Engineering Papers⌕ Search

Engineering topics

Hilton, D. A.

Publications and source records attributed to Hilton, D. A..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Flyover noise characteristics of a tilt-wing V/STOL aircraft (XC-142A)

A field noise measurement investigation was conducted during the flight testing of an XC-142A tilt-wing V/STOL aircraft to define its external noise characteristics. Measured time histories of overall sound pressure level show that noise levels are higher at lower airspeeds and decrease with increased speed up to approximately 160 knots. The primary noise sources were the four high-speed, main propellers. Flyover-noise time histories calculated by existing techniques for propeller noise prediction are in reasonable agreement with the experimental data.

Pegg, R. J.↗
NASA NTRS1974

Sonic-boom ground pressure measurements from the launch and reentry of Apollo 16

Sonic-boom pressure signatures recorded during the launch and reentry phases of the Apollo 16 mission are presented. Five measurements were obtained along the vehicle ground track: 69 km (37.3 n. mi.) 92 km (49.8 n. mi.), and 130 km (70.3 n. mi.) down range from the launch site during ascent, and at 185 km (100 n. mi.) and approximately 5.5 km (3 n. mi.) from the splash-down point during reentry. Tracings of the measured signatures are included along with values of the overpressure, impulse, time duration, and rise times. Also included are brief descriptions of the launch and recovery test areas in which the measurements were obtained, the sonic-boom instrumentation deployment, flight profiles, and operating conditions for the launch vehicle and spacecraft, surface weather information at the measuring sites, and high-altitude weather information for the general measurement areas. Comparisons of the sonic-boom overpressures from Apollo 15 and 16 along with those from current aircraft are also presented.

Henderson, H. R.↗
NASA NTRS1974

Measurements of sonic-boom overpressures from Apollo space vehicles

This paper presents representative results of sonic-boom overpressure data recorded during the launch and reentry of the Apollo 15 and 16 space vehicle systems. Comparisons are made between measured overpressures and those predicted using available theory. The measurements were obtained along the vehicle ground track at 68, 87, 92, 129, and 970 km downrange from the launch site during ascent, and at 9, 13, 55, 185, and 500 km from the splash-down point during reentry. Also included are tracings of the sonic-boom signatures along with a brief description of the launch and recovery test areas in which the measurements were obtained, the sonic-boom instrumentation deployment, flight profiles and operating conditions, and high-altitude weather information for the general measurement areas.

Hilton, D. A.↗
NASA NTRS1974

Comparison of acoustic performance of five muffler configurations on a small helicopter

A field noise measurement program has been conducted on a standard Bell 47 series helicopter and on one that had been modified with specially designed, airframe-mounted mufflers to reduce the engine exhaust noise. The purpose of the study was to evaluate the acoustic performance of five experimental exhaust muffler configurations for a helicopter reciprocating engine in an operational environment. All muffler configurations produced beneficial engine exhaust noise reductions but some configurations were markedly better than others. Flyover noise results indicated that maximum overall noise reductions of approximately 8 db were obtained with the various mufflers. The rotor noise was judged to be the dominant noise component for the muffler-equipped helicopters whereas the engine noise was the dominant component for the basic configuration.

Pegg, R. J.↗
NASA NTRS1974

The noise environment of a school classroom due to the operation of utility helicopters

Noise measurements under controlled conditions have been made inside and outside of a school building during flyover operations of four different helicopters. The helicopters were operated at a condition considered typical for a police patrol mission. Flyovers were made at an altitude of 500 ft and an airspeed of 45 miles per hour. During these operations acoustic measurements were made inside and outside of the school building with the windows closed and then open. The outside noise measurements during helicopter flyovers indicate that the outside db(A) levels were approximately the same for all test helicopters. For the windows closed case, significant reductions for the inside measured db(A) values were noted for all overflights. These reductions were approximately 20 db(A); similar reductions were noted in other subjective measuring units. The measured internal db(A) levels with the windows open exceeded published classroom noise criteria values; however, for the windows-closed case they are in general agreement with the criteria values.

Hilton, D. A.↗
NASA NTRS1973

Results of the flight noise measurement program using a standard and modified SH-3A helicopter

A field noise measurement program has been conducted using both a standard SH-3A helicopter and an SH-3A helicopter modified to reduce external noise levels. Modifications included reducing rotor speed, increasing the number of rotor blades, modifying the blade-tip shapes, and acoustically treating the engine air intakes and exhaust. The purpose of this study was to document the noise characteristics recorded on the ground of each helicopter during flyby, hover, landing, and take-off operations. Based on an analysis of the measured results, the average of the overhead, overall, ontrack noise levels was approximately 4 db lower for the modified helicopter than for the standard helicopter. The improved in-flight noise characteristics, and associated small footprint areas and time durations, were judged to be mainly due to tail-rotor noise reductions. The noise reductions were obtained at the expense of required power increases at airspeeds greater than 70 knots for the modified helicopter.

Pegg, R. J.↗
NASA NTRS1973

Results of the noise measurement program on a standard and modified OH-6A helicopter

A field noise measurement program has been conducted on a standard OH-6A helicopter and one that had been modified by reducing the rotor speed, altering rotor tip shape, and treating the engine exhaust and inlet to reduce the external noise levels. The modifications consisted of extensive aircraft design changes resulting in substantial noise reductions following state-of-art noise reduction techniques. The purpose of this study was to document the ground noise characteristics of each helicopter during flyover, hover, landing, and take-off operations. Based on an analysis of the measured results, the average of the overall on-track noise levels of the final modified helicopter was approximately 14 db lower than that for the standard helicopter. Narrow-band-spectra data of the hovering helicopter show a reduction in the overall noise due to the reductions achieved for the lifting main and antitorque tail rotor, engine exhaust, and gear box noise for the modified helicopter. The noise results of the test program are found to correlate generally with noise measurements made previously on this type of aircraft.

Henderson, H. R.↗
NASA NTRS1973

Rotating-blade vortex noise

An experimental investigation has been made of the Langley full-scale tunnel and outdoors to investigate some of the characteristics of vortex noise generated on a rotating-blade system. Acoustic measurements were made at several microphone positions for two different blade sections with several tip shapes and spoiler configurations. The blades were operated only at zero lift at each radial station, both for operating in their own wake and for operating with the wake blown downstream. Rotors with cylindrical blades generally created more noise throughout the noise spectrum than the rotor with NACA 0012 blades. Blowing the shed wake from the rotor with cylindrical blades did not have an appreciable effect on the frequency-amplitude spectrum. The tip shape changes had very little effect on the frequency-amplitude spectrum of the noise. Spoilers applied to the rotor with NACA 0012 blades increased the amplitude of the spectrum and decreased the number of harmonics of blade passage frequency.

Scheiman, J.↗
NASA NTRS1972

Sonic-boom ground-pressure measurements from Apollo 15

Sonic boom pressure signatures recorded during the launch and reentry phases of the Apollo 15 mission are presented. The measurements were obtained along the vehicle ground track at 87 km and 970 km downrange from the launch site during ascent; and at 500 km, 55.6 km, and 12.9 km from the splashdown point during reentry. Tracings of the measured signatures are included along with values of the overpressure, impulse, time duration, and rise times. Also included are brief descriptions of the launch and recovery test areas in which the measurements were obtained, the sonic boom instrumentation deployment, flight profiles and operating conditions for the launch vehicle and spacecraft, surface weather information at the measuring sites, and high altitude weather information for the general measurement areas.

Hilton, D. A.↗
NASA NTRS1971

Ground noise measurements during landing, take-off, and flyby operations of a four-engine turbopropeller STOL airplane

Noise measurements were obtained for a four-engine turbopropeller STOL airplane during a Federal Aviation Administration flight evaluation program at the National Aviation Facilities Experimental Center. These noise measurements involved landing-approach, takeoff-climbout, and flyby operations of the airplane. A total of 13 measuring positions were used to define the noise characteristics around a simulated STOL port. The results are presented in the form of both physical and subjective measurements. An appendix is included to present tabulated values of various subjective reaction units which may be significant for the planning and operation of STOL ports. The main source of noise produced by this vehicle was found to be the propeller, and noise levels decrease generally in accordance with the inverse-distance law for distances up to about 457 meters. For similar slant ranges, somewhat lower noise levels were experienced during flyby than during takeoff or landing.

Hilton, D. A.↗