Engineering PapersSearch

Engineering topics

Reynolds, R. K.

Publications and source records attributed to Reynolds, R. K..

Hydrogen-fueled diesel engine without timed ignition

Experiments were carried out to investigate the feasibility of converting a diesel engine to hydrogen-fueled operation without providing a timed ignition system. Use was made of a glow plug and a multiple-strike spark plug. The glow plug was found to provide reliable ignition and smooth engine operation. It caused the hydrogen to ignite almost immediately upon the start of injection. Indicated mean effective pressures were on the order of 1.3 MPa for equivalence ratios between 0.1 and 0.4 at a compression ratio of 18. This is significantly higher than the corresponding result obtained with diesel oil (about 0.6 MPa for equivalence ratios between 0.3 and 0.9). Indicated thermal efficiencies were on the order of 0.4 for hydrogen and 0.20-0.25 for diesel oil. Operation with the multiple-strike spark system yielded similar values for IMEP and efficiency, but gave rise to large cycle-to-cycle variations in the delay between the beginning of injection and ignition. Large ignition delays were associated with large amplitude pressure waves in the combustion chamber. The measured NO(x) concentrations in the exhaust gas were of the order of 50-100 ppm. This is significantly higher than the corresponding results obtained with premixed hydrogen and air at low equivalence ratios. Compression ignition could not be achieved even at a compression ratio of 29.

Homan, H. S.

Hydrogen-fueled engine

A hydrogen-oxygen fueled internal combustion engine is described, which utilizes an inert gas, such as argon, as a working fluid to increase the efficiency of the engine, eliminate pollution, and facilitate operation of a closed cycle energy system. In a system where sunlight or other intermittent energy source is available to separate hydrogen and oxygen from water, the oxygen and inert gas are taken into a diesel engine into which hydrogen is injected and ignited. The exhaust is cooled so that it contains only water and the inert gas. The inert gas in the exhaust is returned to the engine for use with fresh oxygen, while the water in the exhaust is returned to the intermittent energy source for reconversion to hydrogen and oxygen.

Laumann, E. A.

High-performance flat-plate solar collector

Concentric glass-tube-envelope device surrounds flat-plate absorber having spectrally selective coating. Transparent envelope has antireflection coating. Heat-transfer medium is gas that circulates along hairpin path.

Reynolds, R. K.

Optical integrated-circuit tester

Computer controlled device can check typical medium scale unit in less than one minute. System scans integrated circuit chip with narrow beam of light while simultaneously scanning reference chip.

Micka, E. A.

Closed-cycle hydrogen-fueled engine

Innovation avoids pollution by retaining combustion products. Potential uses include applicability to pollution-free powerplant using intermittent solar energy. Engine parts are fabricated from silicon carbide, silicon nitride, stainless steel, and other high-tensile strength materials.

Laumann, E. A.

Improved relay chatter detector

Detector provides go/no-go sensing of momentary relay or contact opening during vibration testing. Device compares duration of unwanted openings to calibrated standard and lights indicator if standard is exceeded. Stability and reliability are higher than in any other comparable device.

Reynolds, R. K.