Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “THREE-DIMENSIONAL MOTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

A study of hypersonic small-disturbance theory

A systematic study is made of the approximate inviscid theory of thin bodies moving at such high supersonic speeds that nonlinearity is an essential feature of the equations of flow. The first-order small-disturbance equations are derived for three-dimensional motions involving shock waves, and estimates are obtained for the order of error involved in the approximation. The hypersonic similarity rule of Tsien and Hayes, and Hayes' unsteady analogy appear in the course of the development. It is shown that the hypersonic theory can be interpreted so that it applies also in the range of linearized supersonic flow theory. Several examples are solved according to the small-disturbance theory, and compared with the full solutions when available.

Van Dyke, Milton D↗

Turbulent Flow Between Rotating Cylinders

The turbulent air flow between rotating cylinders was investigated. The distributions of mean speed and of turbulence were measured in the gap between a rotating inner and a stationary outer cylinder. The measurements led to the conclusion that the turbulent flow in the gap cannot be considered two dimensional, but that a particular type of secondary motion takes place. It is shown that the experimentally found velocity distribution can be fully understood under the assumption that this secondary motion consists of three-dimensional ring-shape vortices. The vortices occur only in pairs, and their number and size depend on the speed of the rotating cylinder; the number was found to decrease with increasing speed. The secondary motion has an essential part in the transmission of the moment of momentum. In regions where the secondary motion is negligible, the momentum transfer follows the laws known for homologous turbulence. Ring-shape vortices are known to occur in the laminar flow between rotating cylinders, but it was hitherto unknown that they exist even at speeds that are several hundred times the critical limit.

Shih-I, Pai↗

A Generalized Hydrodynamic-Impact Theory for the Loads and Motions of Deeply Immersed Prismatic Bodies

A theory is derived for determining the loads and motions of a deeply immersed prismatic body. The method makes use of a two-dimensional water-mass variation and an aspect-ratio correction for three-dimensional flow. The equations of motion are generalized by using a mean value of the aspect-ratio correction and by assuming a variation of the two-dimensional water mass for the deeply immersed body. These equations lead to impact coefficients that depend on an approach parameter which, in turn, depends upon the initial trim and flight-path angles. Comparison of experiment with theory is shown at maximum load and maximum penetration for the flat-bottom (0 deg dead-rise angle) model with bean-loading coefficients from 36.5 to 133.7 over a wide range of initial conditions. A dead-rise angle correction is applied and maximum-load data are compared with theory for the case of a model with 300 dead-rise angle and beam-loading coefficients from 208 to 530.

Markey, Melvin F.↗

Generalization of Boundary-Layer Momentum-Integral Equations to Three-Dimensional Flows Including Those of Rotating System

The Navier-Stokes equations of motion and the equation of continuity are transformed so as to apply to an orthogonal curvilinear coordinate system rotating with a uniform angular velocity about an arbitrary axis in space. A usual simplification of these equations as consistent with the accepted boundary-layer theory and an integration of these equations through the boundary layer result in boundary-layer momentum-integral equations for three-dimensional flows that are applicable to either rotating or nonrotating fluid boundaries. These equations are simplified and an approximate solution in closed integral form is obtained for a generalized boundary-layer momentum-loss thickness and flow deflection at the wall in the turbulent case. A numerical evaluation of this solution carried out for data obtained in a curving nonrotating duct shows a fair quantitative agreement with the measures values. The form in which the equations are presented is readily adaptable to cases of steady, three-dimensional, incompressible boundary-layer flow like that over curved ducts or yawed wings; and it also may be used to describe the boundary-layer flow over various rotating surfaces, thus applying to turbomachinery, propellers, and helicopter blades.

Mager, Arthur↗

On the sound field of a point-shaped sound source in uniform translatory motion

A rigorous analysis presented of the excitation of sound by point sources moving in uniform translatory motion at subsonic or supersonic velocities through a two- or three-dimensional medium at rest. The construction of surfaces of constant phase is based upon Huyghens' principle in such a manner that the propagation in the medium at rest of the elementary waves emanating from the sound source is independent of the momentary state of motion of the sound source. Hence, characteristic traits of the sound propagation may be understood even on the basis of simple geometric constructions.

SOUND↗

Three-Dimensional Lunar Mission Studies

Some three-dimensional lunar trajectories have been calculated by integration of the equations of motion of the classical restricted three-body problem of celestial mechanics. The calculations have been used for analysis of several aspects of lunar flight including requirements for achieving lunar impact and for establishment of a close lunar satellite. The allowable errors in initial conditions for lunar missions are strongly dependent on the values of the initial injection velocity and the injection angle. There can be large differences in results obtained from two-dimensional analyses (in which the vehicle trajectory is assumed to remain always in the earth-moon plane) and those obtained from three-dimensional analyses. Some of the accuracy tolerances can be fairly well estimated by use of a two-body analysis which considers the inclination of the plane of the vehicle trajectory to the earth-moon plane. Satisfactory orbits for a relatively close lunar satellite can be obtained with accuracies in the initial conditions approximately equal to those required for lunar impact.

Michael, William H., Jr.↗

Hydrodynamic Properties of Planing Surfaces and Flying Boats

The study of the hydrodynamic properties of planing bottom of flying boats and seaplane floats is at the present time based exclusively on the curves of towing tests conducted in tanks. In order to provide a rational basis for the test procedure in tanks and practical design data, a theoretical study must be made of the flow at the step and relations derived that show not only qualitatively but quantitatively the inter-relations of the various factors involved. The general solution of the problem of the development of hydrodynamic forces during the motion of the seaplane float or flying boat is very difficult for it is necessary to give a three-dimensional solution, which does not always permit reducing the analysis to the form of workable computation formulas. On the other had, the problem is complicated by the fact that the object of the analysis is concerned with two fluid mediums, namely, air and water, which have a surface of density discontinuity between them. The theoretical and experimental investigations on the hydrodynamics of a ship cannot be completely carried over to the design of floats and flying-boat hulls, because of the difference in the shape of the contour lines of the bodies, and, because of the entirely different flow conditions from the hydrodynamic viewpoint.

Sokolov, N. A.↗

A recurrence matrix solution for the dynamic response of aircraft in gusts

A systematic procedure developed for the calculation of the structural response of aircraft flying through a gust by use of difference equations in the solution of dynamic problems is first illustrated by means of a simple-damped-oscillator example. A detailed analysis is then given which leads to a recurrence matrix equation for the determination of the response of an airplane in a gust. The method takes into account wing bending and twisting deformations, fuselage deflection, vertical and pitching motion of the airplane, and some tail forces. The method is based on aerodynamic strip theory, but compressibility and three-dimensional aerodynamic effects can be taken into account approximately by means of over-all corrections. Either a sharp-edge gust or a gust of arbitrary shape in the spanwise or flight directions may be treated. In order to aid in the application of the method to any specific case, a suggested computational procedure is included. The possibilities of applying the method to a variety of transient aircraft problems, such as landing, are brought out. A brief review of matrix algebra, covering the extent to which it is used in the analysis, is also included. (author)

Houbolt, John C↗

Three-Dimensional Orbits of Earth Satellites, Including Effects of Earth Oblateness and Atmospheric Rotation

The principal purpose of the present paper is to present sets of equations which may be used for calculating complete trajectories of earth satellites from outer space to the ground under the influence of air drag and gravity, including oblateness effects, and to apply these to several examples of entry trajectories starting from a circular orbit. Equations of motion, based on an "instantaneous ellipse" technique, with polar angle as independent variable, were found suitable for automatic computation of orbits in which the trajectory consists of a number of revolutions. This method is suitable as long as the trajectory does not become nearly vertical. In the terminal phase of the trajectories, which are nearly vertical, equations of motion in spherical polar coordinates with time as the independent variable were found to be more suitable. In the first illustrative example the effects of the oblateness component of the earth's gravitational field and of atmospheric rotation were studied for equatorial orbits. The satellites were launched into circular orbits at a height of 120 miles, an altitude sufficiently high that a number of revolutions could be studied. The importance of the oblateness component of the earth's gravitational field is shown by the fact that a satellite launched at circular orbital speed, neglecting oblateness, has a perigee some 67,000 feet lower when oblateness forces are included in the equations of motion than when they are not included. Also, the loss in altitude per revolution is double that of a satellite following an orbit not subject to oblateness. The effect of atmospheric rotation on the loss of altitude per revolution was small. As might be surmised, the regression of the line of nodes as predicted by celestial mechanics is unchanged when drag is included. It is clear that the inclination of the orbital plane to the equator will be relatively unaffected by drag for no atmospheric rotation since the drag lies in the orbital plane in this case. With the inclusion of atmospheric rotation it was found that the inclination of the plane changed about one-millionth of a radian per revolution. Thus the prediction of the position of the orbital plane of an earth satellite is not complicated by the introduction of drag. The line of apsides, which without drag but with oblateness moves slowly in space, tends to move with the satellite when drag is included in the calculations. As a results, the usual linearized solutions based on oblateness alone must be basically altered when drag is included to take into account the rapid movement of the line of apsides. In the second illustrative example the final revolution was calculated to impact for a number of trajectories in an orbital plane inclined at 650 to the equator. Of particular interest is the large effect the oblateness gravitational field and atmospheric rotation can have on the impact point. For a value of CDA/m of unity, and for an initial downward angle at 80 miles altitude of 0.01 radian, such as might be utilized for manned re-entry, oblateness had an influence of about 300 miles in the impact point, and atmospheric rotation had about a 150-mile influence.

Nielsen, Jack N.↗

A Visualization Study of Secondary Flows in Cascades

Flow-visualization techniques are employed to ascertain the streamline patterns of the nonpotential secondary flows in the boundary layers of cascades, and thereby to provide a basis for more extended analyses in turbomachines. The three-dimensional deflection of the end-wall boundary layer results in the formation of a vortex within each cascade passage. The size and tightness of the vortex generated depend upon the main-flow turning in the cascade passage. Once formed, a vortex resists turning in subsequent blade rows, with consequent unfavorable angles of attack and possible flow disturbances on the pressure surfaces of subsequent blade rows when the vortices impinge on these surfaces. Two major tip-clearance effects are observed, the formation of a tip-clearance vortex and the scraping effect of a blade with relative motion past the wall boundary layer. The flow patterns indicate methods for improving the blade tip-loading characteristics of compressors and of low- and high-speed turbulence.

Herzig, Howard Z↗