Results for “OSMIUM 170” | Engineering Papers

DOE OSTI2018

Nuclear Data Sheets for A=170☆

Nuclear structure data pertaining to all nuclei with mass number A=170 have been evaluated, and incorporated into the ENSDF data file. This evaluation supersedes the previous evaluation (Coral M. Baglin), Nuclear Data Sheets 96, 611 (2002), (cutoff date 15 August 2002) and subsequent updates of the ENSDF file for Yb to Dy (cutoff 15 April 2010), Lu (cutoff 8 October 1998), Pt (cutoff 17 February 1999) and Ta, Os (cutoff 7 April 1998). Since the previous evaluation, {sup 170}Gd has been observed and the ground state T{sub 1/2} measured. New excited states have also been observed in the neutron rich {sup 170}Dy. The ground state T{sub 1/2} of {sup 170}Tb has been determined, however, there are currently still no excited states observed in this nucleus. There remains some uncertainty in the ground state and longer-lived isomer in {sup 170}Ir which could warrent further experimental investigation.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

DOE OSTI2021

Theoretical and experimental studies of compression and shear deformation behavior of Osmium to 280 GPa

Abstract The compression behavior of osmium metal was investigated up to 280 GPa (volume compression V/V o = 0.725) under nonhydrostatic conditions at ambient temperature using angle dispersive axial x-ray diffraction (A-XRD) with a diamond anvil cell (DAC). In addition, shear strength of osmium was measured to 170 GPa using radial x-ray diffraction (R-XRD) technique in DAC. Both diffraction techniques in DAC employed platinum as an internal pressure standard. Density functional theory (DFT) calculations were also performed, and the computed lattice parameters and volumes under compression are in good agreement with the experiments. DFT predicts a monotonous increase in axial ratio ( c/a ) with pressure and the structural anomalies of less than 1% in ( c/a ) ratio reported below 150 GPa were not reproduced in theoretical calculations and hydrostatic measurements. The measured value of shear strength of osmium ( τ ) approaches a limiting value of 6 GPa above a pressure of 50 GPa in contrast to theoretical predictions of 24 GPa and is likely due to imperfections in polycrystalline samples. DFT calculations also enable the studies of shear and tensile deformations. The theoretical ideal shear stress is found along the (001)[1–10] shear direction with the maximal shear stress ∼24 GPa at critical strain ∼0.13.

Lin, Chia-Min↗