Engineering Papers⌕ Search

Engineering topics

Martin, S.

Publications and source records attributed to Martin, S..

At least 73 records · Page 4

A 90 GHz Amplifier Assembled Using Flip-Chip Technology

This letter reports the performance of a novel single-stage W-band amplifier fabricated utilizing flip-chip bump-bonding. We have bump-bonded a high-speed, low-noise InP high electron mobility transistor (HEMT) device onto a separately fabricated passive circuit having a GaAs substrate.

FET amplifiers Millimeter wave FETs bump-bonding m↗

A Laboratory Study of the Effect of Frost Flowers on C Band Radar Backscatter from Sea Ice

C band images of Arctic sea ice taken by the ERS 1 synthetic aperture radar show transitory regions of enhanced radar backscatter from young sea ice. Published field observations associate this increase with frost flower growth and the capture of blowing snow by the flowers. To investigate the first part of this phenomenon, we carried out a laboratory experiment on the response of C band radar backscatter to frost flowers growing on the surface of newly formed saline ice. The experiment took place in a 5 m by 7 m by 1.2 m deep saline water pool located in a two-story indoor refrigerated facility at the Cold Regions Research and Engineering Laboratory. Sodium chloride ice was grown in this pool at an air temperature of -28 C. The frost flowers first appeared on the ice surface as dendrites and then changed to needles as the ice sheet grew thicker and the surface temperatures became colder. The frost flowers reached to a height of 10-15 mm, and beneath each cluster of frost flowers a slush layer formed to a thickness of approximately 4 mm. Far-field radar measurements of the backscatter from the ice were made at incident angles from 20 to 40 deg and at approximately 6-hour intervals throughout the 3-day period of the experiment. A backscatter minimum occurred early in the flower growth at the time coincident with an abrupt doubling in the ice surface salinity. Once the full flower coverage was achieved, we removed first the crystal flowers and then the slush layer from the ice surface. The results for these cases show that the crystals have little impact on the backscatter, while the underlying slush patches yield a backscatter increase of 3-5 dB over that of bare ice. The laboratory results suggest that this relative backscatter increase of approximately 5 dB can be used as an index to mark the full area coverage of frost flowers.

Nghiem, S. V.↗

A Laboratory Study of the Effect of Frost Flowers on C Band Radar Backscatter from Sea Ice

C band images of Arctic sea ice taken by the ERS 1 synthetic aperture radar show transitory regions of enhanced radar backscatter from young sea ice. Published field observations associate this increase with frost flower growth and the capture of blowing snow by the flowers. To investigate the first part of this phenomenon, we carried out a laboratory experiment on the response of C band radar backscatter to frost flowers growing on the surface of newly formed saline ice. The experiment took place in a 5 m by 7 m by 1.2 m deep saline water pool located in a two-story indoor refrigerated facility at the Cold Regions Research and Engineering Laboratory. Sodium chloride ice was grown in this pool at an air temperature of -28 C. The frost flowers first appeared on the ice surface as dendrites and then changed to needles as the ice sheet grew thicker and the surface temperatures became colder. The frost flowers reached to a height of 10-15 mm, and beneath each cluster of frost flowers a slush layer formed to a thickness of approximately 4 mm. Far-field radar measurements of the backscatter from the ice were made at incident angles from 20 C to 40 C and at approximately 6-hour intervals throughout the 3-day period of the experiment. A backscatter minimum occurred early in the flower growth at the time coincident with an abrupt doubling in the ice surface salinity. Once the full flower coverage was achieved, we removed first the crystal flowers and then the slush layer from the ice surface. The results for these cases show that the crystals have little impact on the backscatter, while the underlying slush patches yield a backscatter increase of 3-5 dB over that o f bare ice. The laboratory results suggest that this relative backscatter increase of approximately 5 dB can be used as an index to mark the full areal coverage of frost flowers.

Nghiem, S. V.↗

Sea Ice Floe Size Distribution in the Beaufort Sea Measured by ERS-1 SAR (abstract)

Model results indicate that understanding summer heat balance and freshwater balance in the polar oceans requires knowledge of how much goes into vertical and lateral sea ice melt. In addition to thickness, two of the key ice parameters that affect melt rate are ice concentration and floe size. Smaller ice floes and more open water enables more heat to go into lateral melt preferentially to vertical melt, thereby enhancing warming up the upper ocean and increasing stratification. Using ERS-1 SAR imagery along two areas, one in the Beaufort Sea and another in the Chukchi Sea, floe size distributions were obtained during the summer period in 1992. Comparisons will be made of floe distributions, together with meteorological and buoy measurements, to examine the differences between an ice sink region (Chukchi) and a multiyear ice region (Beaufort) in the summer melt process.

ERS-1 SAR Beaufort Sea Chukchi Sea heat balance ic↗

Spatial and Temporal Observations of Summer Ice Melt Using ERS-1 SAR Imagery

The complete understanding of the heat and mass balance of the polar oceans includes the melting of sea ice in the summer and the reinjection of fresh water into the upper ocean. This study examines the spatial and temporal character of ice melt. Using ERS-1 SAR imagery, the development of small floes formed by melt and deforma- tion, and changes in the fraction of open water and floes is examined.

geoscience remote sensing polar oceans sea ice ice↗

Fabrication and Performance of Planar Schottky Diodes with T-gate-like Anodes in 200 GHz Subharmonically-Pumped Waveguide Mixers

A T-gate-like structure has been developed, fabricated and tested as the anode for millimeter and submillimeter-wave Schottky diodes. The low parasitics of the T-anode diodes yield extremely high cutoff frequencies, making the diodes useable at frequencies well beyond 1 THz. The diodes were tested as an antiparallel-pair, integrated monolithically with microstrip circuitry on a quartz substrate, in a subharmonically pumped waveguide mixer. A double sideband noise temperature of 600 K with a conversion loss of 4.7 dB were measured at 200 GHz. This is believed to be the lowest noise temperature ever reported for a room temperature subharmonically-pumped Schottky diode mixer at this frequency.

Planar↗