Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Directional Effect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,747 records · Page 97
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Mod 1 wind turbine generator failure modes and effects analysis

A failure modes and effects analysis (FMEA) was directed primarily at identifying those critical failure modes that would be hazardous to life or would result in major damage to the system. Each subsystem was approached from the top down, and broken down to successive lower levels where it appeared that the criticality of the failure mode warranted more detail analysis. The results were reviewed by specialists from outside the Mod 1 program, and corrective action taken wherever recommended.

Source record↗
NASA NTRS1980

Development of procedures for calculating stiffness and damping of elastomers in engineering applications, part 6

An elastomer damper was designed, tested, and compared with the performance of a hydraulic damper for a power transmission shaft. The six button Viton-70 damper was designed so that the elastomer damper or the hydraulic damper could be activated without upsetting the imbalance condition of the assembly. This permitted a direct comparison of damper effectiveness. The elastomer damper consistently performed better than the hydraulic mount and permitted stable operation of the power transmission shaft to speeds higher than obtained with the squeeze film damper. Tests were performed on shear specimens of Viton-79, Buna-N, EPDM, and Neoprene to determine performance limitations imposed by strain, temperature, and frequency. Frequencies of between 110 Hz and 1100 Hz were surveyed with imposed strains between 0.0005 and 0.08 at temperatures of 32 C, 66 C, and 80 C. A set of design curves was generated in a unified format for each of the elastomer materials.

Rieger, A.↗
NASA NTRS1980

Simple turbulence models and their application to boundary layer separation

Measurements in the boundary layer and wake of a stalled airfoil are presented in two coordinate systems, one aligned with the airfoil chord, the other being conventional boundary layer coordinates. The NACA 4412 airfoil is studied at a single angle of attack corresponding to maximum lift, the Reynolds number based on chord being 1.5 x 10 to the 6th power. Turbulent boundary layer separation occurred at the 85 percent chord position. The two-dimensionality of the flow was documented and the momentum integral equation studied to illustrate the importance of turbulence contributions as separation is approached. The assumptions of simple eddy-viscosity and mixing-length turbulence models are checked directly against experiment. Curvature effects are found to be important as separation is approached.

Wadcock, A. J.↗
NASA NTRS1980

Optimal thermionic energy conversion with established electrodes for high-temperature topping and process heating

Applied research-and-technology (ART) work reveals that optimal thermionic energy conversion (TEC) with approximately 1000 K to approximately 1100 K collectors is possible using well established tungsten electrodes. Such TEC with 1800 K emitters could approach 26.6% efficiency at 27.4 W/sq cm with approximately 1000 K collectors and 21.7% at 22.6 W/sq cm with approximately 1100 K collectors. These performances require 1.5 and 1.7 eV collector work functions (not the 1 eV ultimate) with nearly negligible interelectrode losses. Such collectors correspond to tungsten electrode systems in approximately 0.9 to approximately 6 torr cesium pressures with 1600 K to 1900 K emitters. Because higher heat-rejection temperatures for TEC allow greater collector work functions, interelectrode loss reduction becomes an increasingly important target for applications aimed at elevated temperatures. Studies of intragap modifications and new electrodes that will allow better electron emission and collection with lower cesium pressures are among the TEC-ART approaches to reduced interelectrode losses. These solutions will provide very effective TEC to serve directly in coal-combustion products for high-temperature topping and process heating. In turn this will help to use coal and to use it well.

Morris, J. F.↗
NASA NTRS1980

Jet-diffuser Ejector - Attached Nozzle Design

Attached primary nozzles were developed to replace the detached nozzles of jet-diffuser ejectors. Slotted primary nozzles located at the inlet lip and injecting fluid normal to the thrust axis, and rotating the fluid into the thrust direction using the Coanda Effect were investigated. Experiments indicated excessive skin friction or momentum cancellation due to impingement of opposing jets resulted in performance degradation. This indicated a desirability for location and orientation of the injection point at positions removed from the immediate vicinity of the inlet surface, and at an acute angle with respect to the thrust axis. Various nozzle designs were tested over a range of positions and orientations. The problems of aircraft integration of the ejector, and internal and external nozzle losses were also considered and a geometry for the attached nozzles was selected. The effect of leaks, protrusions, and asymmetries in the ejector surfaces was examined. The results indicated a relative insensitivity to all surface irregularities, except for large protrusions at the throat of the ejector.

Alperin, M.↗
NASA NTRS1981

Effect of gravity on coupled convective and interfacial instabilities during directional solidification

Instabilities occurring during the directional constant-rate solidification of a dilute solution of tin in lead are investigated as a function of gravity with particular emphasis on small constant gravitational accelerations. Two types of instabilities have been identified: (1) convective type that corresponds to long wavelengths, and (2) morphological type that corresponds to short wavelengths. These instabilities are coupled but while the convective instabilities depend strongly on gravity, the morphological instabilities are practically independent of gravity. For low velocities, the convective instabilities occur at much lower solute concentrations than the morphological instabilities, whereas at high velocities the reverse is true.

Coriell, S. R.↗
NASA NTRS1982

Some statistical performance characteristics of the 'ITD' modal identification algorithm

Performance characteristics of the Ibrahim time-domain algorithms are examined on a statistical basis. The method uses multiple free-response measurements from a test structure directly in the time domain, and displays varying accuracy, with the strongly excited modes identified most accurately and the weakly excited modes least accurately. Sets of computer-generated free-response functions for a simple 1-mode model are used to study the identification performance for several basic changes in the modal characteristics of the data, the user-selectable analysis constants, and the level of superimposed noise. Results indicate the existence of a direct and often linear effect of noise on the scatter of identified parameters, and good identification is maintained at the 1% noise level down to the point in frequency when only 1/4-cycle of data is analyzed.

Pappa, R. S.↗
NASA NTRS1983

Thermal Modeling of Bridgman Crystal Growth

Heat Flow modeled for moving or stationary rod shaped sample inside directional-solidification furnace. Program effectively models one-dimensional heat flow in translating or motionless rod-shaped sample inside of directionalsolidification furnace in which adiabatic zone separates hot zone and cold zone. Applicable to systems for which Biot numbers in hot and cold zones are less than unity.

Cothran, E.↗
NASA NTRS1983

Feasibility study of a procedure to detect and warn of low-level wind shear

The wind shear program is directed toward investigating the effects of wind shear on aerodynamic performance. Combining the Joint Airport Weather Studies wind shear data with the B-57B gust gradient data, the transient scales of motion involved in wind shear aircraft accidents or mishaps are being identified. The effect of variable winds having these time scales on the aerodynamic coefficients of moist airfoils were fully investigated. Transient and spatial variation of flow over the airfoil may cause premature stall or hysteresis effects which significantly impact the lift and drag (i.e., aerodynamic coefficients). Analysis of airfoil performance subject to 4-D variable flows will be carried out.

Frost, W.↗
NASA NTRS1983

Laser microspeckle technique in displacement measurement near a crack tip

The laser speckle method has been found quite useful in obtaining in-plane displacement measurements. It is especially useful if the displacement field in a small region can be effectively determined. By obtaining directly the speckle patterns at higher magnifications, a better distinction of the displacements in the vicinity of a crack tip is possible. In this short report some results are obtained and compared with those calculated from linear fracture mechanics and the finite element method for an aluminum crack.

Tang, Z. Q.↗
NASA NTRS1982

Response of MnBi-Bi eutectic to freezing rate changes

Reference is made to a study by Fu and Wilcox (1981), which treated theoretically the influence on freezing rate of sudden changes in translation rate in the Bridgman-Stockbarger technique. This treatment is extended here to a linear ramped translation rate and an oscillatory freezing rate. It is found that oscillations above a few hertz are highly damped in small-diameter apparatus. An experimental test is carried out of the theoretical predictions for a sudden change of translation rate. The MnBi-Bi eutectic is solidified with current-induced interface demarcation. The experimental results accord reasonably well with theory if the silica ampoule wall is assumed to either (1) contribute only a resistance to heat exchange between the sample and the furnace wall or (2) transmit heat effectively in the axial direction by radiation. In an attempt to explain the fact that a finer microstructure is obtained in space, MnBi-Bi microstructure is determined when the freezing rate is increased or decreased rapidly. Preliminary results suggest that fiber branching does not occur as readily as fiber termination.

Nair, M.↗
NASA NTRS1983

Radar backscattering properties of corn and soybeans at frequencies of 1.6, 4.75, and 13.3. GHz

The NASA Johnson Space Center made an observational study of the radar-backscattering properties of corn and soybeans in commercial fields in a test site in Webster County, IA. Aircraft-based radar scatterometers measured the backscattering coefficient of the crops at three frequencies, 1.6 GHz (L-band), 4.75 GHz (C-band), and 13.3 GHz (Ku-band), at 10 sensor look-angles (5 to 50 degrees from the nadir in steps of 5 degrees), and with several polarization combinations. Among other findings, it was determined that: (1) row direction differences among fields affected significantly the radar-backscattering coefficient of the fields when the radar system used like-polarization at look-angles from 5 to 25 degrees; (2) row-direction differences had no effect on radar backscattering when the system used either cross-polarization or look-angles greater than 25 degrees regardless of the polarization; (3) wet surface-soil moisture conditions resulted in significantly poorer spectral separability of the two crops as compared to dry-soil conditions; and (4) on the dry-soil date, the best channel for separating corn from soybeans was the C-band cross-polarized measurement at a look-angle of 50 degrees.

Paris, J. F.↗
NASA NTRS1984

Study of spectral/radiometric characteristics of the thematic mapper for land use applications

The previous characterization of scan-related low-frequency noise was confirmed and extended through analysis of reflective-band data from another nighttime acquisition. Amplitude and phase relationships of the level shifts were determined for each detector in each of free full frames. Analysis of scan-direction-related signal droop effects in nighttime data from the reflective bands was begun with encouraging initial observations. Also, an effort to characterize high-frequency noise in the reflective bands through Fourier analysis of nighttime data was initiated. Recommendations are made relative to the choice of radiometric calibration constants in the thematic mapper image processing system for the routine processing of TM data. Non-linear (piece-wise linear) calibration curves are recommended.

Malila, W. A.↗
NASA NTRS1983

Interpretation of radar returns from clear air: Discrimination against clutter

Different kinds of inteference may cause problems to the proper detection and analysis of the atmospheric signals, when using VHF and UHF radars. These are separated into passive and active contributions. Passive contributions are existent in the receiving system without the radar transmitter switched on. Active contributions are due to scatter and reflection of the own transmitted radar signal from unwanted targets, which are called clutter. Of major importance to radar systems are active interference contributions. Different methods can be applied for elimination or at least suppressing unwanted effects. These are; (1) Directional filtering, i.e., applying optimum suppression of antenna sidelobes, (2) Range filtering, i.e., suppressing unwanted signals only in affected range gates, (3) selection by amplitude distributions, (4) Temporal filtering, i.e., recognizing typical temporal variations of the clutter signals, through spectral characteristics, and applying matched filters.

Rottger, J.↗
NASA NTRS1982

Configuration design studies and wind tunnel tests of an energy efficient transport with a high-aspect-ratio supercritical wing

The results of design studies and wind tunnel tests of high aspect ratio supercritical wings suitable for a medium range, narrow body transport aircraft flying near M=0.80 were presented. The basic characteristics of the wing design were derived from system studies of advanced transport aircraft where detailed structural and aerodynamic tradeoffs were used to determine the most optimum design from the standpoint of fuel usage and direct operating cost. These basic characteristics included wing area, aspect ratio, average thickness, and sweep. The detailed wing design was accomplished through application of previous test results and advanced computational transonic flow procedures. In addition to the basic wing/body development, considerable attention was directed to nacelle/plyon location effects, horizontal tail effects, and boundary layer transition effects. Results of these tests showed that the basic cruise performance objectives were met or exceeded.

Henne, P. A.↗
NASA NTRS1984

Experimental and Theoretical Studies of Moisture and Temperature Effects on the Mechanical Properties of Graphite/Epoxy Laminates and Neat Resins

The properties of high performnce composites which are strongly dependent on the physical properties of the matrix resin were studied. Moisture adversely affect the properties of both neat epoxy resin and epoxy matrix composites. Inhomogeneous swelling as to the moisture degradation of mechanical properties, both in the neat resin and the composite. It is postulated that the postcuring process can change structure/moisture interactions and partially alleviate its adverse effects. The study is directed toward are understanding of the physical/mechanical/thermodynamic aspects of this problem.

Sternstein, S. S.↗
NASA NTRS1985

Generation and transfer of polarized radiation in the solar atmosphere: Physical mechanisms and magnetic-field diagnostics

The main physical mechanisms responsible for the generation and transfer of polarized radiation in the solar atmosphere can be classified in a suitable bidimensional diagram with an indicator of the magnetic field strength on its vertical axis and an indicator of the radiation field anisotropy on its horizontal axis. The various polarimetric observations performed on solar spectral lines are interpreted with different theoretical schemes according to their classification in the diagram and to the optical depths involved. These theoretical schemes, and the associated diagnostic tools for inferring the magnetic field vector from observations are reviewed. In particular, the role of magneto-optical effects in determining the direction of the observed linear polarization in active regions is discussed in some detail.

Deglinnocenti, E. L.↗