Engineering Papers⌕ Search

Engineering topics

Hays, J. F.

Publications and source records attributed to Hays, J. F..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Origin of titaniferous lunar basalts

Delineation of low pressure phase equilibria in the composition space relevant to titaniferous lunar basalts demonstrates a significant degree of control by those equilibria on the compositions of the basalts. The existence of two distinct chemical groups of basalts (high and low K) which cannot be related one to the other by fractional crystallization at any pressure, suggests that melting is responsible for the two groups. Consideration of the pressure shift required to produce the differences between groups constrains magma segregation to have occurred in the outer 150 km of the moon. It is difficult to relate low-Ti and high-Ti basalts to the same source region. The preferred source region of high-Ti basalts, based on phase equilibrium considerations, is a late ilmenite-rich cumulate produced from the residual liquid of the primordial differentiation of the outer portions of the moon. This ilmenite-rich layer is sandwiched between the lunar feldspathic crust and a complementary mafic cumulate.

Walker, D.↗
NASA NTRS1975

Melting behavior and phase relations of lunar samples

Cooling rate studies of 12002 were conducted and the results interpreted in terms of the crystallization history of this rock and certain other picritic Apollo 12 samples. Calculations of liquid densities and viscosities during crystallization, crystal settling velocities, and heat loss by the parent rock body are discussed, as are petrographic studies of other Apollo 12 samples. The process of magmatic differentiation that must have accompanied the early melting and chemical fractionation of the moon's outer layers was investigated. The source of regions of both high- and low-titanium mare basalts were also studied.

Hays, J. F.↗
NASA NTRS1975

Differentiation of a very thick magma body and implications for the source regions of mare basalts

Mass-balance calculations indicate that the molten layer originally covering the moon may have been several hundred kilometers deep. The solidification of this magma ocean involved some unusual effects resulting from the large-pressure differential in the thick magma layer. The sunken cumulates from this differentiation would be more iron-rich, less refractory, and would contain more incompatible elements than would be expected in simple isobaric fractional crystallization and crystal sinking models of magma differentiation. These lower cumulates can have the mineralogical and chemical properties of the source regions of the low-Ti mare basalts.

Walker, D.↗
NASA NTRS1974

Lunar igneous rocks and the nature of the lunar interior

Lunar igneous rocks are interpreted, which can give useful information about mineral assemblages and mineral chemistry as a function of depth in the lunar interior. Terra rocks, though intensely brecciated, reveal, in their chemistry, evidence for a magmatic history. Partial melting of feldspathic lunar crustal material occurred in the interval 4.6 to 3.9 gy. Melting of ilmenite-bearing cumulates at depths near 100 km produced parent magmas for Apollo 11 and 17 titaniferous mare basalts in the interval 3.8 to 3.6 gy. Melting of ilmenite-free olivine pyroxenites at depths greater than 200 km produced low-titanium mare basalts in the interval 3.4 to 3.1 gy. No younger igneous rocks have yet been recognized among the lunar samples and present-day melting seems to be limited to depths greater than 1000 km.

Hays, J. F.↗
NASA NTRS1974

The petrology of the Apollo 17 mare basalts

Petrographic studies of Apollo 17 mare basalts indicate that 70215 and 71569 arrived at the lunar surface as liquids. Low-pressure melting experiments show that compositional variations within the Apollo 17 and Apollo 11 ophitic basalt suites may be generated by near-surface fractional crystallization of liquids with compositions similar to 70215 and 70017. High-pressure melting experiments show that liquids similar in composition to 70017 and 70215 can be generated by partial melting of an olivine+clinopyroxene+Fe-Ti-oxide source at depths of 100-150 km within the moon.

Longhi, J.↗
NASA NTRS1973

Origin of lunar feldspathic rocks

Melting experiments and petrographic studies of lunar feldspathic rocks reveal possible genetic relationships among several compositionally and mineralogically distinct groups of lunar rocks and soil fragments. Dry, low PO2 partial melting of crustal anorthositic norites of the anorthositic-noritic-troctolitic (ANT) suite produces liquids of the KREEP-Fra Mauro basalt type; dry, low PO2 partial melting of pink spinel troctolite (PST) produces liquids of the 'very high alumina basalt' or microtroctolite type. Both ANT and PST are probable components of the primitive terra crust. If crystal fractionation in a cooling basaltic liquid could have produced such a crust, it would also produce a mafic interior capable of yielding mare basalts by later remelting at depth.

Walker, D.↗
NASA NTRS1973

Melting behavior and phase relations in the lunar interior

Phase equilibrium experiments at both high and low pressures on lunar samples and synthetic compositions are reported as well as related petrographic studies of lunar rock samples. The objectives were to trace the origins of rocks found on the lunar surface, to characterize the nature of the lunar interior and to locate and identify the sources of lunar magmas.

Hays, J. F.↗
NASA NTRS1973

Experimental petrology and origin of rocks from the Descartes Highlands

Petrographic studies of Apollo 16 samples indicate that rocks 62295 and 68415 are crystallization products of highly aluminous melts. 60025 is a shocked, crushed and partially annealed plagioclase cumulate. 60315 is a recrystallized noritic breccia of disputed origin. 60335 is a feldspathic basalt filled with xenoliths and xenocrysts of anorthosite, breccia, and anorthite. The Fe/(Fe+Mg) of plagioclase appears to be a relative crystallization index. Low pressure melting experiments with controlled Po2 indicate that the igneous samples crystallized at oxygen fugacities well below the Fe/FeO buffer. Crystallization experiments at various pressures suggest that the 62295 and 68415 compositions were produced by partial or complete melting of lunar crustal materials, and not by partial melting of the deep lunar interior.

Walker, D.↗
NASA NTRS1972

Experimental petrology and origin of Fra Mauro rocks and soil

Melting experiments over the pressure range 0 to 20 kilobars were conducted on Apollo 14 igneous rocks 14310 and 14072 and on comprehensive fines 14259. The mineralogy and textures of rocks 14310 and 14072 are presumed to be the result of near-surface crystallization. The chemical compositions of the samples show special relationships to multiply-saturated liquids in the system: anorthite-forsterite-fayalite-silica at low pressure. Partial melting of a lunar crust consisting largely of plagioclase, low calcium pyroxene, and olivine, followed by crystal fractionation at the lunar surface is proposed as a mechanism for the production of the igneous rocks and soil glasses sampled by Apollo 14.

Walker, D.↗
NASA NTRS1972

Radioactive heat sources in the lunar interior.

Published models for the moon's thermal history typically imply present day central temperatures far too high to be consistent with the recently proposed lunar temperature profile of Sonett et al. (1971). Furthermore, chemical data on Apollo samples show that the moon is depleted relative to chondrites in volatile elements, and possibly enriched relative to chondrites in refractory elements. Additional thermal models have therefore been investigated in order to set upper limits on lunar radioactivity consistent with the proposed temperature distribution. For an initially cold, uniform moon, devoid of potassium, a maximum uranium content of 23 parts per billion is inferred.

Hays, J. F.↗
NASA NTRS1972

Experimental petrology and origin of Fra Mauro rocks and soil.

Results of melting experiments over the pressure range from 0 to 20 kb on Apollo 14 igneous rocks 14310 and 14072, and on comprehensive fines 14259. It is found that low-pressure crystallization of rocks 14310 and 14072 proceeds as predicted from the textural relationships displayed by thin sections of these rocks. The mineralogy and textures of these rocks are the result of near-surface crystallization. The chemical compositions of these lunar samples all show special relationships to multiply saturated liquids in the system anorthite-forsterite-fayalite-silica at low pressure. Partial melting of a lunar crust consisting largely of plagioclase, low-calcium pyroxene, and olivine, followed by crystal fractionation at the lunar surface, is a satisfactory mechanism for the production of the igneous rocks and soil glasses sampled by Apollo 14. The KREEP component of other lunar soils, may have a similar origin.

Walker, D.↗
NASA NTRS1971

An interlaboratory comparison of piston-cylinder pressure calibration using the albite-breakdown reaction.

An attempt is made to compare pressure calibration methods among several laboratories in an unbiased way to produce some indication of the bandwidth of observations on the pressure of an equilibrium reaction where sources of discrepancy not resulting from pressure calibration are likely to have been eliminated. The reaction chosen is the breakdown of albite to jadeite and quartz under pressure.

Johannes, W.↗