Engineering PapersSearch

Engineering topics

Fenimore, E.

Publications and source records attributed to Fenimore, E..

Prompt Emission Properties of Swift GRBs

We present the results from the second Swift BAT catalog of 476 gamma-ray bursts, which contains bursts detected by the BAT between 2004 December 19 and 2009 December 21. In addition to the spectral and temporal parameters extracted from the first BAT GRB catalog, 3324 time-resolved spectra have been extracted and analyzed. We show and discuss 1) the duration distribution, 2) the hardness of short GRBs, 3) Epeak distribution, 4) the line of death problem and 5) an additional power-law component in the prompt emission spectrum.

Sakamoto, T.

Global Properties of X-Ray Flashes and X-Ray-Rich GRBs Observed by Swift

We describe and discuss the spectral and temporal characteristics of the prompt emission and X-ray afterglow emission of X-ray flashes (XRFs) detected and observed by Swift between December 2005 and September 2006. We compare these characteristics to a sample of X-ray rich gamma-ray bursts (XRRs) and conventional classical gamma-ray bursts (C-GRBs)observed during the same period. We confirm the correlation between Epeak and fluence noted by others and find further evidence that XRFs and C-GRBs form a continuum. We also confirmed that our known redshift samples are consistent with the correlation between the peak energy (Epeak) and the isotropic radiated energy (Eiso), so called the Epeak-Eiso relation. The spectral properties of X-ray afterglows are similar to those of gamma-ray burst afterglows, but the temporal properties of the two classes are quite different. We found that the light curves of C-GRBs afterglow show a break to steeper indices (shallow-to-steep break) at much earlier times than do XRF afterglows. Moreover, the overall luminosity of X-ray afterglows of XRFs are systematically smaller by a factor of two or more compared with that of C-GRBs. These distinct differences in the X-ray afterglow between XRFs and C-GRBs are key to understanding not only a mysterious shallow-to-steep phase in the X-ray afterglow but also the unique nature of XRFs.

Sakamoto, T.

Swift Burst Alert Telescope (BAT) Instrument Response

The Burst Alert Telescope (BAT), a large coded aperture instrument with a wide field-of-view (FOV), provides the gamma-ray burst triggers and locations for the Swift Gamma-Ray Burst Explorer. In addition to providing this imaging information, BAT will perform a 15 keV - 150 keV all-sky hard x-ray survey based on the serendipitous pointings resulting from the study of gamma-ray bursts and will also monitor the sky for transient hard x-ray sources. For BAT to provide spectral and photometric information for the gamma-ray bursts, the transient sources and the all-sky survey, the BAT instrument response must be determined to an increasingly greater accuracy. In this talk, we describe the BAT instrument response as determined to an accuracy suitable for gamma-ray burst studies. We will also discuss the public data analysis tools developed to calculate the BAT response to sources at different energies and locations in the FOV. The level of accuracy required for the BAT instrument response used for the hard x-ray survey is significantly higher because this response must be used in the iterative clean algorithm for finding fainter sources. Because the bright sources add a lot of coding noise to the BAT sky image, fainter sources can be seen only after the counts due to the bright sources are removed. The better we know the BAT response, the lower the noise in the cleaned spectrum and thus the more sensitive the survey. Since the BAT detector plane consists of 32768 individual, 4 mm square CZT gamma-ray detectors, the most accurate BAT response would include 32768 individual detector response functions to separate mask modulation effects from differences in detector efficiencies! We describe OUT continuing work to improve the accuracy of the BAT instrument response and will present the current results of Monte Carlo simulations as well as BAT ground calibration data.

Parsons, A.

BASIS: A new GRB mission concept

The burst acrsecond imaging and spectroscopy (BASIS) mission concept is reviewed. The scientific objectives of the mission are to accurately locate bursts, determine their distance scale and measure the physical characteristics of the emission region. Arcsecond burst positions would be obtained for approximately 100 bursts/yr in the 10 to 200 keV emission region, allowing deep, unconfused counterpart surveys at other wavelengths. The key enabling technology development is the production of CdZnTe room temperature semiconductor detectors with a spatial resolution of the order of 100 microns. Fine spectroscopy would be obtained between 0.2 and 200 keV. The 0.2 keV threshold would allow measurements of the absorption in our Galaxy and possible host galaxies.

Teegarden, B. J.

The discovery of a source of repeated soft short gamma bursts in Sagittarius

Twelve short cosmic gamma-ray bursts were observed during July-December, 1983. The results of the localization of this source on the basis of Prognoz-9 and ICE data are presented. The source is situated 10 deg away from the Galactic Center. These localizations indicate that the January 7, 1979 burst originated from the same source.

Atteia, J. L.

Diffraction effects on angular response of X-ray collimators

Angular responses have been measured for X-ray collimators with half-widths ranging from minutes of arc down to 10 arcsec. In the seconds-of-arc range, diffraction peaks at off-axis angles can masquerade as side lobes of the collimator angular response. Measurements and qualitative physical arguments lead to a rule of thumb for collimator design; namely, the angle of first minimum in the Fraunhofer single-slit diffraction pattern should be less than one-fourth of the collimator geometrical full-width at half-maximum intensity.

Blake, R. L.

Collimators for soft X-ray measurements

The development of X-ray grid collimators at the Los Alamos Scientific Laboratory is considered with attention given to grid design (patterns and artwork for masters, materials, layout of grid patterns), mounting techniques (index housings, L-bar and T-bar housings, U-housings, rectangular housings). Alignment techniques (adjustable frames and alignment telescope, adjustable frames and on-axis and off-axis telescopes) are considered along with test procedures (plane parallel X-ray beam, convolved response).

Blake, R. L.

Solar X-ray photography with multiplex pin-hole camera

A scatter-hole X-ray camera has been designed and flown in a rocket to measure solar X radiation. Its distinguishing feature is that many single pin-hole images are allowed to overlap - a multiplexing approach that saves space, gives practical signal-to-fog ratio, and requires special object reconstruction techniques. It was possible to reconstruct the appearance of the dominant source of solar emission on the day of rocket flight with better than one arc minute resolution. The coronal X-ray region had the same general shape and intensity distribution as the associated calcium K-line region.

Blake, R. L.

Radiation-induced extrinsic photoconductivity in Li-doped Si.

Investigation of the effects of lithium on radiation-produced complexes having long-time stability by examining the localized energy levels in the forbidden gap which give rise to extrinsic photoconductivity. The levels are found to disappear and in some cases shift with annealing in the 100-450 C temperature range. Due to the complexity of the system and the present lack of adequate theory, no complete analysis of the data obtained could be made.

Fenimore, E.