Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “responsivity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,711 records · Page 95

A flight investigation of helicopter low-speed response requirements

A flight experiment has been conducted using the Canadian National Aeronautical Establishment's variable-stability airborne simulator to define the dynamic response requirements for operations at hover and low speeds. Fourteen Attitude Command/Attitude Hold, Rate, and Rate Command/Attitude Hold configurations were evaluated by six pilots using both conventional controls and a four-axis integrated sidestick over a low-speed course consisting of precision hover, landing, sidestep, and dash/quickstop tasks. The results indicate that with conventional controls all three response-types were acceptable as long as their response bandwidth was sufficiently high, and higher bandwidths were required in roll than in pitch. With the four-axis sidestick, there was a preference for the Rate systems. The range of acceptable bandwidths was lower, and the spread in pilot ratings smaller, than were found in a similar ground-based simulation.

Mitchell, David G.↗

Dynamic response of laminated composite plates using a three-dimensional hybrid-stress finite-element formulation

A method of analysis of dynamic response of laminated composite plates is presented. The analysis is carried by using a hybrid-stress finite element numerical technique. By using this approach, the response of simply supported laminated plates subjected to sinusoidal loading are investigated. For the solution of the finite element equations of motion of free vibrations and dynamic response problems, two effective methods of solution, the space iteration method and the Newmark direct integration method are used. These two methods are discussed here.

Liou, W. J.↗

Analysis and test evaluation of the dynamic response and stability of three advanced turboprop models at low forward speed

Results of wind tunnel tests at low forward speed for blade dynamic response and stability of three 62.2 cm (24.5 in) diameter models of the Prop-Fan, advanced turboprop, are presented. Measurements of dynamic response were made with the rotors mounted on an isolated nacelle, with varying tilt for nonuniform inflow. Low speed stall flutter tests were conducted at Mach numbers from 0.0 to 0.35. Measurements are compared to Eigen-solution flutter boundaries. Calculated 1P stress response agrees favorably with experiment. Predicted stall flutter boundaries correlate well with measured high stress regions. Stall flutter is significantly reduced by increased blade sweep. Susceptibility to stall flutter decreases rapidly with forward speed.

Smith, Arthur F.↗

Modal forced response of propfans in yawed flow

A modal forced response method for propfans in yawed flow is presented. This capability exists in the Aeroelastic Stability and Response of Propfan (ASTROP3) code developed at the Lewis Research Center. The code uses three-dimensional steady and unsteady cascade aerodynamics by Williams and Hwang (1986) and a NASTRAN finite element model to represent the blade structure. In addition, many utility programs exist in ASTROP3 that help in both the preprocessing of the NASTRAN model and the postprocessing of modal response results. The postprocessing work that computes the blade vibratory displacements and stresses in yawed flow are highlighted here.

Narayanan, G. V.↗

Extending the impulse response in order to reduce errors due to impulse noise and signal fading

A finite impulse response (FIR) digital smearing filter was designed to produce maximum intersymbol interference and maximum extension of the impulse response of the signal in a noiseless binary channel. A matched FIR desmearing filter at the receiver then reduced the intersymbol interference to zero. Signal fades were simulated by means of 100 percent signal blockage in the channel. Smearing and desmearing filters of length 256, 512, and 1024 were used for these simulations. Results indicate that impulse response extension by means of bit smearing appears to be a useful technique for correcting errors due to impulse noise or signal fading in a binary channel.

Webb, Joseph A.↗

The influence of gravitoinertial force level on oculomotor and perceptual responses to Coriolis, cross-coupling stimulation

The goal of the present experiment was to determine whether gravitoinertial force magnitude influences oculomotor and perceptual responses to Coriolis cross-coupling stimulation. Blindfolded subjects who were rotating at constant velocity were asked to make standardized head movements during the free-fall and high-force phases of parabolic flight, and the characteristics of their horizontal nystagmus and the magnitude of their experienced self-motion were measured. Both responses were less intense in the free-fall periods than in the high-force periods. These findings suggest that the response to semicircular canal stimulation depends on the background level of gravitoinertial force.

Dizio, Paul↗

Response of stiffened panels for applications to acoustic fatigue

The surface protection systems of aerospace and aircraft structures are often constructed from discretely stiffened panels. This paper presents an analytical study on dynamic stress response of these structures to random surface flow and acoustic loads. To account for aerodynamic heating of high speed flow, thermal effects are included in the structural model. A generalized transfer matrix procedure is developed to obtain the required dynamic response solutions. Numerical results include spectral densities of stress, response root mean square values and fatigue damage for a variety of loading and thermal conditions.

Vaicaitis, R.↗

Multiple-mode large deflection random response of beams with nonlinear damping subjected to acoustic excitation

Multiple-mode nonlinear analysis is carried out for beams subjected to acoustic excitation. Effects of both nonlinear damping and large-deflection are included in the analysis in an attempt to explain the experimental phenomena of aircraft panels excited at high sound pressure levels; that is the broadening of the strain response peaks and the increase of modal frequency. An amplitude dependent nonlinear damping model is used in the anlaysis to study the effects and interactions of multiple modes, nonlinear stiffness and nonlinear damping on the random response of beams. Mean square maximum deflection, mean square maximum strain, and spectral density function of maximum strain for simple supported and clamped beams are obtained. It is shown analytically that nonlinear damping contributes significantly to the broadening of the response peak and to the mean square deflection and strain.

Prasad, C. B.↗

Aerobic fitness in women and responses to lower body negative pressure

The role of tolerance to orthostatic stress in the maintenance of high aerobic fitness in women was investigated by examining the responses of heart rate, stroke volume, cardiac output, Heather index of contractility, arterial pressure, peripheral resistance, change in calf circumference, and thoracic impedance of healthy female subjects to lower body negative pressure (LBNP) applied for 5 min at -50 mm Hg or until a subject became presyncopal. The testing protocol involved a stepwise reduction in pressure and consisted of two parts: an LBNP test in supine position followed by a treadmill test to peak aerobic capacity. Women were found to exhibit the same response pattern to LBNP as was previously reported by Convertino et al. (1984) for men. The results do not support the hypothesis that orthostatic tolerance in women is inversely related to aerobic fitness, as demonstrated by a finding that the peak aerobic capacity of subjects who became presyncopal did not differ from the peak of the tolerant subjects, and that hemodynamic responses to LBNPL were not a function of aerobic capacity.

Frey, Mary Anne Bassett↗

Leg vascular responsiveness during acute orthostasis following simulated weightlessness

The effect of weightlessness on vascular response to orthostatic stress was investigated in human subjects by measuring changes in the arterial pulse volume (APV) of the legs during exposure to lower body negative pressure (LBNP) applied before and after 10 days of continuous 6-deg head-down bed rest. Heart rate, mean arterial blood pressure (MAP), and impedance rheographic indices of APV were measured during rest and at 1 min of -30 mm Hg LBNP. Bed rest was found not to alter the responses of MAP to LBNP. Resting APV was decreased after bed rest; however, APV was reduced upon transfer from rest to 1-min LBPN by the same relative magnitude before and after bedrest. It is concluded that peripheral arterial vasoconstriction, as indicated by reduction in APV during LBNP, is not affected by bedrest. The results suggest that there was no apparent alteration in responsiveness of the leg vasculature following simulated weightlessness, and that the control mechanisms of peripheral resistance do not contribute significantly to reduced orthostatic tolerance following spaceflight.

Blamick, Cynthia A.↗

Stratospheric responses to solar ultraviolet variations - Comparisons with photochemical models

At latitudes and altitudes where transport effects on ozone mixing ratio can be neglected, ozone and temperature responses to short-term changes in solar ultraviolet flux can be used to calculate implied bounds on two basic photochemical parameters: the odd oxygen photochemical relaxation time and the chemical sensitivity of odd oxygen to local temperature changes. Seasonally averaged values of these parameters are derived from response measurements and are compared with model calculations between 0.7 and 4 mbar at tropical latitudes. Results are in agreement within measurement and model uncertainties at all pressure levels. Model values of mean ozone and of the response of ozone to perturbations are functions of the same photochemical data. Therefore this agreement provides a constraint which should be considered when changes are proposed in model input data for the purpose of improving agreement between measured and calculated high-altitude ozone.

Hood, L. L.↗

Influence of time domain unsteady aerodynamics on coupled flap-lag-torsional aeroelastic stability and response of rotor blades

This paper describes the incorporation of finite-state, time-domain aerodynamics in a flag-lag-torsional aeroelastic stability and response analysis in forward flight. Improvements to a previous formulation are introduced which eliminate spurious singularities. The methodology for solving the aeroelastic stability and response problems with augmented states, in the time domain, is presented using an implicit formulation. Results describing the aeroelastic behavior of soft and stiff in-plane hingeless rotor blades, in forward flight, are presented to illustrate the sensitivity of both the stability and response problems to time domain unsteady aerodynamics.

Friedmann, P. P.↗

Response of composite plates subjected to acoustic loading

The objectives of the project were to investigate numerical methodology for the determination of narrowband response in the geometrically nonlinear regime, to determine response characteristics for geometrically nonlinear plates subjected to random loading and to compare the predictions with experiments to be performed at NASA-Langley. The first two objectives were met. The response of composite plates subjected to both narrowband and broadband excitation were studied and the results are presented and discussed.

Moyer, E. Thomas, Jr.↗

Scaling effects in the static large deflection response of graphite-epoxy composite beams

Scaling effects in the large deflection response of graphite-epoxy composite beams was investigated. Eight different scale model beams ranging from 1/6 to full-scale were subjected to an eccentric axial compressive load to promote large bending deformations and failures. Beams having laminate stacking sequences including unidirectional, angle ply, cross ply, and quasi-isotropic were tested to examine a wide variety of composite response and failure modes. The model beams were loaded under scaled test conditions until catastrophic failure. Data acquired included load, end displacement, and strain measurements, and qualitative failure measurements. The experimental data is compared to a large rotation beam analysis and a finite element model analysis. Results from the tests indicate that the beam response becomes nonlinear. Failure modes are consistent between scale models within a laminate family, however, a significant scale effect is observed in strength of the scaled beams.

Jackson, Karen E.↗

The structural response of unsymmetrically laminated composite cylinders

The responses of an unsymmetrically laminated fiber-reinforced composite cylinder to an axial compressive load, a torsional load, and the temperature change associated with cooling from the processing temperature to the service temperature are investigated. These problems are considered axisymmetric and the response is studied in the context of linear elastic material behavior and geometrically linear kinematics. Four different laminates are studied: a general unsymmetric laminate; two unsymmetric but more conventional laminates; and a conventional quasi-isotropic symmetric laminate. The responses based on closed-form solutions for different boundary conditions are computed and studied in detail. Particular emphasis is directed at understanding the influence of elastic couplings in the laminates. The influence of coupling decreased from a large effect in the general unsymmetric laminate, to practically no effect in the quasi-isotropic laminate. For example, the torsional loading of the general unsymmetric laminate resulted in a radial displacement. The temperature change also caused a significant radial displacement to occur near the ends of the cylinder. On the other hand, the more conventional unsymmetric laminate and the quasi-isotropic cylinder did not deform radially when subjected to a torsional load. From the results obtained, it is clear the degree of elastic coupling can be controlled and indeed designed into a cylinder, the degree and character of the coupling being dictated by the application.

Butler, T. A.↗

Association of sex and age with responses to lower-body negative pressure

The effects of age and sex on the human-body responses to -50 torr LBNP were investigated in subjects who have undergone LBNP tests at the Kennedy Space Center. The comparison of results obtained on women and age-matched men indicated that men had larger relative increases in calf circumference and greater increases in peripheral resistance during the exposure to LBNP than the women; on the other hand, women displayed greater increases in thoracic impedance and heart rate. The comparison of the results on men of different ages (between 29 and 56 y) indicated that older subjects had greater increases in peripheral resistance and less heart rate elevation in response to LBNP. It is suggested that the age-related circulatory differences were due to a reduction in vagal response and a switch to predominant sympathetic nervous system influence in older men.

Frey, Mary Anne Bassett↗

Chemokinetic motility responses of the cyanobacterium oscillatoria terebriformis

Oscillatoria terebriformis, a gliding, filamentous, thermophilic cyanobacterium, exhibited an inhibition of gliding motility upon exposure to fructose. The observed response was transient, and the duration of nonmotility was directly proportional to the concentration of fructose. Upon resumption of motility, the rate of motility was also inversely proportional to the concentration of fructose. Sulfide caused a similar response. The effect of sulfide was specific and not due to either anoxia or negative redox potential. Exposure to glucose, acetate, lactate, or mat interstitial water did not elicit any motility response.

Richardson, Laurie L.↗

Scaling effects in the static large deflection response of graphite-epoxy composite beams

In the present investigation of scaling effects in the large-deflection response of graphite/epoxy composite beams, eight model beams ranging from 1/6 to full scale in size were subjected to an eccentric axial compressive load promoting large bending deformations and failures; the beams encompassed unidirectional, angle-ply, cross-ply, and quasi-isotropic types. The data obtained pertains to loads, end-displacements, strain measurememts, and qualitative failure measurements. Test results indicate that beam responses scale in the small-deflection region, but deviate as the response becomes nonlinear.

Jackson, Karen E.↗