Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “laser excitation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Theoretical model for a background noise limited laser-excited optical filter for doubled Nd lasers

A simple theoretical model for the calculation of the dependence of filter quantum efficiency versus laser pump power in an atomic Rb vapor laser-excited optical filter is reported. Calculations for Rb filter transitions that can be used to detect the practical and important frequency-doubled Nd lasers are presented. The results of these calculations show the filter's quantum efficiency versus the laser pump power. The required laser pump powers required range from 2.4 to 60 mW/sq cm of filter aperture.

Shay, Thomas M.↗

Laboratory analysis of techniques for remote sensing of estuarine parameters using laser excitation

The theoretical concepts underlying remote sensing of estuarine parameters using laser excitation are examined. The concepts are extended to include Mie scattering as a measure of the total suspended solids and to develop the water Raman signal as an internal standard. Experimental validation of the theory was performed using backscattered laser light from a laboratory tank to simulate a remote-sensing geometry. Artificially prepared sediments and biological cultures were employed to check specific aspects of the theory under controlled conditions. Natural samples gathered from a variety of water types were also analyzed in the tank to further enhance the simulation. The results indicate that it should be possible to remotely quantify total suspended solids, dissolved organics, attenuation coefficient, chlorophyll a, and phycoerythrin in estuarine water using laser excitation.

Exton, R. J.↗

Development of infrared sensors using energy transfer/energy upconversion processes: Study of laser excited fluorescence in rare Earth ion doped crystals

A summary is presented of the spectroscopic study of three systems: LaF3:Ho(3+), LaF3:Er(3+) and CaF2:Nd(3+). When the D levels of Ho(3+) in LaF3 were resonantly excited with a laser beam of 640 nm, upconverted emissions were detected from J (416 nm), F (485 nm), and E (546 nm) levels. Energy upconverted emissions were also observed from F and E levels of Ho(3+) when the material was excited with an 800 nm near infrared laser. When the D levels of Er(3+) in LaF3 were resonantly excited with a laser beam of 637 nm, upconverted emissions were detected from the E (540 nm) and P (320, 400, and 468 nm) levels. Energy upconverted emissions were also observed from F, E, and D levels of Er(3+) when the material was resonantly excited with an 804 nm near infrared laser. When the D levels of Nd(3+) in CaF2 were resonantly excited with a laser beam of 577 nm, upconverted emissions were detected from the L (360 and 382 nm), K (418 nm), and I (432 nm) levels. Very weak upconverted emissions were detected when this system was irradiated with a near infrared laser. The numbers in parentheses are the wavelengths of the emissions.

Nash-Stevenson, S. K.↗

UV Resonant Raman Spectrometer with Multi-Line Laser Excitation

A Raman spectrometer employs two or more UV (ultraviolet) laser wavel engths to generate UV resonant Raman (UVRR) spectra in organic sampl es. Resonant Raman scattering results when the laser excitation is n ear an electronic transition of a molecule, and the enhancement of R aman signals can be several orders of magnitude. In addition, the Ra man cross-section is inversely proportional to the fourth power of t he wavelength, so the UV Raman emission is increased by another fact or of 16, or greater, over visible Raman emissions. The Raman-scatter ed light is collected using a high-resolution broadband spectrograph . Further suppression of the Rayleigh-scattered laser light is provi ded by custom UV notch filters.

Lambert, James L.↗

Equations for the kinetic modeling of supersonically flowing electrically excited lasers

The equations for the kinetic modeling of a supersonically flowing electrically excited laser system are presented. The work focuses on the use of diatomic gases, in particular carbon monoxide mixtures. The equations presented include the vibrational rate equation which describes the vibrational population distribution, the electron, ion and electronic level rate equations, the gasdynamic equations for an ionized gas in the presence of an applied electric field, and the free electron Boltzmann equation including flow and gradient coupling terms. The model developed accounts for vibration-vibration collisions, vibration-translation collisions, electron-molecule inelastic excitation and superelastic de-excitation collisions, charge particle collisions, ionization and three body recombination collisions, elastic collisions, and radiative decay, all of which take place in such a system. A simplified form of the free electron Boltzmann equation is developed and discussed with emphasis placed on its coupling with the supersonic flow. A brief description of a possible solution procedure for the set of coupled equations is then discussed.

Lind, R. C.↗

Investigation of superelastic electron scattering by laser-excited Ba - Experimental procedures and results

Differential (in angle) electron scattering experiments on laser-excited Ba-138 1P were carried out at 30- and 100-eV impact energies. The laser light was linearly polarized and located in the scattering plane. The superelastic scattering signal was measured as a function of polarization direction of the laser light with respect to the scattering plane. It was found at low electron scattering angles that the superelastic scattering signal was asymmetric to reflection of the polarization vector with respect to the scattering plane. This is in contradiction with theoretical predictions. An attempt was made to pinpoint the reason for this observation, and a detailed investigation of the influence of experimental conditions on the superelastic scattering was undertaken. No explanation for the asymmetry has as yet been found.

Register, D. F.↗

Problems associated with the measurement of coherence parameters - Superelastic electron scattering by laser-excited Ba-138(...6s6p1P1) atoms

Measurements of superelastic scattering of electrons by laser-excited Ba-138(...6s6p1P1) atoms were carried out. An asymmetry observed has been explained using a model of scattering from a target with finite dimensions. This model employed coherence parameters which were calculated in the distorted-wave approximation. The results indicated that the interpretation of coherence experiments in terms of scattering from a pointlike target can lead to serious errors in the deduction of coherence parameters at low scattering angles.

Zetner, P. W.↗

Efficient 30-W, 140-MHz rf amplifier for CW CO2 waveguide laser excitation

Details of a 30-W, 140-MHz rf amplifier for CW CO2 waveguide laser excitation are presented. The amplifier delivers 30 W into a 50-Ohm load while requiring only 40 W of dc power from a 28-V supply and 100 mW of rf drive power for an overall efficiency of 75 percent. A coupling-starting network design theory is given that provides the initiation over voltage for the discharge plasma from an rf power source of limited output voltage capability. The network then matches the drive circuit to the new input impedance of the operating discharge without any adjustments. This design theory applies to the whole class of networks whose losses can be approximated by a loss conductance in parallel with the gas discharge.

Hochuli, U. E.↗

Electron scattering by laser-excited barium atoms

Inelastic and superelastic scattering of 30- and 100-eV electrons by laser-excited 6s 6p 1P and subsequent cascade-populated 6s 6p 3P, 6s 5d 1D, and 6s 5d 3D Ba atoms have been observed. Absolute differential cross sections for the singlet and relative scattering intensities for the triplet species have been determined in the 5 to 20 deg angular region. Under the present conditions excitations dominate over deexcitations.

Register, D. F.↗

Coherent laser excitation of Ba-137 and Ba-138

Computations are carried out for the 1S(6s2)-1P(6s,6p) coherent laser excitation of Ba-137 and Ba-138 in a magnetic field. Results are presented for both the steady-state and time-dependent excited-state populations of the Zeeman-split magnetic sublevels. The quantum-statistical Liouville-equation approach (for the reduced density matrix) is compared to the rate-equations approach. Significant differences are found between these, due to the interference between strongly overlapping lines (especially for Ba-137). The time-evolution profiles indicate that the Ba-137 transient time is much longer than that of Ba-138.

Lam, Kai-Shue↗

Electron-impact ionization of laser-excited Ba-138 (... 5p6 6s 6p) and Ba-138 (... 5p6 6s 5d) atoms

Electron-impact ionization cross sections for laser-excited Ba-138 (... 5p6 6s 6p; 1P1, M = - 1) and cascade-populated Ba-138 (... 5p6 6s 5d; 1D + 3D) atoms were measured in the threshold to 10 eV energy range. The peak cross sections for the excited species are about a factor of 2 larger than that for ground-state Ba. In addition, it was demonstrated that ionization from individual magnetic substates of various hyperfine levels can be studied. The ionization cross sections in the case of Ba-138 (1P1) were found to be equal for the M = 0 and for the M = + or - 1 sublevels within the experimental error limit.

Trajmar, S.↗

D1((2)B2g) to D0((2)Au) Fluorescence from the Matrix-Isolated Perylene Cation Following Laser Excitation into the D5(2)B3g) and D2 ((2)B3g) Electronic States

Fluorescence spectra of the perylene cation, pumped by direct laser excitation via the D(sub 2)((2)B(sub 3g)) (left arrow) D(sub 0)((2)A(sub u)) and D(sub 5)(2)B(sub 3g)) (left arrow) D(sub 0)((2)A(sub u)) transitions, are presented. Direct excitation into the D5 or D2 states is followed by rapid non-radiative relaxation to D1 that, in turn,relaxes radiatively. Excitation spectroscopy across the D(sub 2)((2)B(sub 3g)) (left arrow) D(sub 0)((2)A(sub u)) transition near 730 nm shows that site splitting plays little or no role in determining the spectral substructure in the ion spectra. Tentative assignments for ground state vibrational frequencies are made by comparison of spectral intervals with calculated normal mode frequencies.

Chillier, Xavier D. F.↗

Feasibility study: Monodisperse polymer particles containing laser-excitable dyes

The objective was to determine the feasibility of the preparation of monodisperse spherical poly(methyl methacrylate) and polystyrene particles that contain laser-excitable dyes in the size range 0.1 microns to 1 cm. Poly(methyl methacrylate) and polystyrene were chosen because of their excellent optical properties. The sphericity was required for uniformity of spectral output of re-irradiated light from the dye-containing particles. The monodispersity was required to give each particle the same optical properties when exposed to laser light.

Vanderhoff, John W.↗

Elastic Electron Scattering by Laser-Excited (sup 138)Ba (...6s6p (sup 1)P(sub 1)) Atoms

The result of a joint experimental and theoretical study concerning elastic electron scattering by laser-excited (sup 138)Ba (...6s6p (sup 1)P(sub 1)) atoms are presented. From these studies, we extracted differential scattering cross sections (DCS's) and collision parameters for elastic scattering by the coherently prepared (sup 1)P(sub 1) atoms.

collision elastic scattering convergent close-coup↗

Photoelectrolysis of water at high current density - Use of ultraviolet laser excitation

The behavior of TiO2 and SrTiO3 photoanodes in cells for the photoelectrolysis of H2O has been investigated for high-intensity 351-,364-nm excitation from an Ar ion laser. Intensities up to 380 W/sq cm have been used. For TiO2 a small amount of surface decomposition is found after irradiation at high intensity, whereas SrTiO3 undergoes no detectable changes. Current-voltage properties for both electrodes are essentially independent of light intensity up to the level of 380 W/sq cm, and there is little if any change in quantum efficiency for electron flow. Photocurrent densities have been shown to exceed 5 A/sq cm for O2 evolution. Data show that the energy storage rate associated with the SrTiO3 photoelectrolysis can exceed 30 W/sq cm; this represents the highest demonstrated rate of sustained optical-to-chemical energy conversion.

Bocarsly, A. B.↗