Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Beam tracking”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2011

Two-Photon-Absorption Scheme for Optical Beam Tracking

A new optical beam tracking approach for free-space optical communication links using two-photon absorption (TPA) in a high-bandgap detector material was demonstrated. This tracking scheme is part of the canonical architecture described in the preceding article. TPA is used to track a long-wavelength transmit laser while direct absorption on the same sensor simultaneously tracks a shorter-wavelength beacon. The TPA responsivity was measured for silicon using a PIN photodiode at a laser beacon wavelength of 1,550 nm. As expected, the responsivity shows a linear dependence with incident power level. The responsivity slope is 4.5 x 10(exp -7) A/W2. Also, optical beam spots from the 1,550-nm laser beacon were characterized on commercial charge coupled device (CCD) and complementary metal-oxide semiconductor (CMOS) imagers with as little as 13.7 microWatts of optical power (see figure). This new tracker technology offers an innovative solution to reduce system complexity, improve transmit/receive isolation, improve optical efficiency, improve signal-to-noise ratio (SNR), and reduce cost for free-space optical communications transceivers.

Ortiz, Gerardo G.↗
NASA NTRS1988

Analysis of the EM scattering from arbitrary open-ended waveguide cavities using axial Gaussian Beam tracking

The electromagnetic (EM) scattering from a planar termination located inside relatively arbitrarily shaped open-ended waveguide cavities with smoothly curved interior walls is analyzed using a Gaussian Beam (GB) expansion of the incident plane wave fields in the open end. The cavities under consideration may contain perfectly-conducting interior walls with or without a thin layer of material coating, or the walls may be characterized by an impedance boundary condition. In the present approach, the GB's are tracked only to the termination of the waveguide cavity via beam reflections from interior waveguide cavity walls. The Gaussian beams are tracked approximately only along their beam axes; this approximation which remains valid for relatively well focussed beams assumes that an incident GB gives rise to a reflected GB with parameters related to the incident beam and the radius of curvature of the wall. It is found that this approximation breaks down for GB's which come close to grazing a convex surface and when the width of the incident beam is comparable to the radius of curvature of the surface. The expansion of the fields at the open end depend on the incidence angle only through the expansion coefficients, so the GB's need to be tracked through the waveguide cavity only once for a wide range of incidence angles. At the termination, the sum of all the GB's are integrated using a result developed from a generalized reciprocity principle, to give the fields scattered from the interior of the cavity. The rim edge at the open end of the cavity is assumed to be sharp and the external scattering from the rim is added separately using Geometrical Theory of Diffraction. The results based on the present approach are compared with solutions based on the hybrid asymptotic modal method. The agreement is found to be very good for cavities made up of planar surfaces, and also for cavities with curved surfaces which are not too long with respect to their width.

Burkholder, R. J.↗
NASA NTRS1993

Cellular track model for study of heavy ion beams

Track theory is combined with a realistic model of a heavy ion beam to study the effects of nuclear fragmentation on cell survival and biological effectiveness. The effects of secondary reaction products are studied as a function of depth in a water column. Good agreement is found with experimental results for the survival of human T-l cells exposed to monoenergetic carbon, neon, and argon beams under aerobic and hypoxia conditions. The present calculation, which includes the effect of target fragmentation, is a significant improvement over an earlier calculation because of the use of a vastly improved beam model with no change in the track theory or cellular response parameters.

Shinn, Judy L.↗
NASA NTRS1990

Standard-M mobile satellite terminal employing electronic beam squint tracking

In recent years, extensive experience has been built up at the University of Bristol in the use of the Electronic Beam Squint (EBS) tracking technique, applied to large earth station facilities. The current interest in land mobile satellite terminals, using small tracking antennas, has prompted the investigation of the applicability of the EBS technique to this environment. The development of an L-band mechanically steered vehicle antenna is presented. A description of the antenna is followed by a detailed investigation of the tracking environment and its implications on the error detection capability of the system. Finally, the overall hardware configuration is described along with plans for future work.

Hawkins, G. J.↗
DOE OSTI2025

Poisson Equation for a (General) Homogeneous d-Dimensional Ellipsoid with Applications to Beam Envelope Tracking

This note describes the solution of the free-space Poisson equation in the interior of a $d$-dimensional homogeneous ellipsoid, and the associated space charge fields. An explicit formula (\ref{Sformula}) is provided that relates the $d\times d$ matrix describing the space charge (quadratic) potential to the $d\times d$ covariance matrix of the ellipsoid. For the cases $d=2$ and $d=3$, this result is used to determine the linear map corresponding to a space charge kick, that may be used to push the beam $6\times 6$ covariance matrix during envelope tracking. The treatment of upright ellipsoids for $d=2$ and $d=3$ is well-represented in the literature. However, the approach taken here emphasizes a general ellipsoid with arbitrary correlations in any dimension. The Appendix provides a general solution of the free-space Poisson equation in dimension $d$ for a source distribution with ellipsoidal symmetry.

97 MATHEMATICS AND COMPUTING↗
NASA NTRS1988

Optical Alignment Device For Laser Communication

Optical alignment device under development enables continuous tracking and coalignment of two beams of light. Intended primarily for laser-communication station, in which transmitted beam must be aligned with received beam to ensure transmitted beam falls on receiver at other station. Expected to consume less power and be smaller and less complicated than alignment shutter and drive previously used. Prism and filter separate two overlapping collimated light beams of different wavelength or polarization. Coordinates of two beams tracked on charge-coupled device to determine degree of directional misalignment between two beams.

Casey, William L.↗
DOE OSTI2025

Update on Ce+BAF Injector Baseline Simulations

Progress in the development of the positron injector concept for the Ce+BAF is presented. The results of start-to-end positron beam tracking simulations for two injector operating modes (low current high polarized beam and high current low polarized beam) are discussed. The efficiency of the positron capture system based on a normal conducting focusing solenoid downstream of the conversion target is compared with the efficiency of a superconducting solenoid.

Ushakov [Thomas Jefferson National Accelerator Fac↗
DOE OSTI2026

High-rate heavy-ion tracking using MWPCs and PPACs with an Anti-Discharge Unit

This work reports on the development of two robust, heavy-ion beam tracking concepts operating at low pressure (< 15 Torr) for high rate applications (> 200 kHz). The first concept consists of a Multi-Wire Proportional Counter (MWPC) with a central anode consisting of 12 μm Au-plated Tungsten wires spaced 1 mm from each other. The anode grid is sandwiched between two segmented cathodes aligned orthogonally in the two dimensions for (x,y) particle localization. The second detector is a Parallel-Plate Avalanche Counter (PPAC) that uses the same readout geometry as the MWPC, but replaces the wire anode with a 150 nm silver layer deposited on both sides of a thin (< 1 mg/cm 2 ) polypropylene foil. Additionally, the bias circuitry for the PPAC anode central foil is equipped with an Anti-Discharge Unit (ADU) to prevent transitions from proportional operation to streamer formation, thereby avoiding damaging discharges. The localization capability of both detectors was tested with a low-rate alpha-particle source (241-Am). A position resolution of < 1 mm (FWHM) was achieved under stable, high-gas-gain (> 1000) operating conditions. Their performance in terms of detection efficiency as a function of the isotope charge (Z) was determined by irradiating the detectors with a cocktail beam (Z ≤ 15) with energy of ∼ 100 MeV/u. Full detection efficiency is maintained for all available fragments under optimal operational conditions (i.e., voltage bias). Full detection efficiency was achieved at rates above 200 kHz by irradiating the detectors with a 1 cm diameter 238 U beam at an energy of 143 MeV/u.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2025

Radial Steering Displacement Method to Measure Dispersion

The measurement of the dispersion function in a transfer line plays the crucial role for the development of an accurate optics model for the beam tracking simulation. In this technical note, we describe an experimental method to measure the dispersion value at multi-wire location MW063 in the NASA Space Radiation Laboratory (NSRL) transfer line. Finally, we use our MADX model to calculate the dispersion function at the same multi-wire location. The ultimate goal of this measurement and calculation is to understand the right value of dispersion function and the beam size (emittance) at the entrance of NSRL beam line.

43 PARTICLE ACCELERATORS↗
NASA NTRS2012

Low-Cost Phased Array Antenna for Sounding Rockets, Missiles, and Expendable Launch Vehicles

A low-cost beamformer phased array antenna has been developed for expendable launch vehicles, rockets, and missiles. It utilizes a conformal array antenna of ring or individual radiators (design varies depending on application) that is designed to be fed by the recently developed hybrid electrical/mechanical (vendor-supplied) phased array beamformer. The combination of these new array antennas and the hybrid beamformer results in a conformal phased array antenna that has significantly higher gain than traditional omni antennas, and costs an order of magnitude or more less than traditional phased array designs. Existing omnidirectional antennas for sounding rockets, missiles, and expendable launch vehicles (ELVs) do not have sufficient gain to support the required communication data rates via the space network. Missiles and smaller ELVs are often stabilized in flight by a fast (i.e. 4 Hz) roll rate. This fast roll rate, combined with vehicle attitude changes, greatly increases the complexity of the high-gain antenna beam-tracking problem. Phased arrays for larger ELVs with roll control are prohibitively expensive. Prior techniques involved a traditional fully electronic phased array solution, combined with highly complex and very fast inertial measurement unit phased array beamformers. The functional operation of this phased array is substantially different from traditional phased arrays in that it uses a hybrid electrical/mechanical beamformer that creates the relative time delays for steering the antenna beam via a small physical movement of variable delay lines. This movement is controlled via an innovative antenna control unit that accesses an internal measurement unit for vehicle attitude information, computes a beam-pointing angle to the target, then points the beam via a stepper motor controller. The stepper motor on the beamformer controls the beamformer variable delay lines that apply the appropriate time delays to the individual array elements to properly steer the beam. The array of phased ring radiators is unique in that it provides improved gain for a small rocket or missile that uses spin stabilization for stability. The antenna pattern created is symmetric about the roll axis (like an omnidirectional wraparound), and is thus capable of providing continuous coverage that is compatible with very fast spinning rockets. For larger ELVs with roll control, a linear array of elements can be used for the 1D scanned beamformer and phased array, or a 2D scanned beamformer can be used with an NxN element array.

Mullinix, Daniel↗
DOE OSTI2026

Chromaticity compensation of a ghost collider

The GHOST collider final focus system is a pure quadrupole-drift beamline targeting ¿* = 2 mm at four serial interaction points, with peak ¿-functions reaching ~65 km in the final triplet. Beam tracking simulations reveal that a nominal bunch develops a pronounced C-shape in longitu- dinal phase space at IP1, with ¿¿ growing from 0.15 mm to ~2.3 mm — a factor of ~15× increase that directly re- duces luminosity. The mechanism is identified as chromat- ically amplified betatron path length: off-momentum par- ticles acquire enlarged betatron amplitudes in the high-¿ final triplet, generating excess path length via the geometric ¿¿ = - 1/2 ¿ (¿'2 + ¿'2) ¿¿ integral. Within the monoenergetic Balandin framework, ¿2¿2 with ¿ = - 1/2 ¿ ¿ ¿¿ dominates ¿2¿2 by over four million times; the full beam ¿¿ is a fur- ther factor of ~27 larger, driven by ¿¿ -induced chromatic amplitude growth. Phase-advance scans confirm that ¿¿ is insensitive to the apochromatic (¿ ˜ 0) condition. When combined with the geometric hourglass effect, this distor- tion poses a challenge to maximizing luminosity within the current lattice design.

Gamage, B. [Thomas Jefferson National Accelerator ↗
DOE OSTI2026

The Memory Scaling of Reverse-Mode Differentiation in Particle Accelerator Simulations with Space Charge

The recent development of differentiable simulation codes for particle accelerators has enabled gradient-based workflows that promise finer control and more realistic modeling of accelerator facilities. However, when using reverse-mode automatic differentiation, the memory usage continuously increases during the simulation, and can potentially exceed the available hardware memory - especially when costly space charge computation is included. To study the memory requirements for differentiable simulations, we have implemented space charge in Cheetah, a PyTorch-based beam tracking code that supports reverse-mode differentiation. We find that the memory usage for reverse-mode differentiation grows linearly with the number of macroparticles and cells, and that it is proportional to the number of space charge kicks involved in the simulation. This general scaling can be used to evaluate whether a given differentiable simulation is feasible given hardware memory constraints.

Dhamrait, Arjun↗