Engineering topics

Carlos Malpica

Publications and source records attributed to Carlos Malpica.

21 records · Page 2

NASA NTRSDate not supplied

Enhancements, Verification, and VMS Integration of VTOL Concept Vehicle Simulation Models

Advanced Rotorcraft Technology (ART) and the NASA Ames Aeromechanics branch have jointly developed FLIGHTLAB simulation models for Advanced Air Mobility (AAM) VTOL concept vehicles. The overarching purpose of the simulation model development is to establish a set of well defined reference vehicles for FLIGHTLAB users and the rotorcraft community. The ongoing research effort and enhancement of these AAM simulation models to fulfill the role of quality reference vehicles is this paper’s focus. The content of this paper expands on the established characteristics of these AAM models in three primary areas. First, enhancement of the lift+cruise and tiltwing models with elastic airframe properties is discussed. The process of setting up the elastic airframe model in FLIGHTLAB, as well as the impacts on flight characteristics are explained. The introduction of the elastic airframe modeling allows these models to be used in flight dynamics, loads, and vibration analysis of the configuration designs. Next, linear model generation from the enhanced simulation model is covered. Confirming the validity of the linearized models is of importance, as these linear models are utilized for flight control design and tuning for these experimental configurations. For the final focus, the progress towards implementation of these models into the NASA Ames Vertical Motion Simulator (VMS) is described. This task seeks to demonstrate the procedures of integrating a FLIGHTLAB flight simulation in the VMS environment, test fully integrated simulation with communication between flight dynamics, control, and propulsion models, and explore the essential aspects of simulation model integration in a full flight simulator environment. This includes I/O definition, initialization, trim, flying, etc. By expanding the capabilities of the AAM simulation models, they continue to develop as valuable and approachable modeling references.

VMS↗

NASA NTRSDate not supplied

Flight Dynamics Conceptual Design Exploration of Multirotor eVTOL

The advent of electric propulsion is revolutionizing the paradigm of rotorcraft design, leading to new electric Vertical Take-Off and Landing (eVTOL) aircraft. Direct drive topologies are common within these new designs, and some designers have chosen to utilize this mechanism for Primary Flight Control (PFC), effectively utilizing the aircraft engines as PFC actuators to control the speed of the rotors. This decision integrates the propulsion and flight control systems, and intrinsically couples the aircraft sizing and control. Four separate tools were exercised throughout this study to conduct a conceptual design exploration of eVTOL aircraft handling qualities. The main tasks for these tools were: 1) aircraft sizing and performance analysis, including the calculation of trim; 2) flight dynamics modeling and analysis; 3) handling qualities-centric control law optimization; and 4) electric motor sizing. Sizing of an RPM- controlled Hexacopter concept explored the dependency of aircraft size to fundamental design parameters: 1) disk loading and 2) blade loading coefficient. Increasing the design disk loading resulted in designs with high agility, but at the cost of significant growth in the design gross weight. Finally, Categories II and III pilot-induced-oscillation (PIO) are known potentially-catastrophic handling qualities deficiencies of fly-by-wire flight control systems such as those expected of eVTOL aircraft. Consideration of PIO predictive metrics in conceptual design control synthesis led to increased PIO robustness.

Flight Dynamics↗

NASA NTRSDate not supplied

In-flight System Identification of the Ingenuity Mars Helicopter

The 68th and 69th flights of NASA’s Ingenuity Mars Helicopter marked the first dedicated system identification flights of an aerial vehicle on another planet. Chirp signals were injected into the swashplate cyclic controls for both legs of the two out-and-back flights. Frequency responses were computed from the flight data, using both the Direct Method (DM) and the Joint-Input-Output (JIO) approach, for the identification of stability and control derivatives in forward flight conditions. The resulting identified state-space models were compared against existing flight dynamics simulation models, showing excellent correlation in the higher frequency range. External disturbances were seen to introduce a bias in the identified lower frequency responses, which was partially mitigated using the JIO method. These findings will inform future modeling and flight testing efforts of Mars rotorcraft.

Ingenuity↗