Engineering Papers⌕ Search

Engineering topics

Liu, Jun

Publications and source records attributed to Liu, Jun.

At least 829 records · Page 46

Reversible Sodium Ion Insertion in Single Crystalline Manganese Oxide Nanowires with Long Cycle Life

Single crystalline Na4Mn9O18 nanowires were synthesized via pyrolysis of polyacrylate salt precursors prepared by in-situ polymerization of the metal salts and acrylate acid, followed by calcinations at an appropriate temperature to achieve good crystalline structure and uniform nanowire morphology with an average diameter of 50 nm. The Na4Mn9O18 nanowires have shown a high, reversible, and near theoretical sodium ion insertion capacity (128 mA h g-1 at 0.1C), excellent long cyclability (77% capacity retention for 1000 cycles at 0.5 C), along with good rate capability. Good capacity and charge-discharge stability are also observed for full cell experiments using a pyrolyzed carbon as the anode, therefore demonstrating the potential of these materials for sodium-ion batteries for large scale energy storage. Furthermore, this research shows that a good crystallinity and small particles are required to enhance the Na-ion diffusion and increase the stability of the electrode materials for long charge-discharge cycles.

Cathode material↗

Nanosheet-structured LiV3O8 with high capacity and excellent stability for high energy lithium batteries

Highly stable LiV3O8 with a nanosheet-structure was successfully prepared using polyethylene glycol (PEG) polymer in the precursor solution as the structure modifying agent, followed by calcination in air at 400oC, 450oC, 500oC, and 550oC. These materials provide the best electrochemical performance ever reported for LiV3O8 crystalline electrodes, with a specific discharge capacity of 260 mAh g-1 and no capacity fading over 100 cycles at 100 mA g-1. The excellent cyclic stability and high specific discharge capacity of the material are attributed to the novel nanosheets structure formed in LiV3O8. These LiV3O8 nanosheets are good candidates for cathode materials for high-energy lithium battery applications.

25 ENERGY STORAGE↗

Investigation of the Rechargeability of Li-O2 Batteries in Non-aqueous Electrolyte

In order to understand the nature of the limited cycle life and poor energy efficiency associated with the secondary Li-O¬2 batteries the discharge products of primary Li-O2 cells at different depth of discharge (DOD) are systematically analyzed in this work. It is revealed that if discharged to 2.0 V a small amount of Li2O2 coexist with Li2CO3 and RO-(C=O)-OLi) in alkyl carbonate-based electrolyte. Further discharging the air electrodes to below 2.0 V the amount of Li2CO3 and LiRCO3 increases significantly due to the severe electrolyte decomposition. There is no Li2O detected in this alkyl carbonate electrolyte regardless of DOD. It is also found that the alkyl carbonate based electrolyte begins to decompose at 4.0 V during charging under the combined influences from the high surface area carbon, the nickel metal current collector and the oxygen atmosphere. Accordingly the impedance of the Li-O2 cell continues to increase after each discharge and recharge process indicating a repeated plating of insoluble lithium salts on the carbon surface. Therefore the whole carbon electrode becomes completely insulated only after a few cycles and loses the function of providing active tri-phase regions for the Li-oxygen batteries.

25 ENERGY STORAGE↗

Solvent Evaporation Assisted Preparation of Oriented Nanocrystalline Mesoporous MFI Zeolites

A solvent evaporation route to produce hierarchically porous zeolites with an oriented MFI nanocrystalline structure has been developed, and the method is scalable and productive. In this method, hexadecyltrimethoxysilane is added to an ethanol solution containing zeolitic precursors. A hard gel is formed during the evaporation process. Subsequent hydrothermal treatments produce the hierarchically porous zeolite. High resolution transmission electron microscopy (HRTEM) studies suggest that misoriented zeolite nuclei are produced in the very early stages of the hydrothermal treatment, but further reactions lead to single crystal-like aggregates composed of intergrowth nanocrystals with a mean interparticle pore diameter of 12 nm. All Al atoms exist in tetrahedral sites, as confirmed by 27Al magic angle spinning nuclear magnetic resonance (MAS NMR). Variable temperature hyperpolarized (HP) 129Xe NMR spectroscopy suggest a fast molecular diffusion process from the interconnection between micro- and mesopores. Catalytic conversion of acetone to the isobutene reactions show comparable (with respect to conventional zeolites) selectivity to isobutene. However, hierarchically porous zeolites display enhanced activity and durability because of the more accessible acidic sites in the hierarchically porous structures.

36 MATERIALS SCIENCE↗

Electrode materials and lithium battery systems

A material comprising a lithium titanate comprising a plurality of primary particles and secondary particles, wherein the average primary particle size is about 1 nm to about 500 nm and the average secondary particle size is about 1 .mu.m to about 4 .mu.m. In some embodiments the lithium titanate is carbon-coated. Also provided are methods of preparing lithium titanates, and devices using such materials.

25 ENERGY STORAGE↗

Bubbling Reactor Technology for Rapid Synthesis of Uniform, Small MFI-Type Zeolite Crystals

MFI-type zeolite is an important family of materials used in today’s industries as catalysts and adsorbents. Preparation of this type of zeolite material as uniform and pure crystals of sizes from tens of nanometer to hundreds of nanometer are not only desired by current catalytic and adsorption processes for enhanced reaction kinetics and/or selectivity, but also much needed by some new applications, such as CO2 capture adsorbents and composite materials. However, it has been a major challenge in the zeolite synthesis field to prepare small crystals of MFI-type zeolite over a range of Si/Al ratio with very high throughput. In this work, a gas-bubbling flow reactor is used to conduct hydrothermal growth of the zeolite crystals with controllable Si/Al ratio and crystal sizes. Distinctive, uniform ZSM-5 crystals are successfully synthesized within two hours of reaction time, exceptionally short compared to the conventional synthesis process. The crystals are small enough to form a stable milk-like suspension in water. The Si/Al ratio can be controlled by adjusting the growth solution composition and reaction conditions over a range from about 9 to infinity. Characterization by SEM/EDS, XRD, TEM, N2 adsorption/desorption, and NMR confirms ZSM-5 crystal structures and reveals presence of meso-porosity in the resulting crystals.

36 MATERIALS SCIENCE↗

Direct Conversion of Bio-ethanol to Isobutene on Nanosized ZnxZryOz Mixed Oxides with Balanced Acid–Base Sites

Bio-mass conversion has attracted increasing research interests to produce bio-fuels with bio-ethanol being a major product. Development of advanced processes to further upgrade bio-ethanol to other value added fuels or chemicals are pivotal to improving the economics of biomass conversion and deversifying the utilization of biomass resources. In this paper, for the first time, we report the direct conversion of bio-ethanol to isobutene with high yield (~83%) on a multifunctional ZnxZryOz mixed oxide with a dedicated balance of surface acid-base properties. This work illustrates the significance of rational design of a multifunctional mixed oxide catalyst for one step bio-ethanol conversion to a value-added intermediate, isobutene, for chemical and fuel production. This work was supported by the US Department of Energy Basic Energy Sciences' Chemical Sciences, Geosciences & Biosciences Division. Pacific Northwest National Laboratory is operated by Battelle for the US Department of Energy.

09 BIOMASS FUELS↗

Electrochemical Energy Storage for Green Grid

The is a comprehensive review on the needs and potential storage technologies for electrical grid that is expected to integrate significant levels of renewables. This review offers details of the technologies, in terms of needs, status, challenges and future R&d directions.

25 ENERGY STORAGE↗

A Stable Vanadium Redox-Flow Battery with High Energy Density for Large-scale Energy Storage

Low cost, high performance redox flow batteries are highly demanded for up to multi-megawatt levels of renewable and grid energy storage. Here, we report a new vanadium redox flow battery with a significant improvement over the current technologies. This new battery utilizes a sulfate-chloride mixed solution, which is capable of dissolving more than 2.5 M vanadium or about a 70% increase in the energy storage capacity over the current vanadium sulfate system. More importantly, the new electrolyte remains stable over a wide temperature range of -5 to 60oC, potentially eliminating the need of active heat management. Its high energy density, broad operational temperature window, and excellent electrochemical performance would lead to a significant reduction in the cost of energy storage, thus accelerating its market penetration.

energy storage↗

Correlation of Structural Differences between Nafion/Polyaniline and Nafion/Polypyrrole Composite Membranes and Observed Transport Properties

Polyaniline/Nafion and polypyrrole/Nafion composite membranes, prepared by chemical polymerization, are studied by infrared and nuclear magnetic resonance spectroscopy, and scanning electron microscopy. Differences in vanadium ion diffusion through the membranes and in the membranes’ area specific resistance are linked to analytical observations that polyaniline and polypyrrole interact differently with Nafion. Polypyrrole, a weakly basic polymer, binds less strongly to the sulfonic acid groups of the Nafion membrane, and thus the hydrophobic polymer aggregates in the center of the Nafion channel rather than on the hydrophilic side chains of Nafion that contain sulfonic acid groups. This results in a drastically elevated membrane resistance and an only slightly decreased vanadium ion permeation compared to a Nafion membrane. Polyaniline on the other hand is a strongly basic polymer, which forms along the sidewalls of the Nafion pores and on the membrane surface, binding tightly to the sulfonic acid groups of Nafion. This leads to a more effective reduction in vanadium ion transport across the polyaniline/Nafion membranes and the increase in membrane resistance is less severe. The performance of selected polypyrrole/Nafion composite membranes is tested in a static vanadium redox cell. Increased coulombic efficiency, compared to a cell employing Nafion, further confirms the reduced vanadium ion transport through the composite membranes.

74 ATOMIC AND MOLECULAR PHYSICS↗

In Situ Transmission Electron Microscopy Observation of Microstructure and Phase Evolution in a SnO2 Nanowire during Lithium Intercalation

This paper reports development of a lithium-ion battery nanostructure device using a single nanowire for in-stu TEM study of the battery. This prototype lithium ion battery was built using a single SnO₂ nanowire as the anode, an air stable salt: lithium bis(trifluoromethansulfonyl) imide (LiTFSI) in a hydrophobic ionic liquid: 1-butyl-1-methylpyrrolidium TFSI (P14TFSI) as the electrolyte, and LiCoO₂ as the cathode. The microstructure evolution of the single nanowire anode was studied using TEM imaging, electron diffraction, and electron energy-loss spectroscopy during the operation of the battery. It has been observed that during initial charging, the electrolyte was found to decompose and subsequently be electrodeposited on the anode, leading to the formation of a coating layer on the anode. This coating layer was enriched with Li. Formation of this layer will retard the Li intercalation of SnO₂. This in situ TEM observation provides direct evidence that accounts for the observed low capacity and fast fading of the Li battery when LiTFSI-P14TFSI is used as the electrolyte.

74 ATOMIC AND MOLECULAR PHYSICS↗

Towards Understanding the Poor Thermal Stability of V5+ Electrolyte Solution in Vanadium Redox Flow Batteries

The V5+ electrolyte solution from vanadium redox flow batteries was studied by variable temperature 17O and 51V Nuclear Magnetic Resonance (NMR) spectroscopy and DFT based computational modeling. It was found that the V5+ species exist as hydrated penta co-ordinated vanadate ion, i.e. [VO2(H2O)3]1+. This hydrated structure is not stable at elevated temperature and change into neutral H3VO4 molecule via a deprotonation process. H3VO4 species is also knowingly unstable, leading to the observed V2O5 precipitation in V5+ electrolyte solutions.

25 ENERGY STORAGE↗

High-Rate Cathodes Based on Li3V2(PO4)3 Nanobelts Prepared via Surfactant-Assisted Fabrication

In this work, we synthesized monoclinic Li3V2(PO4)3 nanobelts via a single-step, solid-state reaction process in a molten hydrocarbon. The as-prepared Li3V2(PO4)3 nanoparticles have a unique nanobelt shape and are ~50-nm thick. When cycled in a voltage range between 3.0 V and 4.3V at a 1C rate, these unique Li3V2(PO4)3 nanobelts demonstrated a specific discharge capacity of 131 mAh g-1 (which is close to the theoretical capacity of 132 mAh g-1) and stable cycling characteristics.

25 ENERGY STORAGE↗

Sandwich-Type Functionalized Graphene Sheet-Sulfur Nanocomposite for Rechargeable Lithium Batteries

A sandwich structured graphene sheet-sulfur (GSS) nanocomposite was synthesized as the cathode material for lithium-sulfur batteries. The structure has a layer of graphene stacks and a layer of sulfur nanoparticles integrated into a three-dimensional architecture. This GSS nanoscale layered composite, making use of the efficient physical and electrical contact between sulfur and the large surface area, highly conductive graphene, provides a high loading of active materials of ~70 wt%, a high tape density of ~0.92 g∙cm-3, and a high power with a reversible capacity of ~505 mAh∙g-1 (~464 mAh∙cm-3) at a current density of 1,680 mA∙g-1 (1C). When coated with a thin layer of cation exchange Nafion film, the migration of dissolved polysulfide anions from the GSS nanocomposite was effectively alleviated, leading to a good cycling stability of 75% capacity retention over 100 cycles. This sandwich-structured composite conceptually provides a new strategy for designing electrodes in energy storage applications.

25 ENERGY STORAGE↗

Surfactant Two-Dimensional Self-Assembly under Confinement

Confinement-induced structural rearrangements in supported self-assembled surfactant layers in aqueous salt solutions are investigated using classical Density Functional Theory. The systematic study of the influence of the nature of electrolyte revealed that 2:1 electrolyte stabilizes the hemicylindrical configuration of ionic surfactant layers, while a confinement-induced transition to a tilted monolayer configuration was found in symmetric 1:1 and 2:2 electrolytes. On the basis of this study we formulate a general model for the energetics of structural rearrangements in supported surfactant layers.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗