Engineering Papers⌕ Search

Engineering topics

Lee, C. C.

Publications and source records attributed to Lee, C. C..

At least 19 records

G -type magnetic order in ferropnictide Cu x Fe 1–y As induced by hole doping on As sites

Strong antiferromagnetic (AFM) correlation has long been postulated to be closely related to the occurrence of unconventional high-temperature superconductivity observed in the cuprates, heavy fermions, and organic superconductors. Here, the recently discovered Fe-based superconductors add another interesting member to the list. However, insufficient attention has been paid to the versatile nature of the magnetic correlation in these materials: some showing stripe (C-type) order, others double stripe (E-type) or block AFM order instead, implying potentially richer structures of the superconducting order. Here we report the observation of yet another AFM correlation in the family: a G-type AFM order as seen in the high-T c cuprates, in Cu x Fe 1–y As compounds isostructural to the LiFeAs superconductor. This study not only sheds light on the underlying mechanism of the rich magnetic correlations in the Fe-based superconductors, but also suggests the possibility of realizing a distinct pairing symmetry upon chemical doping or applying pressure.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Coupling of Spin and Orbital Excitations in the Iron-based Superconductor FeSe0.5Te0.5

We present a combined analysis of neutron scattering and photoemission measurements on superconducting FeSe{sub 0.5}Te{sub 0.5}. The low-energy magnetic excitations disperse only in the direction transverse to the characteristic wave vector (1/2,0,0) whereas the electronic Fermi surface near (1/2,0,0) appears to consist of four incommensurate pockets. While the spin resonance occurs at an incommensurate wave vector compatible with nesting, neither spin-wave nor Fermi-surface-nesting models can describe the magnetic dispersion. We propose that a coupling of spin and orbital correlations is key to explaining this behavior. If correct, it follows that these nematic fluctuations are involved in the resonance and could be relevant to the pairing mechanism.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Fuel cell environmental life cycle assessment : a progress report

Energy generation using fuel cells offers the possibility of high conversion efficiency and reduced pollution. Thus, in the futue, conventional methods of energy generation using coalfired power plants, natural gas turbines and internal combustion engines can potentially be replaced by fuel cells. The United States, Japan and several countries in Europe are currently developing fuel cells for transportation, distributed energy generation and portable electronics applications. On a system basis, the efficiency of chemical to electrical energy conversion in fuel cells can be as high as 45%. Also, because of the lower operating temperatures compared to turbines and internal combustion engines, emissions such as carbon monoxide and nitrogen oxides are extremely small. An assessment of the environmental impact of fuel cells over the entire lifecycle is needed to determine the specific benefits in various application scenarios. Such a comparative pollutants assessment must include a "cradle to grave" approach encompassing fuel production, fuel transportation, materials/manufacturing processes, waste management, and recycling. A comparative pollutant model would be a useful tool for industry and government in estimating energy savings and environmental credits, and providing a holistic understanding on regulatory needs. Another important benefit would be the ability to make appropriate comparisons with competitive energy generation technologies such as hybrids, turbines, and internal combustion engines, and to set up realistic targets. Also, exercising the model will assist in the initial screening for potential hot spots and showstoppers and focus on the right component technologies design for manufacturing, designs for input substitution and waste minimization, and prevent any unforeseen burdens.

Narayanan, S. R.↗

Effect of Baffle on Gravity-Gradient-Excited Slosh Waves and Spacecraft Moment and Angular-Momentum Fluctuations in Microgravity

The dynamical behavior of fluids affected by the asymmetric gravity gradient acceleration has been investigated. In particular, the effects of surface tension on partially filled rotating fluids applicable to a full-scale Gravity Probe-B Spacecraft dewar tank with and without baffles are studied. Results of slosh wave excitation along the liquid-vapor interface induced by gravity gradient acceleration indicate that the gravity gradient acceleration is equivalent to the combined effect of a twisting force and a torsional moment acting on the spacecraft. The results are clearly seen from one-up one-down and one-down one-up oscillations in the cross-section profiles of two bubbles in the vertical (r, z)-plane of the rotating dewar, and from the eccentric contour of the bubble rotating around the axis of the dewar in a horizontal (r, theta)-plane. As the viscous force, between liquid and solid interface, greatly contributes to the damping of slosh wave excitation, a rotating dewar with baffles provides more areas of liquid-solid interface than that of a rotating dewar without baffles. Results show that the damping effect provided by the baffles reduces the amplitude of slosh wave excitation and lowers the degree of asymmetry in liquid-vapor distribution. Fluctuations of angular momentum and fluid moment caused by the slosh wave excited by gravity gradient acceleration with and without baffle boards are also investigated. It is also shown that the damping effect provided by the baffles greatly reduces the amplitudes of angular momentum and fluid moment fluctuations.

Hung, R. J.↗

Dynamic gravity Probe-B spacecraft due to gravity jitter induced cryogenic helium disturbances in rotating dewar

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full scale Gravity Probe-B Spacecraft propellant dewar tank imposed by various frequencies of gravity jitters have been investigated. The study shows that slosh waves excited inside the spacecraft propellant tank are characterized by the lowest frequency of the waves initiated, frequencies of the gravity jitters imposed on the propellant system, the levels of background gravity environment, and dewar rotating speeds. Conditions for suppression and amplification of the slosh waves are discussed. It also shows that fluid stress distribution exerted on the walls of the rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank. This can provide a set of data leading toward the control of spacecraft imbalance caused by the uneven fluid stress distribution from slosh waves.

Hung, R. J.↗

Dynamic Characteristics of the Partially Filled Rotating Dewar of the Gravity Probe-B Spacecraft

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a full scale Gravity Probe-B Spacecraft propellant dewar tank imposed by various frequencies of gravity jitters have been investigated. The study of the liquid-vapor interface oscillations due to various frequencies of gravity jitter under different dewar rotating speeds and different levels of background gravity have been numerically simulated. Results disclose the time sequence evolution for the excitation of large amplitude oscillation waves at the liquid-vapor interface. The study shows that slosh waves excited inside the spacecraft propellant tank are characterized by the lowest frequency of the waves initiated, frequencies of the gravity jitters imposed on the propellant system, the levels of background gravity environment, and dewar rotating speeds. Conditions for suppression and amplification of the slosh waves are discussed. It also shows that fluid stress distribution exerted on the walls of the rotating dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating dewar tank. This can provide a set of data leading toward the control of spacecraft imbalance caused by the uneven fluid stress distribution from slosh waves.

Hung, R. J.↗

Effect of the baffle on the spacecraft fluid propellant viscous stress and moment fluctuations

The dynamical behavior of fluids affected by asymmetric gravity jitter oscillations, in particular the effect of surface tension on rotating fluids in a partially filled dewar tank imposed by time-dependent directions of background gravity have been investigated. Results show that a lower frequency gravity jitter imposed on the time-dependent variations of the direction of background gravity induced a greater amplitude of oscillations and a stronger degree of asymmetry in liquid-vapor interface geometry than that caused by higher-frequency gravity jitter. As viscous force between liquid and solid interface greatly contributes to the damping effect of slosh wave excitation, a rotating dewar with installed baffle provides more areas of liquid-solid interface than a rotating dewar without baffle. Damping by baffle reduces the amplitude of slosh wave excitation, angular momentum, and fluid moment fluctuation and lowers the degree of asymmetry in the liquid-vapor distribution.

Hung, R. J.↗

Effect of baffle on the asymmetric gravity jitter excited slosh waves in microgravity

The paper investigates the dynamical behavior of fluids affected by asymmetric gravity jitter oscillations, in particular, the effect of surface tension on partially filled rotating fluids in a full-scale Gravity Probe-B Spacecraft dewar tank, with and without the installation of the baffle-board, imposed by time-dependent directions of background gravity. The time-sequence evolution of the 3D behavior of the liquid-vapor interface oscillations resulting in the excitation of large amplitude slosh waves exerted by gravity jitter disturbances are examined. It is shown that the damping effect provided by baffle reduces the amplitude of slosh wave excitation and lowers the degree of asymmetry in the liquid-vapor distribution.

Hung, R. J.↗

Medium-frequency impulsive-thrust-excited slosh waves during propellant reorientation with a geyser

Slosh wave excitation induced by a resettling flowfield activated by 1.0-Hz impulsive thrust during the course of liquid reorientation with the initiation of geyser for liquid-fill levels of 30, 50, 65, 70, and 80 percent has been studied. Characteristics of slosh waves of various frequencies excited by the resettling flowfield are discussed. Slosh wave excitations shift the fluid mass distribution in the container which imposes time-dependent variations in spacecraft moment of inertia. This information is important for spacecraft control during the course of liquid reorientation.

Hung, R. J.↗

Spacecraft dynamical distribution of fluid stresses activated by gravity-jitter-induced slosh waves

The dynamical behavior of fluids, in particular the effect of surface tension on partially filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B Spacecraft propellant Dewar tank imposed by various frequencies of gravity jitters, has been investigated. Fluid stress distribution, caused by the excitation of slosh waves and their associated large-amplitude disturbances on the liquid-vapor interface, exerted on the outer and inner walls of a rotating Dewar container also has been investigated. Results show that fluid stress distributions near the outer and inner walls of the rotating Dewar are closely related to the characteristics of slosh waves excited on the liquid-vapor interface in the rotating Dewar tank. This can provide a useful tool for managing spacecraft dynamic control leading toward the control of spacecraft imbalance caused by the uneven fluid stress distribution due to slosh wave excitations at the interface between liquid and vapor propellants.

Hung, R. J.↗

Gravity jitter induced slosh waves in liquid propellant and disturbances of fluid stresses on spacecraft

The paper investigates the dynamical behavior of fluids, in particular the effect of surface tension on partially filled rotating fluids (cryogenic liquid helium and helium vapor) in a full-scale Gravity Probe-B spacecraft propellant dewar tank imposed by various frequencies of gravity jitters. Fluid stress distribution caused by the excitation of slosh waves and their associated large amplitude disturbances on the liquid-vapor interface and exerted on the outer and inner walls of a rotating dewar container are also examined. It is shown that fluid stress distributions near the outer and inner walls of the rotating dewar are closely related to the characteristics of slosh waves excited in the liquid-vapor interface in the rotating dewar tank. This can be of utility in managing spacecraft dynamic control leading to control of spacecraft imbalance caused by the uneven fluid stress distribution due to slosh wave excitations at the interface between liquid and vapor propellants.

Hung, R. J.↗

Liquid hydrogen slosh waves excited by constant reverse gravity acceleration of geyser initiation

The requirement to settle or to position liquid fuel over the outlet end of the spacecraft propellant tank before main engine restart poses a microgravity fluid behavior problem. Resettlement or reorientation of liquid propellant can be accomplished by providing the optimal acceleration to the spacecraft such that the propellant is reoriented over the tank outlet. In this study slosh wave excitation induced by the resettling flowfield during the course of liquid reorientation with the initiation of geyser for liquid-filled levels of 30, 50, 65, 70, and 80 percent have been studied. Characteristics of slosh waves with various frequencies excited are discussed. Slosh wave excitations will affect the fluid stress distribution exerted on the container wall and shift the fluid mass distribution inside the container, which imposes the time-dependent variations in the moment of inertia of the container. This information is important for the spacecraft control during the course of liquid reorientation.

Hung, R. J.↗

Similarity rules in gravity jitter-related spacecraft liquid propellant slosh waves excitation

The dynamical behavior of fluids, in particular the effect of surface tension on partially filled rotating fluids in a full-scale prototype Gravity Probe-B Spacecraft propellant tank and various 10 percent subscale containers with identical values of similarity parameters such as Bond number, dynamical capillary number, rotational Reynolds number, and Weber number, as well as imposed gravity jitters have been investigated. It is shown that the Bond number can be used to simulate the wave characteristics of slosh wave excitation, whereas the Weber number can be used to simulate the wave amplitude of slosh-mode excitation. It is shown that a dynamical capillary number can be used to simulate the induced perturbation of the fluid stress distribution exerted on the wall. This distribution is governed by the interaction between surface tension (slosh-wave excitation along the liquid-vapor interface) and viscous (fluid stress exerted on the wall) forces.

Hung, R. J.↗

Effect of asymmetric gravity jitter excited slosh waves at liquid-vapor interface under microgravity

The dynamical behavior of fluids affected by the asymmetric gravity jitter oscillations, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor) in a sub-scale Gravity Probe-B Spacecraft propellant dewar tank imposed by time-dependent various directions of background gravity environment have been investigated. Results show that lower frequency gravity jitter imposed on the time-dependent variations of the direction of background gravity induced a greater amplitude of oscillations and a stronger degree of asymmetry in liquid-vapor interface geometry than that made by the higher frequency gravity jitter. Furthermore, the greater the components of background gravity in radial and circumferential directions will provide a greater contribution in driving more to the increasing amplitude and degrees of symmetry of liquid-vapor interface profiles which, in turn, modify the disturbance of moment of inertia and angular momentum of spacecraft.

Hung, R. J.↗