Engineering Papers⌕ Search

Engineering topics

Lan, C. E.

Publications and source records attributed to Lan, C. E..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Unsteady aerodynamic models for maneuvering aircraft

Forced oscillation tests over a large angle-of-attack range for an F-18 model are conducted in the NASA Langley 12-foot low-speed tunnel. The resulting dynamic longitudinal data are analyzed with an unsteady aerodynamic modeling method based on Fourier functional analysis and the indicial formulation. The method is extensively examined and improved to automate the calculation of model coefficients, and to evaluate more accurately the indicial integral. The results indicate that the general model equation obtained from harmonic test data in a range of reduced frequency is capable of accurately modeling the nonlinear responses with large hysteresis effect, except in the region where a delayed flow reattachment occurs at low angles of attack in down strokes. The indicial formulation is used to calculate the response to harmonic motion, harmonic ramp motion, constant-rate pitching motion and smaller-amplitude harmonic motion. The results show that more accurate results can be obtained when the motion starts from a low angle of attack where hysteresis effect is not important.

Hu, Chien-Chung↗
NASA NTRS1991

Fourier functional analysis for unsteady aerodynamic modeling

A method based on Fourier analysis is developed to analyze the force and moment data obtained in large amplitude forced oscillation tests at high angles of attack. The aerodynamic models for normal force, lift, drag, and pitching moment coefficients are built up from a set of aerodynamic responses to harmonic motions at different frequencies. Based on the aerodynamic models of harmonic data, the indicial responses are formed. The final expressions for the models involve time integrals of the indicial type advocated by Tobak and Schiff. Results from linear two- and three-dimensional unsteady aerodynamic theories as well as test data for a 70-degree delta wing are used to verify the models. It is shown that the present modeling method is accurate in producing the aerodynamic responses to harmonic motions and the ramp type motions. The model also produces correct trend for a 70-degree delta wing in harmonic motion with different mean angles-of-attack. However, the current model cannot be used to extrapolate data to higher angles-of-attack than that of the harmonic motions which form the aerodynamic model. For linear ramp motions, a special method is used to calculate the corresponding frequency and phase angle at a given time. The calculated results from modeling show a higher lift peak for linear ramp motion than for harmonic ramp motion. The current model also shows reasonably good results for the lift responses at different angles of attack.

Chin, Suei↗
NASA NTRS1986

Calculating Aerodynamic-Stability Derivatives

VORSTAB program developed to calculate lateral-directional characteristics of nonplanar wing/body combinations in subsonic flow. Mathematically determines effects of edge-separated vortex flow, including augmented vortex lift, strake-induced downwash, and vortex breakdown. VORSTAB written in FORTRAN IV.

Lan, C. E.↗
NASA NTRS1986

Extensions of the concept of suction analogy to prediction of vortex lift effect

Flow field data for a double delta wing at low speed were used to determine the location of a vortex action point. The result was found to be consistent with what was determined for a delta wing. In supersonic flow, the action point location was determined empirically. For a wing with rounded leading edges, an assumption for initial vortex separation was shown to be equivalent to initial leading edge bubble separation for airfoils. A theoretical formulation by the section analogy to determine the delayed vortex separation on a cambered wing with rounded leading edges was presented. The method of suction analogy was further shown to be applicable to predicting the body vortex lift.

Lan, C. E.↗
NASA NTRS1986

Wake shape and its effects on aerodynamic characteristics

The wake shape under symmetrical flight conditions and its effects on aerodynamic characteristics are examined. In addition, the effect of wake shape in sideslip and discrete vortices such as strake or forebody vortex on lateral characteristics is presented. The present numerical method for airplane configurations, which is based on discretization of the vortex sheet into vortex segments, verified the symmetrical and asymmetrical roll-up process of the trailing vortices. Also, the effect of wing wake on tail planes is calculated. It is concluded that at high lift the assumption of flat wake for longitudinal and lateral-directional characteristics should be reexamined.

Emdad, H.↗
NASA NTRS1986

Investigation of empennage buffeting

Theoretical methods of predicting aircraft buffeting are reviewed. For the buffeting due to leading edge vortex breakdown, a method is developed to convert test data of mean square values of fluctuating normal force to buffeting vortex strength through an unsteady lifting-surface theory and unsteady suction analogy. The resulting buffeting vortex from the leading edge extension of an F-18 configuration is used to generate a fluctuating flow field which produces unsteady pressure distribution on the vertical tails. The root mean square values of root bending moment on the vertical tails are calculated for a rigid configuration.

Lan, C. E.↗
NASA NTRS1986

Transonic airfoil analysis and design in nonuniform flow

A nonuniform transonic airfoil code is developed for applications in analysis, inverse design and direct optimization involving an airfoil immersed in propfan slipstream. Problems concerning the numerical stability, convergence, divergence and solution oscillations are discussed. The code is validated by comparing with some known results in incompressible flow. A parametric investigation indicates that the airfoil lift-drag ratio can be increased by decreasing the thickness ratio. A better performance can be achieved if the airfoil is located below the slipstream center. Airfoil characteristics designed by the inverse method and a direct optimization are compared. The airfoil designed with the method of direct optimization exhibits better characteristics and achieves a gain of 22 percent in lift-drag ratio with a reduction of 4 percent in thickness.

Chang, J. F.↗
NASA NTRS1986

An investigation of empennage buffeting

Progress in the investigation of empennage buffeting in reviewed. In summary, the following tasks were accomplished: relevant literatures was reviewed; equations for calculating structural response were formulated; root-mean-square values of root bending moment for a 65-degree rigid delta wing were calculated and compared with data; and a water-tunnel test program for an F-18 model was completed.

Lan, C. E.↗
NASA NTRS1986

Calculation of asymmetric vortex separation on slender delta wings with a vortex-sheet model

An inviscid vortex-sheet model based on the slender wing theory is developed to examine asymmetric vortex separation at zero sideslip on delta wings. It is found that multiple asymmetric vortex configurations exist at a given angle of attack. Available data on rolling moment measurements and flow visualization are used for correlation to prove the concept.

Lan, C. E.↗
NASA NTRS1985

Calculation of vortex-flap aerodynamic characteristics

The lateral-directional characteristics for configurations with vortex flaps were calculated by the VORSTAB code. In view of the poor correlation between the VORSTABL results and the data, it was decided to examine in detail the reasons behind the discrepancy. After corrections in the data, the characteristics were recalculated. The prediction of dihedral effect is now largely improved.

Lan, C. E.↗
NASA NTRS1985

An investigation of vortex-induced aerodynamic characteristics of supersonic cruise configurations

The linear lifting surface theory which predicts the life in supersonic flow, even though the drag is usually underpredicted, is described. A method for calculating the nonlinear wave drag was developed to remedy this deficiency. The calculated sectional drag is modified by adding the difference between the exact two dimensional (2-D) and the linear 2-D wave drag at the calculated sectional lift coefficient. Improvement in the supersonic drag prediction is shown. The VORCAM code was modified for the FORTRAN 77 language and its input stream was rearranged. The Boeing code was adapted to the computer system. All CDC special features in the code are replaced with standard FORTRAN algorithms. It is suggested that because of the nonlinearity the solution appears to be nonunique crowding of two vortices, a mechanism of vortex asymmetry, is investigated.

Lan, C. E.↗
NASA NTRS1985

Theory of wing rock

Wing rock is one type of lateral-directional instabilities at high angles of attack. To predict wing rock characteristics and to design airplanes to avoid wing rock, parameters affecting wing rock characteristics must be known. A new nonlinear aerodynamic model is developed to investigate the main aerodynamic nonlinearities causing wing rock. In the present theory, the Beecham-Titchener asymptotic method is used to derive expressions for the limit-cycle amplitude and frequency of wing rock from nonlinear flight dynamics equations. The resulting expressions are capable of explaining the existence of wing rock for all types of aircraft. Wing rock is developed by negative or weakly positive roll damping, and sustained by nonlinear aerodynamic roll damping. Good agreement between theoretical and experimental results is obtained.

Hsu, C.-H.↗
NASA NTRS1984

Theory of wing rock

A theory is developed for predicting wing rock characteristics. From available data, it can be concluded that wing rock is triggered by flow asymmetries, developed by negative or weakly positive roll damping, and sustained by nonlinear aerodynamic roll damping. A new nonlinear aerodynamic model that includes all essential aerodynamic nonlinearities is developed. The Beecham-Titchener method is applied to obtain approximate analytic solutions for the amplitude and frequency of the limit cycle based on the three degree-of-freedom equations of motion. An iterative scheme is developed to calculate the average aerodynamic derivatives and dynamic characteristics at limit cycle conditions. Good agreement between theoretical and experimental results is obtained.

Hsu, C. H.↗
NASA NTRS1984

Applications of CONMIN to wing design optimization with vortex flow effect

Slender wings on supersonic cruise configurations are expected to be thin and highly swept. As a result, edge-separated vortex flow is inevitable and must be accounted for in aerodynamic analysis and design. The present method is based on the method of suction analogy to calculate the total aerodynamic characteristics. The method requires the solution of the attached flow problem, the latter being solved by a low-order panel method in subsonic and supersonic flow. In essence, the lifting pressure is calculated by using a pressure-doublet distribution satisfying the Prandtl-Glauert equation. From the pressure distribution, the leading-edge suction is calculated. The latter is assumed to be the vortex lift through the method of suction analogy. For a cambered wing, the location of vortex-lift action point is important in predicting the aerodynamic characteristics. It is also seen that the effect of camber shape appears nonlinearly in all aerodynamic expressions. To design the camber shape, the camber slope is represented by a cosine Fourier series at each of several spanwise stations. The Fourier coefficients are the design variables. To design a leading-edge flap in the vortex flow (i.e., a vortex flap), the coordinates of corner points and the deflection angle are the design variables. The process of wing design is to determine the camber shape and twist distribution such that an objective function, typically the drag, is minimized, subject to various constraints.

Lan, C. E.↗
NASA NTRS1983

Calculation of wing response to gusts and blast waves with vortex lift effect

A numerical study of the response of aircraft wings to atmospheric gusts and to nuclear explosions when flying at subsonic speeds is presented. The method is based upon unsteady quasi-vortex-lattice method, unsteady suction analogy, and Pade approximate. The calculated results, showing vortex lag effect, yield reasonable agreement with experimental data for incremental lift on wings in gust penetration and due to nuclear blast waves.

Chao, D. C.↗
NASA NTRS1983

A lifting surface theory in rotational flow

The partial differential equation for small disturbance steady rotational flow in three dimensions is solved through an integral equation approach. The solution is obtained by using the method of weighted residuals. Specific applications are directed to wings in nonuniform subsonic parallel streams with velocity varying in vertical and spanwise directions and to airfoils in nonuniform freestream. Comparison with limited known results indicates that the present method is reasonably accurate. Numerical results for the lifting pressure of airfoil, lift, induced drag, and pitching moments of airfoil, lift, induced drag, and pitching moments of elliptic, rectangular, and delta wings in a jet, wake, or monotonic sheared stream are presented. It is shown that, in addition to the effect of local dynamic pressures, a positive velocity gradient tends to enhance the lift.

Shiau, M. J.↗