Engineering topics
Chen, Gang
Publications and source records attributed to Chen, Gang.
Studies on the Bi 2 Te 3 –Bi 2 Se 3 –Bi 2 S 3 system for mid-temperature thermoelectric energy conversion
Bismuth telluride (Bi 2 Te 3 ) and its alloys have been widely investigated as thermoelectric materials for cooling applications at around room temperature. We report here a systematic study on many compounds in the Bi 2 Te 3 –Bi 2 Se 3 –Bi 2 S 3 system. All the samples were fabricated by high energy ball milling followed by hot pressing. Among the investigated compounds, Bi 2 Te 2 S 1 shows a peak ZT ~0.8 at 300 °C and Bi 2 Se 1 S 2 ~0.8 at 500 °C. The results show that these compounds can be used for mid-temperature power generation applications. The leg efficiency of thermoelectric conversion for segmented elements based on these n-type materials could potentially reach 12.5% with a cold side at 25 °C and a hot side at 500 °C if appropriate p-type legs are paired, which could compete well with the state-of-the-art n-type materials within the same temperature range, including lead tellurides, lead selenides, lead sulfides, filled-skutterudites, and half Heuslers.
Coherent Phonon Heat Conduction in Superlattices
Explore the source record for details and available documents.
Disordered stoichiometric nanorods and ordered off-stoichiometric nanoparticles in n-type thermoelectric Bi 2 Te 2.7 Se 0.3
Explore the source record for details and available documents.
Study of the Thermoelectric Properties of Lead Selenide Doped with Boron, Gallium, Indium, or Thallium
Group IIIA elements (B, Ga, In, and Tl) have been doped into PbSe for enhancement of thermoelectric properties. The electrical conductivity, Seebeck coefficient, and thermal conductivity were systematically studied. Room-temperature Hall measurements showed an effective increase in the electron concentration upon both Ga and In doping and the hole concentration upon Tl doping to 7 × 10{sup 19} cm{sup –3}. No resonant doping phenomenon was observed when PbSe was doped with B, Ga, or In. The highest room-temperature power factor 2.5 × 10{sup –3} W m{sup –1} K{sup –2} was obtained for PbSe doped with 2 atom % B. However, the power factor in B-doped samples decreased with increasing temperature, opposite to the trend for the other dopants. A figure of merit (ZT) of 1.2 at 873 K was achieved in PbSe doped with 0.5 atom % Ga or In. With Tl doping, modification of the band structure around the Fermi level helped to increase the Seebeck coefficient, and the lattice thermal conductivity decreased, probably as a result of effective phonon scattering by both the heavy Tl{sup 3+} ions and the increased grain boundary density after ball milling. The highest p-type ZT value was 1.0 at 723 K.
Nanocomposites with high thermoelectric figures of merit
The present invention is generally directed to nanocomposite thermoelectric materials that exhibit enhanced thermoelectric properties. The nanocomposite materials include two or more components, with at least one of the components forming nano-sized structures within the composite material. The components are chosen such that thermal conductivity of the composite is decreased without substantially diminishing the composite's electrical conductivity. Suitable component materials exhibit similar electronic band structures. For example, a band-edge gap between at least one of a conduction band or a valence band of one component material and a corresponding band of the other component material at interfaces between the components can be less than about 5k.sub.BT, wherein k.sub.B is the Boltzman constant and T is an average temperature of said nanocomposite composition.
Skutterudite Unicouple Characterization for Energy Harvesting Applications
Skutterudites are enticing thermoelectric materials due to their high figure of merit, ZT, and good thermomechanical properties. Our work reports the effective figure of merit, ZT eff , and the efficiency of skutterudite legs and a unicouple working under a large temperature difference. The p- and n-type legs are fabricated with electrodes sintered directly to the skutterudite during a hot pressing process. CoSi 2 is used as the electrode for the n-type skutterudite (Yb 0.35 Co 4 Sb 12 ) and Co2Si for the p-type skutterudite (NdFe 3.5 Co 0.5 Sb 12 ). A technique is developed to measure the ZT eff of individual legs and the efficiency of a unicouple. An ZT eff of 0.74 is determined for the n-type legs operating between 52 and 595 °C, and an ZT eff of 0.51 for the p-type legs operating between 77 and 600 °C. The efficiency of the p–n unicouple is determined to be 9.1% operating between ~70 and 550 °C.
Role of phonon dispersion in studying phonon mean free paths in skutterudites
Explore the source record for details and available documents.
Enhancement of thermoelectric figure-of-merit at low temperatures by titanium substitution for hafnium in n -type half-Heuslers Hf 0.75–x Ti x Zr 0.25 NiSn 0.99 Sb 0.01
We report the effect of titanium (Ti) substitution for hafnium (Hf) on thermoelectric properties of (Hf, Zr)-based n-type half-Heuslers: Hf 0.75–x Ti x Zr 0.25 NiSn 0.99 Sb 0.01 , has been studied. The samples are made by arc melting followed by ball milling and hot pressing via the nanostructuring approach. A peak thermoelectric figure-of-merit (ZT) of ~1.0 is achieved at 500 °C in samples with a composition of Hf 0.5 Zr 0.25 Ti 0.25 NiSn 0.99 Sb 0.01 due to a slight increase in carrier concentration and also a lower thermal conductivity caused by Ti. The ZT values below 500 °C of hot pressed Hf 0.5 Zr 0.25 Ti 0.25 NiSn 0.99 Sb 0.01 samples are significantly higher than those of the same way prepared Hf 0.75 Zr 0.25 NiSn 0.99 Sb 0.01 samples at each temperature, which are very much desired for mid-range temperature applications such as waste heat recovery in automobiles.
Low-Temperature Ozone Exposure Technique to Modulate the Stoichiometry of WO(x) Nanorods and Optimize the Electrochromic Performance
A low-temperature ozone exposure technique was employed for the post-treatment of WO{sub x} nanorod thin films fabricated from hot-wire chemical vapor deposition (HWCVD) and ultrasonic spray deposition (USD) techniques. The resulting films were characterized with x-ray diffraction (XRD), transmission electron microscopy (TEM), Raman spectroscopy, UV-vis-NIR spectroscopy and x-ray photoelectron spectroscopy (XPS). The stoichiometry and surface crystallinity of the WO{sub x} thin films were subsequently modulated upon ozone exposure and thermal annealing without particle growth. The electrochromic performance was studied in a LiClO{sub 4}-propylene carbonate electrolyte, and the results suggest that the low-temperature ozone exposure technique is superior to the traditional high-temperature thermal annealing (employed to more fully oxidize the WO{sub x}). The optical modulation at 670 nm was improved from 35% for the as-deposited film to 57% for the film after ozone exposure at 150 C. The coloration efficiency was improved and the switching speed to the darkened state was significantly accelerated from 18.0 s for the as-deposited film to 11.8 s for the film after the ozone exposure. The process opens an avenue for low-temperature and cost-effective manufacturing of electrochromic films, especially on flexible polymer substrates.
Heavy Doping and Band Engineering by Potassium to Improve the Thermoelectric Figure of Merit in p-Type PbTe, PbSe, and PbTe(1-y)Se(y)
Explore the source record for details and available documents.
Phonon conduction in PbSe, PbTe, and PbTe 1 - x Se x from first-principles calculations
Explore the source record for details and available documents.
Status Report of the DPHEP Study Group: Towards a Global Effort for Sustainable Data Preservation in High Energy Physics
Data from high-energy physics (HEP) experiments are collected with significant financial and human effort and are mostly unique. An inter-experimental study group on HEP data preservation and long-term analysis was convened as a panel of the International Committee for Future Accelerators (ICFA). The group was formed by large collider-based experiments and investigated the technical and organisational aspects of HEP data preservation. An intermediate report was released in November 2009 addressing the general issues of data preservation in HEP. This paper includes and extends the intermediate report. It provides an analysis of the research case for data preservation and a detailed description of the various projects at experiment, laboratory and international levels. In addition, the paper provides a concrete proposal for an international organisation in charge of the data management and policies in high-energy physics.
Stronger phonon scattering by larger differences in atomic mass and size in p-type half-Heuslers Hf 1-x Ti x CoSb 0.8 Sn 0.2
We report that high lattice thermal conductivity has been the bottleneck for further improvement of the thermoelectric figure-of-merit (ZT) of half-Heuslers (HHs) Hf 1-x Zr x CoSb 0.8 Sn 0.2 . Theoretically, the lattice thermal conductivity can be reduced by exploring larger differences in the atomic mass and size in the crystal structure, leading to higher ZT. In this paper, we experimentally demonstrated that a lower thermal conductivity in p-type half-Heuslers can be achieved when Ti is used to replace Zr, i.e., Hf 1-x Ti x CoSb 0.8 Sn 0.2 , due to larger differences in the atomic mass and size between Hf and Ti compared with Hf and Zr. Finally, the highest ZT peak, ~1.0 at 800 °C, in the Hf 1-x Ti x CoSb 0.8 Sn 0.2 (x = 0.1, 0.2, 0.3, and 0.5) system was achieved using Hf 0.8 Ti 0.2 CoSb 0.8 Sn 0.2 , which makes this material useful in power generation applications.
Effect of Silicon and Sodium on Thermoelectric Properties of Thallium-Doped Lead Telluride-Based Materials
Explore the source record for details and available documents.
Enhancement of thermoelectric properties by modulation-doping in silicon germanium alloy nanocomposites
Explore the source record for details and available documents.
Microscopic mechanism of low thermal conductivity in lead telluride
The microscopic physics behind low-lattice thermal conductivity of single-crystal rock salt lead telluride (PbTe) is investigated here. Mode-dependent phonon (normal and umklapp) scattering rates and their impact on thermal conductivity were quantified by first-principles-based anharmonic lattice dynamics calculations that accurately reproduce thermal conductivity in a wide temperature range. The low thermal conductivity of PbTe is attributed to the scattering of longitudinal acoustic phonons by transverse optical phonons with large anharmonicity and small group velocity of the soft transverse acoustic phonons. This results in enhancing the relative contribution of optical phonons, which are usually minor heat carriers in bulk materials.