Tubes for high power microwave transmission in space
Microwave tubes for high power transmission from space to ground and in deep space communications, discussing klystrons, TWT and crossed field amplifiers
Ramins, P.↗
SEARCH · Engineering Papers
Results for “MICROWAVE TRANSMISSION”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Optimization technique for improved microwave transmission from multi-solar power satellites
An optimization technique for generating antenna illumination tapers allows improved microwave transmission efficiencies from proposed solar power satellite (SPS) systems and minimizes sidelobe levels to meet preset environmental standards. The cumulative microwave power density levels from 50 optimized SPS systems are calculated at the centroids of each of the 3073 counties in the continental United States. These cumulative levels are compared with Environmental Protection Agency (EPA) measured levels of electromagnetic radiation in seven eastern cities. Effects of rectenna relocations upon the power levels/population exposure rates are also studied.
Arndt, G. D.↗
Airplane Ice Detector Based on a Microwave Transmission Line
An electronic instrument that could detect the potentially dangerous buildup of ice on an airplane wing is undergoing development. The instrument is based on a microwave transmission line configured as a capacitance probe: at selected spots, the transmission-line conductors are partly exposed to allow any ice and/or liquid water present at those spots to act as predominantly capacitive electrical loads on the transmission line. These loads change the input impedance of the transmission line, as measured at a suitable excitation frequency. Thus, it should be possible to infer the presence of ice and/or liquid water from measurements of the input impedance and/or electrical parameters related to the input impedance. The sensory transmission line is of the microstrip type and thus thin enough to be placed on an airplane wing without unduly disturbing airflow in flight. The sensory spots are small areas from which the upper layer of the microstrip has been removed to allow any liquid water or ice on the surface to reach the transmission line. The sensory spots are spaced at nominal open-circuit points, which are at intervals of a half wavelength (in the transmission line, not in air) at the excitation frequency. The excitation frequency used in the experiments has been 1 GHz, for which a half wavelength in the transmission line is .4 in. (.10 cm). The figure depicts a laboratory prototype of the instrument. The impedance-related quantities chosen for use in this version of the instrument are the magnitude and phase of the scattering parameter S11 as manifested in the in-phase (I ) and quadrature (Q) outputs of the phase detector. By careful layout of the transmission line (including the half-wavelength sensor spacing), one can ensure that the amplitude and phase of the input to the phase detector keep shifting in the same direction as ice forms on one or more of the sensor areas. Although only one transmission-line sensor strip is used in the laboratory version, in a practical application, it could be desirable to install multiple strips on different areas to detect localized icing. In that case, a multiplexer should be used to connect the various strips to the phase detector for sequential measurements. Experiments have been performed with freezing and thawing of water and of water/glycol mixtures. The experiments have shown that, whether or not glycol is present, it is possible to distinguish between liquid water and ice via the I and Q outputs; in particular, the equipment can be adjusted so that when water freezes, I decreases and Q increases. With respect to the operation of this instrument, the main effect of glycol is to increase the freezing or thawing time.
Ngo, Phong↗
Solar Power Satellite Microwave Transmission and Reception
Numerous analytical and experimental investigations related to SPS microwave power transmission and reception are reported. Aspects discussed include system performance, phase control, power amplifiers, radiating elements, rectenna, solid state configurations, and planned program activities.
Dietz, R. H.↗
Microwave transmission system for space power
The system considered makes use of a combined dipole antenna and rectifier. The dipole elements feed a balanced transmission line low-pass filter. A description of a laboratory model microwave power transmission system is given and a higher-power project with a longer range is discussed. Space power transmission experiments are also considered. It is pointed out that the investigations have shown that high overall transmission link efficiencies are possible.
Dickinson, R. M.↗
Effect of discontinuities on the group delay of a microwave transmission line
The problem is considered of the effect of reflections from discontinuities at each end of a transmission line on the group delay at microwave frequencies. Previous work is briefly reviewed and a general analysis is made. Graphical data are presented based upon the formulas developed. Experimental results are given which confirm the theory.
Beatty, R. W.↗
Applicaton of radiative transfer theory to microwave transmission medium calibrations
Precise determinations of the transmission medium loss and noise temperature contribution which are important to the performance characterization of low noise microwave receiving systems and thermal noise standards are discussed. Tropospheric loss is frequently inferred from microwave radiometer noise temperature measurements. Interpretation of these measurements requires an inversion of the radiative transfer integral equation. This is inconvenient even with computer techniques. Solutions of a rapidly convergent power series of the radiative transfer equations are presented. This solution is applicable to a low loss medium with either uniform or nonuniform loss distributions. A four layer atmosphere model is investigated to demonstrate the accuracy of the solution relative to the model. Applications include thermal noise standards and single- and dual-frequency water radiometers.
Stelzried, C. T.↗
Microwave transmission system for space power
A small total system model and a large subsystem element similar to those that could be eventually used for wireless power transmission experiments in space have been successfully demonstrated by NASA. The short range, relatively low-power laboratory system achieved a dc-to-dc transmission efficiency of 54%. A separate high-power-level receiving subsystem, tested over a 1.54-km range at Goldstone, California, has achieved the transportation of over 30 kW of dc output power. Both tests used 12-cm wavelength microwaves.
Dickinson, R. M.↗
Effect of water additions on microwave transmission through a simulated reentry plasma layer
Explore the source record for details and available documents.
Cooper, D. W.↗
Effects of mismatch on group delay of microwave transmission
Calculation method can be applied to transmission lines operating in TEM mode or to single-mode propagation in waveguides. Derived data are useful for estimating limits on variation of group delay with frequency or in determining how much discontinuity reduction is necessary to achieve given accuracy in predicting group delay.
Beatty, R. W.↗
Microwave Transmission Technique for Accurate Impedance Characterization of Superconductive Bolometric Mixers
The impedance of the supconducting hot-electron bolometer mixer was measured in the range 0.2-4 GHz. A special technique relying on determination of S21 transmission parameter of the device was used. Many advantages of the techinque (wide frequency range, in sity calibration, low tes power, accuracy) are demonstrated. The estimate of the mixer bandwidth from the impedance data using the mixer theory is in good agreement with the results ofthe direct bandwidth measurements.
hot-electron bolometer mixer transmission↗
Free-space microwave power transmission study, phase 3
The results of an investigation of the technology of free-space power transmission by microwave beam are presented. A description of the steps that were taken to increase the overall dc to dc efficiency of microwave power transmission from 15 percent to over 50 percent is given. Included in this overall efficiency were the efficiencies of the dc to microwave conversion, the microwave transmission itself, and the microwave to dc conversion. Improvements in launching the microwave beam with high efficiency by means of a dual mode horn resulted in 95 percent of the output of the microwave generator reaching the receiving area. Emphasis was placed upon successive improvements in reception and rectification of the microwave power, resulting in the design of a rectenna device for this purpose whose efficiency was 75 percent. The procedures and the hardware developed were the basis for tests certified by the Jet Propulsion Laboratory in which an overall dc to dc efficiency of 54 percent was achieved.
Brown, W. C.↗
Space-Based Solar Power Conversion and Delivery Systems Study. Volume 3: Microwave Power Transmission Studies
The Microwave Fower Beam Ionosphere effects and critical interfaces between th Microwave Power Transmission System (MPTS) and the Satellite were studied as part of the NASA/MSFC continuing research on the feasibility of power transmission from geosynchronous orbit. Theoretical predications of ionospheric modifications produced by the direct interaction of the MPTS on the earth's upper atmosphere are used to determine their impact on the performance of the Microwave Power Beam and Pilot Beam System as well as on other RF systems effected by the ionosphere. A technology program to quantitatively define these interactions is developed. Critical interface areas between the MPTS and the satellite which could have a major impact on cost and performance of the power system are idenfified and analyzed. The areas selected include: use of either a 20 kV versus 40 kV Amplitron, thermal blockage effects of Amplitron heat radiation by the satellite structure, effect of dielectric carry-through structure on power beam, and effect of material sublimation on performance of the Amplitron in Geosynchronous Orbit.
Source record↗
Simulation Diagnostics of Multiple Discontinuities in A Microwave Coaxial Transmission Line
Multiple discontinuities in microwave transmission lines can cause unusual reflection and transmission loss charactristics as functions of frequency. This article presents a methord for developing models that simulate return loss and insertion loss data measured over a broad band of frequencies.
Microwave↗
Free-space microwave-power transmission
Laboratory-scale wireless transmission of microwave power approaches fifty-four percent efficiency. DC is converted to a 2.45-GHz signal and is transmitted through horn antenna array; microwave signal is received at rectenna and is simultaneously collected and rectified back to dc at receiving sites; dc is then processed for wired distribution.
Brown, W. C.↗
Workshop on Microwave Power Transmission and Reception. Workshop Paper Summaries
Microwave systems performance and phase control are discussed. Component design and reliability are highlighted. The power amplifiers, radiating elements, rectennas, and solid state configurations are described. The proper sizing of microwave transmission systems is also discussed.
Source record↗
Solar power satellite microwave power transmission and reception system
The microwave power transmission and reception system of the Satellite Power System (SPS) has been intensively reviewed and assessed in a three-year concept development and evaluation program. This paper will review some concepts of SPS with particular emphasis on the design of the microwave power transmission and reception system. Technology requirements and proposals for meeting them will be discussed for various parts of the microwave system and to some degree for critical components such as power amplifiers. Specific subjects to be discussed are SPS concepts, antenna design, phase control, rectenna, and technology.
Finnell, W.↗
Coaxial line configuration for microwave power transmission study of YBa2Cu3O(7-delta) thin films
Microwave transmission measurements through YBa2Cu3O(7-delta) (YBCO) high-transition-temperature superconducting thin films on lanthanum aluminate (LaAlO3) have been performed in a coaxial line at 10 GHz. LaAlO3 substrates were ultrasonically machined into washer-shaped discs, polished, and coated with laser-ablated YBCO. These samples were mounted in a 50-ohm coaxial air line to form a short circuit. The power transmitted through the films as a function of temperature was used to calculate the normal state conductivity and the magnetic penetration depth for the films.
Chorey, C. M.↗