Engineering Papers⌕ Search

Engineering topics

Navarro, Robert

Publications and source records attributed to Navarro, Robert.

29 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS2009

A Deep Space Network Portable Radio Science Receiver

The Radio Science Receiver (RSR) is an open-loop receiver installed in NASA s Deep Space Network (DSN), which digitally filters and records intermediate-frequency (IF) analog signals. The RSR is an important tool for the Cassini Project, which uses it to measure perturbations of the radio-frequency wave as it travels between the spacecraft and the ground stations, allowing highly detailed study of the composition of the rings, atmosphere, and surface of Saturn and its satellites.

Jongeling, Andre P.↗
NASA NTRS2009

NASA Dryden Flight Research Center

This DVD has several short videos showing some of the work that Dryden is involved in with experimental aircraft. These are: shots showing the Active AeroElastic Wing (AAW) loads calibration tests, AAW roll maneuvers, AAW flight control surface inputs, Helios flight, and takeoff, and Pathfinder takeoff, flight and landing.

Navarro, Robert↗
NASA NTRS2008

Breadboard Signal Processor for Arraying DSN Antennas

A recently developed breadboard version of an advanced signal processor for arraying many antennas in NASA s Deep Space Network (DSN) can accept inputs in a 500-MHz-wide frequency band from six antennas. The next breadboard version is expected to accept inputs from 16 antennas, and a following developed version is expected to be designed according to an architecture that will be scalable to accept inputs from as many as 400 antennas. These and similar signal processors could also be used for combining multiple wide-band signals in non-DSN applications, including very-long-baseline interferometry and telecommunications. This signal processor performs functions of a wide-band FX correlator and a beam-forming signal combiner. [The term "FX" signifies that the digital samples of two given signals are fast Fourier transformed (F), then the fast Fourier transforms of the two signals are multiplied (X) prior to accumulation.] In this processor, the signals from the various antennas are broken up into channels in the frequency domain (see figure). In each frequency channel, the data from each antenna are correlated against the data from each other antenna; this is done for all antenna baselines (that is, for all antenna pairs). The results of the correlations are used to obtain calibration data to align the antenna signals in both phase and delay. Data from the various antenna frequency channels are also combined and calibration corrections are applied. The frequency-domain data thus combined are then synthesized back to the time domain for passing on to a telemetry receiver

Jongeling, Andre↗
NASA NTRS2007

NASA ER-2: Flying Laboratory for Earth Science Studies

This viewgraph presentation gives an overview of the NASA ER-2 aircraft. The contents include: 1) ER-2 Specifications; 2) ER-2 Basic Configuration; 3) ER-2 Payload Areas: Nose Area; 4) ER-2 Payload Areas: SuperPod Fore and Aftbody; 5) ER-2 Payload Areas: SuperPod Midbody; 6) ER-2 Payload Areas: Q-Bay; 7) ER-2 Payload Areas: Q-Bay Hatch Designs; 8) ER-2 Payload Areas: External Pods; 9) ER-2 Electrical/Control Interface; 10) ER-2 Typical Flight Profile; 11) Tropical Composition, Cloud and Climate Coupling TC-4; 12) TC-4 Timeline; 13) TC4 Area of Interest; 14) ER-2 TC4 Payload; 15) A/C ready for fuel; 16) ER-2 Pilot being suited; 17) ER-2 Taxing; 18) ER-2 Pilot post flight debrief; and 19) NASA ER-2: Flying Laboratory for Earth Science Studies and Remote Sensing.

Navarro, Robert↗
NASA NTRS2007

ER-2: Flying Laboratory for Earth Science Studies

The National Aeronautics and Space Administration (NASA) Dryden Flight Research Center (DFRC), (Edwards, California, USA) has two Lockheed Martin Corporation (Bethesda, Maryland) Earth Research-2 (ER-2) aircraft that serve as high-altitude and long-range flying laboratories. The ER-2 has been utilized to conduct scientific studies of stratospheric and tropospheric chemistry, land-use mapping, disaster assessment, preliminary testing and calibration and validation of satellite sensors. The ER-2 aircraft provides experimenters with a wide array of payload accommodation areas with suitable environment control with required electrical and mechanical interfaces. Missions may be flown out of DFRC or from remote bases worldwide. The NASA ER-2 is utilized by a variety of customers, including U.S. Government agencies, civilian organizations, universities, and state governments. The combination of the ER-2 s range, endurance, altitude, payload power, payload volume and payload weight capabilities complemented by a trained maintenance and operations team provides an excellent and unique platform system to the science community.

Navarro, Robert↗
NASA NTRS2007

Designing High Speed Printed Circuit Boards Using DxDesigner and Expedition

Mentor's DxDesigner and Expedition schematic capture and printed circuit board tools were chosen to implement a custom high speed signal processing board containing many high pin count Field Programmable Gate Arrays and many high speed serial connections with data rates over 2 Gigasamples/sec. The methodology used to place the parts and route the board involved the interaction of both the DxDesigner and Expedition tools. The basic design philosophy was to specify as much as possible through design constraints at the schematic level. This paper will explore implementing that philosophy in both tools to facilitate part placement and trace routing.

printed circuit boards↗
NASA NTRS2007

The NASA Earth Research-2 (ER-2) Aircraft: A Flying Laboratory for Earth Science Studies

The National Aeronautics and Space Administration Dryden Flight Research Center, Edwards, California, has two Lockheed Martin Corporation (Bethesda, Maryland) Earth Research-2 (ER2) aircraft that serve as high-altitude and long-range flying laboratories. The ER-2 aircraft has been successfully utilized to conduct scientific studies of stratospheric and tropospheric chemistry, land-use mapping, disaster assessment, preliminary testing and calibration and validation of satellite sensors. The research missions for the ER-2 aircraft are planned, implemented, and managed by the Dryden Flight Research Center Science Mission Directorate. Maintenance and instrument payload integration is conducted by Dryden personnel. The ER-2 aircraft provides experimenters with a wide array of payload accommodations areas with suitable environment control with required electrical and mechanical interfaces. Missions may be flown out of Dryden or from remote bases worldwide, according to research requirements. The NASA ER-2 aircraft is utilized by a variety of customers, including U.S. Government agencies, civilian organizations, universities, and state governments. The combination of the ER-2 aircraft s range, endurance, altitude, payload power, payload volume and payload weight capabilities complemented by a trained maintenance and operations team provides an excellent and unique platform system to the science community and other customers.

Navarro, Robert↗
NASA NTRS2006

Digital Front End for Wide-Band VLBI Science Receiver

An upgrade to the very-long-baseline-interferometry (VLBI) science receiver (VSR) a radio receiver used in NASA's Deep Space Network (DSN) is currently being implemented. The current VSR samples standard DSN intermediate- frequency (IF) signals at 256 MHz and after digital down-conversion records data from up to four 16-MHz baseband channels. Currently, IF signals are limited to the 265-to-375-MHz range, and recording rates are limited to less than 80 Mbps. The new digital front end, denoted the Wideband VSR, provides improvements to enable the receiver to process wider bandwidth signals and accommodate more data channels for recording. The Wideband VSR utilizes state-of-the-art commercial analog-to-digital converter and field-programmable gate array (FPGA) integrated circuits, and fiber-optic connections in a custom architecture. It accepts IF signals from 100 to 600 MHz, sampling the signal at 1.28 GHz. The sample data are sent to a digital processing module, using a fiber-optic link for isolation. The digital processing module includes boards designed around an Advanced Telecom Computing Architecture (ATCA) industry-standard backplane. Digital signal processing implemented in FPGAs down-convert the data signals in up to 16 baseband channels with programmable bandwidths from 1 kHz to 16 MHz. Baseband samples are transmitted to a computer via multiple Ethernet connections allowing recording to disk at rates of up to 1 Gbps.

Jongeling, Andre↗
NASA NTRS2006

Implementation of an Antenna Array Signal Processing Breadboard for the Deep Space Network

The Deep Space Network Large Array will replace/augment 34 and 70 meter antenna assets. The array will mainly be used to support NASA's deep space telemetry, radio science, and navigation requirements. The array project will deploy three complexes in the western U.S., Australia, and European longitude each with 400 12m downlink antennas and a DSN central facility at JPL. THis facility will remotely conduct all real-time monitor and control for the network. Signal processing objectives include: provide a means to evaluate the performance of the Breadboard Array's antenna subsystem; design and build prototype hardware; demonstrate and evaluate proposed signal processing techniques; and gain experience with various technologies that may be used in the Large Array. Results are summarized..

array↗
NASA NTRS2005

2005 PathfinderPlus Aero-Elastic Research Flight

This viewgraph presentation describes the 2005 Pathfinder along with an investigation of its aeroelastic responses. The contents include: 1) HALE Class of Vehicles; 2) Aero-elastic Research Flights Overall Objective; 3) General Arrangement; 4) Sensor Locations; 5) NASA Ramp Operations; 6) Lakebed Operations; 7) 1st Flight Data Set; 8) Tool development / data usage; 9) HALE Tool Development & Validation; 10) Building a HALE Foundation; 11) Compelling Needs Drive HALE Efforts; and 12) Team Photo

Navarro, Robert↗