Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “surface spectroscopy”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1997

The Planet Mercury Surface Spectroscopy and Analysis from the Kuiper Airborne Observatory and Analysis and Modeling to Determine Surface Composition

We had two successful flights to observe Mercury from the Kuiper Airborne Observatory (KAO) using High-efficiency Infrared Faint-Object Grating Spectrograph (HIFOGS). Flights were May 8, 1995 (eastern elongation) and July 6, 1995 (western elongation) For the observations one half of the primary mirror was covered to prevent sunlight from entering the telescope. All equipment and the airplane and its crew performed well. These flights were historical firsts for the KAO and for spectroscopy of Mercury in that it was the first time any spectroscopic observations of Mercury from above the Earth's atmosphere had been made. It was the first time the KAO had been used to @bserve an object less than 30 degrees from the Sun. Upon completion of the basic data reduction it became obvious that extensive modeling and analysis would be required to understand the data. It took three years of a graduate student's time and part time the PI to do the thermal modeling and the spectroscopic analysis. This resulted in a lengthy publication. A copy of this publication is attached and has all the data obtained in both KAO flights and the results clearly presented. Notable results are: (1) The observations found an as yet unexplained 5 micron emission enhancement that we think may be a real characteristic of Mercury's surface but could have an instrumental cause; (2) Ground-based measurements or an emission maximum at 7.7 microns were corroborated. The chemical composition of Mercury's surface must be feldspathic in order to explain spectra features found in the data obtained during the KAO flights.

Sprague, Ann↗
NASA NTRS2014

Surface Spectroscopy Center Of Excellence Project

We propose to develop a national center of excellence in Regolith Radiative Transfer (RRT), i.e., in modeling spectral reflectivity and emissivity of grainy or structured surfaces. The focus is the regime where the structural elements of grainy surfaces have grain sizes and separations of tens of microns, comparable to the wavelengths carrying diagnostic compositional information. This regime is of fundamental interest to remote sensing of planetary and terrestrial surfaces.

Regolith Radiative Transfer (RRT)↗
NASA NTRS1975

Surface photovoltage spectroscopy applied to gallium arsenide surfaces

The experimental and theoretical basis for surface photovoltage spectroscopy is outlined. Results of this technique applied to gallium arsenide surfaces, are reviewed and discussed. The results suggest that in gallium arsenide the surface voltage may be due to deep bulk impurity acceptor states that are pinned at the Fermi level at the surface. Establishment of the validity of this model will indicate the direction to proceed to increase the efficiency of gallium arsenide solar cells.

Bynik, C. E.↗
DOE OSTI2025

WO 3 /CuWO 4 Ratio Controls Open-Circuit Photovoltage and Photocurrent in Type II Heterojunction Solar Fuel Photoelectrodes

WO 3 /CuWO 4 photoelectrodes for the oxygen evolution reaction benefit from a type II heterojunction for charge separation. However, the impact of the WO 3 /CuWO 4 ratio on the photocurrent and the photovoltage is not clear. To probe the effect of composition, Cu x W 1-x O y thin films with variable W:Cu ratio were prepared on FTO by reactive magnetron co-sputtering of W and Cu, followed by air annealing at 500ºC. EDS, XRD, Rietveld refinement, and Raman spectroscopy confirm the presence of crystalline WO 3 and CuWO 4 in the W rich films and increasing amounts of amorphous copper oxides in the Cu rich films. Bandgaps were determined by optical absorption spectroscopy, surface photovoltage spectroscopy (SPS), and photoaction spectra and are found to decrease from 2.7 eV to 1.2 eV with increasing copper oxide content. SPS reveals n-type semiconductor photoanode behavior for WO 3 /CuWO 4 samples and p-type photocathode behavior for CuO x rich films. Photoelectrochemical experiments confirm stable water oxidation with Faraday efficiency near unity for all W rich films and photocurrents that are increasing with CuWO 4 content. Optimal performance is seen for WO 3 /CuWO 4 mixed phases containing 47-75 mass% CuWO 4 . These compositions maximize charge separation at the type II heterojunction interface between the two materials. Additionally, according to incident photon to current efficiency (IPCE) data, the WO 3 improves photon conversion below 350 nm, while CuWO 4 improves conversion at 450-525 nm. Overall, this work shows for the first time how the WO 3 /CuWO 4 ratio controls the photovoltage and the photocurrent in type II heterojunction solar fuel photoelectrodes, and how copper oxides in the copper rich films severely degrade the performance. Furthermore, these results are useful in the context of bulk-heterojunction electrodes for the conversion of solar energy into fuels.

CuWO4↗
NASA NTRS1984

Surface fluctuation spectroscopy - A novel technique for characterizing liquid interfaces

Surface fluctuation spectroscopy is a dynamic light scattering technique which involves the detection of thermal fluctuations (capillary waves) that cover every liquid interface. The advantages of this technique over conventional mechanical methods are discussed. The signal resolution and precision are improved by using a grating heterodyne technique coupled with a digital correlator. Detailed calculations showed that, for the measured power spectrum (the Fourier transform of the correlation function) to take the Lorentzian shape, it is necessary that certain optical conditions be met. These conditions are demonstrated with experimental data collected for ethanol at the ambient temperature as a function of the wave number. Once the optical parameters are adjusted correctly, the experimental results show excellent agreement with the literature values. It is also demonstrated that, using microcomputer technology, the entire system can be automated.

Shih, L. B.↗
NASA NTRS1982

Studies of liquid metal surfaces using Auger spectroscopy

The surface composition of liquid gallium-tin alloys is studied in an Auger electron spectrometer as a function of bulk composition and temperature. The sessile drop samples are cleaned by argon ion bombardment sputtering of the liquid. This technique produces surfaces that are entirely free of impurities within the sensitivity of the spectrometer and remain so for many days. Tin is found to be strongly adsorbed at the liquid-vacuum interface. Surface concentrations based on Auger measurements are found to be in reasonably good agreement with values calculated from surface tension measurements interpreted in terms of a monolayer depth distribution model for the adsorbed tin.

Hardy, S.↗
DOE OSTI2024

Revealing subterahertz atomic vibrations in quantum paraelectrics by surface-sensitive spintronic terahertz spectroscopy

Understanding surface collective dynamics in quantum materials is crucial for advancing quantum technologies. For example, surface phonon modes in quantum paraelectrics are thought to be essential in facilitating interfacial superconductivity. However, detecting these modes, especially below 1 terahertz, is challenging because of limited sampling volumes and the need for high spectroscopic resolution. Here, we report surface soft transverse optical (TO1) phonon dynamics in KTaO 3 and SrTiO 3 by surface-sensitive spintronic terahertz spectroscopy that can sense the collective modes only a few nanometers deep from the surface. In KTaO 3 , the TO1 mode softens and sharpens with decreasing temperature, leveling off at 0.7 terahertz. In contrast, this mode in SrTiO 3 broadens substantially below the quantum paraelectric crossover and coincides with the hardening of a sub–milli–electron volt phonon mode related to the antiferrodistortive transition. These observations that deviate from their bulk properties may have implications for interfacial superconductivity and ferroelectricity. The developed technique opens opportunities for sensing low-energy surface collective excitations.

Chu, Zhaodong↗
DOE OSTI2025

Time-Domain Extreme-Ultraviolet Diffuse Scattering Spectroscopy of Nanoscale Surface Phonons

Here, we report the observation of dynamic fringe patterns in the diffuse scattering of extreme ultraviolet light from surfaces, following femtosecond optical excitation. At each point on the detector, the diffuse scattering intensity exhibits oscillations at well-defined frequencies that correspond to surface phonons with wave vectors determined by the scattering geometry, indicating that the optical excitation generates coherent surface phonons propagating in all directions and spanning a wavelength range from 60 to 300 nm. This phenomenon is observed on a variety of samples, including single-layer and multilayer metal films, as well as bulk semiconductors. The measured surface phonon dispersions show good agreement with theoretical calculations. By comparing signal amplitudes from samples with different surface morphologies, we find that the excitation mechanism is linked to the natural surface roughness of the samples. However, the signal is still detectable on extremely smooth surfaces with subnanometer roughness. Our findings demonstrate a simple and effective method for optically exciting coherent surface phonons with nanoscale wavelengths on a wide range of solid samples and establish a foundation for surface phonon spectroscopy in a wave vector range well beyond the limit of conventional surface Brillouin scattering.

Capotondi, F. [Elettra-Sincrotrone Trieste (Italy)↗
DOE OSTI2023

X-Ray Absorption Spectroscopy (XAS): Surface Structural Determination of Alloy Nanoparticles

In catalysis since reactions occur on the surface of nanoparticles (NP), it is essential to determine the composition of this structure, rather than that of the nanoparticles, since the two may be, and often are, different. Conventional techniques including X-ray absorption spectroscopy (XAS) and X-ray diffraction (XRD) are powerful techniques, but these data reflect the average composition of the entire particle. In this chapter, we introduce the method of EXAFS analysis, which isolates the surface atoms of nanoparticles based on its sensitivity to chemical reactions, specifically surface oxidation. As shown in our case studies, if the surface of a Pt-based nanoparticle is contacted by air at room temperature, the surface will selectively oxidize, resulting in the loss of Pt-Pt and Pt-M bonds to the formation of Pt-O bonds. The difference between the completely reduced and surface-oxidized nanoparticle allows for the isolation of signal from the catalytic surface. Although these examples highlight Pt alloys, similar analysis is also possible for other group 8 and IB bimetallic catalysts.

Zhang, Guanghui↗
NASA NTRS1976

Characterization of lunar mare basalt types. I - A remote sensing study using reflection spectroscopy of surface soils

Telescopic reflection spectra of mature mare surfaces are used to identify and characterize major basalt types on the frontside of the moon. The spectra are classified according to (1) continuum slope and (2) near-infrared features. This study indicates that there are major lunar basalt types that are unlikely to have been sampled during the landing missions. Regions of basalt exist in the western maria with a TiO2 content comparable to that of Apollo 11 but with infrared characteristics that indicate a distinctly different composition. Samples from two landing sites, Apollo 12 and Luna 16, may contain fragments of a nearby basalt unit compositionally different from the dominant basalt type of the landing area.

Pieters, C.↗
NASA NTRS1984

Stationary and non-stationary nonlinear optical spectroscopy on surface polaritons

A phenomenological theory is given for non-stationary electromagnetic surface waves propagating along the boundary plane between two homogeneous isotropic media. The description of nonlinear optical effects using shortened wave equations is demonstrated for spontaneous and simulated Raman scattering processes on surface polaritons.

Ponath, H. E.↗
DOE OSTI2024

Progress in Genetic Algorithm Fitting of X-Ray Fluorescence Data for Absorption Spectroscopy of Liquid Surfaces

X-ray fluorescence (XRF) spectroscopy of liquid surfaces is a promising approach to elemental analysis of forensic samples. Elements in the mixture can be identified from the XRF data because chemical elements are associated with unique spectra. This report describes progress in the development of automated identification of unknown mixtures of elements from XRF spectra using a genetic algorithm (GA). The XRF spectra are measured at the Advanced Photon Source (APS) at the liquid-liquid interface during solvent extraction process. The usage of the GA is demonstrated and future implementation for related problems are then discussed.

47 OTHER INSTRUMENTATION↗
NASA NTRS1989

Reflectance spectroscopy and asteroid surface mineralogy

Information available from reflectance spectroscopy on the surface mineralogy of asteroids is discussed. Current spectral interpretive procedures used in the investigations of asteroid mineralogy are described. Present understanding of the nature and history of asteroids is discussed together with some still unresolved issues such as the source of ordinary chondrites.

Gaffey, Michael J.↗
DOE OSTI2024

Non-Equilibrium Nucleation of Rare Earth Metals at Aqueous Interfaces

We conducted mechanical and electrical perturbation experiments on several systems of NdCl 3 aqueous solutions with two phosphonic acids, one as a stable surfactant with high surface activity and another that was fully soluble in aqueous solution. We also conducted experiments with solely the salt in aqueous solution. Our goal was to stimulate surface aggregation at the air/aqueous solution interface that was observable by Brewster angle microscopy, surface tension, and/or surface spectroscopy. We observed changes only with the surface active phosphonic acid. Additional work is needed to further explore confined environments to stimulate surface aggregation events.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗