Engineering topics

Hilton, D. A.

Publications and source records attributed to Hilton, D. A..

At least 19 records

NASA NTRS1979

Ground effects on aircraft noise

A flight experiment was conducted to investigate air-to-ground propagation of sound near grazing incidence. A turbojet-powered aircraft was flown at low altitudes over the ends of two microphone arrays. An eight-microphone array was positioned along a 1850 m concrete runway. The second array consisted of 12 microphones positioned parallel to the runway over grass. Twenty-eight flights were flown at altitudes ranging from 10 m to 160 m. The acoustic data recorded in the field reduced to one-third-octave band spectra and time correlated with the flight and weather information. A small portion of the data was further reduced to values of ground attenuation as a function of frequency and incidence angle by two different methods. In both methods, the acoustic signals compared originated from identical sources. Attenuation results obtained by using the two methods were in general agreement. The measured ground attenuation was largest in the frequency range of 200 to 400 Hz. A strong dependence was found between ground attenuation and incidence angle with little attenuation measured for angles of incidence greater than 10 to 15 degrees.

Willshire, W. L., Jr.↗

NASA NTRS1979

Statistical comparisons of aircraft flyover noise adjustment procedures for different weather conditions

Aircraft flyover noise spectra and effective perceived noise level (EPNL) values obtained under widely different weather conditions were adjusted according to a proposed national standard. The results were statistically compared with the same measured spectra adjusted according to an alternate procedure and with reference spectra and EPNL values obtained under almost ideal weather conditions. Three different ways to represent the weather condition through which the sound propagated were also evaluated.

Mueller, A. W.↗

NASA NTRS1978

The effect of operations on the ground noise footprints associated with a large multibladed, nonbanging helicopter

In order to expand the data base of helicopter external noise characteristics, a flyover noise measurement program was conducted utilizing the NASA Civil Helicopter Research Aircraft. The remotely operated multiple array acoustics range (ROMAAR) and a 2560-m linear microphone array were utilized for the purpose of documenting the noise characteristics of the test helicopter during flyby and landing operations. By utilizing both ROMAAR concept and the linear array, the data necessary to plot the ground noise footprints and noise radiation patterns were obtained. Examples of the measured noise signature of the test helicopter, the ground noise footprint or contours, and the directivity patterns measured during level flyby and landing operations of a large, multibladed, nonbanging helicopter, the CH-53, are presented.

Hilton, D. A.↗

NASA NTRS1978

An acoustic range for the measurement of the noise signature of aircraft during flyby operations

The remotely operated multiple array acoustic range (ROMAAR), which has been developed to give direct measurement and display of aircraft noise in several measurement units during takeoff, landing, and flyby operations, is described. The ROMAAR, which provides information on the ground noise signature of aircraft, represents a unique combination of state-of-the-art digital and analog noise-recording methods, computer-controlled digital communication methods, radar tracking facilities, quick-look weather (profile) capabilities, and sophisticated data handling routines and facilities. The ROMAAR, which is operated by NASA, allows direct data feedback to the NASA Aircraft Noise Prediction Office. As many as 38 simultaneous noise measurements can be made for each aircraft overflight.

Hilton, D. A.↗

NASA NTRS1977

Near noise field characteristics of Nike rocket motors for application to space vehicle payload acoustic qualification

Results of a series of noise measurements that were made under controlled conditions during the static firing of two Nike solid propellant rocket motors are presented. The usefulness of these motors as sources for general spacecraft noise testing was assessed, and the noise expected in the cargo bay of the orbiter was reproduced. Brief descriptions of the Nike motor, the general procedures utilized for the noise tests, and representative noise data including overall sound pressure levels, one third octave band spectra, and octave band spectra were reviewed. Data are presented on two motors of different ages in order to show the similarity between noise measurements made on motors having different loading dates. The measured noise from these tests is then compared to that estimated for the space shuttle orbiter cargo bay.

Hilton, D. A.↗

NASA NTRS1977

Observed variability of aircraft noise footprint measurements

A description is presented of some measurements which illustrate the variability of the experimentally developed ground noise footprints for a series of landing approach operations of a turbojet aircraft and a turbine powered helicopter. Measurements on the recently developed NASA Remotely Operated Multiple Array Acoustic Range are considered. The information presented is related to a turbojet fighter aircraft and a turbine powered helicopter performing landing approach operations along a 3 deg approach path. Each vehicle was acquired on radar tracking approximately 10 kilometers from the touchdown point and entered the test area at an altitude of about 470 m. The measured variations in meteorological quantities for the two time periods during which these tests were conducted are presented in graphs. Other graphs show the ground noise contour for the turbojet aircraft and the turbine helicopter.

Maglieri, D. J.↗

NASA NTRS1976

A Remotely Operated Multiple Array Acoustic Range (ROMAAR) and its application for the measurement of airplane flyover noise footprints

The ROMAAR now in operation at NASA will allow direct measurement and display of aircraft noise in several measurement units during takeoff, landing, and flyby operations. This information, in addition to its application in terms of ground noise footprints, will also permit determination of the statistical variation of footprints or contours due to the atmosphere or aircraft operational parameters, and a measure of the impact of various noise reduction techniques and hardware on ground noise footprints. The methods, techniques, and equipment developed for the ROMAAR concept are applicable to CTOL, STOL, General Aviation, and VTOL aircraft. ROMAAR represents a unique combination of state of the art digital and analog noise recording methods, computer-controlled digital communications methods, radar-tracking facilities, quick-look weather capabilities, and a large data handling facility complemented by a large capacity curve fitting and plotting routine. The ROMAAR is set apart from the standard airport noise monitoring system by having the unique features mentioned above plus the fact that at present as many as 38 separate (but simultaneous) noise measurements can be made for each aircraft overflight.

Hilton, D. A.↗

NASA NTRS1975

Some effects of the atmosphere and microphone placement on aircraft flyover noise measurements

The effects of varying atmospheric conditions on certification-type noise measurements were studied. Tests were made under various atmospheric conditions at two test sites, Fresno, California, and Yuma, Arizona, using the same test aircraft, noise, and weather measuring equipment, and operating personnel. Measurements were made to determine the effects of the atmosphere and of microphone placement on aircraft flyover noise. The measurements were obtained for characterization of not only the acoustic signature of the test aircraft, but also specific atmospheric characteristics. Data are presented in the form of charts and tables which indicate that for a wide range of weather conditions, at both site locations, noise data were repeatable for similar aircraft operating conditions. The placement of microphones at ground level and at 1.2 m over both spaded sand and concrete illustrate the effects of ground reflections and surface impedance on the noise measurements.

Hosier, R. N.↗

NASA NTRS1975

Noise reduction studies for the U-10 airplane

A study was undertaken by the NASA Langley Research Center to determine the noise reduction potential of the U-10 airplane in order to reduce its aural detection distance. Static and flyover noise measurements were made to document the basic airplane noise signature. Two modifications to the airplane configuration are suggested as having the best potential for substantially reducing aural detection distance with small penalty to airplane performance or stability and control. These modifications include changing the present 3-blade propeller to a 5-blade propeller, changing the propeller diameter, and changing the propeller gear ratio, along with the use of an engine exhaust muffler. The aural detection distance corresponding to normal cruising flight at an altitude of 1,000 ft over grassy terrain is reduced from 28,000 ft (5.3 miles) to about 50 percent of that value for modification 1, and to about 25 percent for modification 2. For the aircraft operating at an altitude of 300 ft, the analysis indicates that relatively straightforward modifications could reduce the aural detection distance to approximately 0.9 mile. Operation of the aircraft at greatly reduced engine speed (1650 rpm) with a 1.3-cu-ft muffler provides aural detection distances slightly lower than modification 1.

Hilton, D. A.↗

NASA NTRS1975

Noise reduction studies for the Cessna model 337 (0-2) airplane

A study was undertaken to determine the noise reduction potential of the 0-2 airplane in order to reduce its aural detection distance. Static and flyover noise measurements were made to document the noise signature of the unmodified airplane. The results show that significant reductions in aural detection distance can be achieved by the combination of propeller geometry changes and the addition of engine exhaust mufflers. The best results were estimated for the aircraft equipped with a six-blade propeller operating at 3/4 engine speed in combination with a 3.49 cubic foot exhaust muffler installed on each engine. Detection distance for the modified aircraft is estimated to be reduced from about 4-1/4 miles to about 1-1/2 miles when the aircraft is operating at an altitude of 1,000 ft over grassy terrain. Reducing the altitude to 300 ft over a leafy jungle ground cover should reduce the aural detection distance to 0.9 miles. Reduced aural detection distances were also indicated for a modification utilizing a direct-drive six-blade propeller of reduced radius along with smaller exhaust mufflers.

Hilton, D. A.↗

NASA NTRS1975

Noise reduction studies for the OV-1 airplane

A study has been conducted to define possible modifications to the OV-1 aircraft to reduce its aural detection distance. This effort involved documenting the noise characteristics of the airplane, devising modifications to reduce the noise, estimating the reduction in detection distance, and evaluating aircraft performance as a result of these modifications. It was found that the main noise source on this aircraft is the propeller and hence modifications only to the propeller and the propeller drive system are proposed. Modifications involving only the propeller are noted to involve no increase in weight but they result in only a modest decrease in aural detection distance. In order to obtain substantial decreases in aural detection distance, modifications involving changes both to the propeller and the engine-propeller gearing are required.

Hilton, D. A.↗

NASA NTRS1975

Noise characteristics of the O-1 airplane and some approaches to noise reduction

A brief study of the O-1A airplane to determine possible means for reducing the aircraft aural detection distance was conducted. This effort involved measuring the noise signature of the basic airplane, devising methods to attenuate the noise, and then estimating the effect of several selected modifications on the aural detection distance of the aircraft. A relatively simple modification utilizing a 6.5 ft diameter, six-blade propeller and including a muffler having a volume of 0.725 cu ft is indicated to reduce the aural detection distance of the O-1 aircraft from about 6 miles at an altitude of 1,000 ft and 2 to 3 miles at an altitude of 300 ft to approximately half these values. The flyover noise data suggest that routing the exhaust stacks up and over the wing would provide immediate noise reduction of about 5 dB with an attendant reduction in detection distance. Furthermore, all these studies confirm the work of other investigators that the 1/3 octave band (center frequency=125 cps) is the most critical in reducing aural detection distance.

Connor, A. B.↗

NASA NTRS1975

Ground noise measurements during static and flyby operations of the Cessna 02-T turbine powered airplane

The field noise measurements on the Cessna 02-T turbine powered propeller aircraft are presented. The objective of the study was to obtain the basic noise characteristics of the aircraft during static ground runs and flyover tests, to identify the sources of the noise, and to correlate the noises with the aircraft operating conditions. The results are presented in the form of a overall noise levels, radiation patterns, and frequency spectra. The noise characteristics of the turbine powered aircraft are compared with those of the reciprocating engine powered aircraft.

Hilton, D. A.↗

NASA NTRS1975

Noise reduction studies of several aircraft to reduce their aural detection distances

A study was conducted to assess the extent to which practicable reductions of the external noise level of various aircraft could be achieved by different methods. The aircraft included in the study are the O-1, O-2, U-10, OV-1, and A-6. The noise signatures obtained from field measurements and the estimated aural detection distance of aircraft operating in low speed cruising flight are presented. The characteristics of each aircraft and the modifications made to reduce the aerodynamic noise are explained. Tables of data are included to show the effectiveness of the noise reduction modifications for each aircraft.

Dingeldein, R. C.↗

NASA NTRS1975

A noise study of the A-6 airplane and techniques for reducing its aural detection distance

A study was undertaken to determine the noise reduction potential of the A-6 airplane in order to reduce its aural detection distance. Static and flyby noise measurements were taken to document the basic airplane signature. The low-frequency noise which is generally most critical for aural detection was found to be broad-band in nature from this airplane, and its source is the turbojet engine exhaust. High-frequency compressor noise, which is characteristic of turbojet powerplants, and which is prominent at close range for this airplane, has no measurable effect on aural detection distance. The use of fluted-engine exhaust nozzles to change the far-field noise spectra is suggested as a possible means for reducing the aural detection distances. Detection distances associated with eight-lobe and four-lobe nozzles are estimated for a 1,000-foot altitude and grassy terrain to decrease from 4 miles to about 3 miles, and from 3 miles to about 2 miles for a 300-foot altitude and grassy terrain.

Hilton, D. A.↗

NASA NTRS1975

Thickness noise of helicopter rotors at high tip speeds

A new formulation of helicopter rotor thickness, noise for hover and forward flight, is discussed. The parameters required for this formulation are rotor motion, planform and airfoil thickness distribution. A computer program has been developed to calculate the pressure signature due to blade thickness for a helicopter in arbitrary motion. Comparison with high-speed helicopter tests shows good agreement with calculations when the observer is in or near the horizontal plane in which the rotor disk lies. Characteristics of thickness noise are illustrated by numerical examples indicating strongly that the high-speed blade slap may be due primarily to the thickness effect. The methods of Deming and Arnoldi are discussed as the special cases of this technique.

Farassat, F.↗

NASA NTRS1975

Thickness Noise of Helicopter Rotors at High Tip Speeds

A new formulation of helicopter rotor thickness, noise for hover and forward flight, is discussed. The parameters required for this formulation are rotor motion, planform and airfoil thickness distribution. A computer program has been developed to calculate the pressure signature due to blade thickness for a helicopter in arbitrary motion. Comparison with high-speed helicopter tests shows good agreement with calculations when the observer is in or near the horizontal plane in which the rotor disc lies. Characteristics of thickness noise are illustrated by numerical examples indicating strongly that the high-speed blade slap may be due primarily to the thickness effect. The methods of Deming and Arnoldi are discussed as the special cases of this technique.

Farassat, F.↗

NASA NTRS1974

Sonic-boom measurements in the focus region during the ascent of Apollo 17

Sonic-boom pressure signatures recorded during the ascent phase of Apollo 17 are presented. The measurements were obtained onboard six U.S. Navy ships positioned along the ground track of the spacecraft vehicle in the area of expected focus resulting from the flight path and acceleration of the vehicle. Tracings of the measured signatures are presented along with values of the maximum positive overpressure, positive impulse, signature duration, and bowshock rise time. Also included are brief descriptions of the ships and their location, the deployment of the sonic-boom instrumentation, flight profiles and operating conditions for the launch vehicle and spacecraft, surface-weather and sea-state information at the measuring sites, and high-altitude weather information for the general measurement areas. Comparisons of the measured and predicted sonic-boom overpressures for the Apollo 17 mission are presented. The measured data are also compared with data from the Apollo 15 and 16 missions and data from flight test programs of various aircraft.

Henderson, H. R.↗