Engineering topics

Harris, Charles E.

Publications and source records attributed to Harris, Charles E..

57 records · Page 4

NASA NTRS1988

Analytical and experimental investigation of the notched strength of thick laminates with surface notches

Experimental and analytical investigations of the fracture of a graphite/epoxy laminate with part-through semielliptic surface notches have been conducted. Experimental values of notched strength were determined for a variety of notch aspect ratios and notch depths. Analytical predictions of laminate failure were obtained from three different models. The three models were equally successful in predicting the fracture of laminates with deep notches. The experimental results of laminates with shallow notches indicated more notch sensitivity (that is greater strength reduction) than did the analytical models.

Harris, Charles E.↗

NASA NTRS1988

An experimental investigation of the fracture behavior of thick, notched laminated composites

The fracture of high-modulus fiber-reinforced graphite/epoxy laminates with machined crack-like notches is discussed. An experimental program was conducted, in which stacking sequence,laminate thickness, notch size, and specimen configuration have been investigated. This research has led to the fundamental observation that heterogeneity significantly effects the fracture of thin laminates but has a relatively insignificant effect on the fracture of thick laminates. The results of this program are reviewed with the emphasis on the notch sensitivity and design of thick laminates.

Harris, Charles E.↗

NASA NTRS1987

A fractographic investigation of the influence of stacking sequence on the strength of notched laminated composites

The fracture behavior of T300/5208 CFRP laminate panels with 12 different combinations of ply orientation and stacking sequence is investigated experimentally, using optical microscopy, SEM, and X-ray radiography to characterize the notch-tip damage zones and fracture surfaces of center-cracked tension specimens subjected to tensile loading at constant crosshead displacement rate 20 micron/s. The results are presented graphically and analyzed in detail. Significant differences in notched strength are found for different ply fiber orientations and stacking sequences; the laminates with few major delaminations had a greater percentage of fracture due to broken fibers and also higher notched strength.

Harris, Charles E.↗