Engineering topics
Johnston, A. H.
Publications and source records attributed to Johnston, A. H..
Latent damage from single-event latchup
Explore the source record for details and available documents.
Study of catastrophic latchup in the DSP2100 signal processor chip for MLS
This report summarizes the results of a series of tests to characterize catastrophic radiation-induced latchup in the DSP2100, which is used in three different applications on MLS.
Space radiation effects in advanced flash memories
This paper discusses the space radiation effects in advanced flash memories.
Space Radiation Effects in Advanced Flash Memories
Memory storage requirements in space systems have steadily increased, much like storage requirements in terrestrial systems. Large arrays of dynamic memories (DRAMs) have been used in solid-state recorders, relying on a combination of shielding and error-detection-and correction (EDAC) to overcome the extreme sensitivity of DRAMs to space radiation. For example, a 2-Gbit memory (with 4-Mb DRAMs) used on the Clementine mission functioned perfectly during its moon mapping mission, in spite of an average of 71 memory bit flips per day from heavy ions. Although EDAC worked well with older types of memory circuits, newer DRAMs use extremely complex internal architectures which has made it increasingly difficult to implement EDAC. Some newer DRAMs have also exhibited catastrophic latchup. Flash memories are an intriguing alternative to DRAMs because of their nonvolatile storage and extremely high storage density, particularly for applications where writing is done relatively infrequently. This paper discusses radiation effects in advanced flash memories, including general observations on scaling and architecture as well as the specific experience obtained at the Jet Propulsion Laboratory in evaluating high-density flash memories for use on the NASA mission to Europa, one of Jupiter's moons. This particular mission must pass through the Jovian radiation belts, which imposes a very demanding radiation requirement.
Proton damage in advanced laser diodes
Damage from 50 MeV protons is investigated for several types of laser diodes with wavelengths from 650 to 1550 nm.
Heavy ion induced soft breakdown of thin gate oxides
Heavy ion induced soft and hard breakdown are investigated in thin gate oxides as a function of LET, fluence, and voltage applied during irradiation. It is found that post-irradiation oxide conduction is well described by the Sune quantum point contact model.
Radiation test requirements for ionization and displacement damage
This paper discusses radiation testing requirements for ionization and displacement damage in space systems.
Scaling and technology issues for soft error rates
Th effects of device technology and scaling on soft error rates are discussed, using information obtained from both the device and space communities as a guide to determine the net effect on soft errors.
Radiation damage of electronic and optoelectronic devices in space
The effects of radiation damage on modern electronic and optoelectronics is discussed.
Proton displacement damage in light-emitting and laser diodes
The effects of proton displacement damage on light-emitting diodes and laser diodes are discussed, comparing the radiation sensitivity of current technology devices with older devices for which data exists in the literature.
Displacement Damage in Bipolar Linear Integrated Circuits
Although many different processes can be used to manufacture linear integrated circuits, the process that is used for most circuits is optimized for high voltage -- a total power supply voltage of about 40 V -- and low cost. This process, which has changed little during the last twenty years, uses lateral and substrate p-n-p transistors. These p-n-p transistors have very wide base regions, increasing their sensitivity to displacement damage from electrons and protons. Although displacement damage effects can be easily treated for individual transistors, the net effect on linear circuits can be far more complex because circuit operation often depends on the interaction of several internal transistors. Note also that some circuits are made with more advanced processes with much narrower base widths. Devices fabricated with these newer processes are not expected to be significantly affected by displacement damage for proton fluences below 1 x 10(exp 12) p/sq cm. This paper discusses displacement damage in linear integrated circuits with more complex failure modes than those exhibited by simpler devices, such as the LM111 comparator, where the dominant response mode is gain degradation of the input transistor. Some circuits fail catastrophically at much lower equivalent total dose levels compared to tests with gamma rays. The device works satisfactorily up to nearly 1 Mrad(Si) when it is irradiated with gamma rays, but fails catastrophically between 50 and 70 krad(Si) when it is irradiated with protons.
Proton Damage in Linear and Digital Optocouplers
Optocoupler failures occurred on the Topex-Poseidon spacecraft after about two years of operation. Later work in the laboratory showed that the failures were due to extreme sensitivity of LEDs within the optocouplers to displacement damage from protons. Although earlier work had been done on displacement damage in light-emitting diodes, none of the devices studied previously had been heavily damaged at the low radiation levels where the optocouplers failed in space. Subsequent work has shown that LED damage varies over an extremely wide range, depending on the particular manufacturing technology. This paper discusses proton degradation of linear and digital optocouplers. One obvious way to harden optocoupler technologies is to select LEDs that are more resistant to displacement damage. A direct comparison is made of degradation of a commercial linear optocoupler from one manufacturer with a modified version of the same device with a different LED technology. Other factors, including degradation of optical photoresponse and transistor -ain are also discussed, along with basic comparisons of digital and analog optocouplers. Linear optocouplers are designed with somewhat different requirements than digital optocouplers, which not only affects their radiation response but also the interpretation of radiation test data.
Space Radiation Effects and Hardness Assurance for Linear Integrated Circuits
New effects that complicate the application of linear devices in space are discussed, including enhanced damage at low dose rate and proton damage, which cause permanent degradation. Transients produced by protons and heavy ions are also discussed.
Angular and Energy Dependence of Proton Upset in Optocouplers
Proton upset effects in optocouplers were reported by LaBel, et al. that showed an unexpected increase in cross section for incident angles above 80 degrees. Although it appeared that the angular dependence was related to direct ionization from protons, the angular dependence was weaker than expected from basic geometrical arguments using a shallow charge collection depth. Later work showed that the angular dependence of proton upset observed in the earlier studies at a single energy could be explained by considering the distribution of proton recoil energies along with the assumption of a deeper charge collection depth, which was consistent with upset tests from heavy ions. However, an experimental test of the underlying assumptions in the latter work has yet to be done. Protons in space not only arrive over a wide range of incident angles, but also involve a distribution of proton energies. It is necessary to understand both the angular dependence and the dependence of proton upset on energy in order to determine how optocouplers will respond in space. If the angular dependence only occurs for extreme angles of incidence, it will have little impact on the overall cross section because of the narrow acceptance angle. The present work examines mechanisms for proton upset in optocouplers in more detail, investigating the energy dependence and the effects of different load conditions. A model for proton upset is developed, along with a laboratory screening method to determine whether direct ionization is significant for specific device types.
A Compendium of Recent Optocoupler Radiation Test Data
We present a compendium of optocoupler radiation test data including neutron, proton and heavy ion Displacement Damage (DD), Single Event Transients (SET) and Total Ionizing Dose (TID). Proton data includes ionizing and non-ionizing damage mechanisms.
Radiation Effects on Advanced Flash Memories
Flash memories have evolved very rapidly in recent ears. New design techniques such as multilevel storage have been proposed to increase storage density, and are now available commercially. Threshold voltage distributions for single- and three-level technologies are compared. In order to implement this technology special circuitry must be added to allow the amount of charge stored in the floating gate to be controlled within narrow limits during the writing and also to detect the different amounts of charge during reading.
Comparison of Total Dose Responses on High Resolution Analog-to-Digital Converter Technologies
This paper compares total dose effects on two different technology (CMOS and BiCMOS) 12-bit ADCs from the same manufacturer, Burr-Brown.