Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “pilot”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,711 records · Page 95

Image processing of angiograms: A pilot study

The technology transfer application this report describes is the result of a pilot study of image-processing methods applied to the image enhancement, coding, and analysis of arteriograms. Angiography is a subspecialty of radiology that employs the introduction of media with high X-ray absorption into arteries in order to study vessel pathology as well as to infer disease of the organs supplied by the vessel in question.

Larsen, L. E.↗

The 25-MB sounding data and synoptic charts for NASA's AVE 2 pilot experiment

Rawinsonde data were tabulated at 25-mb intervals from the surface to 25 mb for the 54 stations participating in the atmospheric variability experiment 2 Pilot Experiment which began at 12 Greenwich mean time on May 11 and ended at 12 Greenwich mean time on May 12, 1974. Soundings were made at 3 hour intervals. Methods of processing and data accuracy are discussed, and synoptic charts prepared from the data are presented. The area covered by the sounding stations is the eastern United States east of approximately 105 deg west longitude.

Scoggins, J. R.↗

The effect of communications and traffic situation displays on pilots awareness of traffic in the terminal area

The Air Traffic Control (ATC) system is evolving under a general plan specified by the Federal Aviation Administration. Among the developments being considered is the Discrete Address Beacon System (DABS). The use of this system, although relieving congestion on the communications frequencies, would eliminate information about other aircraft because the party line communications now in use would be lost. One alternative to restore this lost information is an Airborne Traffic Situation Display (TSD). Experienced airline and military pilots participated in a factorial design to evaluate two types of communication (discrete address, party line) and two types of displays (TSD, no TSD). A stop-action quiz was used to evaluate their knowledge of other aircrafts' position, altitude, speed, heading, rate of climb, identity, and landing sequence number. Significant differences between conditions were detected, primarily in the position variables. Workload, as measured by a spare capacity side-task, showed a main effect of displays and a significant interaction between displays and communications. The data are summarized by plotting each display/communication condition configuration in the plane defined by information and workload index. A limited number of blunders by other aircraft were included in the simulations with a significant, but not entirely satisfactory, improvement in blunder detection attributed to the TSD.

Melanson, D.↗

Pilot Performance During A Simulated Standard Instrument Procedure Turn With and Without A Predictor Display

A simulator study was conducted to measure the effectiveness of predictor information incorporated into a CRT display of a computer simulated aircraft's horizontal and vertical situation. Professional pilots served as subjects for the task of executing a standard instrument procedure turn at constant altitude in constant crosswinds with and without their predicted ground track displayed. The results show that the display with the predicted ground track was markedly and significantly superior to the display without this information and that the subjects were generally satisfied with this type of information. Mean rms lateral path error was independent of the crosswind velocity with the predictor information, and increased without it with increasing wind velocity. Rms stick activity decreased with the predictor display which also uncoupled aileron and elevator activity.

John G Kreifeldt↗

In-flight measured human pilot describing function and remnant for pitch attitude control

Flight tests have been performed with a variable pitch-rate-command/attitude-hold flight control system in a Beechoraft Queen air-80 aircraft. Some results of in-flight measured runs for two pilots controlling typical easy and difficult dynamics are presented together with the initial results of the same tracking experiment performed on a ground-based flight simulator. Results are compared with results of other investigators using fixed-base flight simulators.

Mooij, H. A.↗

Land use mapping in Erie County, Pennsylvania: A pilot study

The author has identified the following significant results. A pilot study was conducted to determine the feasibility of mapping land use in the Great Lakes Basin area utilizing ERTS-1 data. Small streams were clearly defined by the presence of trees along their length in predominantly agricultural country. Field patterns were easily differentiated from forested areas; dairy and beef farms were differentiated from other farmlands, but no attempt was made to identify crops. Large railroad lines and major highway systems were identified. The city of Erie and several smaller towns were identified, as well as residential areas between these towns, and docks along the shoreline in Erie. Marshes, forests, and beaches within Presque Isle State Park were correctly identified, using the DCLUS program. Bay water was differentiated from lake water, with a small amount of misclassification.

Mcmurtry, G. J.↗

Experiments in pilot decision-making during simulated low visibility approaches

A simulation task is reported which incorporates both kinds of variables, informational and psychological, to successfully study pilot decision making behavior in the laboratory. Preliminary experiments in the measurement of decisions and the inducement of stress in simulated low visibility approaches are described.

Curry, R. E.↗

Failure detection by pilots during automatic landing: Models and experiments

A model of the pilot as a monitor of instrument failures during automatic landing is proposed. The failure detection model consists of two stages: a linear estimator (Kalman Filter) and a decision mechanism which is based on sequential analysis. The filter equations are derived from a simplified version of the linearized dynamics of the airplane and the control loop. The perceptual observation noise is modelled to include the effects of the partition of attention among the several instruments. The final result is a simple model consisting of a high pass filter to produce the observation residuals, and a decision function which is a pure integration of the residuals minus a bias term. The dynamics of a Boeing 707 were used to simulate the fully coupled final approach in a fixed base simulator which also included failures in the airspeed, glideslope, and localizer indicators. Subjects monitored the approaches and detected the failures; their performance was compared with the predictions of the model with good agreement between the experimental data and the model.

Gai, E. G.↗

Comparisons of pilot performance in simulated and actual flight

Five highly experienced professional pilots performed instrument landing system approaches under simulated instrument flight conditions in a Cessna 172 airplane and in a Link-Singer GAT-1 simulator while under the influence of orally administered secobarbital (0, 100, and 200 mg). Tracking performance in two axes and airspeed control were evaluated continuously during each approach. Error and RMS variability were about half as large in the simulator as in the airplane. The observed data were more strongly associated with the drug level in the simulator than in the airplane. Further, the drug-related effects were more consistent in the simulator. Improvement in performance suggestive of learning effects were seen in the simulator, but not in actual flight.

Billings, C. E.↗

A preliminary investigation of remotely piloted vehicles for airframe noise research

Aircraft noise encountered in the community is caused predominantly by the aircraft engines. However, expected advances in engine noise technology combined with recent experimental evidence indicate that airframe (nonpropulsive) noise, may be a significant aircraft noise component in the future. Thus, methods for research into control of this type of noise are being evaluated and a technique based on the remotely piloted vehicle (RPV) concept appears to overcome some of the difficulties encountered with other test techniques. In particular, this paper presents sample experimental data, gathered during a preliminary RPV experiment, which illustrate the high signal-to-noise ratio attainable with this technique. Further, since the data are recorded as transients or nonstationary signals, a method of measurement and analysis is presented which increases statistical confidence in the results.

Fratello, D. J.↗

Choice reaction time to visual motion during prolonged rotary motion in airline pilots

Thirteen airline pilots were studied to determine the effect of preceding rotary accelerations on the choice reaction time to the horizontal acceleration of a vertical line on a cathode-ray tube. On each trial, one of three levels of rotary and visual acceleration was presented with the rotary stimulus preceding the visual by one of seven periods. The two accelerations were always equal and were presented in the same or opposite directions. The reaction time was found to increase with increases in the time the rotary acceleration preceded the visual acceleration, and to decrease with increased levels of visual and rotary acceleration. The reaction time was found to be shorter when the accelerations were in the same direction than when they were in opposite directions. These results suggest that these findings are a special case of a general effect that the authors have termed 'gyrovisual modulation'.

Stewart, J. D.↗

Fixed-base simulator study of the effect of time delays in visual cues on pilot tracking performance

Factors were examined which determine the amount of time delay acceptable in the visual feedback loop in flight simulators. Acceptable time delays are defined as delays which significantly affect neither the results nor the manner in which the subject 'flies' the simulator. The subject tracked a target aircraft as it oscillated sinusoidally in a vertical plane only. The pursuing aircraft was permitted five degrees of freedom. Time delays of from 0.047 to 0.297 second were inserted in the visual feedback loop. A side task was employed to maintain the workload constant and to insure that the pilot was fully occupied during the experiment. Tracking results were obtained for 17 aircraft configurations having different longitudinal short-period characteristics. Results show a positive correlation between improved handling qualities and a longer acceptable time delay.

Queijo, M. J.↗

Kalman filter estimation of human pilot-model parameters

The parameters of a human pilot-model transfer function are estimated by applying the extended Kalman filter to the corresponding retarded differential-difference equations in the time domain. Use of computer-generated data indicates that most of the parameters, including the implicit time delay, may be reasonably estimated in this way. When applied to two sets of experimental data obtained from a closed-loop tracking task performed by a human, the Kalman filter generated diverging residuals for one of the measurement types, apparently because of model assumption errors. Application of a modified adaptive technique was found to overcome the divergence and to produce reasonable estimates of most of the parameters.

Schiess, J. R.↗

Remotely piloted LTA vehicle for surveillance

Various aspects of a remotely piloted mini-LTA vehicle for surveillance, monitoring and measurement for civilian and military applications are considered. Applications, operations and economics are discussed.

Seemann, G. R.↗

Summary of flight tests to determine the spin and controllability characteristics of a remotely piloted, large-scale (3/8) fighter airplane model

An unpowered, large, dynamically scaled airplane model was test flown by remote pilot to investigate the stability and controllability of the configuration at high angles of attack. The configuration proved to be departure/spin resistant; however, spins were obtained by using techniques developed on a flight support simulator. Spin modes at high and medium high angles of attack were identified, and recovery techniques were investigated. A flight support simulation of the airplane model mechanized with low speed wind tunnel data over an angle of attack range of + or - 90 deg. and an angle of sideslip range of + or - 40 deg. provided insight into the effects of altitude, stability, aerodynamic damping, and the operation of the augmented flight control system on spins. Aerodynamic derivatives determined from flight maneuvers were used to correlate model controllability with two proposed departure/spin design criteria.

Holleman, E. C.↗

A method for predicting the stability in roll of automatically controlled aircraft based on the experimental determination of the characteristics of an automatic pilot

A method is suggested for predicting the stability of automatically controlled aircraft by a comparison of calculated frequency-response curves for the aircraft and experimentally determined frequency-response curves for the automatic pilot. The method is applied only to stabilization in roll. The method is expected to be useful as a means of establishing the specifications of the performance required of the automatic control device for pilotless aircraft designed as missiles.

Jones, R. T.↗

Evaluation of an envelope-limiting device using simulation and flight test of a remotely piloted research vehicle

The operating characteristics of a nonlinear envelope-limiting device were investigated at extreme flight conditions by using a real time digital aircraft spin simulation and flight tests of a scale model remotely piloted research vehicle. A digital mechanization of the F-15 control system, including the stall inhibiter, was used in the simulation and in the control system of the scale model. The operational characteristics of the stall inhibiter and the effects of the stall inhibiter on the spin susceptibility of the airplane were investigated.

Petersen, K. L.↗

A new experimental flight research technique: The remotely piloted airplane

The results obtained so far with a remotely piloted research vehicle (RPRV) using a 3/8 scale model of an F-15 airplane, to determine the usefulness of the RPRV testing technique in high risk flight testing, including spin testing, were presented. The program showed that the RPRV technique, including the use of a digital control system, is a practical method for obtaining flight research data. The spin, stability, and control data obtained with the 3/8-scale model also showed that predictions based on wind-tunnel tests were generally reasonable.

Layton, G. P.↗