Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “KRYPTON 85 TARGET”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

Simple parameterization of nuclear attenuation data

Based on the semi-inclusive deep inelastic scattering data obtained by the HERMES experiment on deuterium, nitrogen and krypton nuclei, it is shown that a ratio of multiplicities on nucleus and deuterium (per nucleon) for given hadron R{sub M}{sup h} can be parametrized in a form of a linear polynomial a{sub 11}+{tau}a{sub 12}, where {tau} is the formation time, which depends on the energy of the virtual photon {nu} and fraction of that energy z carried by the final hadron. Three widely known parametrizations for {tau} were used for the performed fit. The fit parameters a{sub 11} and a{sub 12} do not depend on {nu} and z.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Krypton-xenon separation properties of SAPO-34 zeolite materials and membranes

Separation of the radioisotope 85 Kr from 136 Xe is an important target during used nuclear fuel recycling. In this paper, we report a detailed study on the Kr and Xe adsorption, diffusion, and membrane permeation properties of the silicoaluminophosphate zeolite SAPO-34. Adsorption and diffusion measurements on SAPO-34 crystals indicate their potential for use in Kr-Xe separation membranes, but also highlight competing effects of adsorption and diffusion selectivity. SAPO-34 membranes are synthesized on α$-$alumina disk and tubular substrates via steam assisted conversion seeding and hydrothermal growth, and are characterized in detail. Membrane transport measurements reveal that SAPO-34 membranes can separate Kr from Xe by molecular sieving, with Kr permeabilities around 50 Barrer and mixture selectivity of 25–30 for Kr at ambient or slight sub-ambient conditions. Finally, the membrane transport characteristics are modeled by the Maxwell-Stefan equations, whose predictions are in very good agreement with experiment and confirm the minimal competing effects of adsorption and diffusion.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Chromatographic separation of radioactive noble gases from xenon

The Large Underground Xenon (LUX) experiment operates at the Sanford Underground Research Facility to detect nuclear recoils from the hypothetical Weakly Interacting Massive Particles (WIMPs) on a liquid xenon target. Liquid xenon typically contains trace amounts of the noble radioactive isotopes 85 Kr and 39 Ar that are not removed by the in situ gas purification system. The decays of these isotopes at concentrations typical of research-grade xenon would be a dominant background for a WIMP search exmperiment. To remove these impurities from the liquid xenon, a chromatographic separation system based on adsorption on activated charcoal was built. 400 kg of xenon was processed, reducing the average concentration of krypton from 130 ppb to 3.5 ppt as measured by a cold-trap assisted mass spectroscopy system. Finally, a 50 kg batch spiked to 0.001 g/g of krypton was processed twice and reduced to an upper limit of 0.2 ppt.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Characterization and controllability of radiated power via extrinsic impurity seeding in strongly negative triangularity plasmas in DIII-D

Experiments with extrinsic impurity seeding in strongly negative triangularity shapes in DIII-D achieved radiated power fractions (relative to input power) of up to ≈85% total radiation and ≈55% core radiation in steady-operating conditions. The relationship between core and total radiation was sensitive to impurity species and input power. Attempts to reach higher radiation levels via higher impurity flows resulted in radiative collapse disruptions. Nitrogen, neon, argon, and krypton were tested. Injection was by gas puffing, usually controlled by feeding back real-time estimates for core or total radiating fractions ($P_\textrm{rad} / P_\textrm{input}$). Argon and krypton were controlled by feeding back total radiating fraction, whereas neon was controlled by feeding back the core radiating fraction, due to the lower efficiency of neon as a divertor radiator. Nitrogen flows were pre-programmed. Reasonable total $P_\textrm{rad}$ control target following was achieved with argon or krypton. Control was more challenging with the neon/core radiation configuration, which was more prone to slow response and overshooting of the control target. Poor particle removal contributed to the control challenge: neon particle inventory within the last closed flux surface was roughly constant for up to 1 s (the longest duration tested) after neon injection was halted. However, separate experiments with laser-blow off of non-recycling impurities measured a short impurity confinement time, on the scale of the energy confinement time of ∼100 ms. Modeling with the Aurora impurity transport simulation matched experimental neon density profiles with full recycling (R = 1.0) and weak pumping but predicted rapid decreases in neon inventory if pumping were increased or recycling decreased. This indicates that changes outside the confined plasma (adding a well-placed pump) would improve controllability for all highly recycling species.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Destructive PIE and Safety Testing of Six AGR-5/6/7 Capsule 2 Compacts

This study evaluates fission product retention and particle failure mechanisms in AGR-5/6/7 Capsule 2 uranium carbide and uranium oxide (UCO) tristructural isotropic (TRISO) fuel under high-temperature gas reactor accident-relevant conditions using high-temperature safety tests and destructive post-irradiation examination. Three Capsule 2 compacts were held isothermally at 1600°C for approximately 300 hours and one compact at 1800°C for approximately 300 hours; two additional compacts were examined in the as-irradiated state. Post-test deconsolidation–leach–burn–leach (DLBL) quantified nuclide inventories in matrix and particles. Individual particles were surveyed for radioisotope inventories, and microanalytical approaches resolved microstructural evolution and fission product distributions within the coating layers. At 1600°C, no krypton was detected above the minimum detectable limit, and cesium releases were far below a single particle equivalent, indicating the absence of full TRISO failure or SiC failures. Silver releases were limited and primarily reflected depleted post-irradiation inventories, consistent with prior compact-level exams indicating substantial in-pile 110m Ag loss. At 1800°C, cumulative 134 Cs release of approximately 2.5 particle equivalents and delayed 85 Kr totaling approximately 0.53 particle equivalents were consistent with one full TRISO failure and two SiC failures. Europium and strontium releases were roughly one order of magnitude higher than at 1600°C and comparable to AGR-1/AGR-2 high-temperature tests, with sustained late-hold rates indicating diffusion through intact coatings coupled with matrix depletion. Overall, AGR-5/6/7 Capsule 2 UCO fuel demonstrated fission product retention during safety testing consistent with prior AGR campaigns, while distinctive in-pile 110m Ag depletion and measurable 1600°C europium loss motivate targeted follow-on studies.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Adsorption of Iodine and Tritium from UNF Reprocessing Off-Gas Streams

The need to control emissions of the gaseous radionuclides to the air during nuclear fuel recycling is widely recognized. Gaseous radionuclides can partition to off-gas streams emanating from the various individual processes used in the recycle plant, such as from the mechanical head end (shear), tritium pretreatment, fuel dissolver, vessel vents, cell ventilation, and conversion operations. In traditional recycle plants, the bulk of the four primary volatile fission products (i.e., {sup 3}H, {sup 14}C, {sup 85}Kr, and {sup 129}I) is released in the head-end processes, for example, the dissolution process. The usual off-gas treatment sequence of operations targets removal of tritium (as {sup 3}HHO), iodine, carbon (as {sup 14}CO{sub 2}), and the noble gases, in that order. Water and iodine are captured first because the other species are relatively unimpeded by the sorbents used for water and iodine, so they flow downstream to additional treatment processes. Water and iodine do react with one another, and many techniques used to collect one of these species also collect some fraction of the other. It is quite desirable to sequester the iodine and water separately because the tritiated water may be disposed of as a low level waste. If not cleanly separated, contamination of the low-level waste by iodine may elevate its classification to high-level waste and result in greater costs for disposal. The proposed sorption sequence was tested in the laboratory. Use of a second column of AgZ permits the detection of breakthrough from the primary AgZ column while protecting the downstream 3AMS column from collecting iodine. (This arrangement is equivalent to enabling intra-column sampling of the primary column.) Neutron activation analysis of the 3AMS revealed that iodine was below, or at, the level of detection. The results successfully demonstrated that iodine can be sequestered in the AgZ while the water is collected free of iodine in the 3AMS column. (authors)

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗