Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Energy gap”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1999

Noise and Bandwidth Measurements of Diffusion-Cooled Nb Hot-Electron Bolometer Mixers at Frequencies Above the Superconductive Energy Gap

Diffusion-cooled Nb hot-electron bolometer (HEB) mixers have the potential to simultaneously achieve high intermediate frequency (IF) bandwidths and low mixer noise temperatures for operation at THz frequencies (above the superconductive gap energy). We have measured the IF signal bandwidth at 630 GHz of Nb devices with lengths L = 0.3, 0.2, and 0.1 micrometer in a quasioptical mixer configuration employing twin-slot antennas. The 3-dB EF bandwidth increased from 1.2 GHz for the 0.3 gm long device to 9.2 GHz for the 0.1 gm long device. These results demonstrate the expected 1/L squared dependence of the IF bandwidth at submillimeter wave frequencies for the first time, as well as the largest EF bandwidth obtained to date. For the 0.1 gm device, which had the largest bandwidth, the double sideband (DSB) noise temperature of the receiver was 320-470 K at 630 GHz with an absorbed LO power of 35 nW, estimated using the isothermal method. A version of this mixer with the antenna length scaled for operation at 2.5 THz has also been tested. A DSB receiver noise temperature of 1800 plus or minus 100 K was achieved, which is about 1,000 K lower than our previously reported results. These results demonstrate that large EF bandwidth and low-noise operation of a diffusion-cooled HEB mixer is possible at THz frequencies with the same device geometry.

Wyss, R. A.↗
DOE OSTI2024

Nonadiabatic Derivative Couplings through Multiple Franck–Condon Modes Dictate the Energy Gap Law for Near and Short-Wave Infrared Dye Molecules

Near infrared (NIR, 700–1000 nm) and short-wave infrared (SWIR, 1000–2000 nm) dye molecules exhibit significant nonradiative decay rates from the first singlet excited state to the ground state. While these trends can be empirically explained by a simple energy gap law, detailed mechanisms of nearly universal behavior have remained unsettled for many cases. Theoretical and experimental results for two representative NIR/SWIR dye molecules reported here clarify the key mechanism for the observed energy gap law behavior. It is shown that the first derivative nonadiabatic coupling terms serve as major coupling pathways for nonadiabatic decay processes from the first excited singlet state to the ground state for these NIR and SWIR dye molecules and that vibrational modes other than the highest frequency modes also make significant contributions to the rate. Finally, this assessment is corroborated by further theoretical comparison with possible alternative mechanisms of intersystem crossing to triplet states and also by comparison with experimental data for deuterated molecules.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Small energy gap revealed in CrBr 3 by scanning tunneling spectroscopy

CrBr 3 is a layered van der Waals material with magnetic ordering down to the 2D limit. For decades, based on optical measurements, it is believed that the energy gap of CrBr 3 is in the range of 1.68–2.1 eV. However, controversial results have indicated that the band gap of CrBr 3 is possibly smaller than that. An unambiguous determination of the energy gap is critical to the correct interpretations of the experimental results of CrBr 3 . Here, we present the scanning tunneling microscopy and spectroscopy (STM/S) results of CrBr 3 thin and thick flakes exfoliated onto highly ordered pyrolytic graphite (HOPG) surfaces and density functional theory (DFT) calculations to reveal the small energy gap (peak-to-peak energy gap to be 0.57 ± 0.04 eV; or the onset signal energy gap to be 0.29 ± 0.05 eV from dI/dV spectra). Atomic resolution topography images show the defect-free crystal structure and the dI/dV spectra exhibit multiple peak features measured at 77 K. The conduction band – valence band peak pairs in the multi-peak dI/dV spectrum agree very well with all reported optical transitions. STM topography images of mono- and bi-layer CrBr 3 flakes exhibit edge degradation due to short air exposure (~15 min) during sample transfer. The unambiguously determined small energy gap settles the controversy and is the key in better understanding CrBr 3 and similar materials.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Energy gap of topological surface states in proximity to a magnetic insulator

Abstract Topological surface-states can acquire an energy gap when time-reversal symmetry is broken by interfacing with a magnetic insulator. This gap has yet to be measured. Such topological-magnetic insulator heterostructures can host a quantized anomalous Hall effect and can allow the control of the magnetic state of the insulator in a spintronic device. In this work, we observe the energy gap of topological surface-states in proximity to a magnetic insulator using magnetooptical Landau level spectroscopy. We measure Pb 1-x Sn x Se–EuSe heterostructures grown by molecular beam epitaxy exhibiting a record mobility and low Fermi energy. Through temperature dependent measurements and theoretical calculations, we show this gap is likely due to quantum confinement and conclude that the magnetic proximity effect is weak in this system. This weakness is disadvantageous for the realization of the quantum anomalous Hall effect, but favorable for spintronic devices which require the preservation of spin-momentum locking at the Fermi level.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2021

Multi-atom quasiparticle scattering interference for superconductor energy-gap symmetry determination

Complete theoretical understanding of the most complex superconductors requires a detailed knowledge of the symmetry of the superconducting energy-gap Δ$^α_k$, for all momenta k on the Fermi surface of every band α. While there are a variety of techniques for determining |Δ$^α_k$|, no general method existed to measure the signed values of Δ$^α_k$. Recently, however, a technique based on phase-resolved visualization of superconducting quasiparticle interference (QPI) patterns, centered on a single non-magnetic impurity atom, was introduced. In principle, energy-resolved and phase-resolved Fourier analysis of these images identifies wavevectors connecting all k-space regions where Δ$^α_k$ has the same or opposite sign. But use of a single isolated impurity atom, from whose precise location the spatial phase of the scattering interference pattern must be measured, is technically difficult. Here we introduce a generalization of this approach for use with multiple impurity atoms, and demonstrate its validity by comparing the Δ$^α_k$ it generates to the Δ$^α_k$ determined from single-atom scattering in FeSe where s ± energy-gap symmetry is established. Finally, to exemplify utility, we use the multi-atom technique on LiFeAs and find scattering interference between the hole-like and electron-like pockets as predicted for Δ$^α_k$ of opposite sign.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
NASA NTRS1987

Energy-gap spectroscopy of superconductors using a tunneling microscope

A unique scanning tunneling microscope (STM) system has been developed for spectroscopy of the superconducting energy gap. High-resolution control of tunnel current and voltage allows for measurement of superconducting properties at tunnel resistance levels 100-1000 greater than that achieved in prior work. The previously used STM methods for superconductor spectroscopy are compared to those developed for the work reported here. Superconducting energy-gap spectra are reported for three superconductors, Pb, PbBi, and NbN, over a range of tunnel resistance. The measured spectra are compared directly to theory.

Le Duc, H. G.↗
DOE OSTI2021

A simple generalization of the energy gap law for nonradiative processes

For more than 50 years, an elegant energy gap (EG) law developed by Englman and Jortner [Mol. Phys. 18, 145 (1970)] has served as a key theory to understand and model the nearly exponential dependence of nonradiative transition rates on the difference of energy between the initial and final states. This work revisits the theory, clarifies the key assumptions involved in the rate expression, and provides a generalization for the cases where the effects of temperature dependence and low-frequency modes cannot be ignored. For a specific example where the low-frequency vibrational and/or solvation responses can be modeled as an Ohmic spectral density, a simple generalization of the EG law is provided. Test calculations demonstrate that this generalized EG law brings significant improvement over the original EG law. Both the original and generalized EG laws are also compared with the stationary phase approximations developed for electron transfer theory, which suggests the possibility of a simple interpolation formula valid for any value of EG.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

B—N–Bond–Embedded Triplet Terpolymers with Small Singlet–Triplet Energy Gaps for Suppressing Non–Radiative Recombination and Improving Blend Morphology in Organic Solar Cells

Suppressing the photon energy loss (E loss ), especially the non-radiative loss, is of importance to further improve the device performance of organic solar cells (OSCs). However, typical π-conjugated semiconductors possess a large singlet–triplet energy gap (ΔE ST ), leading to a lower triplet state than charge transfer state and contributing to a non-radiative loss channel of the photocurrent by the triplet state. Herein, a series of triplet polymer donors are developed by introducing a BNIDT block into the PM6 polymer backbone. Further, the high electron affinity of BNIDT and the opposite resonance effect of the B—N bond in BNIDT results in a lowered highest occupied molecular orbital (HOMO) and a largely reduced ΔE ST . Moreover, the morphology of the active blends is also optimized by fine-tuning the BNIDT content. Therefore, non-radiative recombination via the terminal triplet loss channels and morphology traps is effectively suppressed. The PNB-3 (with 3% BNIDT):L8-BO device exhibits both small ΔE ST and optimized morphology, favoring more efficient charge transfer and transport. Finally, the simultaneously enhanced V oc of 0.907 V, J sc of 26.59 mA cm –2 , and FF of 78.86% contribute to a champion PCE of 19.02%. Therefore, introducing B—N bonds into benchmark polymers is a possible avenue toward higher-performance of OSCs.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Momentum-resolved superconducting energy gaps of Sr 2 RuO 4 from quasiparticle interference imaging

Sr 2 RuO 4 has long been the focus of intense research interest because of conjectures that it is a correlated topological superconductor. It is the momentum space ( k -space) structure of the superconducting energy gap Δ i ( k ) on each band i that encodes its unknown superconducting order parameter. However, because the energy scales are so low, it has never been possible to directly measure the Δ i ( k ) of Sr 2 RuO 4 . In this work, we implement Bogoliubov quasiparticle interference (BQPI) imaging, a technique capable of high-precision measurement of multiband Δ i ( k ). At T = 90 mK,we visualize a set of Bogoliubov scattering interference wave-vectors q j : j = 1 – 5 consistent with eight gap nodes/minima that are all closely aligned to the (±1, ±1) crystal lattice directions on both the α and β bands. Taking these observations in combination with other very recent advances in directional thermal conductivity, temperature-dependent Knight shift, time-reversal symmetry conservation, and theory, the BQPI signature of Sr 2 RuO 4 appears most consistent with Δ i ( k ) having d x 2 – y 2 ( B 1 g ) symmetry.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Correlation of Broad Absorption Band with Small Singlet‐Triplet Energy Gap in Organic Photovoltaics

Abstract Organic photovoltaics (OPV) are one of the most effective ways to harvest renewable solar energy, with the power conversion efficiency (PCE) of the devices soaring above 19 % when processed with halogenated solvents. The superior photocurrent of OPV over other emerging photovoltaics offers more opportunities to further improve the efficiency. Tailoring the absorption band of photoactive materials is an effective way to further enhance OPV photocurrent. However, the field has mostly been focusing on improving the near‐infrared region photo‐response, with the absorption shoulders in short‐wavelength region (SWR) usually being neglected. Herein, by developing a series of non‐fullerene acceptors (NFAs) with varied side‐group conjugations, we observe an enhanced SWR absorption band with increased side‐group conjugation length. The underpinning factors of how molecular structures and geometries improve SWR absorption are clearly elucidated through theoretical modelling and crystallography. Moreover, a clear relationship between the enhanced SWR absorption and reduced singlet‐triplet energy gap is established, both of which are favorable for the OPV performance and can be tailored by rational structure design of NFAs. Finally, the rationally designed NFA, BO‐TTBr, affords a decent PCE of 18.5 % when processed with a non‐halogenated green solvent.

Chemistry↗