Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “array”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,783 records · Page 99
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Digital Signal Combiner For Receiving-Antenna Feed Array

Proposed digital system combines digitized baseband samples of signals received by array of feeds in large Cassegrainian paraboloidal-dish antenna. Signals received by subantennas in focal-plane array of large dish antenna combined by system compensating in real time for distortions of wave fronts caused by mechanical distortions of antenna. Signal-combining system combines baseband output signals of receiver front ends according to complex weighting parameters estimated from signals themselves. Intended to compensate in real time for degradation of signal-to-noise ratio by vibrational, gravitational, and wind-induced deformations of antenna structure.

Vilnrotter, Victor A.↗
NASA NTRS1991

Flexible Generation Of Array-Detector Timing Signals

Assembly of custom-made electronic equipment and multipurpose commercial electronic equipment commonly found in electronics-development laboratories facilitates generation and modification of timing pattern signals for control of array detectors. Designed to serve as flexible electronic array-detector-testing apparatus configured via software; timing patterns created, stored, and changed easily. Assembly prepared for experimental evaluation of new detector design in much less time and less expense than necessary to construct special circuits to generate all timing patterns to be tried on new design.

Travis, Jeffrey W.↗
NASA NTRS1991

Initial studies of array feeds for the 70-meter antenna at 32 GHz

The results of a study to determine the feasibility of using array feed techniques to improve the performance of the 70 m antenna at 32 GHz are presented. Changing from 8.4 to 32 GHz has the potential of increasing the gain by 11.6 dB, but recent measurements indicate that additional losses of from 3 to 7 dB occur at 32 GHz, depending on the elevation angle. Array feeds were proposed to recover some of the losses by compensating for surface distortions that contribute to these losses. Results for both surface distortion compensation and pointing error correction are discussed. These initial studies, however, had one significant restriction: The mechanical finite element model was used to characterize the surface distortions, not the measured distortions from three angle holography data, which would be more representative of the actual antenna. Further work is required to provide for a more accurate estimate of performance that utilizes holography data and, in particular, one that evaluates the performance in the focal plane region of the antenna.

Cramer, P. W.↗
NASA NTRS1991

Atomic oxygen degradation of Intelsat 4-type solar array interconnects: Laboratory investigations

A Hughes 506 type communication satellite belonging to the Intelsat organization was marooned in low Earth orbit on March 14, 1990, following failure of the Titan third stage to separate properly. The satellite, Intelsat VI, was designed for service in geosynchronous orbit and contains several material configurations which are susceptible to attack by atomic oxygen. Analysis showed the silver foil interconnects in the satellite photovoltaic array to be the key materials issue because the silver is exposed directly to the atomic oxygen ram flux. The results are reported of atomic oxygen degradation testing of Intelsat VI type silver foil interconnects both as virgin material and in a configured solar cell element. Test results indicate that more than 80 pct. of the original thickness of silver in the Intelsat VI solar array interconnects should remain after completion of the proposed Space Shuttle rescue and/or reboost mission.

Koontz, S. L.↗
NASA NTRS1991

Advanced Solid-State Array Spectrometer (ASAS) data sets from the 1990 field season: A unique look at two forested ecosystems

The Advanced Solid-state Array Spectrometer (ASAS) is a pointable imaging spectrometer which uses a solid-state array to acquire imagery of terrestrial targets in 29 spectral bands from .4 to .8 microns. Performance and calibration of the instrument are described. The ASAS data sets obtained in 1990 provide a unique look at forest canopies from two different forest regions of the North America continent under varying temporal, spectral, and bidirectional conditions. These data sets will be used to study such parameters as the albedo of forest canopies, the dynamics of scene radiation due to factors such as canopy architecture, moisture stress, leaf chemistry, topography, and understory composition.

Walthall, Charles L.↗
NASA NTRS1989

Gallium arsenide processing for gate array logic

The development of a reliable and reproducible GaAs process was initiated for applications in gate array logic. Gallium Arsenide is an extremely important material for high speed electronic applications in both digital and analog circuits since its electron mobility is 3 to 5 times that of silicon, this allows for faster switching times for devices fabricated with it. Unfortunately GaAs is an extremely difficult material to process with respect to silicon and since it includes the arsenic component GaAs can be quite dangerous (toxic) especially during some heating steps. The first stage of the research was directed at developing a simple process to produce GaAs MESFETs. The MESFET (MEtal Semiconductor Field Effect Transistor) is the most useful, practical and simple active device which can be fabricated in GaAs. It utilizes an ohmic source and drain contact separated by a Schottky gate. The gate width is typically a few microns. Several process steps were required to produce a good working device including ion implantation, photolithography, thermal annealing, and metal deposition. A process was designed to reduce the total number of steps to a minimum so as to reduce possible errors. The first run produced no good devices. The problem occurred during an aluminum etch step while defining the gate contacts. It was found that the chemical etchant attacked the GaAs causing trenching and subsequent severing of the active gate region from the rest of the device. Thus all devices appeared as open circuits. This problem is being corrected and since it was the last step in the process correction should be successful. The second planned stage involves the circuit assembly of the discrete MESFETs into logic gates for test and analysis. Finally the third stage is to incorporate the designed process with the tested circuit in a layout that would produce the gate array as a GaAs integrated circuit.

Cole, Eric D.↗
NASA NTRS1991

Rapid thermal cycling of solar array blanket coupons for Space Station Freedom

The NASA Lewis Research Center has been conducting rapid thermal cycling on blanket coupons for Space Station Freedom. This testing includes two designs (8 coupons total) of the solar array. Four coupons were fabricated as part of the Photovoltaic Array Environmental Protection Program (PAEP), NAS3-25079, at Lockheed Missiles and Space Company. These coupons began cycling in early 1989 and have completed 172,000 thermal cycles. Four other coupons were fabricated a year later and included several design changes; cycling of these began in early 1990 and has reached 90,000 cycles. The objective of this testing is to demonstrate the durability or operational lifetime (15 yrs.) of the welded interconnects within a low earth orbit (LEO) thermal cycling environment. The blanket coupons, design changes, test description, status to date including performance and observed anomalies, and any insights related to the testing of these coupons are described. The description of a third design is included.

Scheiman, David A.↗
NASA NTRS1991

Low Earth orbital atomic oxygen micrometeoroid, and debris interactions with photovoltaic arrays

Polyimide Kapton solar array blankets can be protected from atomic oxygen in low earth orbit if SiO sub x thin film coatings are applied to their surfaces. The useful lifetime of a blanket protected in this manner strongly depends on the number and size of defects in the protective coatings. Atomic oxygen degradation is dominated by undercutting at defects in protective coatings caused by substrate roughness and processing rather than micrometeoroid or debris impacts. Recent findings from the Long Duration Exposure Facility (LDEF) and ground based studies show that interactions between atomic oxygen and silicones may cause grazing and contamination problems which may lead to solar array degradation.

Banks, Bruce A.↗
NASA NTRS1991

A carrier-arraying demonstration at Goldstone for receiving Pioneer 11 signals

A carrier arraying technique was demonstrated at Goldstone. The Block III receivers of two 34-m antennas, Deep Space Station 12 and 15, were arrayed together to receive S band (2.3 GHz) signals from the Pioneer 11 spacecraft. Carrier phases in the two receivers were synchronized by the analog phase lock loops, and carrier signals were added at an intermediate frequency to enhance tracking performance. The receiver at DSS 15, which has been unable to lock up and track the Pioneer 11 signal by itself due to a wider tracking loop bandwidth and a higher system temperature, was now able to track the carrier and produce usable baseband signals. The receiver at DSS 12 achieved a reduction of the rms phase error, increasing the telemetry symbol SNR by an average of 0.35 dB. The baseband signals from both antennas were then synchronized and combined using the existing Baseband Assembly, thereby achieving a total symbol SNR increase of 2.5 + or - 0.7 dB relative to DSS 12 alone. A more comprehensive model is presented to permit evaluation of both thermal and phase noise effects. The analysis agrees well with observed data.

Pham, T. T.↗
NASA NTRS1989

Systolic array processing of the sequential decoding algorithm

A systolic array processing technique is applied to implementing the stack algorithm form of the sequential decoding algorithm. It is shown that sorting, a key function in the stack algorithm, can be efficiently realized by a special type of systolic arrays known as systolic priority queues. Compared to the stack-bucket algorithm, this approach is shown to have the advantages that the decoding always moves along the optimal path, that it has a fast and constant decoding speed and that its simple and regular hardware architecture is suitable for VLSI implementation. Three types of systolic priority queues are discussed: random access scheme, shift register scheme and ripple register scheme. The property of the entries stored in the systolic priority queue is also investigated. The results are applicable to many other basic sorting type problems.

Chang, C. Y.↗
NASA NTRS1990

Latest developments in the Advanced Photovoltaic Solar Array Program

In 1985, the Advanced Photovoltaic Solar Array (APSA) Program was established to demonstrate a producible array system with a specific power greater than 130 W/kg at a 10-kW (BOL) power level. The latest program phase completed fabrication and initial functional testing of a prototype wing representative of a full-scale 5-kW (BOL) wing (except truncated in length to about 1 kW), with weight characteristics that could meet the 130-W/kg (BOL) specific power goal using thin silicon solar cell modules and weight-efficient structural components. The wing configuration and key design details are reviewed, along with results from key component-level and wing-level tests. Projections for future enhancements that may be expected through the use of advanced solar cells and structural components are shown. Performance estimates are given for solar electric propulsion orbital transfer missions through the Van Allen radiation belts. The latest APSA program plans are presented.

Stella, Paul M.↗
NASA NTRS1991

An abuttable CCD imager for visible and X-ray focal plane arrays

A frame-transfer silicon charge-coupled-device (CCD) imager has been developed that can be closely abutted to other imagers on three sides of the imaging array. It is intended for use in multichip arrays. The device has 420 x 420 pixels in the imaging and frame-store regions and is constructed using a three-phase triple-polysilicon process. Particular emphasis has been placed on achieving low-noise charge detection for low-light-level imaging in the visible and maximum energy resolution for X-ray spectroscopic applications. Noise levels of 6 electrons at 1-MHz and less than 3 electrons at 100-kHz data rates have been achieved. Imagers have been fabricated on 1000-Ohm-cm material to maximize quantum efficiency and minimize split events in the soft X-ray regime.

Burke, Barry E.↗
NASA NTRS1991

Novel array-feed distortion compensation techniques for reflector antennas

Degradation of antenna performance by reflector surface distortion, which lowers gain and increases sidelobe levels, is addressed. Distortion compensation concepts based on the applications of properly matched array feeds are presented. Results of conceptual developments, numerical simulations, and measurement verifications are presented in support of this approach, with particular attention to the measurement technique. It is shown that the concept is most useful for overcoming the deterioration effects of slowly varying surface distortions, which would make the method very useful for future large space and ground antennas. It is further shown that for a typical, slowly varying thermal or gravitational surface distortion, a 19-element array feed can improve the reflector performance considerably.

Rahmat-Samii, Yahya↗
NASA NTRS1990

The Energetic Transient Array ETA - A network of 'space buoys' in solar orbit for observations of gamma-ray bursts

The Energetic Transient Array (ETA) is a concept for a dedicated interplanetary network of about 40 microsatellites ('space buoys') deployed in an about 1 AU radius solar orbit for the observation of cosmic gamma ray bursts (GRBs). Such a network is essential for the determination of highly accurate (about 0.1 arcsec) error boxes for GRBs. For each of about 100 bursts which would be detectable per year of observation by such a network, high resolution spectra could be obtained through the use of passively-cooled Ge gamma-ray detectors. Stabilization of each microsatellite would be achieved by a novel technique based on the radiation pressure exerted on 'featherable' solar paddles. It should be possible to have a fully functional array of satellites in place before the end of the decade for a total cost of about $20M, exclusive of launcher fees.

Ricker, George R.↗
NASA NTRS1990

A synthesis array for lunar submillimeter astronomy

This paper describes a system concept for a synthesis array for lunar submillimeter astronomy (SALSA). It includes a brief discussion of the science objectives and the advantages of a placing such an array on the moon, the system concept, and a top-level discussion of the various subsystems, including the technology drivers associated with each.

Mahoney, M. J.↗
NASA NTRS1992

Performances Of Arrays Of Ge:Ga Far-Infrared Detectors

Report presents evaluation of performances of two electronic modules containing few-element linear focal-plane arrays of Ge:Ga photodetectors and associated multiplexing readout circuitry. Tested to demonstrate feasibility of many-element, two-dimensional focal-plane arrays of far-infrared detectors and associated circuitry for use in astronomical and other low-background scientific observations. Revealed deficiencies that must be overcome in future designs.

Mccreight, C.↗
NASA NTRS1992

Spectrum-Imaging Detector Array With Integrated Filter

Proposed rectangular array of photodetectors in imaging spectrometer includes integral filter deposited directly on imaging array which would not become misaligned or misregistered as result of mechanical shock, vibration, or differential thermal expansion. Need for precise alignment and registration of filter cannot be over-emphasized.

Labaw, Clayton C.↗
NASA NTRS1992

Tests Of Array Of Flush Pressure Sensors

Report describes tests of array of pressure sensors connected to small orifices flush with surface of 1/7-scale model of F-14 airplane in wind tunnel. Part of effort to determine whether pressure parameters consisting of various sums, differences, and ratios of measured pressures used to compute accurately free-stream values of stagnation pressure, static pressure, angle of attack, angle of sideslip, and mach number. Such arrays of sensors and associated processing circuitry integrated into advanced aircraft as parts of flight-monitoring and -controlling systems.

Larson, Larry J.↗