Engineering topics

Lee, C. C.

Publications and source records attributed to Lee, C. C..

At least 37 records · Page 2

NASA NTRS1991

Laminar-Separation Sensor

Reduction of viscous drag on airplanes explores limits of practical applications of natural laminar flow. Wind-tunnel and flight tests conducted to explore abilities of hot-film sensors to identify separation of laminar flow as principal mode of amplification of instability leading to transition from laminar to turbulent flow. Two different laminar-separation-sensor configurations developed and used to detect boundary-layer transitions. Results show hot-film laminar-separation-sensor technique viable means for detecting existence of transition as well as for indicating reversed flow in laminar-separation bubble. Refinement of sensor configurations provides tools necessary to explore, in all speed regimes, practical limits of laminar-flow applications and viscous-drag-reduction technology.

Manuel, G. S.↗

NASA NTRS1991

Remote sensing of mesospheric and thermospheric density perturbations induced by subtropical heavy rainfalls for spacecraft environment study

The simultaneous measurements of VHF radar and HF Doppler array systems are used to observe three-dimensional wind speeds and gravity waves with the purpose of determining the density perturbations at different heights of mesosphere and thermosphere induced by the convective motions associated with subtropical heavy rainfall during the time period of the raining season. Frequency, horizontal wavelength, vertical wavelength, and phase velocity of the gravity waves are determined from the Fourier power spectral analysis of horizontal and vertical wind velocities. The results are compared with those of density perturbations caused by typhoons, tropical storms, and winter-time drizzles associated with convective motions. It is shown that the maximum amplitude of the density perturbations caused by the gravity waves is +/- 10 pct which is greater than that of density perturbations caused by gravity waves associated with weak convective motions in winter time and is smaller than that caused by the gravity waves associated with tropical storms.

Hung, R. J.↗

NASA NTRS1991

Response of gravity level fluctuations on the Gravity Probe-B Spacecraft propellant system

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled fluids in a rotating dewar under microgravity environment have been investigated. Results show that there is a group of wave trains, both in longitudinal and transverse modes, with various frequencies and wavelengths of slosh waves generated by the restoring force field of gravity jitters and centrifugal forces in this study. The longest wave periods of slosh waves, either the longitudinal or transverse modes, are responsible for the production of wave modes with highest ratio of maximum wave amplitude to wavelength. Also, the lower frequency slosh waves are the wave modes with higher wave energy than that of the higher frequency slosh waves.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter response slosh wave excitation on the fluid in a rotating dewar

The present study investigates the dynamical behavior of fluids, in particular, the effect of surface tension on partially filled fluids in a rotating dewar in a microgravity environment. It is shown that there is a group of wave trains, both in longitudinal and transverse modes, with various frequencies and wavelengths of slosh waves generated by the restoring field force field of gravity jitters and centrifugal forces. The longest wave periods of slosh waves, either the longitudinal or transverse modes, are found to be responsible for the production of wave modes with the highest ratio of maximum wave amplitude to wavelength. The lower frequency slosh waves are the wave modes with higher wave energy than that of the higher frequency slosh waves.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter effected slosh waves and the stability of a rotating bubble under microgravity

The instability of liquid and gas interface can be induced by the pressure of longitudinal and lateral accelerations, vehicle vibration, and rotational fields of spacecraft in a microgravity environment. Characteristics of slosh waves excited by the restoring force field of gravity jitters have been investigated. Results show that lower frequency gravity jitters excite slosh wave with higher ratio of maximum amplitude to wave length than that of the slosh waves generated by the higher frequency gravity jitters.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation in the gravity probe-B spacecraft propulsion system

The dynamical behavior of fluids in a Gravity Probe-B Spacecraft tank imposed by various frequencies of gravity jitters have been investigated. Fluid stress distribution also have been investigated. Results show that fluid stress distribution exerted on the outer and inner walls of rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank.

Hung, R. J.↗

NASA NTRS1991

Gravity jitters excited slosh waves in rotating propellant tank under microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B Spacecraft propellant tank without probe imposed by various frequencies of gravity jitters have been investigated. Results disclose the conditions for the excitation of large amplitude slosh waves which shall be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation in a partially filled rotating tank due to gravity jitters in a microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor), in a full-scale Gravity Probe-B Spacecraft propellant tank without probe imposed by various frequencies of gravity jitters have been investigated. Twelve case studies of slosh wave excitation due to various frequencies of gravity jitters under different rotating speeds of propellant tank and different levels of background gravity environment have been numerically simulated. Results disclose the conditions for the excitation of large amplitude slosh waves which shall be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation of cryogenic liquid helium in gravity Probe-B rotating dewar

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full scale Gravity Probe-B Spacecraft propellant dewar tank imposed by various frequencies of gravity jitters have been investigated. Fluid stress distribution, caused by the excitation of slosh waves and their associated large amplitude disturbances on the liquid-vapor interface, exerted on the outer and inner walls of rotating dewar container also have been investigated. Results show that fluid stress distribution exerted on the outer and inner walls of rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank.

Hung, R. J.↗

NASA NTRS1991

Gravity jitter excited cryogenic liquid slosh waves in microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B Spacecraft liquid helium container tank without probe imposed by various frequencies of gravity jitter have been investigated. Results disclose the conditions for the excitation of large amplitude slosh waves which should be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

NASA NTRS1991

Slosh wave excitation due to cryogenic liquid reorientation in space-based propulsion system

The objective of the cryogenic fluid management of the spacecraft propulsion system is to develop the technology necessary for acquistion or positioning of liquid and vapor within a tank in reduced gravity to enable liquid outflow or vapor venting. In this study slosh wave excitation induced by the resettling flow field activated by 1.0 Hz medium frequency impulsive reverse gravity acceleration during the course of liquid fluid reorientation with the initiation of geyser for liquid filled levels of 30, 50, and 80 percent have been studied. Characteristics of slosh waves with various frequencies excited are discussed.

Hung, R. J.↗

NASA NTRS1990

Stability and slosh wave for rotating bubble due to gravity-jitters under microgravity

Time-dependent fluid behaviors in microgravity environments are examined with particular attention given to the dynamics of bubble configurations. The initial bubble profiles, computed from the steady-state formulation, are used as the initial input for the time dependent computation. The parameters considered are liquid density and its kinematic viscosity, gas density and its kinematic viscosity, surface tension coefficient, angular velocity, and gravity environment. This computer algorithm can be used to simulate the fluid behavior in a microgravity environment, in particular the excitation of slosh waves due to different frequencies of gravity jitters. Results show that lower-frequency gravity jitters excite slosh waves with a higher ratio of maximum amplitude to wave length than that of the slosh waves generated by the higher frequency gravity jitters.

Hung, R. J.↗

NASA NTRS1990

Characteristics and performance of the variable polarity plasma arc welding process used in the Space Shuttle external tank

Significant advantages of the Variable Polarity Plasma Arc (VPPA) Welding Process include faster welding, fewer repairs, less joint preparation, reduced weldment distortion, and absence of porosity. Flow profiles and power distribution of argon plasma gas as a working fluid to produce plasma arc jet in the VPPA welding process was analyzed. Major loss of heat transfer for flow through the nozzle is convective heat transfer; for the plasma jet flow between the outlet of the nozzle and workpiece is radiative heat transfer; and for the flow through the keyhole of the workpiece is convective heat transfer. The majority of the power absorbed by the keyhole of the workpiece is used for melting the solid metal workpiece into a molten metallic puddle. The crown and root widths and the crown and root heights can be predicted. An algorithm for promoting automatic control of flow parameters and the dimensions of the final product of the welding specification to be used for the VPPA Welding System operated at MSFC are provided.

Hung, R. J.↗

NASA NTRS1990

Observations on thermospheric and mesospheric density disturbances caused by typhoons and convective storms

Atmospheric parameter observations have been conducted during the passage of typhoons and tropical storms, from the troposphere to the middle atmosphere, and thence to the thermosphere, using the VHF radar and HF Doppler sounder at an observation site in Taiwan. The density perturbations caused by the propagation of gravity waves due to the typhoons and tropical storms were calculated on the basis of these observations. The short-term middle atmospheric and thermospheric density changes are significant factors in spacecraft launches. The successful remote measurement of three-dimensional winds, gravity waves, and density perturbations is demonstrated for this subtropical site.

Hung, R. J.↗

NASA NTRS1990

HF Doppler and VHF radar observations of upper atmospheric disturbances caused by weak cold front during winter time

The simultaneous use of the Taiwan VHF radar and the HF Doppler sounder for remote measurement of three-dimensional winds, gravity waves, and density perturbations at mesospheric and thermospheric heights is demonstrated. A special event of atmospheric disturbances caused by propagating gravity waves excited by weak convective motions in winter time were investigated. The three-dimensional wind velocities at different heights were determined, and the frequency, horizontal wavelength, vertical wavelength, and phase velocity of the gravity waves were measured. The subtropical, low-latitude site makes the VHF radar and HF Doppler array systems unique, and the observations especially valuable for space projects dealing with low-latitude atmosphere.

Hung, R. J.↗

NASA NTRS1990

Reorientation of rotating fluid in microgravity environment with and without gravity jitters

In a spacecraft design, the requirements of settled propellant are different for tank pressurization, engine restart, venting, or propellant transfer. The requirement to settle or to position liquid fuel over the outlet end of the spacecraft propellant tank prior main engine restart poses a microgravity fluid behavior problem. In this paper, the dynamical behavior of liquid propellant, fluid reorientation, and propellant resettling have been carried out through the execution of supercomputer CRAY X-MP to simulate the fluid management in a microgravity environment. Results show that the resettlement of fluid can be accomplished more efficiently for fluid in rotating tank than in nonrotating tank, and also better performance for gravity jitters imposed on fluid settlement than without gravity jitters based on the amount of time needed to carry out resettlement period of time between the initiation and termination of geysering.

Hung, R. J.↗

NASA NTRS1990

Gravity-jitters and excitation of slosh waves

The instability of liquid and gas interface can be induced by the pressure of longitudinal and lateral accelerations, vehicle vibration, and rotational fields of spacecraft in a microgravity environment. Characteristics of slosh waves excited by the restoring force field of gravity jitters have been investigated. Results show that lower frequency gravity jitters excite slosh waves with higher ratio of maximum amplitude to wave length than that of the slosh waves generated by the higher frequency gravity jitters.

Hung, R. J.↗

NASA NTRS1990

Fluid behavior in microgravity environment

The instability of liquid and gas interface can be induced by the presence of longitudinal and lateral accelerations, vehicle vibration, and rotational fields of spacecraft in a microgravity environment. In a spacecraft design, the requirements of settled propellant are different for tank pressurization, engine restart, venting, or propellent transfer. In this paper, the dynamical behavior of liquid propellant, fluid reorientation, and propellent resettling have been carried out through the execution of a CRAY X-MP super computer to simulate fluid management in a microgravity environment. Characteristics of slosh waves excited by the restoring force field of gravity jitters have also been investigated.

Hung, R. J.↗