Engineering Papers⌕ Search

Engineering topics

Hays, J. F.

Publications and source records attributed to Hays, J. F..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Melt segregation from partially molten source regions - The importance of melt density and source region size

An investigation is conducted regarding the changes expected in the density contrast between basic melts and peridotites with increasing pressure using the limited data available on the compressibilities of silicate melts and data on the densities of mantle minerals. It is concluded that since compressibilities of silicate melts are about an order of magnitude greater than those of mantle minerals, the density contrast between basic melts and mantle minerals must diminish significantly with increasing pressure. An earlier analysis regarding the migration of liquid in partially molten source regions conducted by Walker et al. (1978) is extended, giving particular attention to the influence of the diminished density contrast between melt and residual crystals with increasing source region depth and to the influence of source region size. This analysis leads to several generalizations concerning the factors influencing the depths at which magmas will segregate from their source regions and the degrees of partial melting that can be achieved in these source regions before melt segregation occurs.

Stolper, E.↗
NASA NTRS1980

The mechanism of growth of quartz crystals into fused silica

It is proposed that the growth of quartz crystals into fused silica is effected by a mechanism involving the breaking of an Si-O bond and its association with an OH group, followed by cooperative motion of the nonbridging oxygen and the hydroxyl group which results in the crystallization of a row of several molecules along a crystalline-amorphous interfacial ledge. This mechanism explains, at least qualitatively, all the results of the earlier experimental study of the dependence of quartz crystal growth upon applied pressure: large negative activation volume; single activation enthalpy below Si-O bond energy; growth velocity constant in time, proportional to the hydroxyl and chlorine content, decreasing with increasing degree of reduction, and enhanced by nonhydrostatic stresses; lower pre-exponential for the synthetic than for the natural silica.

Fratello, V. J.↗
NASA NTRS1980

Dependence of growth rate of quartz in fused silica on pressure and impurity content

The effects of pressure, temperature, and some variations in impurity content on the growth rate u of quartz into fused silica were measured. Under all conditions the growth rate was interface controlled and increased exponentially with pressure with an activation volume averaging -21.2 cu cm/mole. The activation enthalpy for all specimens is extrapolated to a zero pressure value of 64 kcal/mole, within the experimental uncertainty. At a given stoichiometry the effect of hydroxyl content on growth rate is described entirely by a linear term C(OH) in the prefactor of the equation for the growth rate. The effect of chlorine impurity can be described similarly. Also u is increased as the ideal stoichiometry is approached from the partially reduced state.

Fratello, V. J.↗
NASA NTRS1980

Controlled cooling and crystallization of a eucrite - Microprobe studies

The paper presents microprobe data on controlled cooling experiments on the eucrite meteorite Stannern, with emphasis on pyroxene zoning and chemistry, development of immiscible liquids in the mesostasis, and compositional boundary layer development adjacent to crystals. Controlled cooling rate experiments on melted samples of the meteorite yield a variety of petrographic textures that can be related to the cooling rate. Textures of clasts in Stannern suggest natural cooling rates of .1 to 100 C/hr for various clasts in the meteorite. Residual liquids are found to unmix at temperatures below about 990 C at moderate cooling rates. Results indicate that Stannern's pyroxenes have evidently undergone subsolidus internal cation exchange, thereby removing Fe-Mg variation in pyroxenes, lowering Al contents, and promoting exosolution.

Powell, M. A.↗
NASA NTRS1979

Rates and processes of crystal growth in the system anorthite-albite

The growth rates and interface morphologies of crystals of synthetic compositions in the anorthite (CaAl2Si2O8)-albite (NaAlSi3O8) plagioclase feldspar system are measured in an investigation of the crystallization of igneous rocks. Mixed plagioclase glasses with compositions of 75% and 50% anorthite were observed using the microscope heating technique as they crystallized at temperatures near the liquidus, and 75%, 50% and 20% anorthite crystals were treated by resistance heating and observed at greater degrees of undercooling. Growth rates were found to be independent of time and to decrease with increasing albite content, ranging from 0.5 to 2 x 10 to the -5th cm/min. The crystal morphologies for all compositions are faceted near the liquidus and become progressively skeletal, dendritic and fibrillar with increasing undercooling.

Kirkpatrick, R. J.↗
NASA NTRS1979

A petrogenetic model of the relationships among achondritic meteorites

Petrological evidence is used to support the hypothesis that although the magma source regions and parent bodies of basaltic achondrite, shergottite, nakhlite, and chassignite meteorites are clearly distinct, they may be simply related. It is proposed that the peridotites which on partial melting generated the parent magmas of the shergottite meteorites differed from those which gave rise to eucritic magmas by being enriched in a component rich in alkalis and other volatiles. Similarly, the source regions of the parent magmas of the nakhlite and chassignite meteorites differed from those on the shergottite parent body by being still richer in this volatile-rich component. These regions could have been related by processes such as mixture of variable amounts of volatile-rich and volatile-poor components in planetary or nebular settings, or alternatively by variable varying degrees of volatile loss from volatile-rich materials.

Stolper, E.↗
NASA NTRS1979

Basaltic volcanism - The importance of planet size

The volumetrically abundant basalts on the earth, its moon, and the eucrite parent planet all have chemical compositions that are controlled to a large extent by dry, low-pressure, crystal-liquid equilibria. Since this generalization is valid for these three planetary bodies, we infer that it may also apply to the other unsampled terrestrial planets. Other characteristics of basaltic volcanism show variations which appear to be related to planet size: the eruption temperatures, degrees of fractionation, and chemical variety of basalts and the endurance of basaltic volcanism all increase with planet size. Although the processes responsible for chemical differences between basalt suites are known, no simple systematization of the chemical differences between basalts from planet to planet has emerged.

Walker, D.↗
NASA NTRS1978

A numerical treatment of melt/solid segregation - Size of the eucrite parent body and stability of the terrestrial low-velocity zone

Crystal sinking to form cumulates and melt percolation toward segregation in magma pools can be treated with modifications of Stokes' and Darcy's laws, respectively. The velocity of crystals and melt depends, among other things, on the force of gravity (g) driving the separations and the cooling time of the environment. The increase of g promotes more efficient differentiation, whereas the increase of cooling rate limits the extent to which crystals and liquid can separate. The rate at which separation occurs is strongly dependent on the proportion of liquid that is present. The observation of cumulates and segregated melts among the eucrite meteorites is used as a basis for calculating the g (and planet size) required to perform these differentiations. The eucrite parent body was probably at least 10-100 km in radius. The earth's low velocity zone (LVZ) is shown to be unstable with respect to draining itself of excess melt if the melt forms an interconnecting network. A geologically persistent LVZ with a homogeneous distribution of melt can be maintained with melt fractions only on the order of 0.1% or less.

Walker, D.↗
NASA NTRS1978

Dynamic crystallization of a eucrite basalt

The textural features produced in Stannern, a non-porpyritic representative of the eucrite basaltic achondrite class of meteorite, at differing cooling rates and various degrees of initial superheating were studied. Textures produced from mildly superheated melts were found to be fasciculate rather than porphyritic as the result of the cosaturated bulk chemistry of Stannern. The qualitative type of texture apparently depends mainly on the degree of initial superheating, whereas cooling rate exerts a strong influence on the coarseness of texture. Increasing the degree of superheating produces textures from intergranular/subophitic to fasciculate/porphyritic. With initial superheating to 1200 deg C the transition to quasi-porphyritic is controlled by cooling rate, but the development of phenocrysts is merely an overprint on the fasciculate background texture of the groundmass. The suppression of fasciculate texture is completed by a decrease of the degree of initial superheating below the plagioclast entry and suppression of quasi-porphyritic texture is completed by decrease of the degree of initial superheating below pyroxene entry; these qualitative changes do not seem to be produced by changes of cooling rate. A grain size/cooling rate dependence has been used to deduce the cooling rate of fasciculate-textured Stannern clasts (10.1 to 100 deg C/hr).

Walker, D.↗
NASA NTRS1977

Plagioclase flotation and lunar crust formation

Anorthitic plagioclase floats in liquids parental to the lunar highlands crust. The plagioclase enrichment that is characteristic of lunar highlands rocks can be the result of plagioclase flotation. Such rocks would form a gravitationally stable upper crust on their parental magma.

Walker, D.↗
NASA NTRS1977

Lunar igneous rocks and the nature of the lunar interior

Lunar igneous rocks, properly interpreted, can give useful information about mineral assemblages and mineral chemistry as a function of depth in the lunar interior. Though intensely brecciated, terra rocks reveal, in their chemistry, evidence for a magmatic history. Partial melting of feldspathic lunar crustal material occurred in the interval 4.6 to 3.9 Gy. Melting of ilmenite-bearing cumulates at depths near 100 km produced parent magmas for Apollo 11 and 17 titaniferous mare basalts in the interval 3.8 to 3.6 Gy. Melting of ilmenite-free olivine pyroxenites (also cumulates?) at depths greater than 200 km produced low-titanium mare basalts in the interval 3.4 to 3.1 Gy. No younger igneous rocks have yet been recognized among the lunar samples and present-day melting seems to be limited to depths greater than 1000 km.

Hays, J. F.↗
NASA NTRS1977

Slowly cooled microgabbros 15555 and 15065

An experimental study involving equilibration of Apollo 15 samples 15555 and 15065 in high-purity iron capsules is described. Comparison of mineral zoning trends with the experimental sequence suggests that the early crystallizing phases in the rock maintained surface equilibrium with the liquid. Olivine and pyroxene chemistry indicates that 15555 cooled slightly more rapidly than 15065, which cooled at approximately 0.2-0.3 C/day. It is suggested that 15065 and 15555 represent liquid compositions, and that these liquids appear to have been fractionated during ascent through the crust (15065), or to have been derived from an olivine-pyroxene source (15555) with Fe/(Fe + Mg) approximately equal to 0.73 at a depth between 150-200 km.

Walker, D.↗
NASA NTRS1976

Crystallization history of lunar picritic basalt sample 12002 - Phase-equilibria and cooling-rate studies

Experimental crystallization of a lunar picrite composition (sample 12002) at controlled linear cooling rates produces systematic changes in the temperature at which crystalline phases appear, in the texture, and in crystal morphology as a function of cooling rate. Phases crystallize in the order olivine, chromium spinel, pyroxene, plagioclase, and ilmenite during equilibrium crystallization, but ilmenite and plagioclase reverse their order of appearance and silica crystallizes in the groundmass during controlled cooling experiments. The partition of iron and magnesium between olivine and liquid is independent of cooling rate, temperature, and pressure. Comparison of the olivine nucleation densities in the lunar sample and in the experiments indicates that the sample began cooling at about 1 deg C/hr. Pyroxene size, chemistry, and growth instability spacings, as well as groundmass coarseness, all suggest that the cooling rate subsequently decreased by as much as a factor of 10 or more. The porphyritic texture of this sample, then, is produced at a decreasing, rather than a discontinuously increasing, cooling rate.

Walker, D.↗
NASA NTRS1976

Heterogeneity in titaniferous lunar basalts

Small but real chemical differences exist between subsamples of fine-grained quench-textured titaniferous lunar basalts. The existence of different textural domains with different chemistries is thought to account for most of this variation. In addition to the textural domains, lunar sample 74275 has a population of olivine 'megacrysts' as well as dunite fragments. These materials are thought to be extraneous and to compromise the primary nature of 74275. Recognition of the small chemical variations present may aid in understanding some discrepancies in the experimental-petrology literature. However, these small variations have a distressing petrogenetic significance since they severely limit resolution in recognizing the number and depth of origin of primary magmas.

Walker, D.↗
NASA NTRS1976

Melting behavior and phase relations of lunar samples

An attempt was made to show that feldspar would float during melting. Large anorthite crystals were placed beneath a silicate glass representative of liquid in which plagioclase accumulation is thought to have occurred. In less than 3 hours at 1,300 C, the crystals rose to the top in a Pt crucible 3 cm deep equilibrated in air and in a Mo crucible 1.5 cm deep equilibrated in an H2/CO2 gas stream of log PO2 = -10.9 (below Fe/FeO). These results suggest that lunar crustal formation by feldspar flotation is possible without special recourse to differential sinking of plagioclase versus mafic minerals or selective elutriation of plagioclase.

Hays, J. F.↗
NASA NTRS1976

Fe and Mg in plagioclase

Distribution coefficients for Fe and Mg between plagioclase and basaltic liquids were measured for lunar, terrestrial and synthetic systems. The data obtained imply that lunar anorthosites crystallized from relatively iron-rich liquids, that Fe/Mg zoning in plagioclase is an indicator of crystallization processes in basaltic magmas, and that Fe/Mg heterogeneity in plagioclase is a clue to the recognition of impact melts.

Longhi, J.↗
NASA NTRS1976

Differentiation of an Apollo 12 picrite magma

The Apollo 12 olivine basalt suite shows a strong positive correlation of grain size with normative olivine content. This correlation is interpreted to mean that the suite of samples represents the basal portion of a cooling unit which differentiated by simple olivine settling. The grain size of plagioclase observed in the coarsest samples indicates the cooling unit may have been as much as 30 m thick. The amount of olivine concentration observed in the suite is quantitatively internally consistent with simple olivine settling in a magma body of this size which has the composition of the chill margin.

Walker, D.↗