Engineering topics

Meyers, James F.

Publications and source records attributed to Meyers, James F..

At least 37 records · Page 2

NASA NTRS1995

Development of Doppler Global Velocimetry as a Flow Diagnostics Tool

The development of Doppler global velocimetry is described from its inception to its use as a flow diagnostics tool. Its evolution is traced from an elementary one-component laboratory prototype, to a full three-component configuration operating in a wind tunnel at focal distances exceeding 15 m. As part of the developmental process, several wind tunnel flow field investigations were conducted. These included supersonic flow measurements about an oblique shock, subsonic and supersonic measurements of the vortex flow above a delta wing, and three-component measurements of a high-speed jet.

Meyers, James F.↗

NASA NTRS1994

Assessing the Capability of Doppler Global Velocimetry To Measure Vortical Flow Fields

A new nonintrusive flow diagnostics instrumentation system, Doppler global velocimetry, is presented. The system is capable of making simultaneous, three-component velocity measurements within a selected measurement plane at video camera rates. These velocity images can provide the researcher with spatial and temporal information about the flow field in a global sense. The investigation of a vortical flow above a 75-degree delta wing comparing standard three-component, fringe-type laser velocimetry measurements with Doppler global velocimetry measurements is presented.

Meyers, James F.↗

NASA NTRS1994

Generation of Particles and Seeding

One of the most important elements in laser velocimetry, yet the most neglected, is the small particle embedded in the flow field that scatters the light necessary to make velocity measurements. The characteristics of this small particle are often ignored in the effort to obtain data. This seems strange since it is the primary cause of measurement error. If the particle is too large, it will not follow the flow resulting in an inaccurate representation of the fluid velocity. If the particle is too small, it will not scatter sufficient light to provide the signal-to-noise necessary to minimize measurement uncertainty in the signal processing electronics. This lecture will attempt to remove the confusion in choosing a seeding method by assessing many of the techniques currently used. It will outline their characteristics and typical limitations imposed by various applications. The lecture will then focus on the ramifications of these methods on measurement accuracy.

Meyers, James F.↗

NASA NTRS1994

Development of Doppler Global Velocimetry for Wind Tunnel Testing

The development of Doppler global velocimetry is described. Emphasis is placed on the modifications necessary to advance this nonintrusive laser based measurement technique from a laboratory prototype to a viable wind tunnel flow diagnostics tool. Several example wind tunnel flow field investigations are described to illustrate the versatility of the technique. Flow conditions ranged from incompressible to Mach 2.8 with measurement distances extending from 1 to 15 m.

Meyers, James F.↗

NASA NTRS1993

Doppler global velocimetry measurements of the vortical flow above an F/A-18

A Doppler global velocimeter is employed to study the vortical flow above an F/A-18 at 25 degree angle of attack. The measurements indicate that the flow possessed the same characteristics as the vortical flow above a standard delta wing. Image to image comparisons clearly indicate that the flow striking the vertical stabilizers is not chaotic.

Lee, Joseph W.↗

NASA NTRS1993

Investigation of the Vortical Flow Above an F/A-18 Using Doppler Global Velocimetry

The flow above an F/A-18 model, set to 25-degrees angle of attack, was measured using a Doppler global velocimeter, (DGV). The investigation indicated that the complex flow contained many similarities to the vortical flow above a simple delta wing set to a high-angle of attack, including flow standard deviations greater than 30-percent of free- stream. These standard deviation levels were also comparable to results found during a previous investigation of the vortical flow above a YF-17 using fringe-type laser velocimetry. The global measurement capability of the DGV provided the first evidence that the burst vortices above the model were structured. These structures were found to maintain their spatial coherence while the flow varied in an overall sense.

Meyers, James F.↗

NASA NTRS1993

Doppler Global Velocimetry Measurements of the Vortical Flow Above an F/A-18

A Doppler global velocimeter was used to investigate the vortical flow above an F/A-18 model at 25-degrees angle of attack. The measurements indicate that the flow had the same characteristics as the vortical flow above a standard delta wing. The flow pattern indicating transition from stable to burst conditions found above the delta wing was also found at the 440 station above the F/A-18. Measurements downstream at the 524 station found that the flow velocity varied considerably, with standard deviations reaching 30 percent of free stream. However, individual data images indicated that the flow was spatially coherent, and not chaotic as expected.

Lee, Joseph W.↗

NASA NTRS1992

Doppler global velocimetry - The next generation?

A new measurement technique is being developed by NASA to measure off-surface flow fields. This method, Doppler global velocimetry, will allow quantification of complex three-dimensional flow fields at video camera rates. The entire flow field structure within a selected plane is measured simultaneously rather than by scanned, point-by-point measurements using conventional laser velocimetry. To assess the capability of this new technique, velocity measurements of the vortical flow field above a thin 75-degree delta wing were made in the NASA Langley Basic Aerodynamics Research Tunnel. The operation of the system is described along with the techniques developed to process the output images. The results are then compared with similar measurements obtained using a three component laser velocimeter.

Meyers, James F.↗

NASA NTRS1992

Three-Component Laser Velocimetry Of Complex Flows

Since aeronautical research community depends on computations, to extent that predictions of flow-field behavior used without supporting data, question arises whether predictions of complex flow fields represent real world. In experiment, laser velocimetry used to validate computed predictions of complex flow fields. Results demonstrated capabilities of orthogonal three-component laser velocimeter to obtain data necessary to validate computational codes used.

Meyers, James F.↗

NASA NTRS1992

Doppler global velocimeter measurements of the vortical flow above a thin delta wing

Doppler global velocimetry, currently under development by NASA for the measurement of off-surface flow fields, will allow quantification of complex, 3D flow fields at video-camera rates and accomplish the simultaneous measurement of an entire flow field structure within the given plane. In order to assess the performance capabilities of the technique, velocity measurements of the vortical flow field above a thin, 75-deg delta wing were conducted at NASA-Langley and compared with results obtained via three-component laser velocimeter. The achievement of performance goals is confirmed.

Usry, Jimmy W.↗

NASA NTRS1992

Three Component Doppler Global Velocimeter Measurements of the Flow Above A Delta Wing

A new measurement technique is being developed by NASA to measure off-surface flow fields. This method, Doppler global velocimetry, will allow quantification of complex three-dimensional flow fields at video camera rates. The entire flow field structure within a selected plane is measured simultaneously rather than by scanned, point-by-point measurements using conventional laser velocimetry. To assess the capability of this new technique, three - component velocity measurements of the vortical flow field above a thin 75-degree delta wing were made in the NASA Langley Basic Aerodynamics Research Tunnel. Measurements were made of the flow field at the 70-percent chord location at angles-of-attack of 20.5 and 40.0 degrees to investigate unburst and burst vortices. For comparison, previous fringe-type laser velocimeter measurements of the flow field at the same conditions are included.

Meyers, James F.↗

NASA NTRS1992

Assessing the Capability of Doppler Global Velocimetry to Measure Vortical Flow Fields

A new measurement technique, Doppler global velocimetry, has been described along with results from an experimental investigation of a vortical flow field. The results of this investigation, when compared to conventional laser velocimeter measurements, indicate that this technique is capable of describing the global velocity field within a measurement plane in real time. Further investigations are being conducted to correct the deficiencies described and to refine the measurement technique for flight applications.

Usry, Jimmy W.↗

NASA NTRS1991

A three dimensional view of velocity using lasers

The use of laser light sheet flow visualization, fringe-type laser velocimetry, and Doppler global velocimetry to make flow field investigations is described. The complementary nature of the techniques is demonstrated by using them to examine the vortical flow fields above a 75 deg swept delta wing and a YF-17 model in a low-speed wind tunnel. The characteristics of these systems are described and their capability to provide fundamental velocity databases for CFD validation is assessed.

Meyers, James F.↗

NASA NTRS1991

Frequency domain laser velocimeter signal processor

A new scheme for processing signals from laser velocimeter systems is described. The technique utilizes the capabilities of advanced digital electronics to yield a signal processor capable of operating in the frequency domain maximizing the information obtainable from each signal burst. This allows a sophisticated approach to signal detection and processing, with a more accurate measurement of the chirp frequency resulting in an eight-fold increase in measurable signals over the present high-speed burst counter technology. Further, the required signal-to-noise ratio is reduced by a factor of 32, allowing measurements within boundary layers of wind tunnel models. Measurement accuracy is also increased up to a factor of five.

Meyers, James F.↗

NASA NTRS1991

Generation of Particles and Seeding

One of the most important elements in laser velocimetry, yet the most neglected, is the small particle embedded in the flow field that scatters the light necessary to make velocity measurements. An attempt to remove the confusion in choosing a seeding method by assessing many of the techniques currently used is presented. Their characteristics and typical limitations imposed by various applications are outlined. The ramifications of these methods on measurement accuracy are addressed.

Meyers, James F.↗

NASA NTRS1991

Biasing errors and corrections

The dependence of laser velocimeter measurement rate on flow velocity is discussed. Investigations outlining that any dependence is purely statistical, and is nonstationary both spatially and temporally, are described. Main conclusions drawn are that the times between successive particle arrivals should be routinely measured and the calculation of the velocity data rate correlation coefficient should be performed to determine if a dependency exists. If none is found, accept the data ensemble as an independent sample of the flow. If a dependency is found, the data should be modified to obtain an independent sample. Universal correcting procedures should never be applied because their underlying assumptions are not valid.

Meyers, James F.↗

NASA NTRS1991

Review of typical applications: Wind tunnels

Laser velocimetry applications to wind tunnels are highlighted. The following are covered: investigation of the flow within a metalorganic chemical vapor deposition reactor; helicopter flow investigations in the 4 by 7 m low speed wind tunnel; boundary layer measurements in a supersonic flow using a laser transit anemometer; basic aerodynamic research tunnel. The future of wind tunnel testing with laser velocimetry.

Meyers, James F.↗

NASA NTRS1991

Signal processing schemes for Doppler global velocimetry

Two schemes for processing signals obtained from the Doppler global velocimeter are described. The analog approach is a simple, real-time method for obtaining an RS-170 video signal containing the normalized intensity image. Pseudocolors are added using a monochromatic frame grabber producing a standard NTSC video signal that can be monitored and/or recorded. The digital approach is more complicated, but maintains the full resolution of the acquisition cameras with the ability to correct the signal image for pixel sensitivity variations and to remove background light. Prototype circuits for each scheme are described, and example results from the investigation of the vortical flow field above a 75-deg delta wing are presented.

Meyers, James F.↗