Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SPECIFIC HEAT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records

Specific heat of Nb{sub 3}Sn: The case for a single gap

The important influence of multiple gaps in the superconductivity of MgB{sub 2} and Fe-based compounds, especially because of the possibility that manipulation of a second gap can significantly raise the upper critical field H{sub c2}, has refocused attention on Nb{sub 3}Sn because anomalies in both specific heat and point-contact tunneling studies have led to the proposal that Nb{sub 3}Sn is also a two-gap superconductor. Here, we search for evidence of the second gap in a careful study of the influence of the homogenization temperature on the sample uniformity. We show that it is very difficult to fabricate samples that are both homogeneous and stoichiometric. We find so-called “second-gap” anomalies disappear only after high temperature and long-term annealing. Such a well-annealed sample shows only a strong, electron-phonon-coupled, single-gap behavior. In contrast, samples reacted and annealed at lower temperatures, as in the earlier two-gap studies, show small chemical composition variations of the A15 phase. We propose that the second gap sightings are actually due to variation of T{sub c} within very difficult-to-fully homogenize samples. A curiosity of the A15 Nb{sub 3}Sn phase is that almost any mixture of Nb and Sn tries to form a stoichiometric A15 composition, but the residue of course contains off-stoichiometric A15, Nb, and other phases when the Nb:Sn ratio departs from the true 3:1 stoichiometry.

36 MATERIALS SCIENCE↗

Specific Heat of Ba 0.59 K 0.41 Fe 2 As 2 , an Fe-Pnictide Superconductor with T c = 36.9 K, and a New Method for Identifying the Electron Contribution [Specific Heat of Ba 0.59 K 0.41 Fe 2 As 2 , and a New Method for Identifying the Electron Contribution: Two Electron Bands with Different Energy Gaps in the Superconducting State]

Here, we report specific-heat measurements on Ba 0.59 K 0.41 Fe 2 As 2 , one of a family of high-T c Fe-pnictide superconductors for which the pairing interaction is of special interest. We use a new method, based on direct comparisons of α-model expressions for the electron contribution with the measured total specific heat, to extract the electron contribution. It circumvents the need in the conventional analyses for an independent, necessarily approximate, determination of the lattice contribution, which is subtracted from the total to obtain the electron contribution, and it eliminates the consequent uncertainties in the electron contribution. For Ba 0.59 K 0.41 Fe 2 As 2 the electron density of states is comprised of contributions from two electron bands with superconducting-state energy gaps differing by a factor 3.8, with 77% coming from the band with the larger gap. The vortex-state specific heat suggests nodeless gaps. Comparison of the normal-state density of states with band-structure calculations shows an extraordinarily large effective mass enhancement, for which there is no precedent in simple metals and no theoretical explanation.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Microscopic parameters from high-resolution specific heat measurements on superoptimally substituted BaFe 2 ( As 1 - x P x ) 2 single crystals

We investigate the electronic specific heat of superoptimally substituted BaFe 2 (As 1-x P x ) 2 single crystals in the superconducting state using high-resolution nanocalorimetry. From the measurements, we extract the substitution dependence of the condensation energy, superconducting gap Δ, and related microscopic parameters. We find that the anomalous scaling of the specific heat jump ΔC ∝ to T$3\atop{c}$ , found in many iron-based superconductors, in this system originates from a T c -dependent ratio Delta/k B T c in combination with a substitution-dependent density of states N(epsilon(F)). A clear enhancement is seen in the effective mass m* as the composition approaches the value that has been associated with a quantum critical point at optimum substitution. However, a simultaneous increase in the superconducting carrier concentration n s yields a penetration depth lambda that decreases with increasing T c without sharp divergence at the quantum critical point. Uemura scaling indicates that T c is governed by the Fermi temperature T F for this multiband system.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Specific heat to H c⁢2 : Evidence for nodes or deep minima in the superconducting gap of underdoped and overdoped Ba(Fe 1–$x$ Co $x$ ) 2 As 2

Low-temperature specific heat, C, in magnetic fields up to Hc2 is reported for underdoped Ba(Fe 0.955 Co 0.045 ) 2 As 2 (T c = 8 K) and for three overdoped samples Ba(Fe 1–x Co x ) 2 As 2 (x = 0.103, 0.13, and 0.15; T c = 17.2, 16.5, and 11.7 K, respectively). Previous measurements of thermal conductivity (as a function of temperature and field) and penetration depth on comparable-composition samples gave some disagreement as to whether there was fully gapped/nodal behavior in the under-/overdoped materials, respectively. The present work shows that the measured behavior of the specific heat γ (∝C/T as T → 0, i.e., a measure of the electronic density of states at the Fermi energy) as a function of field approximately obeys γ ∝ H 0.5±0.1 , similar to the Volovik effect for nodal superconductors, for both the underdoped and the most overdoped Co samples. However, for the two overdoped compositions x = 0.103 and 0.13, the low-field (H ≤ 10 T) data show a Volovik-like behavior of γ ∝ H 0.3–0.4 , followed by an inflection point, followed at higher fields by γ ∝ H 1 . Here, we argue that, within the two-band theory of superconductivity, an inflection point may occur if the interband coupling is dominant.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Hyper-cooling Limit, Heat of Fusion, and Temperature-Dependent Specific Heat of Fe-Cr-Ni Melts

Thermophysical properties of Fe-Cr-Ni melts are studied using electrostatic levitation and rapid solidification techniques. Six hypoeutectic Fe(sub 0.72)Cr(sub w)Ni(sub(0.28−w)) alloys with a Cr/Ni ratio of around 0.8 were melted and solidified at different degrees of undercooling. From the observed relationship between the undercooling and thermal plateau time, the hyper-cooling limit and heat of fusion of Fe(sub 0.72)Cr(sub w)Ni(sub(0.28−w)) melts are determined as a function of Cr mass fraction. A ratio of specific heat and total hemispherical emissivity of the Fe-Cr-Ni melts is calculated using the time-temperature profiles. A new method is presented to evaluate the temperature dependence of specific heat for undercooled melts and applied to this alloy family.

Sangho Jeon↗

Measurement of the Specific Heat Using a Gravity Cancellation Approach

The specific heat at constant volume C(sob V) of a simple fluid diverges near its liquid-vapor critical point. However, gravity-induced density stratification due to the divergence of isothermal susceptibility hinders the direct comparison of the experimental data with the predictions of renormalization group theory. In the past, a microgravity environment has been considered essential to eliminate the density stratification. We propose to perform specific heat measurements of He-3 on the ground using a method to cancel the density stratification. A He-3 fluid layer will be heated from below, using the thermal expansion of the fluid to cancel the hydrostatic compression. A 6% density stratification at a reduced temperature of 10(exp -5) can be cancelled to better than 0.1% with a steady 1.7 micro K temperature difference across a 0.05 cm thick fluid layer. A conventional AC calorimetry technique will be used to determine the heat capacity. The minimized bulk density stratification with a relaxation time 6500 sec at a reduced temperature of 10(exp -5) will stay unchanged during 1 Hz AC heating. The smear of the specific heat divergence due to the temperature difference across the cell is about 0.1% at a reduced temperature of 10(exp -6). The combination of using High Resolution Thermometry with a 0.5 n K temperature resolution in the AC technique and the cancellation of the density stratification will enable C(sub V) to be measured down to a reduced temperature of 10(exp -6) with less than a 1% systematic error.

Zhong, Fang↗

The calculation of high-temperature equilibrium and nonequilibrium specific heat data for N2, O2 and NO

Specific heat data for high-temperature air species are needed to compute the temperature and enthalpy of gas mixtures in aerothermodynamics flowfield calculations. Accurate data are known only for temperatures under 6000 K, but are required for temperatures exceeding 25,000 K. In the present study, CP data are computed for N2, O2 and NO. The calculations are based on summations over all the vibration-rotation energy levels for all known bound electronic states. Estimates are made for the error introduced by the neglect of possible additional high-lying electronic states. In addition, a scheme for the partitioning of the internal energy into vibrational, rotational and electronic contributions is presented which consistently accounts for the nonseparable nature of the various energy modes. The multitemperature specific heat data are recommended for use in nonequilibrium flowfield models.

Jaffe, Richard L.↗

Effect of annealing on the specific heat of optimally doped Ba(Fe0.92Co0.08)2As2

We report the temperature dependence of the low-temperature specific heat down to 400 mK of the electron-doped Ba(Fe{sub 0.92}Co{sub 0.08}){sub 2}As{sub 2} superconductors. We have measured two samples extracted from the same batch: first sample has been measured just after preparation with no additional heat treatment. The sample shows T{sub c} = 20 K, residual specific heat {gamma}{sub 0} = 3.6 mJ/mol K{sup 2} and a Schottky-like contribution at low temperatures. A second sample has been annealed at 800 C for two weeks and shows T{sub c} = 25 K and {gamma}{sub 0} = 1.4 mJ/mol K{sup 2}. By subtracting the lattice specific heat, from pure BaFe{sub 2}As{sub 2}, the temperature dependence of the electronic specific heat has been obtained and studied. For both samples the temperature dependence of C{sub el}(T) clearly indicate the presence of low-energy excitations in the system. Their specific heat data cannot be described by single clean s- or d-wave models and the data requires an anisotropic gap scenario which may or may not have nodes.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

The 55 K specific heat anomaly in palladium hydride

A specific heat anomaly in PdH and PdD has been observed by Aston et al. (1957) close to 55 K. Its position was found to be independent of hydrogen concentration and its magnitude to be linear in hydrogen concentration. Ferguson's (1965) and Brodowsky's (1972) explanations of the anomaly are shown to be unsatisfactory. This is true also for the detailed mechanical statistical model proposed by Staford and McLellan (1974) for interstitial solid solutions of hydrogen in transition metals. It is shown that Gopal's (1966) simple Schottky model of specific heat anomaly, which considers a system of several levels with Boltzmann statistics, provides much better agreement with experiment than the more elaborate models, both in magnitude and in predicting a linear dependence on hydrogen concentration.

Jacobi, N.↗

Reconstruction of the “phase separation – ordering” type and specific heat in carbon nanotubes

The low-temperature behavior of the specific heat in disordered nanotubes strongly depends on structure changes and was not explained by the phonon contribution. Expression for electronic specific heat was carried out taking into account the multiple elastic scattering of electrons on impurities and structural inhomogeneities of short-range order type, it includes dependence on diameter of nanotube, concentration of impurities, parameters of short-range order (structural heterogeneity) and temperature. Anomalous low-temperature behavior of the specific heat of disordered CNT is shown to have electronic nature and may be associated with the electrons that are involved in restructuring.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Doping-depenent specific heat study of the superconducting gap in Ba(Fe1-xCox)2As2

We report a doping, magnetic field, and low-temperature-dependent study of the specific heat of the iron-arsenide Ba(Fe{sub 1-x}Co{sub x}){sub 2}As{sub 2} at underdoped (x=0.045), optimal-doped (x=0.08) and overdoped (x=0.103 and 0.105) regimes. By subtracting the lattice specific heat the temperature and magnetic field dependence of the electronic specific heat has been studied. The temperature and field dependencies of the superconducting part of Cp exhibit similar behavior for all doping concentrations. The temperature variation in the electronic specific heat as well as its field dependence cannot be described by a single isotropic s-wave gap, pointing to a complex gap structure in the system. The lack of doping dependence indicates that the gap structure does not change significantly as a function of doping. We also observe a significant residual linear term of unknown origin in the specific heat of Ba(Fe{sub 1-x}Co{sub x}){sub 2}As{sub 2} which suggests that inhomogeneity may be an important factor in Co-doped BaFe{sub 2}As{sub 2}.

36 MATERIALS SCIENCE↗

The Incredible Effect of Heat Load Increase Rate on the Specific Heat Flux at Boiling of Some Nanofluids

Boiling curves for different heat-load increase rates (HLIRs) are obtained for distilled water, tap water, and two nanofluids (NFs) based on a natural mixture of montmorillonite and attapulgite (AlSi-7) and titanium dioxide (NF-8). An unusually strong influence of the HLIR on the thermal parameters of NFs is detected upon boiling of AlSi-7 based on a mixture of highly anisometric nanoparticles of aluminosilicates of various morphologies capable of forming nanostructured openwork “architectures” on the heater surface. An explanation of the reasons for the observed effect is proposed. The data obtained indicate the existence of an optimal HLIR at which the structure of the deposit appearing on the heating surface during the boiling of an NF is most favorable for heat exchange.

77 NANOSCIENCE AND NANOTECHNOLOGY↗