Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Reversibility”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,747 records · Page 97
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Reverse annealing in radiation-damaged, silicon solar cells

In order to understand the results in terms of properties of the radiation induced defects, a combination of diffusion length measurements and defect data obtained from Deep Level Transient Spectroscopy were used. The results indicate that the defect at E sub v + 0.30 eV is responsible for the observed reversed annealing. The defect was identified as a boron-oxygen vacancy complex. This identification is a guide to processing efforts aimed at increasing the concentration of these radiation induced defects.

Weinberg, I.↗
NASA NTRS1979

Friction measurements in piston-cylinder apparatus using quartz-coesite reversible transition

The value of friction determined by monitoring piston displacement as a function of nominal pressure on compression and decompression cycles at 1273 K is compared with the friction value obtained by reversing the quartz-coesite transition at 1273 and 1073 K in a talc-glass-alsimag cell (Akella and Kennedy, 1971) and a low-friction salt cell (Mirwald et al., 1975). Quenching runs at 1273 K gave double values of friction of 0.25 GPa for the talc-glass-alsimag cell and 0.03 GPa for the salt cell. The piston-displacement technique gave somewhat higher values. Use of piston-displacement hysteresis loops in evaluating the actual pressure on a sample may lead to overestimates for decompression runs and underestimates for compression runs.

Akella, J.↗
NASA NTRS1980

Reversal of nickel cadmium cells

The design of nickel cadmium cells are discussed. The pressure voltage profiles of these cells during low rate reversal are also summarized.

Badcock, C.↗
NASA NTRS1980

Reverse osmosis membrane of high urea rejection properties

Polymeric membranes suitable for use in reverse osmosis water purification because of their high urea and salt rejection properties are prepared by generating a plasma of an unsaturated hydrocarbon monomer and nitrogen gas from an electrical source. A polymeric membrane is formed by depositing a polymer of the unsaturated monomer from the plasma onto a substrate, so that nitrogen from the nitrogen gas is incorporated within the polymer in a chemically combined form.

Johnson, C. C.↗
NASA NTRS1980

The development of an elastic reverse gradient garment to be used as a countermeasure for cardiovascular deconditioning

Using a new nomex lycra elastic fabric and individualized garment engineering techniques, reverse gradient garments (RGG's) were designed, constructed, and tested for effectiveness as a countermeasure against cardiovascular deconditioning. By combining torso compensated positive pressure breathing with a distally diminishing gradient of counterpressure supplied by the elastic fabric on the limbs, the RGG acts to pool blood in the extremities of recumbent persons much as though they were standing erect in 1 g. The RGG stresses the vasculature in a fashion similar to that experienced by the normally active man, hence preventing or limiting the development of post weightlessness orthostatic intolerance and related conditions. Four male, college age subjects received daily treatments with the RGG during a 15 day bedrest study. Four additional subjects also underwent the bedrest, but received no treatments; they served as controls. The preliminary indication was that the RGG was somewhat effective in limiting the deconditioning process.

Annis, J. F.↗
NASA NTRS1980

Origin of reverse annealing in radiation-damaged silicon solar cells

The paper employs relative defect concentrations, energy levels, capture cross sections, and minority carrier diffusion lengths in order to identify the defect responsible for the reverse annealing observed in a radiation damaged n(+)/p silicon solar cell. It is reported that the responsible defect, with the energy level at +0.30 eV, has been tentatively identified as boron-oxygen-vacancy complex. In conclusion, it is shown that removal of this defect could result in significant cell recovery when annealing at temperatures well below the currently required 400 C.

Weinberg, I.↗
NASA NTRS1982

Orifice Blocks Heat Pipe in Reverse Mode

High forward-mode conductance is combined with rapid reverse-mode shutoff in a heat pipe originally developed to cool spacecraft payloads. A narrow orifice within the pipe "chokes off" the evaporator if heat sink becomes warmer than source. During normal operation, with source warmer than sink, orifice has little effect. Design is simpler and more compact than other thermal-diode heat pipes and requires no special materials, forgings, or unusual construction techniques.

Alario, J. P.↗
NASA NTRS1980

On the importance of reverse current ohmic losses in electron-heated solar flare atmospheres

The passage of a beam of nonthermal electrons through the flaring solar atmosphere is considered, paying particular attention to the requirement that the beam be stable to the generation of plasma turbulence. The ratio is computed of energy losses due to reverse current ohmic heating, and heating by Coulomb collisions, respectively, for the greatest flux which can pass stably through the atmosphere. It is demonstrated that this ratio is determined by the low energy cutoff of the beam, by the electron temperature of the ambient atmosphere, and by the electron to ion temperature ratio. It is also independent of the atmospheric density.

Emslie, A. G.↗
NASA NTRS1981

Photospheric subrotations, differential rotation and zonal wind bands - A reverse pirouette

It is noted that on the sun the core is assumed to be rotating with a period of about 12 days while the overlying 'mantle' convection zone has a solid body component of about 27 days. It is proposed that this phenomenon could simply be understood as a 'reverse pirouette'. It is noted that while previously proposed models provide solutions of valid equations and computer analyses, they lack a simple physical picture to explain the phenomenon. In the model proposed here, the solar oblateness is conventionally providing added heat input at the poles. The result is the large scale transport of material toward the equator, causing subrotation. The model is thus seen as facilitating an understanding of the formation of a slowly rotating convection zone above the more rapidly rotating core. The latitudinal photospheric differential rotation is interpreted as a 'second order' effect associated with the horizontal transport of momentum.

Schatten, K. H.↗
NASA NTRS1981

Poly/vinyl alcohol/ membranes for reverse osmosis

A description is presented of the results of studies of the water and salt transport properties of PVA membranes, taking into account radiation crosslinked PVA membranes, diffusive salt permeability through PVA membranes, and heat treated PVA membranes. The experimental findings support an occurrence of independent water, and salt permeation processes. It is suggested that the salt permeation is governed by a solution-diffusion transport mechanism. The preparation of thin skinned, asymmetric PVA membranes is also discussed. The employed method has a certain similarity to the classical phase inversion method, which is widely applied in the casting of asymmetric reverse osmosis membranes. Instead of using a gelling bath composed of a nonsolvent for the membrane material and miscible with the solvent from which the membrane is cast, a 'complexing' bath is used, which is a solution of a complexing agent in water.

Katz, M. G.↗
NASA NTRS1981

Effect of fuel injector type on performance and emissions of reverse-flow combustor

The combustion process in a reverse-flow combustor suitable for a small gas turbine engine was investigated to evaluate the effect of fuel injector type on performance and emissions. Fuel injector configurations using pressure-atomizing, spill-flow, air blast, and air-assist techniques were compared and evaluated on the basis of performance obtained in a full-scale experimental combustor operated at inlet conditions corresponding to takeoff, cruise, low power, and idle and typical of a 16:1-pressure-ratio turbine engine. Major differences in combustor performance and emissions characteristics were experienced with each injector type even though the aerodynamic configuration was common to most combustor models. Performance characteristics obtained with the various fuel injector types could not have been predicted from bench-test injector spray characteristics. The effect of the number of operating fuel injectors on performance and emissions is also presented.

Norgren, C. T.↗
NASA NTRS1982

Dilution Jet Behavior in the Turn Section of a Reverse Flow Combuster

Measurements of the temperature field produced by a single jet and a row of dilution jets issued into a reverse flow combustor are presented. The temperature measurements are presented in the form of consecutive normalized temperature profiles, and jet trajectories. Single jet trajectories were swept toward the inner wall of the turn, whether injection was from the inner or outer wall. This behavior is explained by the radially inward velocity component necessary to support irrotational flow through the turn. Comparison between experimental results and model calculations showed poor agreement due to the model's not including the radial velocity component. A widely spaced row of jets produced trajectories similar to single jets at similar test conditions, but as spacing ratio was reduced, penetration was reduced to the point where the dilution jet flow attached to the wall.

Riddlebaugh, S. M.↗
NASA NTRS1981

Thrust reverser for a long duct fan engine

A bypass duct outer cowl includes a fixed cascade disposed between axially spaced fixed cowl portions and a translatable cowl sleeve and blocker doors movably disposed on the respective radially outer and inner sides of the cascade. Actuation and linkage structure located entirely within the outer cowl provides for selectively moving the cowl sleeve rearwardly and rotating the blocker doors to a position across the bypass duct to cause the fan airflow to pass through the cascade in a thrust reversing manner.

Johnston, E. A.↗
NASA NTRS1978

NASA Pioneer: Venus reverse playback telemetry program TR 78-2

During the entry of the Pioneer Venus Atmospheric Probes into the Venus atmosphere, there were several events (RF blackout and data rate changes) which caused the ground receiving equipment to lose lock on the signal. This caused periods of data loss immediately following each one of these disturbing events which lasted until all the ground receiving units (receiver, subcarrier demodulator, symbol synchronizer, and sequential decoder) acquired lock once more. A scheme to recover these data by off-line data processing was implemented. This scheme consisted of receiving the S band signals from the probes with an open loop reciever (requiring no lock up on the signal) in parallel with the closed loop receivers of the real time receiving equipment, down converting the signals to baseband, and recording them on an analog recorder. The off-line processing consisted of playing the analog recording in the reverse direction (starting with the end of the tape) up, converting the signal to S-band, feeding the signal into the "real time" receiving system and recording on digital tape, the soft decisions from the symbol synchronizer.

Modestino, J. W.↗
NASA NTRS1982

Kevlar/PMR-15 reduced drag DC-9 reverser stang fairing

A reduced drag fairing for the afterbody enclosing the thrust reverser actuators on the DC-9 has been developed with Kevlar-49/PMR-15 advanced composite material. The improved fairing reduces airplane drag 1% compared to the production baseline. Use of composites reduces weight 40% compared to an equivalent metal fairing. The Kevlar-49/PMR-15 advanced composite is an organic matrix material system that can be used at temperatures up to 500 F.

Kawai, R. T.↗
NASA NTRS1981

On the importance of reverse current ohmic losses in electron-heated solar flare atmospheres

The paper considers the passage of a beam of nonthermal electrons through the flaring solar atmosphere, paying particular attention to the requirement that the beam be stable to the generation of plasma turbulence. The ratio of energy losses due to reverse current ohmic heating and heating by Coulomb collisions, respectively, for the greatest flux which can pass stably through the atmosphere is computed. It is shown that this ratio is determined by the low energy cutoff of the beam, by the electron temperature of the ambient atmosphere, and by the electron to ion temperature ratio theta. It is also independent of the atmospheric density. The results show that ohmic energy losses are undoubtedly important in the initial transient state, in agreement with other authors, but that their role is debatable in the flare atmosphere, depending on the value of theta appropriate.

Emslie, A. G.↗
NASA NTRS1982

Dilution jet behavior in the turn section of a reverse flow combustor

Measurements of the temperature field produced by a single jet and a row of dilution jets issued into a reverse flow combustor are presented. The temperature measurements are presented in the form of consecutive normalized temperature profiles, and jet trajectories. Single jet trajectories were swept toward the inner wall of the turn, whether injection was from the inner or outer wall. This behavior is explained by the radially inward velocity component necessary to support irrotational flow through the turn. Comparison between experimental results and model calculations showed poor agreement due to the model's not including the radial velocity component. A widely spaced row of jets produced trajectories similar to single jets at similar test conditions, but as spacing ratio was reduced, penetration was reduced to the point where the dilution jet flow attached to the wall.

Riddlebaugh, S. M.↗