panel structures is presented. The resulting computer program (TPSC, for Thermal Protection System Creep) applies either the time hardening or strain hardening theories of creep accumulation, using iterative techniques to determine structural rotations, creep strains, and stresses as a function of time. Deflections are determined by numerical integration of structural rotations along the panel length. The analytical approach was developed for purposes of analyzing thin gage entry vehicle metallic thermal protection system panels subjected to cyclic bending loads at high temperatures. The method is applicable to any panel subjected to bending loads. Predicted panel creep deflections are compared with results from cyclic tests of subsize and full size corrugation and rib stiffened panels. Empirical equations used in the analysis were developed for each material based on correlation with tensile cyclic creep data.

Cramer, B. A.↗
NASA NTRS1975

Evaluation of coated columbium for thermal protection systems application

Coated columbium alloys were evaluated for thermal protection system (TPS) application in the maximum operating temperature range from 1370 to 1590 K. Evaluation of materials combinations, subsize panels, and single panel TPS led to the development of a full-size nine-panel TPS array. This array was subjected to simulated shuttle missions of both thermal and acoustic loading. Results are presented which illustrate the structural and thermal adequacy under uniform heating and manufacturability of a full-size coated columbium-alloy TPS which is lightweight, reliable, and reusable.

Rummler, D. R.↗